Golf/GTI VI :: 2012 - Steering Voice Button Not Working
Sep 23, 2014
I picked up a 2012 SEL w/ RNS-510 today and the steering wheel voice button doesn't work. It's basically a golf inside and the Tiguan forum is slow so I'll ask here. I checked it with vcds and its coded for voice command to work. Did the 2012's cone with a harness for voice command or do I need to add the wires to the harness? My rns-510 is a version F and the service records show that the original was replaced under warranty. It's running software 3690 but I'm installing 4366 in the morning. Does 3690 disable voice command? I know it works with 4366. I'd mess with it tonight, but I drove 500 miles each way to get it so I'm ready for bed.
When I press the star button on the rns-510 the annoying voice says, "route guidance is not available".
View 1 Replies
Advertisement
I picked up a 2012 SEL w/ RNS-510 today and the steering wheel voice button doesn't work. I checked it with vcds and its coded for voice command to work. Did the 2012's cone with a harness for voice command or do I need to add the wires to the harness? My rns-510 is a version F and the service records show that the original was replaced under warranty. It's running software 3690 but I'm installing 4366 in the morning. Does 3690 disable voice command? I know it works with 4366. I'd mess with it tonight, but I drove 500 miles each way to get it so I'm ready for bed.
When I press the star button on the rns-510 the annoying voice says, "route guidance is not available".
View 9 Replies
I recently purchased a used 2010 GTI with the Autobahn Package, leather seats, Nav, the 510 nav/sound system unit etc. The steering wheel has the button on it that would normally be used to control phone or sound system functions by voice, but when I press it, it acts much like the phone button on the bottom left of the radio/media unit - ie. it mutes the radio, but doesn't do much else. I just wanted to check if that is normal behavior or if the fact that I have that button on my steering wheel mean that it is supposed to function?
View 17 Replies
2013 Prius Three with 5.000 miles. Dealer ran a scan with no results and submitted a claim with Toyota.
View 14 Replies
Basically, with my phone paired to my entune system via bluetooth, at times, the system doesn't understand how I'm asking to make a call, especially with people I call on a normal basis (like my fiance). for example, I'll say, "Call [Bob Harper]" and then it'll ask me which of the following did I mean to say. One possible name it'll bring for would be "[Joe Smith]" which sounds nothing like the name I told to call. I understand voice dialing isn't perfect, but most of the time, it's not dialing the person I want to call. Maybe it's the way I'm speaking into the mic.
View 8 Replies
Whats the deal with this voice button on the dash? what can u do with this?
View 1 Replies
I have had my '12 S for two weeks and love the car. I am just starting to figure out the car and what I want to update/upgrade. But the button on the driver's door isn't working. Before I take it to the dealer, for fear of looking stupid if the fix is simple, is there a fuse I should check or something else I'm missing that would prevent the button from opening the trunk? The fob works and if I use the handle on the truck it opens fine. If there is a fuse I should check?
View 14 Replies
I have a 2012 Prius III and from the time I bought the car I have been having ongoing multimedia system and voice activation problems. I have taken it into the dealer numerous times, and they often say they were unable to duplicate the problems (so I started recording the issues with my iphone!). The third time I took it in with the videos in hand, they agreed to replace the multimedia unit...unfortunately, the problems persisted. They are outlined below.
1. Voice Recognition button doesn't work about 50% of the time. When pressed, it displays "Voice Recognition Not Available"
2. When plugging in my iPod, the multimedia system will often reboot
3. The touch screen buttons sometimes do not work (may 25% of the time, and only some buttons, not all of them, and they are different every time)
4. When my iPod is plugged in and I navigate to the playlist, the wrong songs will be in the playlist.
5. When plugging in my ipod, the screen will just load and load and load....forever...until I unplug it and plug it back in from the center console plug (not from the iphone side).
Turning my car off, then back on often resolves the problems.
View 1 Replies
The owner's manual for my 2012 Toyota Camry does not give a very good description about what the MODE/HOLD button on the steering wheel is for. At first, from what I had read in the manual, I thought it was like a mute button for the radio, cd, etc. when I wanted to use my hands free cell phone. When I first tried to do this, it took me a while to realize it but I was actually muting my cell phone.
View 3 Replies
As some of you may be aware, I swapped out my OEM HU recently for an aftermarket one -- I show it in post 486 here -- and for various reasons, I decided to go back to stock. I got a pair of 70-1761 & 71-1761 wiring harnesses (because I have a 4-channel aftermarket amplifier) and in a lapse of judgement I tapped the dimming wire into the illumination wire.
Later that night, I noticed when driving with my headlights or parking lights on, the center console buttons don't light up. Specifically, the radio, home & other buttons don't light up and all & the climate control dial knobs are very dim. The ventilation buttons buttons of the HVAC all light up fine & my hazard & passenger seat belt light up fine.
I already check the instrument cluster dash light control & I notice the dial knobs react to it but are still very dim. The brightness of the instrument cluster doesn't match their brightness at all.
I went ahead an looked at my fuse box under the steering wheel column and checked the 10 amp PANEL fuse & it's not blown. For good measure, I swapped it out but the buttons still don't light up. I then checked EVERY fuse under the steering wheel column & non are blown.
In addition to that, I checked every 10 amp fuse in the engine bay fuse box & non of them are blown.
View 4 Replies
Is there a setting to adjust the voice control button so it skips that introduction? I feel like I have to wait for an explanation every time when I just want to say a quick command.
View 6 Replies
Wipers, Compass and Steering Volume button stop working.... I cleared all codes, the problem still exists. I checked all the fuses, all ok. What else to do?
View 1 Replies
My 05 has a problem with the recirculate and defrost buttons on the wheel. The recirculate button will sometimes toggle the MFD between the consumption screen and the energy monitor screen like the info button does and won't change the recirculate light on the dash at all. Sometimes it will do nothing, and other times it works normal changing from outside air to recirculate. Also the defrost button will sometimes turn on the windshield defroster with 1 push then turn on the rear defroster with a second push and both will go off on the 3rd push.
Other times both defrost buttons will do nothing or work normally. When the wheel buttons are acting up the MFD will control both the recirculate and defrost functions normally so I don't think the MFD is the problem. The 12 volt battery has been checked and is good at 12.4 volts and there is no malfunction lights or codes set in the system. All the other buttons on the wheel function normally. What to check?
View 3 Replies
I just bought a 2003 W12 Phaeton with 55.000 km on the clock and a few problems that were knocked off the price.
The car is absolutely fantastic, so much better than my previous 4.2 A8, although I bought with a gearbox problem that dropped the price down to USD 8.000.
The gearbox issue is that it jumps from 1st to 2nd gear with a 'clock' and much harder when the other way around (2nd to 1st). Sometimes so hard that it automatically engages the "safe mode" with the yellow PRNDS sign on the screen. Once on 2nd gear and up, it runs smoothly.
My plan is to take the gearbox off the car and bring it to an expert mechanic on ZF gearboxes, as the VW dealer quotes USD 9.000 for a new gearbox.
Re the other issues, I have plugged in the VCDS after changing both batteries (a standard 90 Ah on the right, a VARTA G14 95 Ah on the left) which show many faults that I can't really identify. The problem I have noticed is that one button on the steering (the OK push button on the right) does not work and when it is pushed, the cruise is deactivated (?). Looks like this module will need to be replaced (VCDS says 'control module defective').
The other issue I have noticed is that the TPMS system doesn't work. On the screen it shows clocks on each wheel... and nothing happens. I guess it's the batteries of the sensors, so I am thinking of replacing them. Would this solve the problem?
I just realized that I did my last VAG-COM check before clearing previous DTCs, so I will do that now and come back to post it.
View 24 Replies
Looked in the manual. Couldn't find anything about pairing an iPhone with the "phone" button on the R32's steering wheel -- assume bluetooth is involved.
View 2 Replies
2012 Golf R ; only mod is APR software with launch control and no lift shift. When i shift hard into second power is cut like traction control is being activated. To be clear the instrument cluster indicates ASR is off. I have two codes that pop up in VCDS (no check engine light) these codes have popped up at least twice now. They are below.
005634 - Power Supply Terminal 30
P1602 - 002 - Voltage too Low - Intermittent
Freeze Frame:
Fault Status: 00100010
Fault Priority: 2
[Code] ....
View 8 Replies
So I was driving just a second ago, stopped to get something and where I was parked I had to leave my hazards running. I had them on for a minute at most and when I got back in the hazard button was smoking. I turned it off and blew in the gap as much as possible.
The smoking stopped. Now neither my hazards or blinkers work. I haven't had a chance to check fuses yet. Wanted to see what people thought or if they'd had similar experience ASAP. Will update with finding when I can.
View 2 Replies
As the title says the cruise control is not working, the cruise light comes on but no workee after pressing the the set button. I have followed the steps according the the owners manual.
View 13 Replies
My RNS-510 has stopped dialing names. When I say "call so-and-so" it asks for a phone number (thinking that I want to dial by number).
View 2 Replies
On my 14.5 there is something wrong with the Entune. Every time I try to use voice commands it tells me it is initializing and to please wait. No beep or voice, just a message on the screen. I first thought it was because I had an iPod Classic and it was taking too long to index, but it does that for everything; phone, nav, even voice training. I also notice it often plays a completely different track then the one I select when manually selecting songs on my playlists, it that normal?
I tried cycling the unit on and off, and made sure everything was up to date. Should I try resetting everything on the unit back to factory? I don't think that will default the firmware though, will it? I have a service appointment on the 30th as a 30 day checkup since buying it but would like to try and figure it out first. I've seen some posts suggesting that Toyota has been replacing head units for it, which would suck.
View 4 Replies
I have a 2012 Camry SE with the Entune Navigation unit (58k miles). Everything has worked flawlessly up until two months ago. I was on my way to the airport at 4AM, when I went to hit the "APPS" button on the radio, and nothing. So I tried accessing it via the touch screen, same outcome. Then I tried to use the steering wheel to make a phone call, nothing but a short beep. Now its at the point where the ONLY buttons that work are the AUDIO, SEEK, TRACK, CAR, and VOLUME on both the radio and steering wheel. All other buttons have stopped responding. I can not get to any Bluetooth menus to use my phone, play music from my iPod, etc. Pretty much stuck on AM/FM radio or listening to a CD.
Attempted Fixes:
I just tried to install the latest version of Entune via the download directly from Toyota, however, the car does not respond to the USB when plugged in, so that was a bust. I also took the radio out and checked/cleaned the connections, to no avail.
View 4 Replies
