Golf/GTI VI :: 2012 - CEL For EGR Error?
Jul 5, 2012
I have a 2012 Golf tdi. Got a cel after a 300 mile highway trip.
Got it scanned by dealer, came out to be p2413. Some EGR malfunction. According to service ticket, all vw did was reset my ECM. Does that sound accurate? Car has 16k miles.
Service rep mentioned that it could have something to do with my carbonio intake. True? Or BS?
So far, 100 miles later, no cel and car seems to be running fine.
Just curious if it actually could have something to do with the carbonio, or if he was just busting my balls.
View 19 Replies
Advertisement
I got black side markers for my car and put on the bulbs the side markers came with... I like the look but I got the bulb out error.. Wanna keep these bulbs but the error code annoys me .. Need to know the vag-com code to get rid of this? I searched but I can't find it.. I have a 2012 GTI .
View 11 Replies
I have a 2012 passat se and the airbag error light came on, after it did all the buttons on the steering wheel and the horn stopped working. How is the best way to fix this?
View 4 Replies
I recently got a 2014 Camry SE and have started to experience problems with the USB port in the center.
I generally plug in my 5th gen iPod to listen to audio, but I've started to get an connection error. The message reads Connection error. Please consult your Owner's Manual for instruction on how to connect the USB device." (see image link below)
Sometimes the iPod will connect, but most times it won't. If it does connect, the error will appear when I hit a big bump or pot hole, leading me to believe there might be a connection or soldering failure somewhere.
I can confirm that it's not the iPod's problem, my cell phone, tablet, or any other device plugged in will not get a power signal either. The iPod will connect via Bluetooth, but that is not optimal as I'd rather have my phone connected for hands-free calling.
If not, how easy is it to open up the console to get at the connection to check/fix it myself?
View 8 Replies
I have a 2012 F-150 XLT with 5.0L V8. I am constantly getting a PO304 (misfire) error. This is what my mechanic has done to try to correct the problem. 1. replace plugs 2. replace coil 3. replace coil cables 4. replace injector kit.
The question I throw out is: What other part or adjustment is left?
After clearing the error it seems the Check Engine Light will not come one until the next morning. The engine seems to misfire then then I get the Check Engine light again.
View 10 Replies
I have a 15 Camry, and the other day after about five minutes of driving, the BSM (blind spot monitor) gave a long beep and then an error message to check the BSM showed on the instrument cluster. I tried to reset it while driving by turning the BSM on/off. This didn't work.
After restarting the car, it went away. I've never had a car with BSM, and didn't see any damage to the bumper.
View 1 Replies
I got a 2012 Hyundai Accent SE manual 112000 mostly highway miles. For a month now I am getting the MIL on and P2191 code (System too lean at higher load bank1) after erasing the code it appeared again in 3-4 days. I replaced air filter check all valves and vacuum in air flow, changed to premium gas. Pipe that connected to the valve from EVAP system looks not damaged and valve works as intended. While changing spark plugs I noticed that all of them were quite charred. I am thinking to replace both O2 up/down stream sensors. Which not OEM sensors would be the best match for my Accent?
View 11 Replies
I recently purchased a Rear Bumper Protector for 2010-2014 Toyota Prius for my 2014 PIP. I thought I had it in the correct position when I removed the adhesive strips to install it but realized the next day that the curvature is not lined up properly causing a gap in between the bumper and the protector. My stomach sank when I realized this error.
View 8 Replies
Just bought a 2012 F350 6.7 4x4 in the beginning of March. After about 500 miles the "Exhaust Fluid System Fault - In 50 miles, speed limited to 50 mph" message displayed. So first thing that occurred to me was maybe it was low on DEF, so I added approximate 1.5 gallons as it had some already in there. I also called the dealer who said "well it just needs to be driven on the highway" hmmm, that sounded weird but I did it anyways. After that I started the truck and the message was gone. I thought that fixed it. - Nope, at about 1480 miles I got the same error message again.
So after getting the message again I just kept driving and the message went away. I thought ok. Yeah right! Now in the past few weeks I have been noticing that the truck almost wants to stall and begins to shudder when going over a slight incline and shifting from 5th to 6th at about 45mph. When I accelerate it makes a knocking noise. If I let off the accelerator, let it slow down, it downshifts into 5th and I then accelerate and it goes away.
And today... I decided to go for a nice ride. After about 10 minutes of driving I get the ole "Exhaust Fluid System Fault" error again. Crap! Again, I keep driving and after another 15min - I get that shutter and knocking noise. Anyway I drove until the the truck displayed "Speed limited to 50mph on next restart. I just kept driving and the error message mysteriously disappeared again.
View 6 Replies
So tonight I took apart my glove box and center console in hopes of relocating the TPMS button...Once I put everything back together the MFD says airbag error and when i sit in the passenger seat the airbag icon in the center console is flashing and a 2 and a X. Also the airbag icon is on the dash.
View 13 Replies
Car is at the dealership now and they said that the sensor is being stretched out from being too low. I'm only dropped on a h&r sport cup kit, nothing drastic.
View 24 Replies
So I bought my first VW as a used car. It's a 2011 GTI and already running into some problems. During the test drive at the dealership, the problem didn't occur. The car was sold as "as-is".
So on the way home from the dealership, the car threw an error about low oil pressure (I'm not sure what the wording was exactly at this time). I drove normally. I did not hit red-line or do any hard cornering on the way home. I got freaked out so I stopped, turned engine off and checked oil level. It's at the proper level.
I looked around the engine bay but nothing was obvious. I started the car up again and the code was gone so I made it all the way home. I drove around some more and now it's showing up about every 15-20 mins. Goes away and then comes back on later. The error now is "Low oil pressure. Turn engine off immediately".
View 5 Replies
I have experienced ESP error when trying to start the car. When I turn the key, the engine does not crank, instead, the ESP error shows up on MFD. I have to wait for several minutes until the EPC light is on. Then I can start the car with the ESP and EPC light off.
Here is the video: [URL] ....
From the forums, I have already had my battery replaced and still the problem persists. I take my car to local garage which cannot troubleshoot the cause. They just say it might be the relay or even the ECU. So, wonder if there is any clue?
View 3 Replies
I was trying to install my MDI in a parking lot where I could get some space. I thought the radio fuse was inside the panel by my drivers side door. I pulled those fuses out one by one, the I realized it was under the hood. I'm not done swapping pins, but I need to drive the car and it won't start. I didn't put the radio back in. My MFI says ESP error when I turn the car on. I have a micro can with me, but it's having a hard time finding the interface.
View 4 Replies
I had HID's installed in my fogs (before haters jump in, it doesn't look remotely bad, and they're aimed down, so no glare), and I'm getting a bulb out error. I have a VAG, but I'm not seeing any long coding to disable error checking for the fogs. I have the error cancelling add on, but we forgot to install. Just curious if there's a VAG trick to disable that error before I rip the fogs out again.
View 1 Replies
I have been getting random bulb out errors, usually its the front side lights and today with out turning on the lights I had rear parking light...thing is I get out of the car to check and they are lit? Faulty bulbs? stock tails and side markers but do have a bi xenon retro in the headlights using the usp hid kit in the projectors.
View 3 Replies
I just has a gen 2 haldex and wireless controller installed. 10 minutes of driving around getting on it in sport mode, I feel a thunk from the back and when slowing down a few odd shudders. Drove it cautiously a bit more and felt fine, then harder and harder. Felt better, no understeer, seemed ok.
Got home and scanned with Vagcom, got the errors below, cleared DTC and scanned again, same errors.
Address 22: AWD Labels: None
Part No: HW0 5Ha lde x
Component: Tuning
Coding: 0000001
Shop #: WSC 00000 000 00000
VCID: 5AB1BED4953067CEBA7-800F
2 Faults Found:
16347 - Control Module - EEPROM Error
014 - Defective
02248 - Valve for Controlling Clutch Operating Angle (N373)
014 - Defective
View 3 Replies
I am getting a CEL and the error code is p2187 engine too lean at idle. I have been reading around to try and find the issue, some seem to say PCV could be the issue. I have also read a test would be try and remove the oil cap while car is idling. I did this test and the oil cap was difficult to remove and the idle got really rough once removed.
View 2 Replies
My r is throwing a p0601 sum error. I clear, it comes right back. I know the previous owner has it chipped at a garage that wasn't linked to any brand. I was planning on putting an apr/giac tune over it but now I can't (no money). I know this might mean I need a new ecu. Right now I plan on going to vw on monday and having them reflash the ecu bringing it back to stock...if it returns then i guess i need a new ecu... This sound right?
View 5 Replies
I've got a golf tdi with a tune and straight pipe exhaust, and after I hit about 115mph I get a system error code. When I shut of my car, it dissapears and when I try to find it with a code reader, its no where to be found. What's the cause?
View 6 Replies
Pulled into my driveway one night and a get a AFS failure.
Lights work, everything functions correctly, except my headlights don't level. I've seen some threads refer to it as the "dance".
I have the light out warning on the dash and every time i start my car it says "AFS FAILURE" or something across those lines.
I replaced my headlight level sensor and made sure the level sensor is pointing the correct way (toward the driver side) and that didn't fix it.
My car is lowered, but this issue didn't happen until recently. I do also have Euro Headlights, these were installed months ago. Way before this issue came up aswell.
View 3 Replies
