Golf/GTI VI :: 2011 - Code To Control Windows Using Key Fob?
Feb 6, 2011
What is the code to control the windows using the lock/unlock on the keyfob and also how to get to it? (2011 jetta)...
View 1 RepliesWhat is the code to control the windows using the lock/unlock on the keyfob and also how to get to it? (2011 jetta)...
View 1 RepliesI have a 2011 GTI, has about 4000 miles on it. Sunday went for a quick ride down some FM's and on the hi-way. Got up to about 85mpg for about 10 miles, hit the exit back to the house which is only about a mile away. On that mile ride home I took it real easy maybe 35-45 mph decided to have a little AC also (outside temp 90F degrees).
I pulled into the garage sat and idled for about 30 seconds, on the MF display up pops the Cruise Control Malfunction icon ( amber on the MFI,But the owners manual says it's RED. it's a cruise symbol with a giant exclamation ) then it goes away. I looked at my cruise stalk, cruise was Off. I turned it on and up Pops the Malfunction Icon again then goes Off. Took the GTI back out and No Cruise malfunctions. Also, when I did finally park the Car both cooling fans were on for at least 4-5 mins after I had shut everything down.
Did I run my little GTI too hard? Is the Cruise control Malfunction icon like a nuisance message that doesn't really mean anything or, is it a sign CC it's already toast, or getting ready to go.
I have a 2000 GTI GLX VR6 and when I start it in the morning (ie cold) after the initial "choke" and the revs drop it becomes erratic. Sometimes it will stall out. If I restart the car it will throw a check engine light and go into limp mode. If I let the car warm up it runs fine. If the car has been driven and is relatively warm it runs fine. Initially there were several codes but after replacing the MAF and the fuel pump relay the only remaining code is P1545.
My mechanic seems to think it may be the coolant temperature sensor. The code seems to indicate the problem is the throttle. "Throttle position control malfunction". Not sure why warming it up makes a difference (unless of course it is the temp sensor). When I replaced the MAF sensor I did clean the throttle body. I was very careful in doing so. Problem existed prior to my cleaning it as well. After changing the fuel pump relay things were better for a few days but then the problem returned.
Check engine light came on the other day. Brought the car over to autozone and this was the code that came back. P0441 EVAC Control System; Incorrect flow. Where I should start looking?
View 3 RepliesThe code the R threw was p0606 which is the Powertrain/ Engine control module? Where these components are in my R? Or how I can go about trouble shooting this problem?
View 9 RepliesSoild CEL, autozone pulled a P2015 code, but couldnt find it for VW in their system, just hyundai, toyota, dodge, and kia codes came up.
Looked around and everywhere says it's the notorious MKVI IM replacement issue.. Im under PT warranty until Nov. '15 so im good there.
Heres the catch.. sometimes it goes off without any changes to the vehicle. First thing (before the obd2 reader from autozone) i checked was my gas cap, that will cause a CEL sometimes, next time I started the car the CEL was off. the next day, without touching the gas cap since, the CEL was on again, today its off
car idles fine, drives fine, MPG are fine, pulls fine, stops fine, steers fine, everything works in the car. year: 2011
Getting this code. 01309 - Power Steering Control Module (J500) on my 2012 GTI. Does the module need to be reset or does it need to be replaced?
View 2 RepliesI have an intermittent check engine light that's popping up due to a P2187 code. The CEL will come and go, and if I clear the code it it'll be back within the next week or so. The car is a stock 2011 GTI with DSG. What I need to be looking at to get this sorted out?
View 4 RepliesI'm owner of a VW GTI 2011 Stage 2 APR
Chip Stage 2, APR Intake
Today I got a Check Engine light, I plugged my scanner and read: P2404/009220 EVAP Leak Detection Pump Sense Circuit: Implausible Signal. But I realize that I have 2 tube near the motor that doesn't have anything on it.
My key died today so I had to pull out my spare. Isn't there a way to make the key control the windows and sunroof with the key? I'm only finding info on how you can make it unlock the drivers door or all. I have a 2010 SEL 4Motion.
View 9 RepliesI have a 2014 IS350. Is there a way to roll the windows up and down with the remote? My friend has and Acura that can roll the windows up and down with the remote. He holds the lock or unlock buttons to adjust them.
View 5 RepliesI was minding my own business when my 2002 Audi A4 started acting up. All of these issues occur on an intermittent basis.
First, none of the windows roll down.
Second, the interior lights come on and stay on even when the doors are closed.
Third, the obnoxious seat belt warning beep stays on even when my seat belt is on and the doors are closed.
Fourth, the remote control will not lock the car (although the key works).
Fifth, the remote control will not unlock the trunk.
All of these seem to happen at the same time. My car is silver color.
I got a Ford f150 and getting the error code P0446 Evaporative Emission Control System Vent Control. My truck has burnt up 3 of these things already in the last 8 months. Why my truck keeps killing them?
View 2 RepliesHow to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
For what it's worth I found a gent locally who has the Vag-Com setup on his laptop and we were able to get the windows and sunroof programmed to open and close when holding the lock/unlock buttons on the remote.
The article we followed is here: [URL] .....
He had to do this the long way with the long code as my '11 Tiguan wouldn't take the programming from the adaptation menu. A couple of other items to note is that the doors did have to be unlocked for the Vag-Com to be able to read the Central Electronics section of the ECU. When they were locked the software on his laptop alternated between saying too many connections and timing out. Also we had to check then uncheck the Comport Opening Only for Drivers Door Active to get all of the windows to open and close...
I am a newbie Gx470 owner. I just finished a timing belt job on my 2005 Gx470 with 127K on the clock. After the work, the driver's master window control would not activate any window but the drivers. On a recent outing my wife activated the passenger' window. I suddenly regained control of that window from the drivers position. You guessed it, when I ran the rear windows up and down, I regained control of them also.
View 3 RepliesOn my wife's car a 2009 Sonata, the driver's control of the power windows for the right side stopped working last Friday. The window switches operate on all doors, but can't control them from the Driver's door.
View 4 RepliesMy control of the both right side windows on the driver side do not function but I am able to move them when I control them individually. Is there a solution to fix this issue by myself or will I have to take it to a maintenance shop?
View 10 RepliesSo the car is a 2014 hyundai hybrid limited I had all the door panels off cause i was upgrading all 4 door speakers putting everything back to gather and a few days later I went to roll the rear window down and neither one works the front to works but both back will not go down or the heated seats in the back wont work. I check all connections and the fuses and they all seem fine what else can be the problem....
View 3 RepliesI found this issue today after using my PIP for about a month. Front driver side's windows switch can not open/close the rear windows ( With un-lock button depressed), It can control front passenger side windows.
View 3 Replies99 f150 xlt power windows. My friends always like to roll my windows down to try and smoke cigarettes. I was wondering if there is any way to install a window lock maybe a switch that turns on or off but still allows me to control the windows from the drivers side.
View 2 Replies