It seems like my 11 GTI doesn't exhibt anything impressive in 1st and 2nd gear and I fall behind other non-sporty cars when lifting off from a traffic light. But upon shifting to 3rd gear I'm zooming incredibly.
View 2 RepliesSo after my 500 mile break in I decide to see what my new set up is made of. Had the kinetics stage 3 and the south bend stage 3 clutch installed. Did my first launch...everything went great. Got just a little bit of spin and the car took off like a scud missile. Right as Im going to shift into second my Rpms go down fast. No weird noises no metallic sounds nothing. No fluid under the car. Only a slight clutch smell nothing crazy. Car wouldn't go into gear. Shut the car off and it goes into gear.
View 20 RepliesI just traded my MKIV GTI yesterday for an R32. Super happy.
But I have a question, Should I put in new tranny fluid? cause when I try to go fast and go from 1st to 2nd it gets blocked, but if I'm going slow and slowly feather the clutch it goes into the second fine.
My 2011 ISF has around 50K miles. Recently I noticed that when I shift into 1st from 2nd, usually on approach to a slower curve or slowing down to a light, there appears to be a distinct shudder. It doesn't happen all the time, and it happens regardless of Sport or normal mode.
Right after it shifts to 1st and the RPMs climb (or so it seems), I get 3-4 distinct back and forth movements .. i.e shudder. I think this is a recent phenomenon, as I know shifting into 1st is usually not very smooth, but I don't think I felt this shudder before.
No codes etc ...everything else normal. Don't think the trans is slipping, as car pulls hard and traction control is always busy. Motor mounts? Car is never tracked and driven spiritedly, but never ever abused or tracked. I do enjoy shifting it.
This morning while driving on the freeway, the the transmission stopped shifting into 6th gear. This was at 70 mph. The only way it would shift up to 6th is by using the manual mode, however after manually shifting to 6th I moved the stick back over and it immediately downshifted to 5th at 70+ mph. Concerned, I pulled off and turned the engine off. After i restarted the engine, I continued to my destination and the trans shifted up to 6th on its own. The car has never done this.
View 3 RepliesHave a question when I shift slow from 2nd to 3rd my o2j tranny doesn't grind but when I shift fast from 2nd to 3rd it grinds it happens starting at 3000 Rpms thru 6000 Rpms. It also doesn't happen when I shift from 4th to 3rd. Have performed a tranny fluid change. Along with replacing the clutch at 1500 miles ago. The engine is AWP.
View 4 RepliesExperienced an accidental shift from automatic to sports mode when attempting to "park" your Sonata? It happened to me last weekend. My car shot forward like a torpedo, doing considerable damage, not just to my car but to others as well. I have often thought it takes no effort to switch to the sports mode, but have never used it. Now I wish it were not available.
View 18 RepliesI just picked up my 2011 FX4 Ecoboost with the 4.10 axle ratio. While in drive, the transmission will not shift into 6th gear until around 65mph. The rpms in 5th gear at this point are around 2300(ish). If driven with Tow/Haul mode on it will shift into 6th at 45mph and lock the converter. If traveling at a speed in drive (no T/H) where you would think it would be in 6th, lets say 50mph on flat ground, and you force the trans into 6th, either by using manual mode or T/H, and then return the transmission to normal drive mode it WILL hold 6th just fine with the converter locked and will even accelerate holding 6th.
If you accelerate more rapidly and the transmission downshifts, it will not return to 6th until forcing it to do so by one of the two ways above. I realize that the truck has adaptive learning strategies, but this doesn't seem right. It also has only 300 miles. Initially I had even thought that this might be some sort of break-in programming, but not anymore.
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 RepliesSo I just got home from a road trip yesterday, no problems on the trip. This morning I drive out of my neighbourhood, turn onto the highway and I think to myself, that's strange, clutch feels a little notchy ... and then I go to shift gears and it won't go into gear. Any gear. I push down and it just won't engage, it pops right back up. Had to walk a mile home carrying my kid in his car seat and trailing my 6 year old little girl. Now I'm getting it towed home so I can check the engine bay to make sure everything is cool. If everything is connected and I can't determine the issue then I gotta flash back to stock and hit up VW and have it towed over there.
View 9 RepliesI know it will get a little notchy when its cold out, but shifting from 1st to 2nd is really notchy, and the shift box is pretty loud on that shift. I don't think its a trans issue, the noise seems like its only in the shift box. and goes away after 5-10 minutes or so, but it seems a bit excessive, especially for a new car. Car has 3500 miles on it, and has been doing this pretty much the whole time on cold starts.
View 14 RepliesI have a 2003 jetta 1.8t. Just recently it hasn't been shifting from 3rd to 4th gear. It will when the transmission is cold but once warmed up it will no longer shift into fourth gear. Just looking for some possible solutions. Going to check the fluid this weekend.
View 1 RepliesLast couple morning here in Michigan we've seen temps in the low to mid 30's. The last two mornings when I shift between 1, 2 & 3 I'm hearing a clicking noise coming from the clutch when engaging the gear. After a few minutes, once it warms up, the clicking goes away.
I am @ stage 1+ W/VWR intake, but I'm not expecting clutch troubles from that.
The DSG in my MY08 R32 is a lemon. It thumps/clunks quite loudly when shifting into 6th gear at low speed (50-60km). It seems to make the noise a lot when it's in D mode.
View 7 RepliesWhen I was driving on Friday I noticed that moving into 2nd, 4th, and 6th were "soft." I could hardly feel it engage into those gears at all so I thought maybe I would adjust my linkages. So I adjusted my linkages and while sitting in my drive way everything felt solid. When I took my car for a ride down the street I could feel it engage 1st, 2nd, 3rd no problem but after driving around for a few minutes my 2nd, 4th, and 6th gears felt soft again and then it got worse where I couldn't even shift into those gears anymore.
So my R, 1, 3, 5 all worked fine but didn't have 2, 4, 6. After taking a look at my linkages and I pulled off the selector cable and and shifter cable end. I noticed that on the shifter cable end that it felt wobbly and on the selector cable end it was rock solid. I am just wondering if the shifter cable end being worn out could be my issue? Is the shifter cable end supposed to have a little play in it and be wobbly? Or is there another issue I should be looking for? Here is a video of just how wobbly it is. [URL].....
So I have a 2.0L jetta with 160,000ish (daily driven) miles. And I'm starting to see a bit of a shifting issue mostly into third. Seems like I get locked out of the gear while shifting from second to third. I have to push it in(catches the "lock out") then I pull back and push forward again and it pops in. I rarely miss gears or grind. And I've noticed only a few times it does it in fourth as well. No grinding (unless I try to force it super hard) just won't let me go into gear.
Also while on subject of gear issues...
When I go into reverse, after the car has been sitting over night or for a longer period ( I would say between 8-14 hours) it will act up, almost like I am trying to drive with the parking brake fully engaged. In order to make it stop such bad behavior I have to rev it higher and it makes a *pop* or *crack* noise. Then it reverses just fine.
I've done a little bit of searching, "Look for a binding in the engine bay" and I have looked and haven't found much.
Just recently, my car 6 speed has started acting up and it's got me worried. First, and most notably, when I go to shift into 4th gear, there is a slight grinding noise and its a little tough to shift into 4th. Once it is in 4th gear, though, it shifts and drives fine with no other grinding noise. A buddy of mine says it might be the synchros, but what that means or how I can fix it.
Also, it has been having a rough idle on startup for a while now. It will idle at around 1,200 RPMs for a bit when I start it up, and it will kind of backfire out the exhaust a bit, kind of like it's a misfiring coilpack or something, but will usually go away after I drive for a bit.
Driving my car right now isn't very fun when I am only worrying about what's wrong with it, so I really want to get it fixed sooner rather than later, before these develop into larger problems.
So yesterday my car was running as fine as it always has. Then today came around...Car started fine, shifted into first and second fine, but when I hit 3rd it started to sputter in the low rpm's. Around 3000 it picks up a bit. This then continued happening through all of the gears. I noticed that the engine light was flashing for a few seconds and then went away completely. It still putters, struggles, and shakes when accelerating in the low rpms but its not throwing any codes. I know there are a few things it could be i.e. vacuum pump, bad coils or plugs, are maybe something more serious (fuel pump maybe?). I'm at a loss, especially since the car is throwing no codes (so there is nothing to scan for). I was hoping vortex could give me somewhere to start on this, I don't have a VAGcom so getting it scanned means $$$ and I want to get a start on the problem before I go that route. Here's some basic info:
Its at 182,XXX miles. Its never thrown any engine light or cel code in the 2 years 40,000+ miles i've owned it. I run 0w 40 eurpean car formula oil through it every 3-5k. I run seafoam through it every 6 months. I'm NOT sure when the last time the coils have been replaced.
Whenever I completely engage the clutch after shifting into 5th, there car bogs for a second if I give immediate throttle after shifting. It doesn't happen if I wait a second or when driving in fifth gear.
View 12 RepliesI have been reluctant to post another clunking thread because it's nearly impossible to accurately describe what is happening. But I have reached by breaking point and I wanted a few opinions before I take it into the dealer. I am still under powertrain warranty, but I want to be confident I am not wasting mine and the dealers time if I am just missing something easy. I also know dealers don't always take clunks seriously so I want to pinpoint it first.
Symptoms : Car has 50k miles. I am the original owner.
From a stop, when getting the car rolling moderately aggressively there is a clunk/pop noise from the car. I can slightly feel it in the pedals and it is fairly loud. Almost like a distant hammer and nail pounding. It's a single clunk, with sometimes a double "pop pop". It's noticeable even with the radio turned up a little. If you are smooth on the throttle it doesn't make the noise. It seems random, like something is hitting something which only happens under certain weight shifts.
It sounds like it's from the rear and the front. It seems to switch. But honestly I am not confident either way. Where it is. It is silent on turns, bumps, speed bumps, driveway, etc. I don't think it's the suspension. It is not a clicking/tapping, only a single clunk or knock.
It also happens in 1st/2nd in stop and go traffic. If you leave it in 1st and the traffic is moving from say 8-15mph where you don't need to use the clutch it will clunk during on/off throttle. Anything above ~30mph I haven't been able to replicate the noise with on/off throttle.
It also does it if I downshift when coming to a stop and don't rev match. Say you are slowing down and you go from 4th, 3rd, then 2nd, let the clutch out and it rev matches up to ~3,000rpm which causes the weight to shift forward....clunk! It is not easy to replicate which is another reason I am slow to bring it to the dealer until I pinpoint it.
Things I have tried:
- Subframe bolt torque check. Installed ECS spacer/bolt kit anyway.
- Sway bar links are tight, or at least they didn't budge at all.
- Adjusted the rear hatch a million different ways as it was making a similar noise earlier.
- Spare tire tightened, tools removed
- Rear seats up/down/mix/seat belts fastened, etc.
I was only able to locate one motor mount? Where they are. Seems fine. Dogbone seems fine, again hard to tell.
Suspect:
I have VWR springs, but I am 90% sure this started happening right before I had them installed. I did the rears myself, a well known shop did the front. I noticed the noise maybe 2k before the springs were installed.
Clutch linkage somewhere - I had issues with my transmission (early build). The clutch was replaced at 7k. I've always had a very loud flywheel and a grinding feeling in the pedal. Maybe the shifter linkage is hitting something? I have little experience with VW's so I am still learning and don't know what to check.
My rear harmonic balancer is cracking like everyone else. I have no vibrations yet and I don't see how it could be causing a clunk in the current state. Maybe a motor mount is bad that I cant see? It feels like something is loose in the drivetrain.
I come today for a apparently transmission problem. I have an automatic VW Jetta 2000 2.0 that i bought a few months ago, the car is great, has 250K miles.
The problem is in the morning when car is still cold, the transmission isn't shifting gear until 3K RPM (For 1-2 is about 2.5K RPM, and 2-3 is about 3K RPM). After 5 minutes of driving all back to normality and transmission shift gear about 2.2K to 2.3K RPM.
The question is: this is normal?, what could be wrong?.