Gen 3 Prius (Audio/Electronics) :: Navi Screen Opens When Volume Knob Is Turned
Mar 24, 2016
I have a 2011 Prius Four with JBL/navi package. When I go to turn the volume knob up or down the navi screen pops open as if I were going to eject or insert a cd. Only sometimes will it close back up when I press the eject/close button otherwise I have to twist the volume knob back and fourth until it randomly closes. THEN, when I set FM/AM station presets, power off the car, power car back on, the screen shows "loading" and everything resets except for the Bluetooth phone settings. Is there any firmware update I need to install via usb?
View 1 Replies
Advertisement
When I got my Prius, the volume knob didn't work, and I thought I could live with it. Steering wheel controls work fine except when I'm turning the wheel, then I have to chase the buttons. I really want the volume knob to function properly.
The post that inserts into the head unit volume receiving column is sheared off and stuck in there. I tried super-gluing it back together, but that didn't give me the slight bumpy sensation when I turned it. I thought it would at least depress, but not when it was superglued together. It won't pop in and out when I press on it when it was glued.
View 9 Replies
I discovered shortly after I bought my (used) 2012 C 4 that I couldn't turn off the radio. The volume knob didn't push in to turn off. Not a big deal, but I mentioned it to the dealer and they ordered me a new replacement knob. In the meantime, I just swapped the tuning knob over to the volume side and it's all fine. But I also discovered that the tuning knob side does push in – even with the broken knob – and not only that, it beeps when you push it. What is it supposed to be doing other than tune stations/change tracks? The Entune radio has a separate function for tone, balance, fader, etc., so it isn't doing that with the knob.
View 2 Replies
My prius 2008 I have been using for past 8 months or so was running fine with no issues until recently its audio system started malfunctioning. The power/disc/am/scan or volume tab won't function but it can be operated through the button on steering wheel .
After restarting car two times it started working.
View 1 Replies
I can change my nav system radio for just a radio? I am not smart enough to make the nav work and the light from the backup camera wipes out my night vision.
View 2 Replies
Just got my 06 Prius. The screen shows that Audio Off. The radio doesn't want to turn on. What could be the issue. 06 Prius with nav, Bluetooth, JBL etc. Everything else seem to work except the radio. Fuse perhaps?
View 3 Replies
Is there anyway to have the audio screen remain permanently on view? On my 2010 Prius, the screen view changes back to another screen after about 15 seconds. I would like the audio screen to remain on view so I can make changes between various presets. I know I can do this with the buttons on the steering wheel, but this may involve lots of button pushing. I also want to be able to flip between the presets and the text view (which shows me artist and song title.
View 1 Replies
Beginning yesterday, my touch screen and radio work only part of the time. It started with the radio just going silent for a few seconds at a time. Today, and this seems odd, I can mostly make it fail by starting car with foot on brake. I can mostly make touch screen and radio work normally by starting it with with foot off the brake. I considered fuse, which is unlikely, but... According to manual, touch screen and audio are on same fuse as clock, and clock is working fine.
View 2 Replies
Do not like having the nav screen always be on especially since we rarely use it. Would much rather look at the audio screen. How do I make audio screen default?
View 3 Replies
The MFD works and I can change modes and stations, but no volume with the audio. Nothing for bluetooth handsfree, am/fm/aux/cd, etc.
View 7 Replies
I have a 2010 package IV not 4 because it is a 2010 and only 2010 used uppercase roman numerals for model designation, with jbl non nav stereo. I have been having issues with the volume control not working so was looking into upgrading it to a a jbl with nav since I can get a good deal on the stereo and nav antenna. My question is will the existing wire harness support this and will a unit from a 2012-2013 fit a 2010?
View 6 Replies
I have a 2011 prius with just a regular stereo and no amplifier. the sound in the speakers go off when putting the volume up, however if I umplug the front speaker connector to the stereo the sound will work fine on the back speaker but once I plug that connector back the sound goes off. the sound to the speakers work fine with the Bluetooth.
View 17 Replies
Is there a way to keep the screen on map and still have the audio show? I tried this with dual screen but it only appears to stay in maps when I do this. I find myself switching to audio often so I can see what song is playing on xm.
View 8 Replies
An intermittent problem has showed up over the last few weeks that is quite distressing when it occurs.
When starting the car, the radio comes on a full volume. Turning volume control knob does not work, but only turning off the radio or turning off the car. [This only occurs if the radio was left on when the car was shut off previously.]
Also, the problem is noticeable if the radio is off and the buttons on the navigation system are pushed resulting in a high-pitched "beep." Then I turn the car off, then on again, and everything is back to normal.
This happens about once or twice every couple of weeks.
View 13 Replies
I get frustrated when I start my car and the radio volume is really loud from my previous driving experience. When I shutdown my 2012 prius 3 with the radio volume turned up loud it seems to remember the volume level. I do not have volume control until 4 seconds after I start it.
View 4 Replies
Just purchased a Prius III a week ago, like it so far. But one thing I have not figured out is how to adjust the rear speakers volume. My Prius has a JBL system, the two front speaks are quite strong, but the rear ones are not. On my other car, Camry, the volume can be easily adjusted to make either the front or rear speakers loud / light / balanced. How to do this in Prius? I believe it must be capable of doing such a basic thing, right?
View 5 Replies
When I have the navigation routing somewhere, I can't figure out how to adjust the volume of the voice. How can I do this?
View 9 Replies
Even though I have my 2013 Prius for 2 months, I just started trying the voice command system. I find that the volume of the voice prompts are very very low, and can't figure out how to raise that volume. The volume controls on the steering wheel have no effect, the radio volume control knob doesn't do anything, and there's no icon on the audio/navigator screen to make the voice prompts any louder (that I can see or find). It's probably something real easy and I'm just missing it, right?
View 1 Replies
I recently purchased a 2013 prius two. My building's parking garage is very long (full city block) and narrow, and I have to back out of it each time I leave. While I understand the benefits of the beeping, it is SO LOUD! Is there any way to lower the volume? I know I can take it to the dealer to get it switched to one beep, but all I really want to do is make it quieter, not go away. Alternatively, where the speaker the sound comes out of is? Maybe I can muffle it with tape or something.
View 4 Replies
I just purchased a 2010 Prius II. I have an I Phone 5. When I connect the phone thru Blue Tooth and listen to music app, I can only adjust the volume with the phone. I want to be able to adjust the volume with the car stereo volume knob.
View 3 Replies
Strange occurrence the other day that I have not been able to remedy. The volume/power button that can pop in & out on the dashboard hadn't been used of late but when I went to depress it, the button popped out. It is spring loaded and the knob itself has an end that is cut into quarters - persumably to fit into the female end within the JBL stereo unit itself. But can't figure out how to get it to stay in place as it continues to pop back out. Volume & power functions still work but button/knob won't stay in.
View 1 Replies