GTI 337/20th Anniversary :: Won't Start At First Attempt When Sitting For Few Hours
Feb 13, 2012
I have a small problem with the 337. this morning it was -21 and i started the car and it died right away second try it died right a way third try it started no problem. after work it was around -2 and same problem. i have problem starting the car when its been siting for a few hour.
What could cause this? i changed the crank sensor last weekend. put a brand new battery. cause the last one was 7 years old.
View 1 Replies
Advertisement
Car is hard to start when sitting about 9 hours or longer to a day without being started up it is hard to crank over, I am at a loss to what is causing it, the car has a new battery, new distributor rotor w/wires and cap, my car is an 1993 Nissan stanza ALTIMA GXE w/automatic seat-belts, the car is fully loaded Except for sun roof or heated seats, I do have 242360+ miles on the car. I kept the car well maintained from Nissan, and they can't find anything wrong with it. is this the case of just old age on the cars behalf? what I do notice is there's a slight drop in voltage reading on battery the night before to the next day, can a starter be my problem??
View 12 Replies
I had left my car for about 30 hours without driving, which I've done before all winter with no issues. Went to start it up yesterday morning to head out and when the key FOB failed to open the door, I knew I was in trouble.
I unlocked the door manually, and put the key in to start it up and the Treg was completely dead and the key wouldn't release from the ignition. After a call to VW roadside assistance, and a jump start, it started right up and I dropped it off at the dealer for them to look at.
The service report says "diag and found low state of charge. charged battery and found passes tests. performed TSB 27-05-01 and cleaned ground point for battery. rechecked OK"
This is a V6 Touareg (there is a similar TSB I understand for V8s).
View 1 Replies
My Corolla sometimes cranks longer than it should when starting. This happens if the car has been sitting for a few hours. Although it doesn't always happen.
It happens when the tank is full and empty. The weather has ranged from 100 down to 60 degrees. The car has 20k miles on it and has had regular dealer servicing. What's going on with it? Otherwise it runs fine
Video: [URL] .....
View 6 Replies
After installing my FK Streetline X Coilovers I noticed my rear driver side was sitting lower and and the wheel had more camber.
View 3 Replies
About 7 months ago my truck started cranking longer than normal to start after sitting for more than 2 hours. This went on for about 3 weeks, then it started normally again. (By longer crank time, i timed it between 5-7 seconds on average. Normal is about 2 seconds). Now it has started doing this again about 4 weeks ago. Now I'm thinking HPO slow leak. Yesterday all is good again. What should I be looking for as a starting point to fix this permanently? When it cranks longer, the icp stays at 0, the ipr goes to 77%. Then it just fires off. No slow build of pressure. You can see all my mods and updated parts in my sig. I wonder if one of the new dummy plug o-rings is starting to give up already after only 15k miles. (Batt voltage is at 13.9-14.2, ficm is at 49.5 steady).
View 5 Replies
I have a 2002 celica after sitting for a hour or so car has very long crank....
View 1 Replies
I have a 1997 Explorer Sport 4.0 SOHC, 110,000 miles. When I start it in the morning or after sitting for a few hours, the idle is very rough. Most of the time it wont even stay running. My first thought was a vacuum leak. I found four leaks and repaired them, including the EGR valve control and the EGR solenoid. One stem on each was broken off. I bought these parts from the dealer and then tested the vacuum, which I now have vacuum pressure. The check engine light is on and doesnt read the "system evap emission control pressure sensor low" (vacuum leak) anymore, but it now reads "system too lean (bank 1) and system too lean (bank 2). I cleaned the IAC valve and have ran several bottles of injector cleaner through. My mechanic thinks it is the IAC, but when you disconnect the plug on it, the car will barely idle, so it must be working at least a little. I have seen suggestions for a fuel filter, which I am going to replace, but I am really lost here.
View 14 Replies
I hear a squeaking noise when I start my car. It is mostly in the mornings. Sometimes other parts of the day also. I believe it is on cold start because I usually hear it when the car has been sitting for a few hours.
My first thought was that it may be the belt so I popped the hood and looked at it. The belt seemed nice and tight and there were no cracks or extensive wear on it.
Second thought was brakes. My front brake pads are good but rear brake pads are close to needing replacement. Sometimes when I brake I hear the squeaking noise but it is hard to tell because at time it feels like it is coming from other cars.
Could the brakes be the cause of this sound? Even though it is at start up and not constant.
Car is 2007 Sonata with 100k+ miles on it.
View 3 Replies
My 1995 Buick Lesabre will intermittently drain the battery after sitting for about 12 hours. It is unpredictable. The battery was newly installed in December, 2010 and the alternator was tested at that time and about three weeks ago and proved to be recharging properly. This battery kill happens even when there is no visible sign of current usage, such as a dome light being left on. What I should look for in order to to find the source of the current drain?
View 2 Replies
I have a 2007 3.3L Sonata.
The car has been sitting for around 8 hours. Wh en I start it, the idle moves up and down about 100rmps. When I drive off there is a slight hesitation until I have driven for about 10-15 minutes. The idle is nice and steady after the too.
If I use a fuel system cleaner, it appears the car is fine for awhile and then the issue comes back.
View 4 Replies
I have a 2005 Passat Wagon, V6, 2.8L. I purchased this car used about a year and a half ago with 10,000 mi. It now has 32,000. I have done all scheduled maintenance. About 8 mo ago I started noticing a problem when starting the car. It seems to take a while for it to "turn-over" while starting it up. We've taken it to two different VW dealerships to try and solve the problem. About 4 mo ago, one of the dealerships replaced the ignition coil. They were able to read a memory chip of some sort to identify the problem I was having. Since this repair however, the problem has begun again. There is no consistency. Hot or cold temp. After sitting several hours or only a few minutes. The problem happens about one out of every five starts.
View 7 Replies
From the first day i bought this car i had a strange noise coming under the hood. Every time i leave my car for at least 2 hours parked and then started, when i do a few meters i hear a noise like a hydraulic valve comes in place and my brake pedal does a small movement. After that everything is normal.
View 2 Replies
I have a 1998 Toyota Camry , whenever I start it after its been sitting for 3 or more hours the rpm's shoot up to2,000 and stay there for 3-4 minutes straight, if I hit the gas they don't go down, if I turn my heat on they come down a little bit.
View 3 Replies
2005 Ex with 6.0. It has been bulletproofed. But has had a long crank after sitting for over 5 hours. I was starting to think glowplugs but no codes, Then thinking FICM, nope voltage has always been good. After I run the truck for a few miles if I kill it. It would crank right up. No issues. Only happened after it sat for awhile. I knew it had to do with HPOP system since it took about 5 to 8 seconds to show over 500PSI.
The passenger side does not have a leak since the oil is to the top of ICP sensor. When I was going to remove it. So I took off the drivers side. I inspected the dummy plug. No issues there "they are the 12mm with teflon plugs" I inspected the stand pipe. No issues there either. I inspected the small test port on the top of the rail. No issues there either. So I decided to air test it. So I used my auto-ingenuity to close the IPR valve after I heard all the oil blow out.
Then after sitting with 120 psi of air for about 10 minutes. I hear a bubbling sound coming from the Drivers side Rail. It was a plug I have never seen mentioned here. It is at the back of the rail. I removed it and sure enough the oring is split in 2. I went to ford and picked up a new Oring it was like $4. It also looks like its a different material. I am still in the process of putting the truck back together so i have not started it back up. But I am pretty sure this was my problem.
View 9 Replies
I have a 1983 Nissan Sentra with a Hitachi carburetor. The fuel in the float bowl seems to drain completely after sitting for 48 hrs. Is this normal? If not, what is the solution to preventing this fuel loss?
View 7 Replies
I had to drop my fuel tank and as a result, I replaced the fuel lines from the underbed filter to the tank. After replacing everything, I purged, purged, and purged some more. With much difficulty I was able to get the truck running and it ran good. But, I have trouble restarting the truck anytime I let it sit for a couple of hours. It cranks and cranks and eventually fires, but with much difficulty.
View 12 Replies
My car wont start I have replaced the coilpacks, ecu relay, and had the immo defeated. Here is the vag log [URL] .....
View 2 Replies
I get EPC and ASR upon cold start from time to time. Usually EPC goes away if I restart in a couple of minutes. ASR goes away after a while and restart.
So after car warms up and restarted, everything seems fine.
View 2 Replies
The car is a 2004.5 GLI 1.8t. My car threw a CEL about two weeks ago. When i ran the codes it had one for the camshaft position sensor, one for the secondary air injection, and one for the camshaft position sensor. I cleared all the codes and the light came back on. The only code that came back was the camshaft position sensor P0340 i believe. I drove the car for a week and out of nowhere it just shut off on me while driving.
All the lights on my dashboard were flashing (traction control, battery light, engine light, etc.) I tried to jump it just to see if it would turn over and still nothing. I rolled it down a small hill and tryed to pop start it...still nothing. So I had it towed to my house and I replaced the cam position sensor AND the crankshaft position just to be safe. but now the car still won't start...
The engine is cranking and you can hear the pistons moving but it just can't get the juice to start. After failing to start it 3 times, i noticed a loud vacuum like noise coming from the engine when i turned the key off...but my car would do that every other morning when it actually started and didn't have the CEL, and then once it warmed up the sound would go away.
View 1 Replies
So my 20th randomly won't start. It's happens about once a week or so. Most of the time when it happens the car cranks but doesn't start. Every once in awhile when I turn the key nothing happens at all and I have to keep trying and it'll crank and turn on. I also have no way to check for codes
View 6 Replies
