I get a wobble only when on the brakes when I am decelerating at about 40 mph. I have brand new tires on, 1000 miles maybe, with I think a good balance Started happening a couple hundred miles ago... What do you think? Warped rotors? bent axel? It's definitely coming from the front.
View 5 RepliesI started noticing the noise about a week ago, When i seem to let of the gas or even once in a wail push on the gas Hear a "CLICK" noise, this is not when pressing the brakes at all only when letting off pedal?
I am thinking it could be transmission, but have read it could be a few thing, From the brake pads to CV joint to trow out bearing, Axles, Lightened flywheel, Motor mounts, etc. But i am unsure where to start, Its and O2M 6spd tranny in my 20th, with lsd installed, lightened flywheel, VFmotormounts...
To say the least, I had a long winter. First I bent two of my RC's with potholes and blasted my power steering rack with some more potholes. So now I have brand new set of rims, a new steering rack and also when i did the steering rack, i threw some new ball joints on. I am still experiencing a "shimmy" in the steering wheel at higher speeds. What would be the next logical step to check out what could be causing this? Maybe control arm bushings?
View 20 RepliesHad my trans worked on, it was out of the car completely. After picking it up, I got it on the highway, got it up to cruising speed, now there's a wobble at 70-80 mph. it wasn't there before I took it in. should I be getting a front end alignment now? waiting to hear back from the shop now.
View 2 RepliesRecently purchased an '05 GLI (my second mk4) and it has the stock RCs and Eagle F1 tires. They are good on tread, wear pattern, and pressure, but seem to be making an awful lot of road noise, especially at lower speeds and decelerating to around 20 mph. as I read in one post "it sounds like a semi-truck". When I test drove the car it was still in winter mode and there were no noises or pull and so I do not suspect any mechanical issues.
It does not result in any real vibration that you can see in the wheel, but you feel the buzzing. the steering is straight and true as well with no pulling left or right. IT'S JUST LOUD!! lifted the front end and shook the front wheels. the bearings seem nice and tight with no wiggle. I was going to remove the tires and rotate, or put on the spare to see for a diff, but the BBS tool for the center caps is a POS and I couldn't get them off. So ultimately I'm looking for some vortex advice on this noise, its causes, remedies, and and anything else I should be looking for.
Ok my 2002 337 has 87,600 miles on it and for quite a while now its been making a lot of font end noise, its most noticeable at 25-30 MPH, decelerating or holding a steady speed, it disappears when your accelerating hard, and at high speeds. But the noise is horrible, its like a buffeting
Its been serviced regularly, since the noise I've done, new front brake rotors, new pads, wheel bearings, inner and outer CV boots replaced, CV joint checked. My local mechanic who's done a lot of work for me isn't sure what to think, he said try rotating the tires because it may be tire noice on the road? Im running some generic tires, the brand on the tire says "sunny" but they appear to be a good performance tire, and handle well
I want a 20th AE & have seen pics that say ESP on a button next to the hazard & others say ASR. I know that their was one option for the car: ESP. So what's ASR? Is one better than the other? Is it the same? I've heard that the ESP sucks for autocross. Is this true?
View 8 RepliesI was driving at about 60mph in 4th gear and knocked it into 2nd and the rpm's hit the max and the car shut off and I have not been able to get it started. I have compression, fuel, and spark . I've checked oil and don't have any coolant in and nor did I have any oil in my coolant. When I try to start it it try's to start but won't turn over so .
View 12 RepliesDriving home from work, I was about 5 minutes from home, got to a light only to not be able to go into 1st. I popped it into 2nd and drove home like that pretty much. Car will let me get into reverse and all other gears.
I can put the shifter towards first but it doesn't fully go in and when I gave it gas it would let me start to creep and then grind a little and pop out.
Heres a pic for your click .....
I was searching but I can't find any DYI's on turning your Daytime Running Lights off on our cars. I don't feel like buying a euro switch right now. How to do this or has done this to their vw's?
View 24 RepliesI was following the directions on the APR site to remove the ECU and it seems to not make sense. Saying the ECU is on the passenger side underneath the molding....
is the ECU in the center?
I've had the leak for a long time now possibly from when I've gotten it... anyway when I first bought it I drove it a lot, like 8k miles in 6 months. During that time I went through a qt of oil about every week and a half. Now the last 3 months I've been barely driving it due to life changes so I'm barely putting oil in I'll go weeks sometimes of checking the level and it'll be fine. This leak has to relate with how often its driven and maybe hot?
I've had the car up multiple times to try and find the spot all I know is it's behind the engine below the valve cover gasket and above or near the turbo area(I've only owned my first VW this 20th for less then a yr so I'm still learning)
I get up to go to work today and the car runs fine, a few hours later i get back in, try to put it in reverse, and nothing.. it wont let me shift in after i push it down. So i push it back in neutral and drive away.. every gear works fine, when i got home i took off the boot, tried to see if anything was loose, shake it a few times and out of nowhere first and second give. They were working perfectly 5 min before, and now they just feel really loose, but every other gear works fine, so now I have no reverse, 1st or 2nd. Did I just knock something out of alignment or is the problem a lot worse.
View 3 RepliesI recently took out my headliner And my passenger's side seat. When I put everything back together, I turned the car on and the light came on. What can be the issue?
View 10 RepliesAfter I got gas yesterday I drove about 10miles and the CEL light came on. The gas cap seemed a little loose so I am assuming it is that until I get it scanned soon. I was just wondering how long is stayed on if it wasn't cleared, I know some cars take a few days.
Does euroswitch installed have a problem with the audible headlights-are-still-on tone? If I leave my lights on, and exit the car no sound will sound. If I open it back up, then it will make a sound. Pretty useless.
Also, still looking on the best length for the Thule wind fairing for stock votex racks?
So I just changed the valve cover fast but I am still getting oil onto the hood of my car. It did this before I changed the gasket as well. Is my valve cover bent maybe?
View 7 RepliesOk first lemme start I have a 20th with 76,000 miles chipped. I was driving down my street and the car julted a little, didn't think it was much, kept driving the check engine light turned on and the engine sounded like it was hesitating and I lost alot of power. Also it sounds like a Subaru. I haven't yet changed my coils so I'm thinking that's what it is.
View 3 Repliesso my check engine light came on recently and i took my car to a local shop to get it checked out and they told me one of my o2 sensors might be bad and that i should replace it. but because the catalytic converter that i have installed is an aftermarket one(installed before i bought the car used), they told me they were unable to remove the sensor attached because it was welded(?) on or something to that effect and they didnt have the tools to fix it.
so i did some research and found a better shop that deals with catalytic converters and exhaust systems and im thinking of taking my car there to see what they can do BUT, i was just researching online and ive found other posts saying that it may not even be a bad o2 sensor, it could be a different problem but the its just the bad o2 sensor code that comes up and now i dont know what to do.
just wanted to see what everyones opinion is on this subject or if they have gone through this before!
I am trying to put a exhaust cut out on my car, I am trying to put it right before the cat. Looking for pics?
View 15 RepliesI have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.
View 3 RepliesWhenever I go over about 50 MPH it starts shaking like the dickens. We have a lot of snow around so I'm thinking i just have messed up alignment from hitting snow chunks but who knows. [URL] ....
View 6 Replies