GTI 337/20th Anniversary :: Transmission Malfunction - 1st And 2nd Gear Are Gone
Jul 23, 2009
Well, driving down the road just like any other day. I go from 1st to 2nd gear. It feels like I missed a shift, no big deal decide to put it in 3rd. Missed 3rd gear...... weird, no big deal through it in 4th and was on my way. Got to a red light, no 1st or 2nd gear. Where 1st and 2nd gear are, it feels like there is nothing there when i tried to shift into gear. If I go into 3rd gear its now 1st gear, 4th gear is 2nd gear.Had a mechanic look at my car, and the linkage and clutch are fine. He feels that something minor broke inside the transmission.
A) What do you think might be broken?
B) How could this happen?
Driving my car like a baby, I am never hard on my clutch. No pre-warning, no bad sounds, and I have never had an issue with my transmission before. I am hoping I do not have to pull my transmission out but it looks like I may not have a choice...
View 19 Replies
Advertisement
One day i was driving my pedal went flat to the floor ,then i noticed my brake fluid was low so then i tried adding more fluid and bleeding it n pumping the clutch i got pressure back, but now i hear chatter in the tranny and it wasn't doing that till after I bleed it. It will go into gear with the car off but as soon as the car starts in wont at all.
View 12 Replies
Alright so basically i lost 1 and 2nd gear and i want to replace the transmission since this one already has 150k on it. The hard part is finding a used one because of the six speed! What models can i swap transmissions from? Like i heard i could use a 2003 Audi TT six speed transmission! What I can use to swap out my transmission or do i have to just look for a used one specifically for a 20th?
View 20 Replies
I have a 20th anniversary it grinds going into 3rd gear every time...
View 9 Replies
My clutch was done about a year ago and the car now has a sort of "chattering" sound while the car is out of gear. Once you press the clutch down though the sound goes away. Is this just a by product of being converted from a Dual Mass Flywheel to a single, or is this a bearing issue or something otherwise that can be resolved?
View 4 Replies
When I am going into or downshifting to second gear in my GLI it makes a thud sound after I let out the clutch. It doesn't always happen and it does it if I just throw it down and if I don't have a perfect rev match. It just started a few days ago.
View 11 Replies
My 337 transmission is acting a bit weird lately. Sometimes when I shift the gear from neutral into the first gear too quickly when the car is stationary (with the clutch fully pressed), the gear or the transmission makes a distinguish sound. I don't know how to describe this sound. It sounds like gears knocking each other in order for it to engage or set in place. It sounds different from shifting gear without fully pressing down the clutch. When I took the car to the mechanic, he test drove the car around the block but didn't hear anything strange. So he told me to wait till this problem becomes worse and happens more frequently.
View 2 Replies
The other day my transmission was driving fine, until I stopped to let someone out. When I tried to throw it back into gear, it wouldn't engage at all, just had a slight grind almost like the sound of a chain coming off a bike (so I pushed back in the clutch and parked it). I haven't been having any issues with it nor have I been driving it hard.
View 2 Replies
So the motor has a new oil pump and pickup and was all cleaned out. Sludge is not the issue here. I'm running the royal purple filter ( the equivalent of mann 950/4) and royal purple 5w30. My heart dropped after the light came on on the first drive. I pulled out over and checked the oil and for leaks and... full with no leak. So I checked the temp and proceeded to drive home. I don't have an oil pressure gauge but I'm getting the bottom of the fill cap with oil so I know it's making it all the way to the top of the motor, and the motor is not loud or sounding starved.
Basically, I wanted a second opinion that it is most likely oil pressure sensor malfunction. Garrett 60 trim, feed and return lines are brand new and sufficient diameter.
View 4 Replies
I have a 377 gti 2002 and just the other day i had some hesitation on take off. it sounded like the engine was cutting the fuel, at the time i had an o2 sensor code so i replaced the o2 and got new spark plugs while i was at it. it was still hesitating and cutting out so i figured it might be the maf because ive already replaced it once, i cleaned it and still doing the same things. i called my local vw/audi shop (audub) and he said it might be the pcv valve. i checked to see if there was air sucking in through the oil dip stick and the oil cap. its running just fine at idle and it seems that in first and second gear that its hesitating at 1000-2000 rpm and the higher gears are fine. could a leak cause this or is the pcv system bad?
View 7 Replies
I've been having trouble with my rear wiper since forever. Every time i try to use the washer fluid for the rear, it doesn't squirt right and fills up the motorized lock for the trunk and malfunctions the lock for a day or 2 until it drys. I had this same problem with my old 1.8t gti, just in that case i had to have the whole lock replaced due to the damage from the washer fluid (luckily the dealer payed for it).
I was thinking maybe swapping it out for the polo rear wiper on ecs tuning.
View 1 Replies
So basically a couple months ago I picked up a 03 20th and GTI, I love the thing to pieces, recently I've got into drive it and I can watch my temp gauge steadily climb to 90 and stop. (before I go any further, I haven't gotten any overheat warnings or anything like that, I've just noticed my car is really hot all the time and the temp gauge goes to 90 within a minute or so of driving but doesn't go over). heat works fine, I've gone in the engine and tested a few things, tested the fans by jumping the connections, my large fan is dead but the small works fine. to my understanding, the large fan isn't used much unless it's really hot anyway. so I removed it and continued trying to find my problem, I felt the rad after letting the car run for a bit, the top half was hot but the bottom half was cool, took the hoses off and flushed my rad thinking maybe something was clogging it, water ran through fine, so I put it back together, put new coolant and tried again. same thing. so I took it for a rip and came back, obviously, the top hose and the rad were hot, but the bottom one was kinda warm. I looked for answers online but I can't seem to find anything like what I'm dealing with. the water pump seems to be working fine, I'm not sure how much flow is supposed to be coming through the Small hose at the top of the reservoir, But I checked it and it has a steady stream coming out of it. I've worked all the air out of the lines as well. The car isn't overheating and doesn't really pass the 90 mark, fans almost never come on but the small one kicks into low when I turn the AC on. which as far as I'm aware is what's supposed to happen.
The car feels like its running hot, checked everything I can think of. rad is hot on the top half and cools at the bottom, coolant has a steady flow back to the reservoir. no actual overheat warnings, I'm just wondering if these cars run hot normally or if I should be concerned.
View 1 Replies
I am currently putting the interior of my car back together after a water issue force me to remove everything and have just put the carpet in. While stopping for the night, I noticed that all the overhead lighting doesn't work, the key fob can't lock the car, I can't open the trunk via the button on the door and even if I close all my doors, the car door open light stays on. However, the dash, vents, radio, gauges and headlights work, the car starts, the headlights and tail lights work, and the gas door button works. The ONLY thing I did was remove a #53 block relay that was wired into the rear fogs, since the way the fogs were wired up, they weren't working.
So I removed the relay and wired the fogs directly to the headlight switch. The wiring of the relay was, one wire going to the #9 pin on the headlight switch, one wire going to the 12V source and the last one going to a ground, nothing else. I didn't touch any other wiring or pull any wiring out. What my car is doing now? I was hoping to have it together to go to MIVE's chilifest tomorrow, but this electrical issue makes me uneasy about driving my car over an hour from home without a trusty tow vehicle to rescue me if it goes south.
View 1 Replies
The car is a 2005.5 GLI (75k mi) w/ EvoTech Stg1 software, GHL stack intake, and an Iridium billet diverter valve.
Well today I was driving and the Malfunction Indicator Light on the dash came on and started blinking. When I stepped on the accelerator, the car felt like it had 1/4 the power and began shaking. The car idles kind of weakly, and feels like it has no power when you step on the gas. Also, when you step on the gas the car will shake. The strength of the shaking depends on how hard I press on the throttle, more throttle = more shaking. There is no shaking when it idles or when I have it cruising, only when accelerating.
View 7 Replies
Bought a 04 GLI had the bad engine, had the engine installed sat at the shop for nearly a year. Towed car to my house to finish it and now I am running into their lack of knowledge and fixing their crap. Now the current issue...On the thermostat housing, a nipple that comes off the side has nothing connected and leaking coolant.
View 7 Replies
Driving home from work, I was about 5 minutes from home, got to a light only to not be able to go into 1st. I popped it into 2nd and drove home like that pretty much. Car will let me get into reverse and all other gears.
I can put the shifter towards first but it doesn't fully go in and when I gave it gas it would let me start to creep and then grind a little and pop out.
Heres a pic for your click .....
View 24 Replies
I have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.
View 3 Replies
So I get in the car to move my car this morning and I can't get the car into 1st gear. It turns out I can't get the car into reverse, 1st gear, or even 3rd gear. It feels like something is blocking me from even approaching those gears, however the others (2,4,5,&6) seem to be fine.
View 14 Replies
I bought a rebuilt trans from a fellow vortex member a little over a month ago. I had it installed and ever since then when I am getting on it going from second to third it grinds a little bit going into third gear. It only does this when i get on it, but when im just cruising its fine. Could the shift linkage just need aligned? Or what else could it be?
View 5 Replies
As of two days ago my car ust refused to go into 1st gear. I know that it is a common occurrence with the 02j and shift fork, but 2nd works perfectly, so how could it be that shift fork?
View 16 Replies
So I've been noticing that my GLi is tough to put into first gear sometimes. I feel almost like I have to jam it in place and hold it there, it doesn't just click in. Could this be the shifter cable ends or the cables themselves? Its weird... its only ever been a problem for 1st gear though.
View 15 Replies
