GTI 337/20th Anniversary :: Sensor Light Came On For Brake Pads
Oct 30, 2008
I have an '05 GLI @ 45,000/mi. The sensor light came on for my brake pads about a week ago. So obviously I need new brake pads (front & rear? not sure...I know the sensor is only for the front). But I was also wondering if I need to replace the rotors.
I understand there is a measurement for the OEM rotors to tell when they need to be replaced. There is a little lip on the them, more so on the front than back. And they feel slightly grooved.
View 17 Replies
Advertisement
So a few days ago the warning light that my break pads are getting low came on. My friend needs a ride this weekend that would bring the round trip to about 300 miles. How soon are my break pads on my 20th going to be shot? I don't know if this is an early warning to let you plan to get break pads in the near future, or if it's the same thing as seeing the gas light(Oh crap, gotta head to the gas station and fix this NOW).
View 7 Replies
My brake pad sensor light came on today. How long do I have until they start to ruin the rotors?
View 4 Replies
Having trouble with front brake pads rattling? About a month ago, I replaced pads - rotors - caliper pins on my 20th GLI. I know these cars ride a bit stiff but it sounds like my front end is about to fall off. All brake parts were torqued to spec - I've gone through all T25/T30 torx front end screws etc and I just can't find the rattle??? This has only started within the last few days. Any other places to check for obvious loose bolts etc?
View 15 Replies
I went to my dealer to tell them that I had the sensor light showing "check brake pads" after the normal service at 75000km I left the dealer and the same problem showed.
I returned and was told everything was fine with the pads but to fix the sensors was "not worth it".
A few days later the screen showed I had a flat tire and after trying everything it would not go away after resets etc etc..
View 2 Replies
So the motor has a new oil pump and pickup and was all cleaned out. Sludge is not the issue here. I'm running the royal purple filter ( the equivalent of mann 950/4) and royal purple 5w30. My heart dropped after the light came on on the first drive. I pulled out over and checked the oil and for leaks and... full with no leak. So I checked the temp and proceeded to drive home. I don't have an oil pressure gauge but I'm getting the bottom of the fill cap with oil so I know it's making it all the way to the top of the motor, and the motor is not loud or sounding starved.
Basically, I wanted a second opinion that it is most likely oil pressure sensor malfunction. Garrett 60 trim, feed and return lines are brand new and sufficient diameter.
View 4 Replies
If you don't have a high flow cat on, will it throw ur check engine light on, saying its the rear 02 sensor....
View 14 Replies
When I bought my 2003 20th it was completely stock, except for a pos blow off valve had been installed, and get this, the diverter valve was left on, and just capped off. I installed a no name CAI, and the check engine light came on, i had it turned off and when i start the car, or rev the engine high at all, triggers again.
View 4 Replies
I have a light flickering on and off that claims the door is open, after a few months and a lot of testing I have come to the assumption that the sensor in my trunk hatch is sending a relay to the computer as if the door is open.... I can't find a latch sensor or relay for this thing, just the striker plate and the wiring that unlocks the switch as well as the wiring for the rear wiper blade....
View 3 Replies
When I am driving around, my brake light will appear flashing for several seconds then it goes off. What is that about?
View 8 Replies
After a full complete stop or slow down to almost complete stop upon acceleration from that stop or slow down my dash brake light blinks and yells at me for the standard amount of time then goes away. It only does it upon acceleration its weird its almost instantaneous with me pressing the gas pedal. No squealing noise or anything else is coming from the rotors and everything feels normal its just starting to get annoying as hell.
About 6 months ago I replaced my pads and rotors with the drilled and slotted kit performance-cafe offers and had it professionally installed because, I'm lazy and it would have take me years to do it. This problem only started recently so I'm pretty sure its something else or something went bad. What I should check or have specifically looked at if I take it in?
View 7 Replies
What makes the brake light on the dash blink and beep after every stop? I've checked my e brake and made sure it was off so I know that cant be the issue
View 2 Replies
so my check engine light came on recently and i took my car to a local shop to get it checked out and they told me one of my o2 sensors might be bad and that i should replace it. but because the catalytic converter that i have installed is an aftermarket one(installed before i bought the car used), they told me they were unable to remove the sensor attached because it was welded(?) on or something to that effect and they didnt have the tools to fix it.
so i did some research and found a better shop that deals with catalytic converters and exhaust systems and im thinking of taking my car there to see what they can do BUT, i was just researching online and ive found other posts saying that it may not even be a bad o2 sensor, it could be a different problem but the its just the bad o2 sensor code that comes up and now i dont know what to do.
just wanted to see what everyones opinion is on this subject or if they have gone through this before!
View 2 Replies
Got a code for knock sensor bank one however this is the wiring going to it. Could it be throwing the code simply because the wire is cut or do i need a new sensor maybe too?
View 11 Replies
I install sports MFA cluster on my GTi 1.8t. Now I need to install out temp sensor.I know it's mounted somewhere on the driver side behind air duct.I just need the picture to see how exactly this sensor is mounted. My new (used) euro bora sports cluster. I temporally install the sensor.
View 12 Replies
I have an 04 GLI and keeps throwing a code for the 02 sensor, and after putting the car on the lift, and disconnecting the 02 sensor harness, a fine oil leaks out at the end of the connector and smells and looks like power steering fluid.
View 9 Replies
I have been having problems with my car for a few weeks now and someone told me my car could be jumping time. if it is jumping time wouldnt it still be jumping when i remove the maf sensor?
View 2 Replies
just found my cranksensor was dead.. on the highway today.. sooo!.. can som1 tell me where is that sensor exactly so i can change it today.
View 1 Replies
Where it's located i heard passenger side behind front bumper. i just looked for about 30 min can't locate it. Reason being is when i check the outdoor temp i get ---F so either it fell off or it's bad lol if someone can post a quick pic ....
View 8 Replies
So I have a bad map sensor and lately my turbos been going in and out of limp mode. I recently just replaced with a new n75 valve and it solved the problem for about a week and now it's acting up again. Its not a constant problem it occurs usually every 20 starts. Could the map sensor be the reason why my car is going into limp mode?
View 4 Replies
The CEL just came on in my 20th AE Gti. The code indicates a Camshaft Position Sensor issue. Don't know where this sensor lives under the hood of the GTI? Is an easy enough fix for a beginner to attempt? (have hand tools, former bike mechanic, but no shop just a parking lot in the Texas sun!)
View 6 Replies
