GTI 337/20th Anniversary :: Radio, Low Beams, Rear Defrost Button, Turn Signals Suddenly Stopped Working
Nov 3, 2013
2005 Jetta Gli 1.8t. It decided to do some funky things on me today. I has been running perfectly fine up until I went out for dinner.
When I came back to start her up. Everything worked except for: Radio, Low Beams (both) Fogs, windshield wipers/fluid, rear defrost button, turn signals (but hazards worked fine) and the fan for my heater.
What was working, oddly enough are the amber lights, tails and brake lights, all other lights including the high beam, but ONLY in the position when the stalk is pulled toward the driver. (Have to hold it to keep the high beams on).
It's not the battery because my car wouldn't have started at all if that was the case. It's not the alternator because I disconnected my battery and the car ran just fine and never died. I checked all the fuses of the things that went out but nothing seemed out of the ordinary and all of them seemed just fine.
Where to look next or what to do. I have no check engine lights, or any lights for that matter so I have nothing to scan.
View 9 Replies
Advertisement
My buddys mk4 GLi headlights and signals just stopped working if he holds the stalk in position the brights will come on but that's it. The car is a 2005 GLi with a euro switch, Were going to replace the switch in a little bit, as of now all fuses seem fine.
View 10 Replies
I started my car yesterday and noticed the headlights, A/C, defroster, turn signals were all not working. I checked the fuses and they're all fine. Checked other posts and it looks like the common denominator is the ignition switch. (Looking for pics) how to change out the ignition switch? And what is the level of difficulty?
View 1 Replies
I own a 1999 F350 CC SRW w/ 7.3L PSD engine. My turn signals stopped working suddenly. I've checked the fuse panel under the dash but it doesn't show any fuse for the turn signals.
My hazards do work although I noticed something very strange. When I tilt the steering column down the hazards stop working and when I tilt the column all the way up they work again. Still no turn signals though.
View 1 Replies
I have a BMP 20th and I notice that I cannot turn on my high beams but I can flash them. What the problem could be? I was planning on installing my OEM HIDs tonight but now I am wanting to get this fixed before I put them in.
View 2 Replies
So I pullled into a reststop to relieve myself and when I drove off none of my lamps (high,low,or fog) worked. Along with them my blower fan does not work nor the rear defoggers, wipers, spray with wipers, turn signal (hazards do work though). Is there a fuse or relay that connects them together?
View 2 Replies
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 Replies
The turn signals and high beams do not work on my 1998 ford ranger xlt 4x4. I have replaced the multi function switch, the yellow flasher relay checked all fusses and all are good. What could be the problem?
View 7 Replies
Checked bulbs and fuses: not blown.... Is there a recall?
View 3 Replies
Recently my tail lights went out and my turn signals dont work either, the light for the turn signal on the dash doesn't light up either. My brake lights do work tho and so do my reverse lights.
View 3 Replies
My headlights flicker everytime I hit the turn signals and bring my windows down, what might be causing this?
View 1 Replies
I know this may sound trivial but I use this all the time. Saturday morning was listening to a podcast on my phone, 30 minutes later the button stopped working. The car is 18 months old.
View 4 Replies
X2 nights ago at 11:45pm I was driving home from a friends house with my gf and were going about 65 on the highway and it's lightly raining, then all of a sudden my headlights, windsheld wipers, turnsignals, my ac/fans all just shut off so I had to pull over right away. After sitting there for about 15 mintues I figure out my high beams still work but only if I hold them on(clicking it on doesn't work. So I drive home and the next day check all the fuses in the drivers door and they r all fine. Everything else works in the car but the stuff stated above. My car was reposesd about a year ago when I lost my job and they put this thing I have to enter a code every month, it messed my windsheld wipers and turn signals up before but not anything else! But it still works and the other stuff doesn't, and behind the dash it sounded like crackling and smelt like burning electric right before it shut off.
View 6 Replies
I have a 2007 3.6 wagon. Tonight, I opened the tailgate with the remote and when I pushed the button on the gate to close it, nothing happened. The close button has suddenly stopped working. I called the dealer and he told me to push it down by hand. That's fine for now, but I want the button working.
There isn't something I did wrong to get the button to refuse to close the door is there? I am assuming the button is broken and needs to be replaced, unless someone tells me that this is a common problem and there is an easy fix.
View 7 Replies
So I get to explore my first repair with this new to me car. Yesterday morning, turn signals works fine. That afternoon, the stalk apparently stopped working, which I have heard of. Interestingly though:
-the brights and cruise work
-the hazards work (my improvised indication that I'm turning )
-the stalk had been replaced once before by the PO.
Did this thing eat another stalk, or are there some other things I should check first?
View 4 Replies
My brother in law is on a road trip and his radio suddenly stopped working. The radio panel displayed "No Radio." He stopped for gas, turned the car off and the radio was working again when he restarted the car. Is this normal or could he have a more serious electrical or computer problem
View 3 Replies
Yesterday (3/28/12) my Radio Data System (RDS) feed suddenly stopped working on one of the radio stations I listen to on my car radio. Until it stopped, it identified the title and artist of the song I was listening to as well as the station. It still worked on other radio stations, and it worked on other radio stations this morning (3/29/12). Then the RDS feed suddenly stopped working on every station, and now no RDS information appears on my car radio screen at all. What could have possibly happened?
View 7 Replies
I used the volt meter wrong while testing my turn signal bulbs for power and not they do not work (or hazard lights).
View 3 Replies
I own a 2004 hyundai santa fe and just recently my turn signals have stopped working. My bulbs are fine because they still light up when I lock my car and my hazards work too. The flashing arrows on my dashboard wont show up for my turn signals but they will show up for hazards. I checked the fuse and its completely fine. I am so confused with what is wrong. The only thing I was doing before was messing with my new head unit which involved unplugging a lot of the stereo and fog lights and hazards but that all should have no affect on my turn signals.
View 6 Replies
The issue I am now experiencing is my passenger headlight would only turn on once in a while . The driver side headlight would work just fine both high beam light also . Today I opened my hood I verified the cable had a poor ground to the headlight I noticed a burnt smell after checking the cables . I turned on my high beams both sides turn on . Then out of no where my turn signals both (Left - right - back and front stopped working. Including the Hazard lights both front and back). The cluster would not show neither turn signals turning on ( left-right ) I noticed that my headlight turn signal on the passenger side would turn on but not blink it would stay dim only when . I pushed the hazard light button . My cluster would show the right turn signal ( no clicking no flashing arrow ). The driver side would not work either. What can I do to fix the problem? I know that I will not be able to drive the car due to the issue.
View 5 Replies
All of a sudden my radio and clock stopped working, k-checked fuses 20A, seem fine- two days later, the door chimes stopped working, and then the lights are one-chimes stopped, then the key in the ignition, and when the door is ajar, stopped dinging---is this a computer malfunction or sensor-WHICH ONE? 1997 toyota corolla........
View 2 Replies