I just noticed recently, that while accelerating, the needle on my boost gauge never really holds. It flutters back and forth between psi throughout the acceleration, rather than holding. This also occurs while I am idle and have the A/C on, the needle flutters back and forth. I have the stage I set-up Revo software which I have had for a while.
View 5 RepliesOk I was driving home right know from work, and looking at the speedometer, i notice that my temperature gauge turns off (the needle goes all the way down). what can it be?
View 2 RepliesI finally got my 20th to run right. But now and ever since I bought it the gas needle keeps going down and back to normal every time i make a sudden move or go through a bump. What could be causing it?
View 5 RepliesI'm not sure what to make of this ... I disconnected the battery before installing . The gauge seems to be reading correct based on what i researched. If there was a slight leak would it throw the CEL ? is it maybe just a one time thing that needs to be cleared afterwards ? Car drives fine and I plan on trying to stop at autozone to get there crapo freebie scan . Kinda annoyed considering everything went smoothly up until I drove the car more then 50 miles .
View 14 RepliesCar now has about 67,000 miles on it. I drove it from the bay to Lake Tahoe 2 weeks ago, which is when I first noticed the light. I tried to go to a couple of autozone's to get the code read but none of them would do it. I also noticed that now on my boost gauge that i am only reading 4-5psi under load, so its not quite feeling like i'm getting as much power as before. What a common issue is at about this many miles on a 1.8t car? (GLI)
View 3 RepliesI've had this problem a while but now i want to get around to fixing it.. my boost gauge is always at 0 now and sometimes when i drive the car it starts working but it starts like sticking... like when i didn't have my chip it would go up and down really fast between 10 - 15psi... i heard from a friend that you can take it apart and re-adjust some screws or something so it works like a charm... right now its just like frozen at 0 psi when i drive it doesnt go down or up.
View 4 RepliesOkay I just installed a boost gauge in my car and when I cranked it up it said airbag fault and the airbag light is on now.. What it could be?
View 13 RepliesI have a strange problem, my boost guage needle is jumping like crazy, there is no vacuum leak and the max boost i get is 0.5 bar, when the guage needle is not jumping I get a boost of 1.4 bar. I have mechanical boost control.
97' passat B5 1.8T AEB with FMIC,K04-15,2.75",chip (that was made for the original k03).
So driving over the pass last weekend, I noticed as I reached about 15 psi on my boost gauge the needle started to stumble/flicker and I could audibly hear a "pffsssfftst" at that same time, back down away from 15lbs boost and the noise goes away? I am leaning towards a boost leak, it sounded like it was coming from the driver side anyways. I hate to just assume it is something, and mindlessly throw parts at it, on the other hand I know that is one way to start replacing old worn out parts.... So I am thinking start at ordering some new CAC boots from riffraff, anything else I could consider? Could be a worn out spring on the wastgate?
View 14 RepliesCar is a 2012 GTI 6MT with APR intake.
Within the last couple of days, my engine temperature gauge has been acting a little strange. The needle will fluctuate depending on if I'm accelerating or at speed. I've actually seen it go down several times before going back up to normal temp. On a couple of days, it will go up to about halfway to normal temp, and just stay there for a lot longer than it usually seems to.
There have also been times when the car is at normal operating temp, I'll go into a store for maybe 15 minutes, and when I come out, it shows the engine temperature is maybe halfway to where it should be. Then it will go back to normal after a few minutes of driving. I would think that if the engine is warm, it should stay there for more than 15 minutes, even if the car isn't on.
We haven't had any abnormally cold days lately, and I'm not getting any CEL, but I was wondering if anything to worry about, or if it's normal.
I'm to the point of driving the car off a cliff! I've included a log of the car acting upt. The car is a 20th AE GTI AWP. It was chipped all it's life and ran like a champ. In November I installed a Frankenturbo F21T turbo kit, Bosch EV14 550cc injectors, 3" MAF, eBay FMIC, 3" catted exhaust, and a custom tune from Motoza. Dave at Motoza has updated the file 4 times and no matter what he changes, the car will boost up to the requested boost of 19psi and hold it for almost one second, then boost will drop to 12-15psi and then boost past the request to like 22-24 psi and go back and forth until the gear is over and I shift. Then it does the same thing in the next gear. i just want a solid 18-20psi without a manual boost controller! Things I have tried:
-Changed the N75J back to a NEW stock N75
-Replaced all the N75 vacuum lines
-Wastegate cracks at 7-8psi
-Replaced every worm feed clamp to a nice T-bolt clamp
-Boost leak tested to 18psi and found no leaks
-Deleted SAI, N249, and N112
-Unplugged MAF, nothing changed
LOG with multiple WOT pulls: [URL]...
I have a 20th 1.8t. It was running fine last week but all of the sudden i was only getting about 4-5 psi. I have check all over vwvortex for somewhat of an answer. I have no C.E.L.. I have checked for vacuum leaks with nothing coming up. I tried to check for boost leaks but it comes out of the dipstick hole. I have undone and re-installed the pancake pipe. The DV is holding pressure.
View 1 Replieswhen the traction control is off my boost hits 18psi and there have been times where it was 20 psi. My friend said i probably have stage 1 software .
View 4 RepliesStart with the basics, no CEL's, car has not cut out while driving and I've only had to attempt cranking up the car twice since I started noticing these issues about 6 months ago.
Symptoms: hesitation/variation in boost during acceleration- doesn't matter if I really get into the gas or just "normal" passing acceleration RPM's steadily climb, but just not as consistent or quickly. Also, the one that really has me really confused. With a 1/4 tank of gas or less, going up a slight incline (overpass); 70-mph-ish... acceleration dies off, rpm's slowly decline, and gas pedal doesn't respond for about 2-3 seconds. Car never shuts off, no CEL's, then everything is fine again! Even does it when I'm using cruise control. Car just rolled 110,000 miles
So I have a 20th AE with 113k Miles.
All of engine is stock, but when I FLOOR it from about 3rd-4th or sometimes 2nd-3rd the car will build up boost but release it without me letting go off pedal.
So, basically as I am driving the car sort of builds up, drops, builds up, drops without my doing anything but drive.
It will rev to about 3k stop for a second, rev to 4k stop for a split second, rev to 5k and so on... Not sure what this is or why it could be happening...
Having trouble with car going into limp mode or just not boosting at all. Tried some basic things to fix it, plugs, coilpacks, tune, none have work.
View 4 RepliesSo I just installed a boost gauge. Vacuum line is running off the fuel pressure regulator. My boost is now not going over 10 psi and the engine is cutting out. It kinda feels like the dv isn't holding psi but just always open. The car is a 05 gli with intake and exhaust.
Also the car seems to be running alright at below 2000 rpm and it just starts to cut out when it should be making boost. And I'm pretty sure this car is reprogrammed because yesterday when I finished the boost gauge install it was running at19 psi.
For some reason My car won't boost like it used to in the upper gears. 1st, 2nd and even 3rd I can still boost around 18 but once I go 4th, 5th, 6th my boost get lower and lower to the point the I get only 10psi in 6th gear. The car also seems slower a doesn't spool that fast like it used. i checked most of the hoses, even my intercooler pipes which were leaking before and everything is tight. Could it be my DV which is still stock or should I look someplace else?
View 13 RepliesWhen I hit the gas and my turbo reached high boost (15 psi and up), it would slightly sputter and make an odd sound. I even noticed my exhaust made a different exhaust note than usual. While it sputtered the CEL began flashing. I then drove it normally (not high boost) all the way home and it drove completely fine. I'm gonna try and get my codes checked tomorrow.
View 9 RepliesIf your diverter valve is bad, will it throw a CEL or not always? I don't have a CEL but sometimes I feel like there is a lag in the boost. Wondering if the diverter valve is bad or not.
View 6 RepliesSometimes while driving if i accelerate the car fully the rpms will accelerate way to fast (at least 2x faster than usual) without picking up much speed at all. I can tell that the car is not going to full boost. The problem is the worst in 5th and 6th gear (when the car is relying more on boost im guessing?) and will happen one day and be perfectly fine the next. I just had the car checked for a boost leak about 3 weeks ago so i dont think its that. The car is chipped with uni stage 1+ (20psi) and has a full 3 inch turboback.
View 15 Replies