GTI 337/20th Anniversary :: Loud Vibrating Sound When Making Left Turns?
Jun 24, 2011
Have a 05 GLI tiptronic. Every time while making a left turn there is a LOUD vibrating/rattling sound coming from underneath my shifter. Dealership told me it was my exhaust rattling since it was larger than OEM. That doesn't sound right at all.....
View 1 Replies
Advertisement
When i make a left turn i can hear a rubbing sound thats like a low groan. Searched it but couldn't really find one that was described this way. It's a 20th GTI.
View 22 Replies
When spooling my turbo, or even when im in idle, it almost sounds like there is a leaf inside it. the noise was barley noticeable before, but now its quite loud. What this could be.
View 7 Replies
My 04 gli makes a rubbing noise when accelerating thru hard left turns.. but weird enough i can take the same turn at the same speed in neutral and have no noise at all. I changed both front wheel bearings and cant seem to find the answer. I brought it to vw and they checked the whole suspension struts springs cv's tie rods ect. and they all checked out good they said. the car used to have a exhaust and i just recently put it back to stock, could the exhaust make the noise perhaps?
View 1 Replies
ok i don't know if it is a problem or if it is alright but my 18t GLI makes a weird sound in third when I let off the gas. kind of like a whine/grind. I asked the guy i bought it from and he said it has been this way since he bought it too. It sounds like it might involve the turbo but thats just a guess. it only does it in third gear.
View 6 Replies
I'm getting a clunk sound from my Passat's front left suspension when making turns. I've found info on how to diagnose control arms and I plan to jack the car up tomorrow and check it out. But how would I diagnose a tie rod end problem?
My Passat has 53,000 miles on it.
View 6 Replies
When I turn left sharply i hear a rubbing sound. I thought it was just tire rubbing but I am not sure. What else could it be? The car is stock height stock everything. It just got new brakes and tires recently. it looks like something is rubbing the cv boot....
View 5 Replies
If I am going under 15mph or so and turn the wheel left or right i hear a small "clunk" sound. It happens when i get the wheel to about 2 and 3 when i turn right and about 10 and 9 when i turn left... What could this be? Also i do not hear it when I am going over 20mph or so ...
View 24 Replies
I just replaced my front brake pads and rotors. Car had no squeaking sounds before this. When changing the right front pads and rotor, the set screw that holds the rotor in place snapped on me when I tried to remove it. I drilled out the remaining screw and inserted an easy out / screw extractor to try to remove the broken screw. Screw wouldn't turn/budge and eventually the easy out snapped in half while trying to turn it. Here is where I fear I made a little problem into an even bigger one; I tried to remove the broken easy out by banging the back end (smaller end) of it with a hammer and screwdriver, hoping it would pop out from the front of the hub. No success, and continued using a lot of force to try to remove it from the rear part of the hub. Eventually I noticed the hub area by the back of the easy out bent a little from me using force from the rear to remove the easy out. I stopped there, bent the hub section back to original shape (didn't bend too much to begin with) and sawzawed off the protruding end of the easy out from behind.
After driving a few times I started noticing the squeaking sound coming from the front right wheel, the sound sounds like is in tune/harmony with the wheel rotation. As soon I step on the brakes, the sound stops. I had a similar sounding problem with a rear wheel a long time ago and it ended up being that the bearing needed adjustment. I know the front bearings are pressed in so they can't be adjusted. I am thinking the force used to try to remove the broken easy out damaged something with the hub or bearing or maybe the axle nut.
View 2 Replies
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
View 8 Replies
So I was driving home from my girls house the other day, i stepped on the gas pretty decently, and instead of the normal "whoosh" from the intake, i hear the "whoosh" with an extra loud "whoosh" sound. Then when i came to a halt, the engine wanted to stall out and was sputtering incredibly bad. car seems to run fine @ 2k rpms+. Now it actually does crap out on me, so I am currently not even driving it.
I got fault codes p0300, 0301, 0303, 0304. random misfires in cyls 1,3,4 right? I checked my hoses and I don't seem to have a leak anywhere...
View 21 Replies
Have a 2007 Avalon, original owner. For past 3 winters, when temp is 10F or less, there is a loud clicking sound when the car turns left from a stop. The frequency of the clicking sound increases as the car accelerates. Once the car makes the turn, the sound stops. In extremely cold weather (0F or less) the noise happens when turning right, but less intense. The clicking usually goes away after driving several miles and will return after sitting outside overnight or for 4 or 5 hours if the temp is below 10F. Dealer claims all of the CV joints are good. I drove it with a tech this morning and it was clearly present.
View 6 Replies
So, yesterday I had my GLI in the shop to put a new timing belt on as well as some ECS Lightweight Pulleys. When I went to pick up the car, they did not install the pulleys. The reason they said was because the stock crank pulley has a dampener which keep vibration and balanced weight on the crank assembly and that the lightweight crank does not have these benefits.
So, now I have a set red anodized pulleys.. [URL].............
View 8 Replies
When I drive my car past about 3000 rpms then let them fall i hear an odd sort of vibrating noise coming from the turbo between where ever I rev it up to and about 2600 rpms. Is this normal? Its fairly quiet and can only be heard without the radio on and if your listening for it. This worries me because I've only had this k03 for about 5000 miles .Some background info I am chipped with uni at 20psi, full 3" turbo back and an 007 dv.
View 3 Replies
So 2 weeks ago I noticed that after 30 minutes of driving on the highway my steering wheel started making a loud growling noise and vibrating really hard! When I hit the brakes it got worse but got better as I slowed to 30 mph. It doesn't happen all the time and not right away, only after a while of driving and the dealership says without codes they can do nothing...
View 7 Replies
So my Gti 337 it starts but it turns right back off starts and turns right back off people are telling me it's the fuel pump checked it it's not that people are saying its my ECM.
View 5 Replies
My 2005 Dodge Ram (53,000 miles) will sometimes die while I'm making a left turn, or when I'm moving slowly in a parking lot.I get the oil change regularly and asked my mechanic to checkinto it. He. thought it has something to do with using cheaper gas, so I started buying the more expensive gas but it is still doing it. This is scary when it happens because not only do I suddenly slow down, but the power steering goes out and I have to muscle it around the turn.
View 1 Replies
I have a question? I have had my car parked for about 2 1/2 months and I just started it this weekend and I've always noticed on our cars when we start them in the morning I think it's the secondary air pump that turns on, it sounds like a blow dryer.. It only stays on for about 10 seconds maybe. Cause when I started my car this weekend I didn't hear come on.
View 3 Replies
A buddy of mine has a gti that is not starting. he said the temp light has been coming on and the car would start to struggle. of course he kept driving. Today it came on and stalled out. Now the car turns over but wont start. I replaced the temp sensor (green plug) and it wasn't the issue. its a 1.8t with 80k on it. 2002. I am assuming its got to be fuel or spark.
View 15 Replies
Ok I was driving home right know from work, and looking at the speedometer, i notice that my temperature gauge turns off (the needle goes all the way down). what can it be?
View 2 Replies
I've got a loud, intermittent, swooshing, vibrating noise from the front left wheel area at highway speeds. I put a camera down there and saw that when there was noise, the front driveshaft and front left halfshaft were spinning. When they stopped spinning on their own, the noise stopped. Hubs are Warn Premium (gold) and unlocked. Unit bearing already replaced. What could it be?
View 10 Replies