Quick q recently just got a gli and I've noticed a knocking sound when accelerating and shifting from stops could this be my motor mounts ? I was thinking my tranny or clutch but everything runs smooth and goes into gear fine
View 5 RepliesQuick q recently just got a gli and I've noticed a knocking sound when accelerating and shifting from stops could this be my motor mounts ? I was thinking my tranny or clutch but everything runs smooth and goes into gear fine...
View 1 RepliesMost of the time I take a corner I hear this somewhat knocking sound I believe its the back wiper but I'm not sure. Any easy fixes, besides the obvious replacing it.
View 10 RepliesI just replaced my front brake pads and rotors. Car had no squeaking sounds before this. When changing the right front pads and rotor, the set screw that holds the rotor in place snapped on me when I tried to remove it. I drilled out the remaining screw and inserted an easy out / screw extractor to try to remove the broken screw. Screw wouldn't turn/budge and eventually the easy out snapped in half while trying to turn it. Here is where I fear I made a little problem into an even bigger one; I tried to remove the broken easy out by banging the back end (smaller end) of it with a hammer and screwdriver, hoping it would pop out from the front of the hub. No success, and continued using a lot of force to try to remove it from the rear part of the hub. Eventually I noticed the hub area by the back of the easy out bent a little from me using force from the rear to remove the easy out. I stopped there, bent the hub section back to original shape (didn't bend too much to begin with) and sawzawed off the protruding end of the easy out from behind.
After driving a few times I started noticing the squeaking sound coming from the front right wheel, the sound sounds like is in tune/harmony with the wheel rotation. As soon I step on the brakes, the sound stops. I had a similar sounding problem with a rear wheel a long time ago and it ended up being that the bearing needed adjustment. I know the front bearings are pressed in so they can't be adjusted. I am thinking the force used to try to remove the broken easy out damaged something with the hub or bearing or maybe the axle nut.
I have a 2004 VW jetta GLI 1.8 turbo and when i get it to about three and a half grand it feels like my turbo is giving out, all acceleration stops. But I doesn't do it all the time, meaning not every time i step on the gas, like I can step on it all through first and second, and it will do it in third or visa-versa. Which leads me to believe that it could be a fuel delivery problem but I don't know, im new to the VW game. The check engine light will come on while the car is bogging down but as soon as the rpms go down it will turn off.
View 1 Replies2001 F150 5.4 v8 ... In the past few months my truck has been a bit strange, but in the past few weeks it's gotten to the point I'm nervous to drive it. Usually when shifting around 30-35, the engine revs up and stops accelerating and I have to take my foot off the pedal to make it return to normal. It doesn't do this after I do that, but the past time I tried to drive I couldn't get above 35 and the rpm was in the upper 2000s going at a constant 35. When I stop for any reason such as making a turn, when it shifts it lurches forward and I hear a loud clunk.
Naturally, I've checked all the fluids and fuses and they're all fine. The mechanic I regularly visit insists that nothing is wrong with it.
I have an 04 Gli with 85000 miles on it. I just had the clutch done with a conversion from a dual mass to a single. When the car is idling there is some chatter coming from the tranny but it stops once i press the clutch.
View 3 RepliesThis started recently and it's definitely out of the norm... When I activate my signal and it switches off, i still hear the ticking but no lights are flashing. it'll go on for about a few sec then shut off, sometimes comes on even when i didn't activate my blinkers. Also when i start my car i feel a vibration from under my feet. Sounds like a knocking noise when i accelerate/turn. But then goes away after about 20 seconds of driving.
View 13 RepliesI am having some issues with my GLI. it's not accelerating smooth. when I press the gas it kind of hesitates before it starts to accelerate. basically power delivery isn't consistent. When pressing the gas the car accelerates a little and then I get this small surge of power. I don't know what's causing this.
Other than the issues mentioned above I think I need to mention that one time, last week when I was accelerating from a light I lost ALL power to my gas pedal even though I had my foot on the gas & then 1 sec later I was able to accel again. I thought the car was going to stall. I think problem solved, Just unplugged the MAF and problem are gone. the car is running smooth. looks like I need a new MAF even though I cleaned it the other day. still, have to check for leaks tho before spending money. I just replaced my MAF and it didn't change a thing. still same problem.
CEL came on this evening. I was accelerating at the time. The only thing that I can think of is I stopped by the car wash to wash the salt off her and left the car running. Could water have gotten into my CAI, and would that cause the light to come on? It's running perfect. Is the CIL even a reason to get concerned??
View 3 RepliesI have the po411 code, not sure which problem it is but when I first start the car it sounds awful like almost a grinding or rattling noise then stops after a few seconds.
View 3 RepliesSo I was warming up my car after work tonight, and it was idling really rough right above 1RPMS and i heard a lil knocking noise from the engine what could have caused this? I was parked on a slight hill but i doubt that has something to do with it.
Also my buddy told me a way to see if my clutch was going out, is to try and kill the car while in gear, so i tried 1st time it shook really really bad but didn't die. So I tried again and it seemed like it was trying to catch its self and then shook bad again and then died. I did this in 1st gear just letting off the clutch before giving it gas. Does this mean my clutch could be going out already? the car only has 63k on it...
If the car is moving, the transmission feels like it doesn't want to let you shift into first (even with the clutch all the way in) until you've slowed down considerably. it grinds if the clutch is all the way in and i try to put it into 1st at about 30 mph, for example.
I always thought that it was probably a safety feature so you don't try to get into such a steep gear at that speed. i guess I'm just trying to make sure of that, because I've never researched it before. What I'm starting to notice now (or maybe its in my head) is that the trans is being real particular about me having the clutch pushed in all the way _to the floor_, something that it something that it tends to give me a bit more slack with the other gears.
For example shifting 2nd to 3rd, i can usually have the clutch pedal about an inch off the floor and it will still shift. is this a sign of clutch wear? it's got over 100K miles on it of mostly granny shifting.
Trying to find if any updates to this problem. Just broke a second fork yesterday- only issue I've seen is to simply replace with the same brass fork.
View 10 Replies04 BMP GLI, 135000kms
This odd noise just started today. Whenever i accelerate at any rate, an odd "buzzing" sound occurs. It almost sounds like a diesel... Boost is not holding as it should, and I get exhaust backfires in first, second, and third gear. Makes no noise when i lay off the throttle, only when i touch the gas... I don't have a VAG-com, I'm thinking a exhaust leak or boost leak.
K04 turbo
Unitronic Stg 2+
Eurojet side mount intercooler
Milltek 2.5"
Evolution Motorsports intake
FX350 clutch
Wavetrac limited slip diff
I want to reduce engine movement when accelerating, so is is good enough to get the ECS Dogbone Mount Kit With Stretch Bolts or should i get the ECS Tuning Ultimate Dogbone Mount Kit which includes the dogbone itselft?
View 7 RepliesI just had new R32 rear lower control arm bushing installed but I still notice that the car rocks and bucks somewhat when I shift. I can control it I shift and accelerate slowly and deliberately but where's the fun in that?
I didn't replace the front lower control arm bushings but I'm starting to think I should have. Or maybe something else needs replacing??
Experiencing this bucking when shift? Maybe I just suck at shifting?
was diriving my toy1and was shifting from 3rd to 4th when the rpm reved up and the car would not take any gears to drive foword or revers my gears when you shift are engagging but no mvement also i dont have to push the clutch in to shift it will go with out clutching.
View 9 RepliesOkay, this all started a couple weeks ago when i first heard a weird knocking noise about 10 minutes after I left my house. I pulled the car over and it seemed to be coming from the right rear of the car. I started to turn around when it stopped. Over the next few days I notice the longer I let it warm up the sooner I hear the noise. I park in the garage and have read different things on the temp changing etc. About a week ago my check gas cap light went on shortly after I heard the knocking noise.
I pulled over to check if it was tightened and when i restarted it the light was off.... I didn't think much about it but this weekend it went on again, after I heard the noise and I pulled over to check it, tightened it and started. This time it did not go off. After letting the car sit for a bit and restarting it finally went away. Then again this morning 7/2 after hearing the noise the gas cap light goes off again...same thing as the last. Light will not go off... the car is parked right now and hopefully the light is off when I go back to turn it on.
Received error code P0445 now and gas cap light no longer on, check engine light now comes on. I had my bf locate the fuel pump and he ran it and the noise seems to come from there...(TY Savko@HSTuning). When he moved it the check engine light went off for about 15 minutes but eventually came back on. I read to replace gas cap first with a P0445 error so I ordered a new Gas Cap and if that doesn't work I guess the fuel pump will be next?
2004.5 GLI 1.8t. Its got 70k on the clock, its a Cali car, runs like a charm BUT... For some reason when it gets warmed up, it makes a knocking noise by the pass side floor board?
Its just at idle, i mean i can give it a little rev, and it doesn't seem to get worse so that eliminates bottom end or head... so???? Ive read some post on here that say... its nothing... just ignore it... but idk.
Like I said its just at idle and it sounds like its coming from the pass floorboard.... I left it running and popped the hood and couldn't hear it.
I just noticed recently, that while accelerating, the needle on my boost gauge never really holds. It flutters back and forth between psi throughout the acceleration, rather than holding. This also occurs while I am idle and have the A/C on, the needle flutters back and forth. I have the stage I set-up Revo software which I have had for a while.
View 5 Replies