GTI 337/20th Anniversary :: Engine Code AWP?


Dec 9, 2010

What is the factory AWP 20th AE boost pressure?

View 6 Replies

Advertisement

GTI 337/20th Anniversary :: Misfire With Engine Code

So i have a 2004.5 gli 6spd that had two of the coils go bad and had a serious misfire with engine code and all car didnt want to even move. So i got this fixed made it about a mile down the road and it had a cylinder 3 misfire took it back had third coil replaced and all new plugs put it. Got the car back it ran fine until i hit about 4000 rpm under heavy boost it misfires but no flashing cel like before and the car still runs but cold start warmed up it misfires under boost

View 20 Replies

GTI 337/20th Anniversary :: Engine Code For 2004.5 GLI 1.8t?

whats the engine code for the 04.5 gli 1.8t???

View 5 Replies

GTI 337/20th Anniversary :: Fixing Engine Code P0704?

Check engine light just came on. I scanned the car and the code PO704 came up.

"Clutch switch input circuit malfunction."

If I replace my clutch switch, will this solve the problem? I got the part number #1jo 927 189f i just want to make sure its that switch that's bad.

View 5 Replies

GTI 337/20th Anniversary :: Code PO322 - Engine Speed Sensor

I drive an 05 Gli n my car has been shutting off on me took it for a diagnostic n the code po322 came up engine speed sensor. So my question is. Is their a DIY on replacing the sensor I'm picking it up tomorrow. To be honest I don't even know where the sensor is located...

View 8 Replies

GTI 337/20th Anniversary :: Keep Getting CEL / Code P0420

I have Unitronics Stage 2, and a 3" downpipe... I keep getting a CEL P0420. I know its about the second o2 sensor, but I don't understand why I am getting the CEL with my chip? Could it be possible that when I put the downpipe back in i reversed the 2 sensors? Or are they the same...

View 5 Replies

GTI 337/20th Anniversary :: Error Code Is Coming Up For Bad ECM

Ever since ive owned my 337 its always been a pain to keep my cel off but i got a pocket scanner and found that the code is coming up for a bad ECM !!! i called around and the cheapest i found was 1200.

View 8 Replies

GTI 337/20th Anniversary :: 04.5 GLI 02 Keeps Throwing Code For 02 Sensor

I have an 04 GLI and keeps throwing a code for the 02 sensor, and after putting the car on the lift, and disconnecting the 02 sensor harness, a fine oil leaks out at the end of the connector and smells and looks like power steering fluid.

View 9 Replies

GTI 337/20th Anniversary :: Converter Below Threshold Code

Car is throwing Converter below threshold code. I figured i would put in MagnaFlow High-Flow cat from my work but didnt know if that would work. The position of the stock 02 sensor is what baffles me.

It seems to me the factory design has the 02 sensor in between 2 chambers. Could I just install this Magnaflow cat and put the 02 sensor after the cat? Can get rid of this code after installing high-flow cat?

View 3 Replies

GTI 337/20th Anniversary :: 2004 1.8t GLI - Lean Code PO171

I got a 04 mk4 gli 1.8t and I got a po171 lean code and I know it could be a vacuum leak the maf sensor and other things. But when I clear the code it takes a couple days for it to come back on. But when I do clear it and start the car for the first time the car idles read bad almost sounds like miss fire. The when I pull out it hesitates just for a little than runs fine. Could this be a bad or dirty maf sensor? Like I said it takes a while for the cel to come back on.

View 1 Replies

GTI 337/20th Anniversary :: Resolving P0601 Code With CEL Light On

I have a 2002 GTI 337. I'm getting a P0601 code with the CEL light on.That code says "internal control module memory check sum error".

View 7 Replies

GTI 337/20th Anniversary :: CEL Came On After DV Switch Replaced - Code P0420

So I recently (within the last month) replaced my DV for a Forge 007 and my stock air box for an EVOMS v-flow. My cel came on after the DV switch and was throwing the P0420 code at me. Then I swapped the intake and it has been good but I felt like I was running a bit rich and pulled my codes and it now has P0030 in addition to P0420. Why this is? I have 88K miles. Spoke to a mechanic and he says he thinks it is my cat dying. I'm a bit confused since I have a turbo back exhaust.

View 6 Replies

GTI 337/20th Anniversary :: CEL On - Code Is Running Lean With A Base One

I was parking today and when i looked up my CEL was on. So I got the code pulled and it turns out I'm running lean with a base one. I think it was? the mechanic told me it was my o2 sensor but I'm not sure which one it may be whether it be before or after the cat?

View 5 Replies

GTI 337/20th Anniversary :: CEL On After Changing O2 Sensors - Code P1174

I just changed both of the o2 sensors on my 337 like i was told and my car ran for about 80 miles until the engine light went back on again I brought it back in to get it scanned again and i got a P1174 code. What it is and some solutions.

View 7 Replies

GTI 337/20th Anniversary :: 2002 - Way To Fix P0420 Error Code?

I have a 2002 GTI 337, 1.8T and I get the faulty code P0420 insuf.cat flow?? ... it is a way arround it

View 10 Replies

GTI 337/20th Anniversary :: Traction Control Code - Switch To Turn On

I have heard that there is a traction control code u can have switched on when your car is started traction control is automatically off and u have to use the switch to turn it on!

View 5 Replies

GTI 337/20th Anniversary :: 2004 GLI 1.8T - CEL Came On / Code P0303 Cylinder 3 Misfire

So I have a 2004 Jetta gli 1.8turbo and my CEL came on last night from normal driving, after it came on it still drives the same. I had it scanned for codes and got the p0303 cylinder #3 misfire. wondering what could be the solution for this? I dont think its the coil pack because I had them changed at the dealer from the recall about 2 months ago (anyway to check?) Also I have 97,000 miles on my car and my last oil change I used 0w-40 oil. I know this is probably not the best oil to use at this mileage but I had an extra 5 quarts of them laying around so I decided to use it.

View 24 Replies

GTI 337/20th Anniversary :: Oxygen Sensor Code P0420 Will Randomly Come On In Any Weather

My Jetta has been throwing this code on and off for over a year now. It used to only come on when it was really cold with wet roads. Now the code will randomly come on in any weather. I usually just clear it but it's coming on to often now. I don't notice any performance issues or gas mileage problems.

Scan shows : Trouble Code - P0420 Catalyst System Efficiency Below Threshold (Bank 1)

I've been reading and apparently 1.8t engines only have One bank? I'm assuming this the the front 02 sensor throwing this but not sure?

I have an aftermarket exhaust/high flow cat. Apparently this can be caused by a high flow after market catalytic converter and one solution is to use a test pipe or spacer to move the rear O2 sensor further from the exhaust gas flow. But I'm not sure this is the issue since I think it's my front sensor throwing the code? That's not by the Cat is it? I just don't want to have the sensor replaced to have the code still come up.

View 5 Replies

GTI 337/20th Anniversary :: CEL On With P0130 Code - O2 Sensor Front And Rear Difference?

Just got hit with the P0130 code when my CEL came on for the pre-cat o2 sensor. On ecs there are front and rear sensors. I'm assuming front would correspond to the pre-cat that is throwing the code?

View 17 Replies

GTI 337/20th Anniversary :: Code P0456 EVAP System / Very Small Leak Detected

This is the code i pulled from Vag. Its not the gas cap...

VCDS Release 805.0: Generic OBD2
Mode 03: Emission related fault codes
Address 10 (Engine): 1 Fault Found:
P0456 - EVAP System: Very Small Leak Detected

View 8 Replies

GTI 337/20th Anniversary :: Check Gas Cap Light Went On And Knocking Noise / Error Code P0445

Okay, this all started a couple weeks ago when i first heard a weird knocking noise about 10 minutes after I left my house. I pulled the car over and it seemed to be coming from the right rear of the car. I started to turn around when it stopped. Over the next few days I notice the longer I let it warm up the sooner I hear the noise. I park in the garage and have read different things on the temp changing etc. About a week ago my check gas cap light went on shortly after I heard the knocking noise.

I pulled over to check if it was tightened and when i restarted it the light was off.... I didn't think much about it but this weekend it went on again, after I heard the noise and I pulled over to check it, tightened it and started. This time it did not go off. After letting the car sit for a bit and restarting it finally went away. Then again this morning 7/2 after hearing the noise the gas cap light goes off again...same thing as the last. Light will not go off... the car is parked right now and hopefully the light is off when I go back to turn it on.

Received error code P0445 now and gas cap light no longer on, check engine light now comes on. I had my bf locate the fuel pump and he ran it and the noise seems to come from there...(TY Savko@HSTuning). When he moved it the check engine light went off for about 15 minutes but eventually came back on. I read to replace gas cap first with a P0445 error so I ordered a new Gas Cap and if that doesn't work I guess the fuel pump will be next?

View 5 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved