GTI 337/20th Anniversary :: EPC Light Comes On And Gas Pedal Does Not Work
Jan 12, 2010
Car ran perfectly normal. come back out start the car, the EPC light comes on, and my gas pedal doesn't work. Doesn't do a THING...first 3 times i killed it and re-started it, the rpms shot up to 4500 for a second then fell to around 1100 and stayed there. now i start it and it just hangs at 1100. car has 47k miles on it, a 3in DP 2.5in magnaflow catback, short ram intake, TIP, 710N DV, stock N75. Only thing I can think of is TPS but I don't have access to a vag com.
View 2 Replies
Advertisement
Air condition will not work in my car. The A/c button will light up but will not do anything. The fan speed will only work on high and not on the other settings. I mean when I set it on 1-3 it will not kick on the fan. When I switch it to 4 it will kick the fan on but no A/C still even at that setting.
View 1 Replies
Recently my tail lights went out and my turn signals dont work either, the light for the turn signal on the dash doesn't light up either. My brake lights do work tho and so do my reverse lights.
View 3 Replies
Can't manage to get it back on. Who knows the trick?
View 4 Replies
I have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.
View 3 Replies
I recently got the GTI 1.8L 337 with 64,000 on it. It had been sitting, with daily start-ups, for about 8 months until the ALT was replaced. I've been driving it for a month with no problems until last week. At first I noticed the clutch pedal would pause on the way up for a split second then tap the bottom of my shoe. I thought maybe it needed adjustment but nothing serious. A few days ago the pedal would stick at 3/4 of the way up, and stay there most of the time unless I raised it with my foot, till the car warmed up a bit. Yesterday and today the pedal started to stick 1/4 of the way up, unless raised with my foot, at the morning start-up and will only come up 3/4 when warm. It also wont go into reverse at initial start-up until it gets really warmed up, shifting into other gears is fine. I've had no problems or real sounds shifting into any other gears, though out of 1st has been a little jumpy.
View 3 Replies
We were headed home the clutch pedal went soft... Ok, I thought it's either the clutch master or slave. I get it home and replace the master and after bleeding I had good pedal feel.
Great I thought, I got lucky and it was only the master. Drive it around for a bit and get on the highway and just as I was about to downshift the pedal went flat to the floor again.
Well after pumping the pedal until it had good feel again I got it home and bleed it a couple more times just to make sure I got all the air out. Drove it again. Same thing, after a little while the pedal gets soft again.
Now before I go and replace the slave is it possible I have a faulty master? Having issues after replacing the master?
View 3 Replies
My headlight bulb is out on the left side. Tt's just a regular bulb, not HID's or anything. I got a new bulb and it still doesn't work. I checked the wiring and it seems intact. The other lights which are connected in the housing work fine.
View 1 Replies
it all started out like this. i was unable to go into reverse took it to a shop when first and second were good. Came out of the shop after inspection and now i can shift into first or second gear but not the rest, its stuck in those two and they do not work. do i need a new trans or is it a shift fork and or linkage?
View 11 Replies
The shift lever goes into the gates fine, if a bit easier. No weird noises. 1st and 2nd gear don't work - they act like neutral.
3rd-6th and reverse work fine. Clutch hadn't been slipping. It's the original clutch.
Local mechanic found no issues between the shift lever and the transmission itself. 3 weeks ago replaced timing belt and water pump and the car has been running well.
Yesterday I was driving home from work in light stop-and-go traffic. At one point I put the car in first and it acted like it was in neutral. Engine revved but there was no engagement of the drivetrain. 2nd gear was the same story. After experimenting, 3rd-6th and reverse worked and I was able to get the car limping off to a parking lot by starting in 3rd.
I got it towed to a local mechanic who services my car who said he doesn't crack open transmissions but would look to see if there was something obvious wrong between the transmission and the shift lever. He didn't find anything.
View 1 Replies
So I got this car for 750 and I did choose to take on the problems of the car for the miles on it and how much life I've seen these jettas go for I thought it was a pretty good deal runs and drive great except front left wheel bearing. Onto the lighting so found that the low beams only work when the car is in the on position and when the car is started and running the low beams do not work the bulbs are good because I replaced them and they work when the ignition is in the on position and I have check the fuses all seemed to be fine I also noticed that the only lighting I get on my cluster is the two display screens down on the bottom not even rpm/mph cluster? Could any of this be symptoms of faulty headlight switch? Or too much resistance somewhere?? I also notice my high beam switch also doesn't stay on I would have to hold the switch if I wanted to keep it on....
View 2 Replies
My radio does not work kinda... when i turn the car on it works for a minute just fine, then the volume goes off and i cant put it up or down, but i can use and other function cd/casset fm, change stations and all that i just cant use the volume, or hear anything if i turn the radio off and then back on it works for like 5 sec then same thing happens.... I know sounds like fuses, but why does it work then shuts off?
View 3 Replies
For some reason my headlights and fog lights dont work as well as the turn signals, however the marker lights and 4ways do. The ac and fan also dont work. This all happened at once yesterday. I checked the fuses and they are fine. They must not be getting any power.
View 7 Replies
Noticed the other day my clutch pedal trim is coming off... What did you do to fix it?
View 8 Replies
I keep finding air every time i bleed my clutch. I am not losing fluid but i can not figure out whats causing my problems. The pedal is soft at first and then gets harder and it sometimes needs pumped before i change gears or to even get into gear. I am afraid its the slave but i also just may have air in the system.
View 8 Replies
I just replaced my clutch and have put everything back together, and bled my clutch line, but I have absolutely no pressure still in my pedal. I read that u need to make sure your brake fluid reservoir is filled to the max, but following the clutch line, I dont see it going to the reservoir? I also read that the master cylinder is behind the clutch pedal, does the master cylinder hold any fluid that maybe I lost during the bleeding? I'm at a loss right now.
View 12 Replies
When I Accelerate It almost feels like I am fluttering the gas pedal. Its weird on my car now I have revo stage 2, a TIP, 42DD TBE, 4bar FPR.. Do I need to buy a race n75 vavle ?
View 11 Replies
Today I used my remote to unlock my car without a problem. When I got home from work I went to lock my car and nothing. I went a bought a new battery and replaced it, still no luck which now means I can lock my car but cannot set my alarm. I tried my extra remote and no luck with that one either.
View 4 Replies
I have a 2003 AE and my keyless entry doesn't work. I have tried all the instructions that i can find on the internet and my manual. I replaced the key in my fob and had a locksmith check and its sending the 315hz signal just like it should. before i take it to the dealer is there anything else i can do? is it my car and how and what do i need to check? what part of the car accepts the signal?
View 6 Replies
Had my trans worked on, it was out of the car completely. After picking it up, I got it on the highway, got it up to cruising speed, now there's a wobble at 70-80 mph. it wasn't there before I took it in. should I be getting a front end alignment now? waiting to hear back from the shop now.
View 2 Replies
So last night I was driving home from work, and at a red light while i was waiting to go i had my clutch down when light turned green i tried to go and noticed i could not put it in gear and that my clutch pedal was stuck in place. i didn't know what to do so I checked my shifter plate everything looked fine so went to look at the pedal and i pulled it forward and it came lose. I started it up everything was fine and back to order. This morning going to work same thing happened again, I don't know what is going on and what could be the cause?
View 5 Replies
