GTI 337/20th Anniversary :: Crank 20 Seconds Then Start - EPC Light On?
Aug 24, 2012
So today as I was pulling my handbrake after parking the car, apparently it snapped, so np, taking it tomorrow to the garage for a fix. Anyways had an urgent outing, started the car and went for a 10 mins drive. I didn't give it enough time to warm up. So finished what i had to do, got back in the car, tried to start it, nothing. Took me two tries and 20 seconds of cranking before the car would start. started with EPC light on, drove it nothing wrong in it, except the check EPC light is on. What it might be?
View 3 Replies
Advertisement
There wasn't even a crank. Held the ignition for a couple of seconds and it starts. The next day I had the battery and the alternator checked, they were both good. Another couple days passed and it did not want to start again. Got it scanned no codes come up. I changed the ignition switch and still I have the same problem with no crank.
View 8 Replies
When I am driving around, my brake light will appear flashing for several seconds then it goes off. What is that about?
View 8 Replies
Recently its been pretty cold here, and in the morning or when it sits for awhile i start her up and about 10secs after i start her the little "stop" light comes on and says "check coolant". so went through all that, checked the service manual and dont see any red flags. and if i were to turn it off and then turn it back on it wont show again... but still curious.
View 6 Replies
So driving on the highway my car died. It would crank but not start. Got it towed. This is what I have done to troubleshoot.
1. Swap ECUs. The car should start for a second and shut off because the car doesnt match with the ECU. Still just crank and no start.
2. Fuel pump still primes when I open the door. I also hear a weird air leaking noise when I reconnect the battery, but I think it comes from the fuel pressure regulator (which I think is normal).
3. Checked for current at the ecu wires, wasn't sure what to look for but it was getting numbers.
4. Battery had 12.1 volts running through it (Haynes said 12.5 but is that really much of a difference?
5. Checked spark plugs for spark. Pretty sure we did it right, but there was still no spark. We tried multiple times.
6. Scan car, get code P01314 twice (ECM error).
7. Try to clear codes, says Comm error.
Why am I not getting spark? and why is the ECU error occurring, because we tested with a new ecu, and there was still no start, not even for a second like there should be.
View 2 Replies
I have the po411 code, not sure which problem it is but when I first start the car it sounds awful like almost a grinding or rattling noise then stops after a few seconds.
View 3 Replies
My 20th has been having a starting issue and I've honestly tried everything I can think of, this issue just randomly started one day the car will not start on first crank it starts second or third every time. After it's started and running it runs perfect its just getting it started.
I've replaced the Crankshaft sensor, Camshaft sensor, Coolant temp sensor, the car has had new injectors (440) installed about two months ago, has the new battery. My father is a mechanic and he has also tried everything he knows to do and we asked our local VW specialist and he said to try the things we have already did. Ran codes when the issue started and it only came up with camshaft sensor and we replaced that and cleared the code still nothing. Once this issue started we parked the car and started troubleshooting and the oil was low? even though I know before the issue started it was good and full. the car has a stage two intronic tune, 440 injectors, secondary air delete and all and a shaved and partially tucked bay, there are no resistors is the open unused sensors.
View 1 Replies
just found my cranksensor was dead.. on the highway today.. sooo!.. can som1 tell me where is that sensor exactly so i can change it today.
View 1 Replies
I got the car like that. When I take off hard there is a crack somewhere in the front. Then when I stop hard it cracks too. What could it be??? Sometype of bushing??
View 1 Replies
So, yesterday I had my GLI in the shop to put a new timing belt on as well as some ECS Lightweight Pulleys. When I went to pick up the car, they did not install the pulleys. The reason they said was because the stock crank pulley has a dampener which keep vibration and balanced weight on the crank assembly and that the lightweight crank does not have these benefits.
So, now I have a set red anodized pulleys.. [URL].............
View 8 Replies
I get a ticking niose when i crank the wheel all the way to the left or right and reverse .. What it could be (its fine when I drive forward)....
View 2 Replies
It has only happened 2 times so far. I understand it's normal when it's really cold outside. But it's still warm here. I booked an appointment with dealer next week but I want to knowledge myself before going. Can this be battery? Or starter? I remember there's a common problem on my model that a oil leak will damage the starter. Will that cause this symptom?
View 11 Replies
1996 GMC Jimmy SLS. I've looked at the "starting issue" threads in this forum but none are quite the same as mine. When you initially try to start the Jimmy (cold or warm), it seems to just crank for 20-30 seconds before it even tries to fire. New plugs, cap, rotor, wires. Battery is 2 months old, and so is the alternator. What about the relays or starter. It's not an intermittent problem either. This happens EVERY time you start the vehicle. The jimmy sat for a good while before we bought it, but would that cause the starting issue? It seems to run fine after it starts, but hesitates (stumbles)a little coming up off idle when its warm.
View 5 Replies
06 5.4 screw. This truck sits in the garage all week long as I drive a work van daily. When I take the truck out on the weekends it starts up normally at the house and when I stop someplace for a few minutes it starts right back up but if it sits for an hour or more it will crank over for 10-15 seconds, it does always start back up. It always runs and drives fine, it is all factory as far as the motor, intake, exhaust, tuner etc. What to do with it.
View 12 Replies
My car wont start I have replaced the coilpacks, ecu relay, and had the immo defeated. Here is the vag log [URL] .....
View 2 Replies
I get EPC and ASR upon cold start from time to time. Usually EPC goes away if I restart in a couple of minutes. ASR goes away after a while and restart.
So after car warms up and restarted, everything seems fine.
View 2 Replies
The car is a 2004.5 GLI 1.8t. My car threw a CEL about two weeks ago. When i ran the codes it had one for the camshaft position sensor, one for the secondary air injection, and one for the camshaft position sensor. I cleared all the codes and the light came back on. The only code that came back was the camshaft position sensor P0340 i believe. I drove the car for a week and out of nowhere it just shut off on me while driving.
All the lights on my dashboard were flashing (traction control, battery light, engine light, etc.) I tried to jump it just to see if it would turn over and still nothing. I rolled it down a small hill and tryed to pop start it...still nothing. So I had it towed to my house and I replaced the cam position sensor AND the crankshaft position just to be safe. but now the car still won't start...
The engine is cranking and you can hear the pistons moving but it just can't get the juice to start. After failing to start it 3 times, i noticed a loud vacuum like noise coming from the engine when i turned the key off...but my car would do that every other morning when it actually started and didn't have the CEL, and then once it warmed up the sound would go away.
View 1 Replies
My 245 is running great. Love this car to death. I have been experiencing something weird. The car will start hard after sitting intermittently. It'll crank for 3 seconds and if I press the gas pedal it will fire right up. If I don't touch the pedal, itll will continue to crank...eventually sputtering and then firing. It will usually fore up right away if I don't let it sit for hours. I haven't exactly narrowed it down to a fuel prime issue, but that's kind of what it seems like to me. Are there any check valves or anything like that I could look into?
View 1 Replies
I recently took out my headliner And my passenger's side seat. When I put everything back together, I turned the car on and the light came on. What can be the issue?
View 10 Replies
So my 20th randomly won't start. It's happens about once a week or so. Most of the time when it happens the car cranks but doesn't start. Every once in awhile when I turn the key nothing happens at all and I have to keep trying and it'll crank and turn on. I also have no way to check for codes
View 6 Replies
I have a perplexing problem and I'm at wits end trying to figure it out. I have an 03 GTI 1.8t 20th. The car has been running great until today when I replaced a few bolts with the front bumper and replaced a motor mount bolt on the passenger side mount. Everything was great until I did the work on it. I figured I had bumped the cam position sensor so I swapped it out for a new one and nothing still. I have verified I have spark and I definitely have fuel as it keeps drenching the spark plugs. I have cleaned the spark plugs and tried starting only for the car to violently sputter and misfire. No codes are being recorded and nothing else has been touched.
View 9 Replies
