If I am going under 15mph or so and turn the wheel left or right i hear a small "clunk" sound. It happens when i get the wheel to about 2 and 3 when i turn right and about 10 and 9 when i turn left... What could this be? Also i do not hear it when I am going over 20mph or so ...
View 24 RepliesI've been hearing a "clunk" like noise here & there when I turn the wheel on my GLI all the way to one side then turning it back. I've heard it when making u-turns and when reversing. It seems to be coming from somewhere on the bottom of the drivers side and it doesn't happen all the time. I've brought it to the shop twice but they can't seem to figure out what the problem is & the car won't make the noise whenever they seem to test drive it. What this might be?
View 13 RepliesWhen i make a left turn i can hear a rubbing sound thats like a low groan. Searched it but couldn't really find one that was described this way. It's a 20th GTI.
View 22 Repliesis it just a 337 thing? but, the rear wheel on the left is poked out farther than the wheel on the right. I didn't measure it just yet but it looks as it's almost a 5mm difference. I didn't realize it until today when an old friend was inspecting my car.
View 11 RepliesI was sitting at the stoplight in neutral when the light turned green. I pushed in the clutch and put the car in first then all of a sudden a huge CLUNK like when you take out the starter bolt without supporting the trans or motor. Then while letting out the clutch about halfway all hell broke loose. It sounded like a bunch of marbles rattling like crazy in the trans. I pushed the clutch back in then it stops until you let it back out again. The car still moves forward and reverse but with all that noise. The sound seems like it's coming from under the driver side motor mount. When I put my hand on the tranny I can feel the vibrations very well. Does this sound like the throw out bearing?
View 3 RepliesI get a ticking niose when i crank the wheel all the way to the left or right and reverse .. What it could be (its fine when I drive forward)....
View 2 RepliesI have an intermittent problem with vibrations coming from the front left wheel area. It vibrates my whole car to the point where I need to slow down to 30mph speeds. It usually occurs during extended periods of driving, but not always. When I am on the interstate driving and it happens, it works when I pull off to the shoulder and turn my wheel all the way to each direction multiple times. Is this an axle related problem? What other things should I look for?
One more thing to add. When this problem first started happening, I noticed that it would only happen when I was in gear and giving it gas. It would stop vibrating when I was coasting in neutral.
My 20th just recently started making clunking noises around the front left wheel area. It sounds like when I let off the gas it sounds like something is shifting forward... I don't think it is the engine mounts I'm wondering if its something with the suspension. The suspension is the stock 20th suspension.
View 4 RepliesWhen I turn left sharply i hear a rubbing sound. I thought it was just tire rubbing but I am not sure. What else could it be? The car is stock height stock everything. It just got new brakes and tires recently. it looks like something is rubbing the cv boot....
View 5 RepliesRecently picked up a 05 GLI with the bbs wheels. Last night i was driving into my parking garage and noticed a clicking noise comming from the back left wheel.
I lifted the car on that side and spun the wheel but it didn't make the noise. But once i set it back down and rolled the car the click came back. So i'm guessing it has something to do with pressure being applied to the wheel.
Have a 05 GLI tiptronic. Every time while making a left turn there is a LOUD vibrating/rattling sound coming from underneath my shifter. Dealership told me it was my exhaust rattling since it was larger than OEM. That doesn't sound right at all.....
View 1 RepliesA while back as I was driving, I heard some sort of clunk, and the steering wheel locked and would not turn left. It then unlocked after a few seconds. Ever since then, it has been very hard to turn to the left (and right, at slow speeds and on sharp turns, but much easier than turning left). This happened a few days after I replaced both front end struts and inner tie rod ends, and got an alignment - they were cheap quick struts (entire assembly), but seem to be of fairly good quality.
Initially after some consultation I thought it was the power steering pump, so I replaced that. It became easier to turn right, but still very hard to turn left. I took the front end off the ground and turned the wheel all the way left and right, no problem or resistance. I am nearly certain it is not the pump.
At this point, I am fairly certain it is either the steering gear or some part of the rack and pinion. I am planning on getting the assembly replaced. The fastest and cheapest way is apparently to just buy the entire steering gear/r&p assembly. Would bad strut mounts ever cause an issue like this? Any other possibilities besides the steering linkage?
Every day I make a u-turn around the median in order to get to our driveway...which means I turn the steering wheel all the way to the left. As I turn the wheel and drive, there is a clannnngKK sound on the driver's side from somewhere near the front. I wondered if there is something getting hung up/caught "under there" but have no real working knowledge (obviously) of my truck's anatomy. It only makes this noise when I make this u turn. I've not heard it any other time.
View 1 RepliesI've just started noticing a "clicking/ grinding/ creaking" when I turn my wheel. It makes the noise if I'm parked, or driving slowly. I can feel it in the steering wheel, and hear it in the cabin, but can't hear anything when I'm under the car.
It sounds like 'two pieces of rubber binding on each other', is the best I can describe it. I THINK its coming from the driver's side. I've considered: strut mounts shifting, CV joints, something in the steering column, Tie rods, power steering pump...
Everything is tight on the wheel when I try to move it by hand (on jacks), and no rips/ tears in any boots.
I've had my R since late mid-summer, and one of the first things I noticed was this clunk sound when reversing into my parking spot and when making an aggressive sharp turn. Usually Left.
After reading multiple threads on this topic, I came to the conclusion that it was my sub-frame and the bolts need replacing. I got in a GB for the tyrol subframe stiffening kit after reading some good reviews/responses.
Today, on my day off, I finally went to a mechanic to get this installed. I just changed my mechanic, and this was my first visit to the guy hes had over 10 years experience at vw and just opened up his own shop. He did a great job, torqued the bolts to spec, made me drive around, do some pulls in 2nd and 3rd gear, reverse forward etc.
So hes about to pull the car back in to retorque and.... CLUNK...
Get in the car, reproduce the sound, get the car back up on the hoist... and at this point I'm expecting the worse. He takes my control arms off, checks the end links...
Brings the car down, and the clunking sound is louder than ever. It was the weathergaurd. When I turned on the wheel it was pulling it out and when I straightened the wheel it was popping it back into place, making a big clunk sound.
This was the exact sound that I was hearing, thinking it was my subframe. The bolts that came out were not stretched or bent out of shape like the ones you see in other reviews. They're actually in great shape. I'm glad I did the Tyrol kit and do not regret it, and I definitely feel a difference when I went into some aggressive turns.
I just replaced my front brake pads and rotors. Car had no squeaking sounds before this. When changing the right front pads and rotor, the set screw that holds the rotor in place snapped on me when I tried to remove it. I drilled out the remaining screw and inserted an easy out / screw extractor to try to remove the broken screw. Screw wouldn't turn/budge and eventually the easy out snapped in half while trying to turn it. Here is where I fear I made a little problem into an even bigger one; I tried to remove the broken easy out by banging the back end (smaller end) of it with a hammer and screwdriver, hoping it would pop out from the front of the hub. No success, and continued using a lot of force to try to remove it from the rear part of the hub. Eventually I noticed the hub area by the back of the easy out bent a little from me using force from the rear to remove the easy out. I stopped there, bent the hub section back to original shape (didn't bend too much to begin with) and sawzawed off the protruding end of the easy out from behind.
After driving a few times I started noticing the squeaking sound coming from the front right wheel, the sound sounds like is in tune/harmony with the wheel rotation. As soon I step on the brakes, the sound stops. I had a similar sounding problem with a rear wheel a long time ago and it ended up being that the bearing needed adjustment. I know the front bearings are pressed in so they can't be adjusted. I am thinking the force used to try to remove the broken easy out damaged something with the hub or bearing or maybe the axle nut.
Car is in for knocking sound made when you are stopped and you turn the wheel quick from left to right. Also does the same thing when you hit a bump. Dealer is saying it was always that way I say bs. 2008 prius.
View 1 RepliesI have a 2003 Volkswagen Passat, and I'm having some trouble with it. When I turn the steering wheel, there is a groaning sound both to the left and right. the other problem is when I'm accelerating slowly up an incline and turning the steering wheel, there a type of clicking sound I hear and feel on my accelerator. By the way, it's a V6 engine, Front wheel drive.
View 2 RepliesSo I've been driving my 3GS 350 and every time i make a right turn the left wheel makes this metal shaking sound? or scraping sound? I've checked it out seems like nothings in the way but I don't know how to tell if i have a bad wheel bearing..
View 9 RepliesMy taurus makes this weird sound when I turn my steering wheel left or right. It sounds like that cartoon "rubber being stretched" sound or maybe a little like plucking an overly tightened string. It doesn't affect driveability but I've been dealing with this for quite some time and I'm trying to sell it now... it's a major buyer turn off.
View 7 RepliesSo.. Today coming back from work, I felt clucking sound from front wheel when going from 5-15mph. I even felt that when I had my left foot on the foot rest area. Its appeared during the driving from work to home and check whether if there is any rock or tree branch on tire or wheel but no...
So after 30mins later, went to gym and the the sound was completely gone.. Would it be because of bad wheel bearing or suspension or ball joint issue?
2012 ISF