GTI 337/20th Anniversary :: 2004 - How To Install Oil Pressure Gauge
Feb 28, 2012
I am wanting to install a oil pressure gauge to go along side my boost gauge in my double pod on top of my steering column, how to do this?
View 4 Replies
Feb 28, 2012
Advertisement
GTI 337/20th Anniversary :: How To Install Oil Pressure Gauge
I need to know how to install an oil pressure gauge...or what is the location on the oil filter flange where this thing gets installed...
View 5 RepliesGTI 337/20th Anniversary :: Hesitation After Intercooler Install
Last week I had the Godspeen intercooler installed on my 05 Jetta GLI. I would say that since the install I have put about 300+ miles on the car so I would think that the computer has learned the additional air flow. I notice that if I'm cruising in 4th gear just below 3000 RPM's and punch it there is hesitation. It is quite noticeable because I have a full 3" inch exhaust so you can hear it hesitate for about a second and then kick in again and continue up the powerband. Do I need to get a good tune or has the computer just not learned it yet?
View 15 RepliesGTI 337/20th Anniversary :: Loss In Fuel Economy After A CAI Install
Noticed a loss in fuel economy after a CAI install??
View 10 RepliesGTI 337/20th Anniversary :: Bucking / Limp / Hesitation After Clutch Install
I took my car in for a clutch install, everything was fine except the clutch slipping. I go to pick up my car and once the car warmed up it started bucking / limp mode while accelerating. Take it back to the mechanic and he thinks he didn't reset the throttle body. So he says that should be it and I pull away. Same thing. Leave it with him again and he replaces with "diag" coils and new plugs. Leave again, same thing. He tells me to get totally new coils and try that. I am thinking its a missed ground cable or messed up ECU or something. During all this not one code it thrown.
20th GTI 1.8T 6 speed, stock clutch, all stock
Ford 6.0L Power Stroke Diesel :: Fuel Pressure Gauge Install
I finally received all the parts needed for installing my fuel pressure gauge, but I am wondering if I am going to need a schrader valve on my fuel pressure line going to the sending unit, or if I am going to be safe with just doing a 6 time cycle of the fuel pump like we do when we change out the fuel filters. Seems like that should work for getting the air out of the fuel lines, same concept I would think.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Where To Install Oil Pressure Sensor For Gauge
I need to install an oil pressure sensor sending unit. I've already occupied the 1/8"NPT test port on the rear of the oil cooler, where else might I be able to tap into oil pressure? (LPOP)
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Fuel Pressure Gauge - Install Sensor Into Lift Pump?
I am installing a fuel pressure gauge into my 02 7.3 I went to the thread the sensor into the plug hole on the fuel filter housing and it wasn't threaded, turns out the sensor thread is slightly smaller and a different thread ... The directions say to install it into the filter housing or the lift pump ... So I'm assuming I have to go the lift pump direction of installing it but where the lift pump is or how to install the sensor into it while not throwing a code or causin problems ... A step by step and even pictures.
View 14 RepliesGTI 337/20th Anniversary :: CEL After Installing NS Boost Gauge
I'm not sure what to make of this ... I disconnected the battery before installing . The gauge seems to be reading correct based on what i researched. If there was a slight leak would it throw the CEL ? is it maybe just a one time thing that needs to be cleared afterwards ? Car drives fine and I plan on trying to stop at autozone to get there crapo freebie scan . Kinda annoyed considering everything went smoothly up until I drove the car more then 50 miles .
View 14 RepliesGTI 337/20th Anniversary :: Speedometer Is Out And Gas Gauge Goes Up And Down During Drive
I just replaced my turbo inlet hose because I was losing boost due to a crack in the OEM one. After I replaced it, my speedometer stopped working and my gas gauge goes up and down when I drive it. I saw a sensor broken off when I looked under hood but I couldn't tell which one it was. Besides obviously replacing that sensor. I'm not sure if the two are correlated.
View 4 RepliesGTI 337/20th Anniversary :: Fuel Gauge Does Not Go Full
I don't think this is normal since my 01 2004.5 GLi go all the way... Note that i took this picture right after i "full" fueled the car (Just drove 2.3miles)...
View 24 RepliesGTI 337/20th Anniversary :: CEL On / Boost Gauge Reading 4 - 5 Psi Under Load?
Car now has about 67,000 miles on it. I drove it from the bay to Lake Tahoe 2 weeks ago, which is when I first noticed the light. I tried to go to a couple of autozone's to get the code read but none of them would do it. I also noticed that now on my boost gauge that i am only reading 4-5psi under load, so its not quite feeling like i'm getting as much power as before. What a common issue is at about this many miles on a 1.8t car? (GLI)
View 3 RepliesGTI 337/20th Anniversary :: Little Sluggish - Gauge Hitting 9 Lbs While Usually Hits 11 Lbs?
Driving into work this morning I noticed that my car was a bit sluggish. So in the name of science (mainly curiousity) I decided, that I would try to punch it. Came to find out that my girl is runnin a little sluggish. Turbo was pulling as hard as it normally does, and my gauge was saying that im only hitting 9lbs when usually its around 11lbs. Could this be a sign of my turbo going out and now is time for a k04-22 or is it time to change the springs in my 007?
by the way I just rolled over 113k. had all the services done at 104k
GTI 337/20th Anniversary :: Boost Gauge Not Working Properly?
I've had this problem a while but now i want to get around to fixing it.. my boost gauge is always at 0 now and sometimes when i drive the car it starts working but it starts like sticking... like when i didn't have my chip it would go up and down really fast between 10 - 15psi... i heard from a friend that you can take it apart and re-adjust some screws or something so it works like a charm... right now its just like frozen at 0 psi when i drive it doesnt go down or up.
View 4 RepliesGTI 337/20th Anniversary :: Temperature Gauge Turns Off / Needle Goes All The Way Down
Ok I was driving home right know from work, and looking at the speedometer, i notice that my temperature gauge turns off (the needle goes all the way down). what can it be?
View 2 RepliesGTI 337/20th Anniversary :: Tire Pressure In Summer?
Was thinking what should tire pressure be on wheels during summer time, assuming you have stock wheels. More pressure = you go faster/ have better gas mileage, but have less handling ability. Less pressure = better handling but slower speed/ lower gas mileage.
View 1 RepliesGTI 337/20th Anniversary :: Gas Gauge Needle Going Down And Back To Normal When Go Through A Bump
I finally got my 20th to run right. But now and ever since I bought it the gas needle keeps going down and back to normal every time i make a sudden move or go through a bump. What could be causing it?
View 5 RepliesGTI 337/20th Anniversary :: Gauge Cluster Needles Don't Move As Soon As Car Turns On
I have a 2005 mkiv GLI and my gas gauge, temp gauge, and information display stopped working when the car is running. They work when the car is on auxiliary but not while it's running. The lights all work on the cluster all the time but the needles don't move as soon as the car turns on.
View 3 RepliesGTI 337/20th Anniversary :: Coolant Light Came On - Faulty Temperature Gauge
Last night I went to drive my car and my coolant light went on. I checked the overflow and it was very low. There was barely any left in the overflow. I thought this was strange because I had just checked the coolant a couple days ago. The coolant that was in my car was an orange color (after searching I realized that I think this is g12 which I was unfamiliar with). Before searching I added Prestone 50/50 pre diluted green coolant. The bottle said it was mixable with any type of coolant color or kind. After reading more threads I'm seeing that I think the g12 just contracted with the cold weather and I should of just left everything. I have barely driven the car since adding the prestone. Am I doing harm mixing in the prestone? If so, How can I fix this?
On another note, With the cold weather my temp gauge seems to be acting a little funny. Once the car is up to operating temperature the gauge will then drop around 40-50 degrees. It will then stay like this while im driving, but then will go back to normal once the car is stopped and running.
GTI 337/20th Anniversary :: Installed FMIC Now Temp / MPG Gauge Reset?
I just installed a eurojet race FMIC (bumper fitting was horrible but thats another story) and now my outside temperature and mpg readings are all off on the cluster computer. The temperature actually just rises when i start driving and the mpg doesnt change at all? Should I just disconnect the battery so it resets? ]
View 1 RepliesGTI 337/20th Anniversary :: Needle On Boost Gauge Never Really Holds While Accelerating
I just noticed recently, that while accelerating, the needle on my boost gauge never really holds. It flutters back and forth between psi throughout the acceleration, rather than holding. This also occurs while I am idle and have the A/C on, the needle flutters back and forth. I have the stage I set-up Revo software which I have had for a while.
View 5 Replies