GTI 337/20th Anniversary :: 2002 Not Shifting Out Of 1st Gear Until Warmed Up For 20 Minutes
Jun 4, 2014
2002 GTi 337 not shifting out of 1st until is warmed up for 20 min. Then shifts fine. I've already attempted to add the "liquid gold" G-052-990-A2 ATF fluid from VW at $35qt. I put in about 200ML to no change, then another 200ML to no change. So from reading other posts in VWvortex I've seen many folks with the Jetta have had very similar symptoms. They are installing a new (Solenoid valve N92 (green) to fix this issue. Many of them are even using over the counter synthetic ATF. Before I dig in, just wanted to know what folks with the GTi 337 think about this? Am I dealing with basically the same transmission?
View 2 Replies
Advertisement
If the car is moving, the transmission feels like it doesn't want to let you shift into first (even with the clutch all the way in) until you've slowed down considerably. it grinds if the clutch is all the way in and i try to put it into 1st at about 30 mph, for example.
I always thought that it was probably a safety feature so you don't try to get into such a steep gear at that speed. i guess I'm just trying to make sure of that, because I've never researched it before. What I'm starting to notice now (or maybe its in my head) is that the trans is being real particular about me having the clutch pushed in all the way _to the floor_, something that it something that it tends to give me a bit more slack with the other gears.
For example shifting 2nd to 3rd, i can usually have the clutch pedal about an inch off the floor and it will still shift. is this a sign of clutch wear? it's got over 100K miles on it of mostly granny shifting.
View 8 Replies
i have a 2002 automatic gti , now car was running gr8 , then poof out of the blue, car started vibrating, yeah , like am on a big vibrator, and only when its on gear D,4,3 or 2 its vibrates , if i place on P or N vibration stops.
and keep in mind it only vibrates on speeds of 10 miles ,20 miles up to ~50 miles speed , if i give it gas,the vibration stops , i slow down on the gas , and the vibration is back , and whenever i stop at a red light , car starts to present minor chocks and viberation.
View 7 Replies
I have a 2002 337. My gear selector has broke down under the boot.
Can I replace this part? Where can I get one? How do I get the old one out?
View 1 Replies
I have an '02 337 GTI, Chipped but the previous owner don't know what chip is installed
Anyways, lately if I'm just cruising around the city in 5th, or on the highway, the engine will shut off completely. Electrical still on, battery light and all that jazz does not come on unless the RPMs go all the way down, then I have to actually start the car up again. Takes alot longer to crank afterwards.
Sometimes I will be driving and it happens, but I keep my foot down on the throttle, and just wait and engine will kick back in hard as hell!
View 3 Replies
20th with 120,000 miles. Ok here's my problem, get in my car in the morning after a coldish night, (around freezing) clutch pedal goes almost to the floor with no resistance, i pump it a say 5 or 6 times and it gets stiffer but not 100% i drive it for 10 or 15 min and it warms up and the clutch gets back to normal stiffness. I'm thinking its the master or slave cylinder going bad or maybe it just needs to be bled and before i go and buy both of them and replace them, just wanted some opinions. Also its not leaking fluid at all and the reservoir is full.
View 2 Replies
2004.5 GLI 1.8t. Its got 70k on the clock, its a Cali car, runs like a charm BUT... For some reason when it gets warmed up, it makes a knocking noise by the pass side floor board?
Its just at idle, i mean i can give it a little rev, and it doesn't seem to get worse so that eliminates bottom end or head... so???? Ive read some post on here that say... its nothing... just ignore it... but idk.
Like I said its just at idle and it sounds like its coming from the pass floorboard.... I left it running and popped the hood and couldn't hear it.
View 10 Replies
Bought a 2007 es350 2 months ago and transmission shifted fine during test drives but now seems to hesitate when shifting from 2nd to 3rd gear when not warmed up. Also seems to not engage at low speeds of around 5mph again when cold. Seems to shift normally when warmed up or after the the first couple shifts of the morning. Is it a simple fix or a prelude of something worse to come? Other than that I love the car so far.
View 7 Replies
Trying to find if any updates to this problem. Just broke a second fork yesterday- only issue I've seen is to simply replace with the same brass fork.
View 10 Replies
I just had new R32 rear lower control arm bushing installed but I still notice that the car rocks and bucks somewhat when I shift. I can control it I shift and accelerate slowly and deliberately but where's the fun in that?
I didn't replace the front lower control arm bushings but I'm starting to think I should have. Or maybe something else needs replacing??
Experiencing this bucking when shift? Maybe I just suck at shifting?
View 11 Replies
was diriving my toy1and was shifting from 3rd to 4th when the rpm reved up and the car would not take any gears to drive foword or revers my gears when you shift are engagging but no mvement also i dont have to push the clutch in to shift it will go with out clutching.
View 9 Replies
First off i couldn't get the car into reverse to back out of a convenience store and then i let off the clutch to try and pump it again and the car just dies. drove just fine up until i parked. Now when i try to move through gears it sounds like it's shifting but the car doesn't move. The car does have a stronger clutch and unitronic chip if that would have to do with anything.
View 13 Replies
Quick q recently just got a gli and I've noticed a knocking sound when accelerating and shifting from stops could this be my motor mounts ? I was thinking my tranny or clutch but everything runs smooth and goes into gear fine
View 5 Replies
sometimes when i switch from 1st to 2nd or 2nd to 3rd i get a loud popping noise like my exhaust is hitting the under side of the center column. I have had the car on a lift and shook the hell out of the exhaust...it's not moving enough to cause that loud popping...so i figured it could possibly be the dogbone mount gone and the downpipe is hitting when i shift because the mount is bad?
Or could it be one of the other mounts...I'm going through a divorce right now and really really broke so i need to make sure i get the right one and fix it right the first time. What mount it is if not positive its the dogbone?
View 4 Replies
2002 elantra gls 125k miles, Automatic
I have a very intermittent problem starting the vehicle first thing in the morning ( this has happened twice this week, but only 5-6 times in the past year or so). It will crank and sound as if it just about to start, but not quite fire. After 5-10 mins of cranking, shifting into and out of gear, rocking vehicle (not sure what actually causes it to start, if anything) the car fires and runs just fine, starting normally until the next "event".
Plugged it in and got no codes.. The only difference I can see is that every time this has happened recently the car has been parked in a parking garage at work on a minor incline for about 13 hours.
View 5 Replies
Driving home from work, I was about 5 minutes from home, got to a light only to not be able to go into 1st. I popped it into 2nd and drove home like that pretty much. Car will let me get into reverse and all other gears.
I can put the shifter towards first but it doesn't fully go in and when I gave it gas it would let me start to creep and then grind a little and pop out.
Heres a pic for your click .....
View 24 Replies
I have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.
View 3 Replies
So I get in the car to move my car this morning and I can't get the car into 1st gear. It turns out I can't get the car into reverse, 1st gear, or even 3rd gear. It feels like something is blocking me from even approaching those gears, however the others (2,4,5,&6) seem to be fine.
View 14 Replies
I bought a rebuilt trans from a fellow vortex member a little over a month ago. I had it installed and ever since then when I am getting on it going from second to third it grinds a little bit going into third gear. It only does this when i get on it, but when im just cruising its fine. Could the shift linkage just need aligned? Or what else could it be?
View 5 Replies
As of two days ago my car ust refused to go into 1st gear. I know that it is a common occurrence with the 02j and shift fork, but 2nd works perfectly, so how could it be that shift fork?
View 16 Replies
So I've been noticing that my GLi is tough to put into first gear sometimes. I feel almost like I have to jam it in place and hold it there, it doesn't just click in. Could this be the shifter cable ends or the cables themselves? Its weird... its only ever been a problem for 1st gear though.
View 15 Replies
