GTI 337/20th Anniversary :: 2002 - Check Engine Light Came On / Failed Clutch Vacuum Vent Valve Switch
Apr 19, 2010
I have an 2002 Volkswagen GTi 337 edition with the 1.8t engine in it. My check engine light came on so I went to my local autozone to check the code and that's what code it threw on the ODBII sensor. It says my problem could be a "failed clutch vacuum vent valve switch". It also revs about 100-200 rpms extra in between shifts and I'm not a mechanic but know a little about cars. I just don't know if I should replace the OEM clutch safety switch or what I should do about this.
View 19 Replies
Advertisement
This is my other question. I have an APR program and turbo-back billy boat exhaust. I installed a boost gauge that gets the reading off of the intake manifold (fuel regulator.)
So if I'm just tooling along, short-shifting and only using 1/10 throttle, and my boost gauge never reads above -5, let alone 0 or positive, why does my valve release pressure?
Why would there be pressure to release if there is a vacuum, according to the gauge? I wouldn't think that a recirculating or blow-off valve would work in reverse.
View 3 Replies
I have a '98 Ford F-150 XLT, 2WD, Short bed, Ext. cab, 4.6L, automatic trans. with 65,000 orig. miles. I bought this truck new. When I have the A/C or heater or just outside air coming in through the dash or floor vents, the air will switch to coming out of the defrosters when I accelerate and then the air will return to it's normal position when I let up on the gas. Is this caused by a bad vacuum check valve and if so where is it located and what does it look like??
View 11 Replies
I chipped my car with unitronics stage 2 3 weeks ago. 300 mile later the check engine came on. 42 DD down 3" to 2.5 cb no DV yet.
View 6 Replies
So recently my check engine and abs light came on. I went to go get it checked out and it was the MAF censor. And here recently i noticed the airbag light came on. I replaced the MAF today, and the abs went away but check engine is still on due to the downpipe. And the airbag light is also on. Why it might have came on?
View 8 Replies
So I was on my way to work and i noticed my check engine came on. i get out of work and its still there. i go to the movies to watch friday the 13th (ok movie, worth watching in my opinion)...still on. i drive to my friends crib after to chill...still on.
View 2 Replies
So I just recently bought a 20th anniversary GTI with 80k miles on it that I'm really happy with. However, the guy who sold it to me, neglected to put gas in the car. I know that the car is suggested to take Premium, however I put Plus gasoline in it. About 20 minutes of driving later, my Check Engine Light came on, and I'm a bit worried as to what the reason for this might be. What the issue might be. I checked the gas cap numerous times, as I know that many people neglect to screw it on correctly, so I doubt that would be the problem.
View 7 Replies
I seem to have a big loss of power. I just got my 337 last week and it was faster than expected with the GIAC chip. I drove down to mass in the rain last weekend and now it seems slow as hell. My question is does a bad coil pack cause a check engine light to go on? My car's check engine light is NOT on and I do have a boost gauge, and it seems to be boosting normal so I imagine it is not a boost leak. If it were misfiring I imagine I would really know it, but I've never had a misfire on a turbo car so I am not sure how bad it is affected.
View 10 Replies
If you don't have a high flow cat on, will it throw ur check engine light on, saying its the rear 02 sensor....
View 14 Replies
I have a 337 and the check engine light came on a couple months ago and i got the clutch safety switch replaced. but I forgot to take the light back off with my friends snap on tool. the car runs fine now but another friend with a TDI jetta said something about a master ecu reset? something like turn the key in the on position then hold the gas pedal for like 15 secs? I tried it but nothing happened. I just want the light to go away...
View 6 Replies
I have a 2003 20th ann. GTI, it shut off on me on my way to work. It would turn on but only for a sec and turn back off. I turned it on and tried to move it over out the way of traffic and wouldnt move and turn back off. Got the check engine light checked and the codes P1007 which is coolant temp sensor and P0011 which is camshaft sensor. I replaced both and problem not solved car will start but wont go and turns back off, black smoke and a strong smell of gas comes out the exhaust.
View 3 Replies
I have a 20th anni GTI. I was driving down the road about a week ago going about 50 in 5th gear. all of a sudden when i go to give it gas my car starts lagging and the check engine light starts flashing on and off. I used a check engine light tester to figure out the possible problems and found that cylinder 2 misfired.
Spark plugs could have been the problem so i replace them. Nothing changed. so then i thought it could be one of the coils so i switch 1 and 2 aroud to see if there was a misfire on 1 now. still cylinder 2 misfired. I am starting to thnk it may be my catalytic converter. There's a funny spell coming from my exhaust. Like fire crackers or rotten eggs maybe.
View 2 Replies
So i start my car up drive about fifty feet and my temp gauge shoots all the way up, check engine light comes on and coolant light keeps going off......What is wrong with my car?
View 8 Replies
So I go and get my oil change on Sunday at a local place. Oil change is done and later that evening my engine light comes on (solid orange). I call the local VW service and they say its nothing to worry about. "Maybe a little moisture got inside my gas tank." The service manager said to continue to drive it like nothing is wrong and it should go off. Here I am two days later and its still on. So should I be worried?
View 9 Replies
When I bought my 2003 20th it was completely stock, except for a pos blow off valve had been installed, and get this, the diverter valve was left on, and just capped off. I installed a no name CAI, and the check engine light came on, i had it turned off and when i start the car, or rev the engine high at all, triggers again.
View 4 Replies
So yesterday i was driving fine and all of the sudden the car started jolting like it was going to stall and the check engine light came on. I pulled over popped the hood to see if there was anything i could see and got back in and took off no problem and the light went off. I starting pushing it and accelerating it to see if it would come back on and it didnt. Today it started doing the same thing but this time the light stays on and every time i change gears it does that jolting like its going to stall.
Its a 2004 gli 6 speed gli 1.8t ....
View 7 Replies
2002 F250 SD 4X4 5.4L. 4.5 inch pro comp lift tire size 305/75/R16. K&N cold air set up. 208,000kms
I know the truck does horrible on gas but lately is been getting worse, maybe I am getting 350km to a tank. Mixed highway city driving. Sounds like I might have a vacuum leak somewhere but I have no engine light. I've had the truck since last year and put about 10,000km. on it done regular oil changes .. brake maintenance no motor work so far.
View 2 Replies
so i bought projector headlights on my 05 gli and they were easy to install and for the first few days no problems, when the car was off and the lights on it was the parking (P) lights (amber lights), later if the lights were on and the car was off the radio would turn on, the A/C and the low beams would be on even if the hand-break was up, and i still have the DTR lights on. is it a short circuit problem???
View 2 Replies
I just bought a 2005 GLI and when i test drove it the Clutch was extremely light when I shifted, I have never drove a gli before. Now after researching and further driving i think the clutch is going out. am i right? if so, should i bother putting in a new stock clutch kit or should i go stage one etc...
View 3 Replies
My reverse lights are out on my GLI 2004, i bought a new reverse light switch thinking that would fix it but no.......
I then checked for power in line and by jumping it and the light go on
So Switch is goodLine as power
But as soon as it's intalled no go, light out.... it seem's like the lever inside doesn't reach the connector from the switch.
View 3 Replies
I need to put a check valve into the vacuum line that runs to the gas tank. I know that this line is somewhere in the rear passenger side of the engine compartment, but there's so many lines there that I find myself confused when I look at it.
View 1 Replies