My 1999 GMC Sonoma has a occaisonal problem--the tail lights stay lit after the light switch and the ignition are turned off. The brake pedal does not appear to be sticking. The cure has been to remove both light bulbs, wait a few minutes, plug them back in, and all is well. This might happen an average of once a month, seems more common in hot weather.
View 1 RepliesMy sons 98 F150 4x4. First off he had a head light go out and replaced the bulb. Then a day or so later his tail lights would not go out after he turned the truck off. I had him to replace the pressure switch(I think that's what it is called ) anyways, that didn't work. So now he takes out the fuse every time he turns off the truck, just so the lights will go out. But, when he puts the brake fuse back in, the brakes work fine, but his windows will not roll down. I am totally confused with what is going on.
View 1 RepliesMy tail lights have recently stopped working. When I use blinkers, they are slow, and don't blink if brakes are pressed. The brakes show as a very faint light that cannot be seen in day time. I turned on the hazards to look myself, and they started beeping. I called GMC support and it's too old for them to still know anything about it. I checked the fuses for the rear end and they are both working.
View 19 RepliesOk, so I'm working on a 2004 Hyundai Santa Fe, 93,000 miles. The vehicle runs great! So great that you cant get it to stop running!! The problem is intermittent and generally happens after the vehicle has been running for at least 3 minutes. I turn the key off and she keeps on running (not dieseling, but running at 340-450 rpms!) I have already removed the aftermarket remote start that was installed on the vehicle thinking that was the problem, it was not. Then I went to the ignition switch and unplugged that, also to no avail! I plugged my scan tool in and can communicate with the computer and view pids while the key is on. When I turn the key off, I should loose communication. When everything acting normal and the car actually shuts off with the key, I loose communication with the computer upon turning the key off. When I turn the key off and the veh. keeps running, I do NOT loose communication with the pcm. The only way to shut the car off is to step on the gas pedal. Otherwise it'll run at 400 or so RPM for an hour or so!!
View 8 RepliesThis started today, when I turn off the ignition and remove the key the radio stays on and the steering column does not lock. The guy at the dealership suggested spraying wd 40 into the ignition. No go.
2008 sonata.
My wife's 2001 Gran Prix has a problem with the ignition switch, or related to the ignition switch. Intermittently (more frequently in warm weather or when the car's warm) the ignition switch can't be turned back to the 'off' position all the way, meaning the key can't be removed from the switch. We've heard from several mechanics that there are a couple problems that can cause this, and in fact had the ignition switch replaced which did not solve the problem. I understand there is a connection to the transmission or gear shift lever that may also be part of this problem in some way. There can only be so many solenoids, switches, connections, etc, related to this, I'd like to fix the problem and avoid spending money unnecessarily.
View 2 RepliesI have had this ongoing issue with the rear running lights on my 337; the lights just don't turn on all the time. At first I thought the bulbs were burning out but they aren't. I can just knock on the tail lights and the lights come on and stay on. I assume that it's not a short or bad contact or they would flicker.
View 6 RepliesHaving issues with the rear tail lights will not shut off when you turn off the car? This all happened at the same time but I'm not sure what it is???
1. The traction control dash light comes on and stays on.
2. The cruise control stopped working.
3. The rear tail lights won't shut off even when the car is off.
TPMS light was on. It was the spare , added more air. Then checked the other tires, one was low too and added air. Now TPMS light stays off no matter what position the TPMS switch is in. The light used to come on when switch was in the 'wrong' position.
2005 GX470 66k miles
Car: 1992 GMC Sonoma 2.8L Manual Miles: ONLY 197,000 miles
Symptom: When ever I put the switch to OFF or VENT or HEAT the console starts to smoke (if the truck is on, of course). I noticed that I can hear the A/C running even when I put switch to one of the off positions.
Fixes: I have not had a mechanic take a look at this yet. They usually complain about other things when I bring it in. Little things like "your brakes are almost gone" (big deal, I don't need breaks because it is a stick shift) or "your tires are showing their metal wire" (big deal, I've had a front tire blow out before at 70 mph... on this same truck come to think of it).
Current workarounds: I keep the A/C on all the time even if I don't need it. I tried pulling the fuse and that did work, I can put the switch anywhere without the fear of smoke but it turns off the blower motor as well. If the blower is off then I'll have a hard time getting heat in the winter (Florida winters are very cold, down to the low 40s sometimes)
Feeble attempt to diagnose: I think I've seen card board be used as insulation inside the console before, I think whatever insulation was in there started degrade. I'm thinking that I'd like to track down the wires for and put the A/C on a different switch so I can still turn off the A/C and keep the blower going for the cold cold winter. Are there simpler solutions?
After I turn the car off the "PARK" light in the Dash stays lit for about 6 seconds after all the other lights have turned off. Is this normal?
I will advise, I have the parking brake set to auto and the car seems to be functioning normally.
Camry 2002 XLE 4Cyl. 2.4 ... When I switch ignition key on, there are no ABS and Brake light come on. Why is that happening? How to fix it? Normally, when we switch ignition key on, what are indicator light on?
View 6 RepliesWhen ignition is turned on the front defrost light blinks fo 30 second before the climate control screen initializes. Then the temp defaults to 75 degrees instead of the last teperatue / mode selected. Only dash vents blow regardless of mode selection. Dealer report was inoperative servo motor. my inspection, visual was that all three servo motors power and move to default position when battery power is restored. It seems that the command to the center servo motor is not correct.
View 1 RepliesFound a simple fix for unlit radio control buttons, cd player opening and center display buttons while the parking/headlight switch is turned on. As it turns out, if the wire connector directly behind the dimmer switch wheel located to the left of the steering wheel is accidentally disconnected, you will not have any backlight for your in dash cd player opening,radio control buttons or your emergency hazard flasher button.
The simple fix is to first remove the left side silver/gray plastic vent cover which is located directly to the left of your dimmer control knob. Place one hand on the top of the vent cover and the second hand at the bottom the vent cover and firmly pull directly out. Second step is to pull towards you the miniature dash panel that the dimmer switch wheel is mounted to.
The arrow tip guide on the miniature dash panel will pull away from 2 guide slots mounted to the main dash panel. Third step is to reconnect the disconnected white male plug to the back of the dimmer switch wheel's female connector. Last step is to push back the miniature dimmer switch wheel's dash panel until it snaps back in place, then snap back in place the silver/gray plastic vent cover until it clicks back in place.
It's a 1999 Toyota Celica GT 2.2L, about 190000 miles and I just replaced the transmission not too long ago. Here's what happened, I was sitting a light, the light turned green, and I pushed the gas and the car stalled. I put it in park, tried to turn it on, and it won't start, but is still turning over, making an awful whining noise. Not the transmission. Battery is good, windows, stereo, etc still work. Terminals are good. Everything is still connected, I just changed my oil about 1000 miles ago, still has oil. Has transmission fluid, actually has all it's fluids, no leaks. No check engine light or any other lights. She did not overheat, if anything was colder than usual, No water in my motor, everything LOOKS good, and I take good care of my car, so I'm really baffled. I just spent my savings on the transmission, I'm not a mechanic, I'm just learning to do things on my own.
View 19 Replies2002 F350 7.3 PSD. 192k miles.
From my understanding, a CEL is supposed to illuminate each time you turn the ignition ON as part of normal startup procedure.
I figured the previous owner must have pulled out the bulb to hide the fact that the truck had a few "issues" before selling it, so today I pulled out the gauge cluster and it looked as if the CEL bulb was a tiny LED soldered directly into the gauge cluster itself. There were a few serviceable/removable bulbs for things like turn signal indicators, high-beam etc... but the CEL did not have a serviceable/removable bulb.
I've been driving this truck and working through it's "issues" and fixing things as I go, but it keeps throwing codes without the CEL illuminating. What's going on here?
I thought the check-engine-light was supposed to illuminate each time the ignition was turned on, and that it would come on each and every time the vehicle registered a fault code in the ECU/PCM.
I have a 2001 Chevy S10 4.3L. The CHECK GAUGES light stays on, and the oil pressure gauge stays at 0. The oil is full, and the engine runs and sounds fine. I drove it about 5 miles with no change. Up until now, the gauge has worked normally. Could it be the sending unit?
View 2 RepliesLately when i take my key out of the ignition, my radio stays on and my car will chime with the door open as if the key was still in the ignition (and it lasts for different periods of time). I also have found it more difficult to get the key in and out. Obviously there is something wrong with the ignition.
View 1 RepliesThe fuel pump on my 1989 Mercury Grand Marquis is still running after turning the ignition off, causing the battery to drain. Replacing the fuel pump relay stops this from happening for a short time but it soon reoccurs. Is it possible there is a short in the ignition system, or is this a sign that the fuel pump is going out?
View 11 RepliesOk so I just got HID's put in the GLI and now when I take my key out of the ignition my heater fan stays on till I turn off my lights... does this sound normal?
View 21 RepliesThis just started today and when I turned off my car and removed the key from the ignition, the radio stayed on. Also, when I opened the door, the door chime came on as if the lights were still on and now I'm not able to lock the car or set the alarm using my key. I've read that some vw cars are wired so that the radio stays on after the car is turned off, but this has never been the case with my car. My main concern is battery drainage and being unable to lock and arm my alarm.
View 2 Replies