Ford - Explorer :: Grinding Noises When Depressing Gas Pedal / Placing In Reverse?
Feb 26, 2013
2004 Ford Explorer Sports Trac.
Just recently when driving down any road, when I let go of the gas to slow down from any speed, there is a funny grinding noise coming from under the truck, the Speedo drops fast, but the RPM`s stays the same. Then at around 30-40 km/hr, it just stops. When I place it into 4x4, I don`t have the problem. Also, again just recently, when I put the truck into reverse, I get the same grinding noise from under the truck. I have to putt he truck into 4x4, and then I put it in reverse for it to work.
I don`t have the problem going into drive. Both problems don't happen all the time, it will go away for 2-3 days then ill have problems for a few days after. I Took the truck to the shop and they said its the tranny so I replaced with a brand new one thinking that is the problem, but After the Tranny was replaced its still making all the same noises. The grinding noise sounds like "ice in a grinder" or to that effect. I'm not sure whats wrong, and I'm getting frustrated at my truck.
View 3 Replies
Advertisement
I have a 97 jetta trek that is having problems. Grinding noises from transfer , no reverse, hard to shift, loud winding noise. I think it's may be the trough out baring thing from what I'm reading.
View 6 Replies
My truck has grinding noises when i am making turns from a stop or at slow speeds. Also my 4x4 dash light keeps flashing several times both when I am sitting still and when driving. Neither my 4x4 auto or 4x4 high work but the low will work. Trying to pinpoint where I should look to fix them. I did replace the 4x4 control mod as an attempt to fix this.
View 1 Replies
2007 explorer makes a grinding sound I feel in the gas pedal upon acceleration. Also hesitates when acceleration on highway.....
View 3 Replies
I recently had an issue with my transfer case that caused me to have to replace it with a rebuilt one. I did so and am now having a different issue. I have a switch on my dash that shows Auto, 4 High, and 4 Low. Whenever I shift that switch over to 4 High from Auto the light changes and I hear a click sound. When I shift the switch from 4 High to 4 Low I get nothing. So, I took off the transfer case motor and switched things over by hand. When I shift the transfer case (manually by hand) over to LOW setting on the transfer case; it seems to run ok as if it is in 4 low, BUT, when I shift the transfer case (manually by hand) over to HIGH setting I can shift into every gear but seemingly have no reverse. Reverse seems to make a whirring grinding sound.
View 2 Replies
The last couple winter's we've experienced a significant "clunking" sound when placing the van from Park to Reverse. It doesn't do this by moving the gear shift from Park to Drive or Neutral. This only happens when the engine is cold and has been sitting for several hours. Outside temps below 35-40 degrees. Don't have the problem in Spring, Summer, or Fall. We have 177K miles. Transmission fluid/filter has been changed regularly by my mechanic according to Honda's instructions.
No problems with the transmission or engine since we've owned the vehicle, and we've been the only owners. No leaking found. Honda thought the problem could be a rear engine mount. Just had another local mechanic (I'm 65 miles from the nearest Honda dealer) whom we trust replace the Rear Transmission Mount. Still have the clunking noise, and you can really feel it too. It's been a great van for us, and we'd like to keep it another 50K, if possible.
View 6 Replies
I bought my girlfriend a 2000 Ford Focus with 150k Miles on it to drive for the summer in Oregon. The car is physically in great condition with no noticeable leaks on it. After a week or so of driving, my girlfriend complained that a couple of times she would be driving the car and while going up a hill "nothing would happen" sometimes when she punched the accelerator. I asked her if the engine revolutions were going up and if the engine made a "vroom" sound (to try to see if the transmission was slipping) and she said it did not.
On a long trip driving from Seattle to Portland, she was driving again and we were climbing a long hill and she suddenly complained that "nothing was happening" when she punched the accelerator. She panicked and pulled off to the side of the road quickly. There was no shaking or vibration. I did not hear the engine wind up when this happened... so I am assuming the tach was not going up when she depressed the gas pedal. I opened the hood and looked inside and seeing nothing obvious, I switched to the drivers' side. No codes were thrown. I drove the car up the rest of the hill and to a flat area and we let the car cool off for a few minutes. I drove the car for the next 75 miles to Portland without event. When we got to her grandparents house, I changed the spark plugs (which were pretty fouled up), and changed the fuel filter (which actually looked pretty new.) and it seemed to satisfy her for awhile. Being that I havent experienced the issue, I just assumed she is not used to driving a small hatchback with a fairly wimpy engine.
In the meantime I had the entire front end redone, control arms, etc and alignment because she had had a slight shake...which is unrelated here but i figured I'd mention it. So, the other night she calls me on the side of the road, slightly shaken. Her latest incident was as such: at the bottom of an on-ramp to the highway, she punched the accelerator and "nothing happened" when she hit the pedal. This time the check engine light briefly came on, and the "OIL" light came on. She was able to pull off to the side of the road somehow and then pull to an exit. She turned the car off and let it sit for 5 minutes.
Here's the weird part: She started it up and claims she put it in "Drive" and pressed the gas pedal and nothing happened and the car actually started creeping backwards. She hit the brake and turned the car off. She started the car and drove away 5 minutes later without incident and drove it 20 minutes home. She said her gas was very low when this happened, close to the gas light coming on.
She took the car to a reliable mechanic in seattle the next day, and they said there was no issues and they thought the car was actually in great shape. Unfortunately no codes were logged and no codes have been logged at all! My only other weird observation about the car is that the tach seems to fall kind of quickly after acceleration... almost comically compared to my volkswagen 1.8 which has a gentle rise and fall to it. It kind of bounces up and down but the ride is smooth. Random, but i figured i'd mention it
Should she just make sure to keep the gas level above low/empty?Should a fuel pressure check be on the docket? The previous owner claimed the timing belt only had 25k on it, but he could have been lying.
View 4 Replies
96 Aerostar Cargo 6 cyln. Auto.
There is a noise coming from what sounds like the rear passenger side wheel. Also, when you put it in drive and release your foot from the brake the van stays still. You have to push the gas to get it moving, like the brake is holding it. If you are going very slow on a flat surface the van will eventually stop instead of idling forward.
I have removed the wheel, it does turn hard. Pulled the drum (was very hard to remove). Had to move adjuster to remove drum. Cleaned inside, inspected the brake shoes, put drum back on, etc. I am pretty sure that brake is causing resistance. How to resolve it?
View 7 Replies
I have a 2005 Chevy Malibu, automatic transmission. When I put it in reverse and then press the gas pedal, I get a rather loud grinding noise for a couple of seconds. What is causing this, and is it doing any real damage? I have no other problems with the transmission.
View 2 Replies
Just noticed this the other day, when depressing my GF's 2011 Accent's brake pedal it made a low hissing sound, it would go away when you took your foot off the pedal, you would never hear this with the radio on, but it was enough to make me think it could be a concern.
Drove the car and it didn't affect the brake permormance, but the longer this goes, I can't imagine this being a good thing.
Car is 3 years old, and has 80-20 city/hwy driving under it.
View 7 Replies
I have a 2011 4 door and I drive it VERY LITTLE... I have a company truck so the car sits most of the time but when I get in it to drive on the weekends or whatever, sometimes when I hit the brakes it feels like they stick while depressing the pedal. Its nothing unsafe feeling just annoying and it forces me to kinda slam on the brakes. it seems to go away after I drive it a while, I have been attributing it to sitting so much but wanted to double check.
View 1 Replies
Happens when I quickly let off gas pedal and engine spools down. Just curious, hopefully no big deal but though I would ask. No maintenance lights on either.
View 6 Replies
I have a 2010 Santa Fe w/ ~25,000km. Yesterday, I noticed that after depressing the brake pedal (while driving) i hear a wheezing noise and then a click right before i come to a complete stop. When i am stationary, and i depress the break pedal, i hear the clicking noise but no wheezing sound.
I just took it into service today and even drove around the lot with one of the service techs and he says its normal. That the clicking noise is coming from the shifter release. I don't believe i heard this sound when i bought it, nor any other time till yesterday. The sound is driving me crazy! This cant be normal .... can it?
View 5 Replies
Looking for a fix for the annoying squeaking noise often happening when depressing the brake pedal?
Dealer "bled" the brake actuator...did not work, said I need new actuators for 2.5k.... 2007 LS 460L ....
View 1 Replies
I have Corolla 1.6 dual VVTi (year - 2009.), manual transmission, 1ZR engine, for about a year, ~50000miles on clock. About a month ago from a engine part it began to produce sound that can be heard on the accompanying recordings.
For these sounds is characteristic that:
- can be heard only while driving and depressing a gas pedal, its not heard when Im changing rmps while the car is stationary..
-only when engine is warm
-from about 1900rpm to 3000rpm.
-Toyota service is not useful, they fail to locate the source of the sound.
I submit sound recordings that I made by placing a microphone in the motor department.
[URL] ......
View 1 Replies
I just got a used low-milage 2013 LS460, and noticed that every time I tap the break pedal I hear a "clicking" sound coming from under the dash or hood. This seems to happen every time I touch or press on the brakes, at seemingly any speed. It sounds almost like an actuator of some kind... perhaps like the type which allows the transmission to shift out of park. Is this normal, or an indication of a an issue?
View 14 Replies
My husband had my tires replaced this week. I drive a 2008 Ford Explorer.The car has been running fine - no problems what so ever. Now there is a sound when I turn or go quite slowly. We live on a street that is 25mph so we go slowly to start. I hear the sound while going straight at slower speeds, but also when turning - almost at full lock. It is difficult to describe the sound - not grinding and not screeching. Its almost as if I turned the wheel too far. The sound when running straight is lower maybe rubbing. The sound seems to be coming from the right side of the car. I can also feel the sound, but it isn't a strong vibration. My husband drove the car and said he felt nothing (of course - just like TV repair man syndrome). All 4 tires were replaced. Hubby checked the nuts - says they were alright.
View 5 Replies
1990 Ranger 5 speed... The tranny has recently started making noises, first I thought it was the throw out bearing but I am afraid it is more than that. As I go thru the gears the trans makes rattling/grinding sounds: in 1st, 2nd, 3rd and 5th it is loud but 4th it is quiet. What might be going on inside the tranny....
View 14 Replies
I have a 2001 f250 4x4 about 4 months ago I replaced my pass. side front wheel bearing unit and here recently about 3 to 4 weeks ago I get a grinding/ rubbing sound when ever I turn right it gets louder the harder the right turn I do not seem to notice it as much moving at speed but driving through parking lots and slow speed right turns I can hear it. I have checked everything and nothing is loose and I can not see any signs or fresh rub marks on anything. I am getting to the point of just buying a new unit and replacing the one I just replaced. What my problem could be?
View 3 Replies
Over New Years I had to engage the full-time 4x4 button on my 2003 Explorer 4WD. Shortly thereafter I started noticing an airplane propeller noise that comes and goes with acceleration. It's pretty loud. It has not affected mileage or dashboard engine indicators. Tires still have 40% left, not them. Have I ruined an axle or something? There is a rear end whine that Ford says is endemic to this model and year, but I think they are not related.
View 1 Replies
Went on a 400 mile trip today and noticed some strange noises. The rig is an 06 F250 lariat, V10, Zf6, SC, LB and only has 43k miles. It behaves normally except when coasting down a hill at 65+ mph, and it doesn't matter if I'm in neutral or overdrive, it makes a feint grinding sound that gets louder as speed increases. Maybe grinding isn't the best word to describe it, I'd say a cross between humming and light grinding. As soon as I give it any throttle or put any load on the tranny is goes away. It's really freaking me out as I just got the truck a month ago and I know the ZF6's are almost bulletproof.
View 14 Replies
