Ford Wiring/Electrical :: 2011 F350 - Marker Lights Come On When Door Is Opened
Feb 8, 2014
I have a 2011, F-350, Lariat, Crew Cab, 4x4, 6.7 Stroker. I have asked if any way to disable the automatic feature that turns on the marker lights when opening a door. That has been sometime back and nobody seemed to know. I have checked with Ford and their response was that if the truck was equipped with the "Police Package" that it could be done.
There has to be a way to disable a relay, cut some wire or something to stop the lights from being turned on automatically. Maybe duct tape over the door switch?
View 2 Replies
Advertisement
2005 Super Duty 350. Getting ready to get my truck DOT-ed and I noticed the front amber side marker and parking lamps are not working (both in the headlight assembly). There is a fuse called "exterior lamps" that I believe these are on, the fuse is fine and all the rest of the exterior lamps on the truck work fine (all other markers, clearance lights and I.D. lamps on that same all inclusive circuit). Is there a special relay or something else I'm missing for these four front bulbs?
View 1 Replies
Two Issues....
1.My rear dome lights work when manually turned on. They do not come on when the door is opened. However, the front dome lights do.
2.The lights on my side mirrors turn blink when using the turn signal, and when hitting the lock/unlock/remote start buttons. They do not work when driving around with my head lights on.
View 7 Replies
Repaired my locks on my F350. Had the motor reversed. Before I figured that out I thought I needed to change the wires in the plug. Changed them and it didn't work, put them back and now the switch on that door does not work for the lock; however, all other switches work. What do I need to fix?
View 2 Replies
I am beginning to think that I need a whole forum dedicated to my trucks wiring issues ... I finally got my reverse lights to work but my newest issue Is that while driving tonight i lost power to my parking lights, my instrument cluster lights, and my heat control lights... everything still works inside (gauges all act properly but they won't light up) and i still have turn signals and brake lights, and headlights. I really don't know where to start with this one. I don't have an owners manual so i can't figure out what fuses to check or what relays to look at. It is a 2007 f350 diesel....
View 9 Replies
My steering wheel lights r out and need to know which wire runs power to those. also the led in my headlight switch is very dim.I checked the wiring and all the wires check out with high 11's and high 12 volts.i checked the volts at the led in the switch and it read 2.18 v.i have another light switch from the salvage yard and the same thing. which wire powers that light. also, the light only comes on when the key is in the on position or back for accessory. if i just turn the lights on it wont lite, only with key in ignition in those positions. truck is a 2000 f350 xlt dually.....
View 14 Replies
I recently purchased a 2011 Ford Edge with the My-Touch control system. I am planning on taking it to music festivals where I "camp" in and around my vehicle. Some of the lights go on every time a door or hatch is opened. As I am in and out of the vehicle day and night, is there a way to disable this feature?. I ask mostly because of lights bothering me and others, but am a little concerned about battery drain. It could be up to a week without starting or driving. I do turn the headlights off, but others (inside and out) come on.
View 10 Replies
I have a 1990 F-350 7.3 lariat crew cab. The tail lights fail to work but all the turn signal and brake lights work. I changed the light switch located to the left of the steering wheel but that didn't solve the problem. all the fuses under the dash appear to be ok to. Is there another fuse for just the tail lights.
View 6 Replies
I was replacing the dome light in my 06 Ford F350. I tested the light and it worked then while screwing it back in, the lights when out and then the radio. I suspect it may be a fuse, but have yet to find the culprit.
View 2 Replies
Looking for a schematic on this truck,standard cab diesel. I have a dead short on exterior lamp fuse. I have no tail lights, running lights, door ajar light is also on.
View 4 Replies
My interior lights won't come on when I open the doors.
View 3 Replies
My 96 F-350 Crew Cab driver rear door lock is stuck in the locked position. I don't have a cause but do now notice that the pass door lock will not operate with the lock/unlock switch. The rear solenoids seem dead. Front door locks are working.
I tried to put a 10-32 coupling nut on the lock riser and pull. The down position is now 1/8-1/4" higher than normal. This thing is really stuck and is really bad.
So before I start pulling the rear seat and trying to remove the door panel from a closed door; how I might unlock this door? It would be a lot easier to get the panel off if it is open.
View 2 Replies
The map lights in my 2011 Santa Fe GLS are supposed to come on whenever the door is opened or unlocked, and up until recently they did just that. But now they don't.
There is a button next to one of the map lights labeled "door" that controls this function, but I've pushed that on and off to no avail.
I can turn the map lights on manually, so the bulbs are fine. And the dome light (further back in the car) still does come on when the door is opened or unlocked. Just not the map lights.
View 3 Replies
I have a '95 dually and it has small yellow running lights on the rear fenders. The only time those lights will come on is when the headlights are on (or parking lights) and I put it in reverse. Not sure, but I would have guessed they are supposed to on when the lights are on and go out when the truck is put in reverse.
View 5 Replies
I have a 2000 E150 (Glavel Conversion) van and the interior lights do not illuminate when the doors are opened, although they used to. They also no longer turn on from the headlight dimmer switch. They will turn on individually if the manual switch at each light is pressed while the engine is running, so the bulbs and wiring appear to be working. I replaced the headlight switch with no noticeable effect. Is there a timing circuit that switches these on for a short period of time to allow illuminated entry that could have failed? If so, where would I find the module and how would I test? Relays and fuses look good.
View 1 Replies
I am working on friends 2011 Ford F450 Diesel He has lost Brake Lights and Turn Signal/Hazards.
Turn signals work in front of truck. Running lights are working fine.
Same goes when trailer is connected on truck. What could be the problem.
View 7 Replies
What I am trying to do it put in 2 led spot light for added backing up light. What i want to do is have them turn on when put into reverse but also have a switch i can use to turn them on when not in reverse. Just need to know what relay I need and if it even can be done.
I was also thinking of just taping into the wiring harness and adding a wire that goes to the spot lights and another wire that goes to a switch that I could turn on and supply power to the light when not in reverse (I know it will light the revers light also) but is it ok to do that?
View 5 Replies
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 Replies
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 Replies
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 Replies
Truck is up in the back country and has quit. It has two factory gas tanks, I can't hear either of the fuel pumps will come on when you turn the switch on. The problem started as an intermittent fuel starvation issue. Truck would act like it ran out of gas then pick up and go again. Switched tanks back and forth but it got worse throughout the day and finally will not start at all. I have listened to both tanks when the ignition switch is turned on but can not hear the pump come on for either tank (switching the selected tank with the switch on the dash). We went through some bumpy terrain just before the problem started so I am thinking maybe a wire might have come loose or got broke somehow. I am asking for wiring schematic so I can check for voltage in the correct place going to the fuel pumps. Both tanks are full of gas so for now dropping either tank is not an option.
View 8 Replies
