Ford Wiring/Electrical :: 2008 F250 - Power Mirrors Not Working
Dec 11, 2013
I have a new to me 2008 F250 XLT. Neither side on the power mirrors is working. The manual shows fuse number twelve on the passenger side fuse block is the one that controls this circuit. The fuse is good (continuity wise). What I need to know is what color is the wire that feeds power to the switch block on the driver's side door panel. Pulled it out of the door panel and wiring was intact and corrosion free. I need to find out if there is power there or is it an issue between the fuse block and the switch.
View 2 Replies
Advertisement
I have an early 99 F250. The a/c compressor stopped working. Have checked pressures, switches, freon etc. Found the switch in the dash is not getting power to send to the compressor. Where the feed for this switch is? I have checked all fuses, all good. The manual does not show a relay as being an a/c relay, so I am stumped without taking it somewhere now but I would like to avoid that.
View 7 Replies
I have an 89 f250 7.3. horn has not been working for the longest time the relay clicks but still nothing. It doesn't matter weather the key is in the on or off position. I know it might be a grounding problem because the cruise control does not work any more (even though recently it was working just fine). I didn't see any bad fuses.
View 6 Replies
I have a 2001 F250 with 7.3. We swapped the auto for a zf6 manual. We left the auto's shift position sensor tied to the frame and left in neutral. I did install a pcm from a manual transmission pickup. Also have the clutch position switch hooked up. I have an Edge Evolution CTS2 reprogrammer, and on the display the gear indication always shows P. I suspect that is why my cruise doesn't work. For interests sake, I tried manually adjusting the shift position sensor through all gears, and the reverse lights come on when in reverse but the Edge's display always shows P. My question is with a manual transmission, how does the pcm know that it is in gear? The only sensor that I am aware of is the reverse sensor on the zf6.
View 4 Replies
My 2008 F250's passenger side mirror will not fold/unfold with the switch. Also the motor continues to run when the switch is moved to fold/unfold the mirrors.
View 4 Replies
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 Replies
I have a 2004 f250 I just purchased a complete 2008 dash with steering column, wheel everything. I also installed the 08 door panels. I would love to keep the newer column and wheel. I'm not worried about the wiring. Just need to know the wiring colors or numbers for each truck to match?
View 2 Replies
I have a 2000 Ford F250 lariat 7.3 .... This vehicle has an aftermarket double din stereo pillar gauges for Pyro meter and transmission temp and has also had a snowplow attached but since re moved since I purchased it. It also has H ID headlights, which are run by the passenger side headlight connection.
The problem I'm having is that whenever I turn on the parking lights it is blowing the number eight fuse under the hood. Which is giving me no dash lights running lights parking lights or taillights. Initially the fuse would last for a few minutes and then burn out. I should also add that the trailer wiring harness doesn't work either and the driver side headlight will work sporadically.
View 7 Replies
Swapping the 08 mirrors onto older trucks. Which wire I should splice into in the door sill for the right turn signals?
I have an 08, with the tow mirrors/turn signals integrated. On the passenger side, the turn signal does not work. I'm not getting power at the plug.
I traced the wire colors from the headlight and taillight turn lamps and tried splicing into the same colored wires under the passenger door sill. This didn't work (I did get it to work on park lamps though, just not the turn signal). I can't find wiring diagrams.
View 7 Replies
I'm replacing tow mirrors on my 2004 F250 with 2008 mirrors. Both are factory Ford mirrors. Need wiring diagram since connectors and wires are different. They both have power mirrors, turn signals, heated mirrors, but are not power retract or fold.
View 1 Replies
2002 f250 v10 4x4. Truck will loose all power...
View 10 Replies
I have a 2002 F250 7.3 PSD and the drivers side power window will not go up. How do I troubleshhot it. Is it the switch, motor, fuse? The other three windows work fine.
View 2 Replies
a buddy of mine has a 12 F250 that he bought new and is ready to add power locks and windows. I know we can get some aftermarket kits for both but he wants to use the factory door panels and switches from a power setup. I am sure we could use the factory window regulators and panels and just use and aftermarket wiring and flush mount switches. I had figured the wiring might be in the jambs but not in the doors, but when I pulled the trim back, we didn't find any extra wiring going to the rear doors, its a crew.
View 1 Replies
I have a 2000 f250 super duty. Right now the only problems with it are:
1: When i press the door lock switch the passenger door lock will click and come down about half way but the door still is unlocked. in order to lock it, you have to press the latch down by hand.
2: My key won't unlock or lock the driver's side door from the outside, however it works to start the truck and open the passenger door.
3: When i bought the truck the previous owner game me a handheld wireless unlock and lock button. The little black thing with an alarm button, and it doesn't work either, i replaced the batteries and still nothing. So what would be the solution to fixing all of this?
View 2 Replies
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 Replies
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 Replies
Tried to start my truck after sitting for 2 days in sub zero weather. wouldn't crank. pulled the batteries and charged them over night. Tried to start it the next day-wouldn't crank but the starter relay clicked. Was going to pull the starter and check it but decided to replace the relay first. replaced it and tried to start but now have no power to the cab-nothing comes on. I've checked the batteries with a load tester and they are ok. I've checked the fuses and they seem to be ok. when I tried to start it and the relay clicked there was a loud buzzing noise that seemed to be coming from under the dash. it has done this before but this time was louder than usual. I live out in the sticks so taking it somewhere is a last resort. It is a 1999 7.3 with 290000 miles.
View 14 Replies
Well I've had her just 1 week, used, and today I turned it on and the power is out on the A/C n Heater /Fan Control ASSY. It worked the last 900 miles from FL to OH. And today worked this morning, but 2nd time I got in the truck today there was No Lights in the Air Control Assy. I didn't get an Owners Manual, so what fuse to check.
View 3 Replies
What Relay switch controls these.
View 3 Replies
I just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 Replies
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 Replies
