Ford Wiring/Electrical :: 2008 F150 - Battery Light On And Charging Gauge Drifting Down To The Left
Dec 19, 2016
Start out, drive about 20 minutes, get on the Interstate and the battery light comes on 2008 F 150 5.4L 4X4 - 57K miles..... get to my destination, went about 20 miles, turn around to come home, without turning the truck off because of the battery light being on and I notice the charging gauge drifting down to the left, get back on the Interstate and the wipers are slowing down and lights on the dash are dimming.....go around 15 more minutes I lose all lights on dash, wipers, defroster everything, charging gauge is now pegged all the way down to the left and the truck is starting to act up running like crap so I barely make it off the Interstate and call a flatbed, I guess I was about an hour into the trip ..... battery is only about a year old and it started fine that morning and the day before when it was about 12 degrees ...... dealership had the truck, just gave me a call and said they can't find anything ?? ..... never a days problem since I bought it new in late 07' ....
View 5 Replies
Advertisement
I have a 1999 Ford F150 6 cyl. 4.2, 2 WD with 160,000 miles. Replaced the battery May 2010.
Today battery light came on. Battery gauge did not look like it was discharging. Had battery checked they said it was a little low but OK. Then they continued test and tried to check alternator, test stopped and they said something wrong with alternator most likely.
I took alternator out and had it bench tested. They said it was OK, putting out 98 amp on 95 amp alternator. They said check wires, grounds, harness, connections. Checked connections and wires as much as possible, reinstalled alternator, light still on.
Have not checked fuses yet. Was told to start vehicle, disconnect positive battery cable and if engine continued to run alternator was good, if cut off alternator was bad and to replace. Should I try this and is it true?
What is the part on the fire wall that is between the alternator and the battery that the wire connection runs through? Can it be bench tested/checked?
View 5 Replies
Okay, my 1986 f150 with a 351w (non-feedback carbed) Has no lights on the cluster, and none of the gauges work (haven't tested the speedo yet, truck is not registered yet).
I also have a minor issue with the turn signals... Fronts work, no rears. The left turn indicator light on the dash does not come on but the right turn one does. All my "primary lights" (markers, tail, headlights) work fine. I have not yet tested the brake lights.
Fuses all look good, truck did have some roof leaks. I've done some research, does this sound like the dreaded voltage regulator issue for the gauges?
My assumption for the left turn indicator light is that there is a replaceable bulb in the dash (probably blown), is that right? Rear signals might be wiring (PO installed his own trailer wiring) or bulbs? haven't gotten that far into it yet...
View 8 Replies
Problem with my 2006 F150 5.4 4x4... Voltmeter spikes, battery light comes on, grinding noise as 4x4 engages on its own then everything returns to normal after about 60 seconds. Took to Ford who replaced the alternator and battery, still doing it so they replaced the alternator again...they checked the wiring and replaced some other misc parts and don't know what the problem is. The problem occurs once every few days, after only a few minutes or after a few hours, completely random.
View 6 Replies
I've been trying to trace down a issue with the airbag warning light flashing. The seatbelt light is flashing also. The airbag code is 53. If i search it i get the front crash sensor..I replaced it with a new sensor and pigtail. Other than that the search leads me to believe it could be anything.
I've checked and clean every connection that i could find. I haven't removed the center console yet to check the module. I did buy the truck last fall as a winter/work truck. The issue started a couple of months after i started driving it. Not sure if the module would just go bad.
View 13 Replies
98 Ford Expedition 4.6L, 198K Miles, New Battery, Alternator replaced, but battery light still on and after a minute charge indicator drop until left indicating zero, temp gauge on top while temperature motor is cold, gas gauge drop, when lights are turned on oil light turn on also check engine both for a few of seconds.
View 2 Replies
My fuel gauge indicates empty at all times. The first suggestion I received was to replace the sending unit in the gas tank. I did that but the gauge still indicates empty.
I tried the HEC Dealer test mode and I now know that FUEL reads 255. Which should be an 'open' state. The connector near the fuel tank does appear to be making good contact, so my suspicion is a broken wire somewhere between the rear of the truck and the front.
I tried following the wire on it's way towards the front of the truck, but I quickly loose sight of the wire as more branches enter into the wiring harness. Where does this wire end? Does it terminate in the engine compartment, at the instrument cluster, somewhere else?
I just can't figure out how to narrow down where the break in the wire might be. Or am I chasing down the wrong root cause?
View 1 Replies
I have a 1998 Ford F-150. It has an issue with starting sometimes. The truck won't start with a fully charged battery but when I hook it up to a charger, the truck starts normally. It was going to get the wheels aligned today and when the mechanic went to drive it off the ramp, it wouldn't start. I told him to put a charger on the battery and it started right up. Without the charger it just cranked over and wouldn't start. It doesn't do this every time I go to start it only occasionally. The mechanic had no idea what the problem was and has never heard of this kind of situation. I'm assuming it is an electrical problem but I'm not an expert with engines. The battery was fully charged at the shop and the battery is a year old.
View 4 Replies
My neighbor's kids truck battery drains from full charge to "no start" in 1-2 days. 1999 Ford F-150 w/ 4.6L engine. He has already.....
1) Replaced the Battery.
2) Replaced the GEM module.
3) Replaced the Turn Signal Relay.
He did all this before I looked at it....
I checked the following....
1) Truck off, doors closed, hood open... Amp meter shows 3.6 amp draw. When 1st hooked up, shows 4.2 amps... after a while drops to 3.6.
2) To isolate the draw, we pulled fuses while checking current draw at battery.
a) Under Dash fuse Panel. (Yes, with door closed) We remove fuse #15 "stop lamp switch, speed control, brake shift interlock, ABS, PCM,GEM, RABS test connector". (Really... couldn't be more stuff?)
b)Under the hood is another fuse box (drivers side). We remove Fuse #103. "Junction Block Battery Feed".
3) Found that if we remove the #15 fuse under the dash with the door opens, all interior lights flash on/off at about 1 second intervals... weird.
4) Again, another weird one... with the fuse #15 removed and door closed, the "ABS" indicator and some other indicators and dash lights are staying partially lit... not fully lit.
5) The only "aftermarket" stuff i can see is a dealer installed trailer brake system. Wiring looks professional and disconnecting it does not remove the amperage drain.
I'm hoping that one of you wizards will give me the "slam dunk"... if this happens, it must be that. Can I be so lucky? And, yes. I have my own '06 F-150 that i absolutely love. 6-cyl., manual trans, stripped down without even power door locks... my kinda technology.
View 8 Replies
I have an 08 F150 5.4L with about 68k miles. When the temperature is 40 degrees or colder it will not crank. I had the same issue with my 2005. I can turn the key and nothing, lights, radio and everything work. The dash display has dashes all the across for the miles, temp and compass. I have found out that it doesn't matter if I leave the key forward in the run position or try to crank, it won't do anything.
Battery is good and no problems with the truck. After the key is in and I give it anywhere from 15 to 60 seconds you can hear an electrical click real faintly and see the red security light come on and then the computer display comes on and then I can start with no problem? What could this be? My dealership has no clues and I can get it to act up because after I get it there it starts with no issue. The remotes work fine and this issue was why I got rid of my '05.
View 2 Replies
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 Replies
My center brake light went out a month ago. Thought it was the bulb so replaced that, still didn't work. Checked the fuse and its not broken so my guess was electrical?
Hasn't come on once that I know of but I was randomly walking behind my truck and the light was on. Truck was off lights were off and key wasn't in the ignition.
Went and turned my truck on and turned the lights on and the cbl stayed on. When I switched my lights off it went out and stayed out.
Now I'm definitely thinking wiring but not sure where to start fixing?
Oh and it's a 1990 F150 XLT
View 2 Replies
I've searched all over and can't seem to find the answer. When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct?
View 8 Replies
I have an 06 F150 XLT and lately the map lights blink when starting and driving. This does not occur every time but it sure is a problem when driving at night. What is causing this and hopefully a minor repair.
View 1 Replies
Why the parking brake light in my dash stays on, 2004 F150. Fluid in master cylinder is full, has no signs of leaks anywhere.
View 2 Replies
Looking for a wiring diagram for a F-150 XLT LARIAT 5.8L 4BBL, all the books I have looked at show the wiring for this year with fuel injection and this truck came with a 351W with a Holley 600 4BBL, I have a few wire's in the engine compartment that melted away all the insulation, they are located close to where the harness passes the firewall before the ignition module. Is this a common problem on old models ?. Need a clear copy of the correct diagram for a f-150 1987 with carburetor, how I can get a copy so I can fix this problem before it gets worse.
View 3 Replies
My truck has been sitting more lately, which means up to a week without starting and running. Each time this happens I run into a dead battery. And I mean dead. I've charged it full and then used the truck no problem.
We did a test where we unhooked the negative terminal wiring clamp and ran a meter to check for amp draw. We did this by touching the meter leads to the negative post clamp (unhooked) and to the negative post on the battery. It gives a reading of ~1.5 amps. Trying to figure out where the drain might be.
We'll jut pull each fuse to see if we find the electrical area drawing the amps.
2008 F350 V10 CC SB DRW 4x4
View 8 Replies
I have a F250 towing a Big trailer and the RV folks have told me that while the factory seven prong will supply power to the RV, it would take a days to charge the RV batteries. So...
1) Does the connector not really significantly charge the batteries?
2) Is there a faster way to charge the RV batteries while driving?
3) Would instructions something like I found at How to Charge Two 12 Volt Batteries on an RV Towed by a Ford F-150 | etrailer.com work?
4) Would #3 eventually tax my alternator so badly that I kill it?
5) Would #3 fry the electronics in the trailer?
I'm trying to charge 2 6-volt marine deep charge batteries in series.
View 8 Replies
2005 Ranger XL 2.3L 5 speed 2WD 305,000 miles. Alternator has about 100,000 miles on it.
Battery light came on about 0400 and 50 miles into my daily 90 mile drive to work, made it to work. After the truck cooled down for 3 hours and I got time I checked the battery voltage 12.6VDC and started the engine and the system is charging at 14.2VDC with no battery light on (battery light out when cold). Serpentine belt looks good, dry weather.
Other than alternator nearing end of life and being warm is there anything else that may cause battery light to come on.
View 2 Replies
I bought a truck recently and I am attempting to get the alternator to charge. A previous owner hacked up the wiring pretty badly. We found that they had connected the voltage regulator to the horn relay for some reason. Anyway, I am trying to get it rewired and have searched existing threads for info and I thought that I had the wiring sorted out, however it is still not charging the battery.
The alternator has been tested and works. The voltage regulator is new. This is how it is currently wired.
Regulator A Terminal --> Battery side of started solenoid --> Alternator Batt Post
Regulator F Terminal --> Alternator Fld Post
Regulator S Terminal --> Alternator Sta Post
Regulator I Terminal --> Empty
Regulator body --> Radiator Support --> Alternator Ground Post --> Neg batt
When running, the battery is showing about 11.8 and slowly dropping as it runs. The truck has an ammeter in the dash, however it looks like it is no longer connected. Does it need to be connected in order for the alternator to charge the battery?
View 4 Replies
I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.
1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)
2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.
Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....
View 10 Replies
