2008 Escape, while driving, the doors will lock/unlock themselves like crazy. Sometimes it's 20 times, others it's 100 times. Sometimes it won't happen for a day or two, sometimes it's every time I drive it. When the car is off, remote works fine, car stays locked. Where to start?
View 1 RepliesI am installing power windows and locks in a 1990 F350. The donor truck was a 90 F250.
I got everything switched and all is working except the passenger side door lock switch.
The drivers side lock switch will unlock and lock both doors.
The passenger side will unlock the passenger and drivers side door but will not lock them.
I replaced the passenger side switch with a new one. Upon further checking, I found out that it was a window switch. It still unlocked the door but would not lock it.
Is there a difference between window power switches and door lock switches?
I can ground a pink w/ orange wire on the passenger side switch to the door frame and the switch will work. I have ohmed checked pretty much everything.
Could the drivers side power lock switch be bad. I have looked over a schematic and it looks like the circuit may pass threw the drivers switch to ground.
As I asked before is there a difference between a window and lock switch?
I have a 2008 expedition. Just the other day this problem arose. When hitting unlock on the drivers door switch no function happens. If I hit unlock on the passenger door switch doors on lock as they should. The drivers door will unlock using the keypad on the door. Also it will not unlock from the key Fob but I will hear the relays clicking as if it should. I checked the fuse it's good. I searched online I found some videos showing the wires in the driver side rocker and kick panel and that's a place where alarm companies tap into the factory wires.
Sure enough a few connections or poor so I redid them. However the problem remains. I don't know if this is something as simple as just the switch is bad, or is it something else like a relay to unlock. How to verify the switch is functioning with a multimeter? ... I just learned from Ford that the passenger side switch is identical to the driver side. So my next diagnosing and install the passenger side switch that I know it's functioning in the driver side and see if the problem goes away. If the problem goes away obviously the switch is no good. If the problem remains it's something in the wiring up to the switch. I'll report back and let you know because if it's the wiring
I have a 2005 excursion with about 112,000 miles and last week all 5 doors decided to stop working on me when trying to lock or unlock with the remote or the door switch. I do hear a sound like something is happening just right of the fuse box. I did a little research and found that this is a wide spread problem. I did order 4 of the 5 actuators and I replaced the drivers door but nothing yet. Do they all have to be replaced in order to work? Or is it most likely something else causing this? Just trying to figure it out before I install the other actuators or take it in to a shop.
View 1 RepliesSo, I got my explorer about 3 months ago and it has never locked, the door ajar light was always on and I fixed that by using some WD-40.
Now that the door light is off, the explorer beeps once when i lock it using the key fob but it doesn't actually lock. When I use the lock switch in the rear (by the spare wheel tools) it will lock and unlock. The driver's door lock switch won't lock or unlock, the passenger will unlock but won't lock.
Stock alarm system.
B1602 PATS Recieved Invalid FMT/Key CD
P0753 Shift Solenoid A Electrical
P0758 Shift Solenoid B Electrical
P0740 Torque Converter Clutch Fault
P1760 Pressure Control Solenoid A Short
p0305 Cylinder 5 misfire Detected
P0316 Engine misfire Detected on Startup
The Trans will unlock while driveing for a few seconds then lock back up and drive fine, it seems to be worse over the past couple days. It is no different cold or hot. I also noticed the head lights dim and the voltage on my scanner drops to around 12 volts when the trans disengages. When it is not acting up it drives and shifts perfect.
I have checked a few grounds that were visible and cleaned battery connections. There has to be a wire harness or ground that I am missing some where that is bad?? The misfire code has been fixed, not related.
I have this problem with both the key fobs provided with my 2007 UK spec. Santa Fe 2.2crdi: The fob works only intermittently to lock/unlock the doors. I have replaced the CR2032 batteries, and the red light on the fob works as well. Is there a sensor that needs cleaning/adjusting?
View 1 RepliesMy landlord's daughter is having some electrical problems with her car, and we're trying to troubleshoot it ourselves. It's a 2006 chevy cobalt with 66,000 miles on it. Here are the issues: 1) The radio's display does not work (you can't see the time or the station). The radio's volume, on/off switch, AM/FM control, and tuner don't work. So, basically, it's stuck on one AM station and she can't do anything about it. 2) Her power locks occasionally lock / unlock themselves when the vehicle is running. 3) This is the most important safety issue right now - there's no power to the pump for her windshield washing fluid. What could it be? Fuses? Wiring? Something else?
View 4 RepliesWhile on a recent vacation, my sister-in-law, trying to do a good thing, washed my clothes but neglected to remove my FOB for my 2008 Prius. I returned home only to find that the FOB would not lock/unlock the doors.
I replaced the battery (the old one was reading only .03vDC) but still no remote lock/unlock.
How can you tell if the FOB is working since there is no "little red light" like I have seen mentioned by other owners
It looks as if the FOB should be watertight, is it? Any way to clean inside the FOB in case there is some corrosion? What should be my next step?
Remotes suddenly will not lock/unlock doors or open trunk.Background - guy left key in ignition in 'on' position overnight. Also thunderstorm with very near lightning strike during that time.Battery dead in am, though after jump start it was not necessary to reset radio, clock, etc.Neither remote works.Checked the door lock fuse - looks OK, but did not replace it as there were no spares in the spare slots.Where else to look for the problem?
View 2 RepliesAfter going through a car wash my Prius has started locking all doors when I start the car and unlocking driver's and passenger front doors when I turn it off. Kind of wondering how this could happen, but since I like it that way I don't really want to change it back. Is there a way to toggle this and can I change it so that rear doors and hatchback unlock also when I turn the car off?
View 7 RepliesMy Chevy Venture 1998 power lock doors will unlock but won't lock. Checked fuse and is ok.
View 13 RepliesMy doors are locking and unlocking while driving down the road.
View 9 Replies2002 super crew. My key fob will unlock the doors but it will not lock the doors even though lights blink and horn honks like it is locked. Also on all doors the unlock buttons works but all of the lock buttons do nothing. At first I though just maybe had 1 bad lock but why would all the doors start doing this at once?..
View 7 Replies2008 Escape, while driving, the doors will lock/unlock themselves like crazy. Sometimes it's 20 times, others it's 100 times. Sometimes it won't happen for a day or two, sometimes it's every time I drive it. When the car is off, remote works fine, car stays locked. Where to start?
View 2 RepliesI have a 03 Excursion. The door lock buttons work perfectly to lock the doors but nothing happens when I try to unlock with the buttons on the doors. However the key fob and keypad entry work flawlessly. I was sure it was the drivers side master switch but replaced it with a brand new one today still doesn't do anything, no sound from actuators or any relay click nothing but the mechanical click of the contacts in the switch.
View 2 RepliesLet me start by saying electrical is something I really have no knowledge of....(never used any kind of an elec meter and don't have one) simple, Pos-grd and fuse, NP. I really don't want to fry something in these expensive new seats w/my normal trial and mostly ERROR!
The 08 (drivers) seat has 4 wires in the input clip.
GRN-RED (heavy gauge)
BLK-PURP (heavy gauge
BLU-RED
BLK-WHT
and my 01 whip out of the floor has a 3 wire setup.
GRN (heavy gauge)
BLK (heavy gauge)
BRN-BLU
I can wire PS side seat from fuse box and ground it NP. It only has a 2 wire set-up in the new seat.
My camry has been giving me this issue for last couple of weeks. The door will lock correctly using the key fob and by pressing the buttons on door of drivers + passenger. But while trying to unlock only the driver lock unlocks.
The car does not has any starting problems and I even tried a secondary battery to see if its a battery issue. The issue remains the same even the car is started or moving i.e. doors will only lock and will not unlock.
Someone said the Relays might have a problem and I was able to locate the two relays in the fuse box but I am not sure which one to pull out.
My FOB doesn't work locking/unlocking my '06 prius. I use the embedded key to lock. When I want to lock it, I lock it from the inside.
a. I know the door lock actuator motors are not bad because I was able to lock it from the inside using the lock/unlock switch on the driver side door panel.
b. I checked the voltage on the AUX battery. It read 12.4v. So that is not the problem.
c. Key fob battery strength is good (I see the red LED every time I use the remote).
d. I don't have a SKS system so no switch exists to enable or disable the SKS under the steering.
Wondering if there is a way to program the headlights and running lights so they DO NOT come on when I open the doors?? And to turn OFF when the switch is off??
2014 super duty lariat
My daughter picked up an 08 Base, option package #1 yesterday. It has 166K miles and checked out okay by me (coolant moving by inverter pump, no signs of water in spare tire well...etc.). The car only had 1 key fob (non-SKS) wit no spare key or fob. The key is uncut but the remote starts and runs the car. The remote will not lock or unlock the doors.
The first thing I did was replace the CR2032 battery with no change. It still operated the car but not the locks. I noticed that the little red light wasn't coming on when pushing the buttons and found the red panic button was stuck. Took care of that and thought all was good until I tried to lock and unlock the doors again. Nope! Light comes on, works in slot to start the car, but not the locks.