Ford Wiring/Electrical :: 2003 E250 - 4 Way Flashing System Replacement?
Nov 24, 2012
'03 E250, standard van with RKE if that's pertinent.............
Looking to replace the on-board 4-way flashing system with Whelen strobes and looking to have the column mounted button be the on/off switch for that power supply. I have a schematic from a '97 E250 (almost identical FWIW) which I can post the pin out, test procedure and EVTM version of the hazard portion of that Multi Function Switch if that's useful.
I know it would be far, far less complicated to control the Whelen via a separate switch but this above reversible mod would be somewhat cool IMHO.
View 2 Replies
Advertisement
'03 E250 connector C3136 located by the left lower B Pillar---have lost power to the Brown wire which seems to be designated as Circuit 124.
Which fuse controls that circuit? I have a factory EVTM but I can't find what fuse to check. And here I though I knew something?!
View 2 Replies
I have an '88 E-250 with no power to accessories. Was starting fine but now no power to anywhere but the ignition light that is below and to the left of the steering wheel. No headlights or radio. Checked my fusible links but just visual so gotta get the meter out there and start poking around. Only thing I did different before it started this was take loose the ground wire holding strap that holds the middle of the ground wire to the body but I didn't think this was an actual ground spot but I could be wrong.
Earlier I reinstalled that strap and took out the ignition switch. I noticed that the radio turned on when I turned the key to acc. but not when I turned it to run. Would the headlights run through this ignition switch on the column? I have power to the yellow wires coming into the switch and the ground is good. I checked the fusible links I could find out in the engine bay and all tested good but could've missed some. Fuses in the box looked good but don't know if there is a master fuse box for bigger fuses but I don't see one.
1988 E-250 5.8 auto.
View 9 Replies
On a 2008 E250, Where is the dome light wire and what color is it? To use with an omega security system.
View 4 Replies
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
View 8 Replies
I just replaced my Wiper motor last week and noticed something strange. For the last year or so when I turn on the key to start the truck, once in a while my radio, gauges, and other electricals such as windows wouldn't work for a bit, anywhere from a couple seconds to maybe as much as a couple minutes. Since my wiper motor was on the fritz, I pulled the fuse and the radio,gauges,ect. wouldn't work until the WTS light went out, then everything worked just fine, even after I started the truck and the glow plugs come back on.Since I replaced the motor everything works as soon as i turn the key. Coincidence? Or could one of the internal relays on the motor being stuck cause that?
View 5 Replies
Noticed one of my cab lights was out. Cant imagine replacing it is too bad. But, wheres a good place to find replacement? Probably get 5 for when the rest go.
View 6 Replies
I wired up a new set of halo projector headlights. I put in load resistors for the led marker/blinker bulbs I purchased. I tested the resistors and after a few minutes I hooked up the halos for the headlights into the running lights. Noticed the resistors were pretty hot, burned my hand. I then accidentally touched the hot marker wire to the ground. That popped the fuse under the hood. But now that same side blinker. Same wires I grounded that also got hot. Blinker stays on, light on dash too. Checked blinker relay it's fine.
View 3 Replies
I've been trying to trace down a issue with the airbag warning light flashing. The seatbelt light is flashing also. The airbag code is 53. If i search it i get the front crash sensor..I replaced it with a new sensor and pigtail. Other than that the search leads me to believe it could be anything.
I've checked and clean every connection that i could find. I haven't removed the center console yet to check the module. I did buy the truck last fall as a winter/work truck. The issue started a couple of months after i started driving it. Not sure if the module would just go bad.
View 13 Replies
2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
View 5 Replies
2000 F350 CC DRW 4X4. There's a 3 light bar lamp mounted here that needs replacing. Plastic mounting -Grote 10-7016-01 PCC.- Can't find one. looking for replacement PN? like to have LED.
View 1 Replies
I have a 77 ford truck with a 351 ,the ignition system keeps shorting out, killing spark. If i replace the starter solenoid, it works for a while, then goes out again. I have replaced 4 solenoids this month. What could be shorting the solenoid out? Had the truck for 8 yrs. now, never had a problem with it till now. It has a mallory dist. it was in when i bought it.
View 7 Replies
We have a broke (aren't they all?) college kid living with our family who's parents have basically signed off on him. He has this car and so far it has been reliable. He was driving on the freeway last week and he said it began to smoke, so he hot to the side and turned it off. He then had it towed to a neighboring street off the freeway and came for my advice. Unfortunately he knows little about cars in general, so he couldn't tell me if the smoke was steam or how it smelled or anything. I told him I should go back with him and check the oil before he attempted to restart it, I am guilty of blowing up my own transmission in college bc I thought my dad was checking the oil and he thought I was checking the oil...well, no one was...anyway, I got him to call his insurance and we found out he had coverage, so instead he got it towed here. I checked the oil after it got here, there was little oil in it, but, it would also not start. It would not even attempt to turn over. Putting it into accessories did nothing.
My husband then got involved and cleaned off the battery connections and then we attempted to jump it. After about an hour, we gave up, and took the battery in, and they said it was the original battery so we replaced it out of our pocket. Put that in the car and now we only get a dash light of a car with a key that is red and flashes. No lights, no radio, no anything else but an annoying red flashing light. Turns out he has an intelikey system. The dealership over the phone said they have to reprogram the key fob and car so they need both to do so. That's an initial charge of $175 and another call to the insurance for towing...which I'll have to pay. But, if I do that and that doesn't cure all that ails it and it doesn't start...then what? Is there anything else we can try first or does that intelikey hold the access to everything on the car? My husband has some mechanical skills but not a lot of time to search and troubleshoot and hasn't worked on a nissan before, his job is very demanding right now, but given direction can do a lot himself.
View 2 Replies
I have a 2002 Toyota Corolla. The issue I have been having is that the headlamps and tail lamps are flashing randomly. They flash for about 10 seconds then stop for about 30 seconds then flash again. There is also a clicking sound(similar to the one made when the hazards are on) heard from the inside. I know it is not the hazards because when I turn the hazards on their is another, separate clicking noise made and the flashing lights are brighter. I have attempted to reset the computer, pull out and put back in all fuses to no avail.
View 16 Replies
I own a 2014 F-150 XLT 3.5 L 6 cyl Twin. Saturday afternoon I tried to start the truck once and it didn't start like it normally does. It started on the second try, but the A/C didn't work and I got a "Starting System Fault" warning on my screen. When I shut the truck off, it would not start at all. All the lights and gauges worked, just no start.
Had to tow it to Ford Dealer, where the service department had already closed for the day (of course). Today it was determined by the service department that the Body Control Module had malfunctioned. I was told that the tech tapped on the control module and the truck started. Now waiting two days for a replacement part to come in. Luckily, I'm just under 36K miles and three years. Is this a common occurrence?
View 2 Replies
I'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
View 12 Replies
03 F250 Instrument panel does not work. Have checked all fuses with a meter. Have already fixed broken wires from the OD button on shifter handle. and also the alternator is not charging. I need wiring diagram that shows the wires coming out the back of the fuse box so I can see if the fuse holder is burned out......
View 8 Replies
My work truck is an 03 F250 5.3L. My flashers recently stopped working. I turn them on, and they will work anywhere from 5 seconds to a few minutes, then either blink rapidly and shut off, stay solid for a few seconds and shut off, or just shut off. I push the switch off and on again, and the cycle repeats. All my other lights and turn signals work fine with no issues.
This wouldn't be a huge issue, but where I work I need the flashers a lot. The truck has a bar light and siren/pa system wired into it, but not to the lights or anywhere near that. I can't say exactly how it's wired because I didn't install it, but I followed the wires and they don't go under the steering wheel where I would assume the relay and wires for flashers would be.
What sounds like is wrong? I wouldn't think it would be the relay because then I would think that I would be having problems with more than just the flashers. So I'm not sure if there would just be a ground issue or if it's the actual switch that turns on the hazards. Also, there are no lights that are burnt out.
View 6 Replies
Just bought a used, 03 F-150 SuperCrew Lariat. Having some minor electrical issues. While cleaning truck, I discovered a red wire coming into engine area on passenger side of vehicle. Wire has a built in 40amp fuse but isn't connected to anything. What this is for/ should be connected to???
View 1 Replies
My 03 expedition has a blinking air bag light. It blinks 4 times and then 2 times and repeats. I have googled this and found 42 = Primary Crash Sensor #2 Feed/Return Circuit - Open
How to fix this? Where to look, what to test, what the service manual says?
View 6 Replies
My vehicle would not turn over and we could tell it was fuel related. The fiel pump relay has burnt through the motherboard of the fusebox. It is my understanding that this cannot be fixedand another fusebox must be installed. I have been to many junkyards in my are looking for it to avoid the dealer prices..all of the expeditions that we have found locally have already had the fusebox pulled. Any other vehicles that this might be interchangable with? My friend has an 01 expedition..would this work?
View 1 Replies
