On my 2002 Ford Escape my high lights do not illuminate. I changed the light but it does not light up.
On the dashboard, the little blue light does not turn either to indicate that the switch is high.
Is this a relay, where it is placed? Otherwise what would be the problem?
I *think* I'm having trouble with the alternator on my 2002 Navigator with the 5.4L DOHC engine.
A year ago in Feb 2014 the alternator quit charging. I thought the headlights were a little dim, but when the radio turned itself off and then the heater fan did the same, I noticed that the alt light was on. Then the engine shut down about 1.5 miles from home.
I'd heard of war stories about rebuilt alternators so I sprang for a brandy new one. I also got a voltmeter that fits in the cigarette lighter so I can monitor the system voltage. All seemed good and the new alternator put out 14.2 to 14.5 volts. Except that the battery never seems to be fully charged. If I check the battery voltage with the engine off it typically reads 11.9 to 12.2 volts. I had Interstate Batteries check the battery. They thought it was okay, but offered to put a new battery in to keep me happy.
Six months and 8,000 miles later I'm up in Ontario back country (on vacation - no tools in the truck) and I notice the engine idles at 900 RPM instead of the usual 650 +/- RPM. Oh-oh, I also notice the volt meter is reading 11.9 volts and drops a tenth about every 10 miles.
Found a shop that was open and they installed a rebuilt alternator and it was putting out 14.2 to 14.5 volts. All was good (except for my wallet!).
Now, here we are six months and 5,000 miles later and the rebuilt alternator is struggling to put out 12.5 volts this afternoon. At a steady 50 MPH with the cruise Control on, the radio, and the heater fan on low, the voltage is bouncing between 12.2 volts and 12.7 volts.
Now to my questions:
1. Shouldn't an alternator put out 14.2 to 14.5 volts all the time? Not just when the alternator is new?
And
2. Is there anything on my truck that could be killing these alternators? Or am I just unlucky in the alternator lottery?
Sometimes the headlights won't come on unless you move the steering wheel up & down.
View 1 RepliesI have a 2002 Toyota Corolla. The issue I have been having is that the headlamps and tail lamps are flashing randomly. They flash for about 10 seconds then stop for about 30 seconds then flash again. There is also a clicking sound(similar to the one made when the hazards are on) heard from the inside. I know it is not the hazards because when I turn the hazards on their is another, separate clicking noise made and the flashing lights are brighter. I have attempted to reset the computer, pull out and put back in all fuses to no avail.
View 16 RepliesI have a 2000 E150 (Glavel Conversion) van and the interior lights do not illuminate when the doors are opened, although they used to. They also no longer turn on from the headlight dimmer switch. They will turn on individually if the manual switch at each light is pressed while the engine is running, so the bulbs and wiring appear to be working. I replaced the headlight switch with no noticeable effect. Is there a timing circuit that switches these on for a short period of time to allow illuminated entry that could have failed? If so, where would I find the module and how would I test? Relays and fuses look good.
View 1 RepliesAny COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 RepliesI've been wondering about this issue for about a year now. I haven't torn out the stereo to see if the wiring is jacked up (came with the truck). When I have the truck running and the radio is on I pull the light switch and the radio turns off, then turns back on...... The radio also buzzes when the truck is running, kind of like it has a bad ground but I've checked the grounds and powers and all is good.
View 14 RepliesHere's the breakdown. I have a '95 Ford F150 that I bought the previous year and it has been nothing but a problem. The most recent problem is the attempt to turn on the headlights. I will pull the plunger to turn on the headlights but I will only get the parking lights and when attempting to turn on the high beams I still get nothing. The only way that I get any sort of lighting is if I pull on the turning stick (almost like doing a manual override on a tripped wall plugin). Now here's the kicker. I still have parking lights, brake, tail, cab, and dash lights. Winter in quickly approaching and the nights are already getting dark, pretty soon the days will be just as dark.
View 3 RepliesOk, I admit this isn't on a Ford, it's my old man's 1970 AMX, but it's an odd electrical problem we can't figure out. The front right blinker works fine when the headlights are OFF but when the headlights are on it doesn't blink. The other three work as they should. He has tried new bulbs, ohmed and voltage tested the sockets. Ohm reading was around 1-2ohms and voltage was 9v.
The voltage also fluctuated when the blinker was on but when you put a bulb in it didn't blink. He has noted the bulb on the passenger side is brighter than the other side. He's trying to get it ready to take to Pigeon Forge next weekend for a car show and I 4.5 hours away. What could be going on??? Could a bad headlight switch cause this? Bad socket?
The truck has a 300 straight 6 and runs pretty good until you turn the headlights on or anything that uses current for that matter ie. Radio , Fan ect. But is worst with lights. Just got the truck last week and can't seem to figure this one out.
View 1 RepliesAfter replacing my battery cables (Pos and Ground),My Truck stalls every time I turn on the headlights. The truck stays running with the parking lights on or if no lights on at all. Could I have mixed up the 2 positive accessory wires?
View 13 RepliesSeries 7 , 82 model, light switch drama. I think they worked fine before I had removed the dash but it has a multi plug that I never interfered with but the truck had been in water and the contacts on it were rusty and I know the unit has been submerged.
Anyway, the unit clicks and sort of buzzes and the headlights and side lights flicker and the rear LED lights barely flicker, need to watch closely. I have cleaned and used contact fluid all connections under the truck as I washed it the other day too.
Brake lights work perfectly, indicators too, just associated lights from this pull switch. The unit gets hot, not burning hot but hot enough not to hold for too long. So, thoughts ?
Need new unit ?
Touched something ?
Water ingress finally making unit fail ?
88 f250 5.0 when my headlights are on my driver side blinker doesn't work at all but with lights off it does also with the blinker on the dash blinks with the blinker also I'm lost. Also when I turn my key on the windshield wipers wanna turn on
View 2 RepliesSo I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesWondering if there is a way to program the headlights and running lights so they DO NOT come on when I open the doors?? And to turn OFF when the switch is off??
2014 super duty lariat
I'm working on the '73 F250 in my sig. I'm not very skilled when it comes to electrical work and I don't want to hack things. First up is I'm wiring a 7-way trailer connector with brakes. I need to tap into the brake light switch at the pedal, what is the cleanest way to do this? I was thinking of sticking a blade connector in the existing connector or adding a plug pigtail.
Also in the future I will (hopefully) be doing a 3G alternator swap and adding relays to keep my headlights from shutting off. I'm looking for suggestions on a junkyard or aftermarket fuse block that will accommodate the circuit breaker for the trailer brake, the 100 amp fuse for the 3g swap and the relays for the headlights.
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 RepliesThe problem is that my headlights on my 1996 Cherokee Jeep XJ switch off unexpectedly. I can get them to come back on for extended periods by fiddling with the control knob in certain ways. This is the kind where you pull out of the knob to turn the lights on, and can rotate the knob to brighten or dim the dash.
If I pull a bit harder on the knob, the lights come on; if I twist this way just so, then off they go; that sort of thing. The fuses are fine and the contacts in the fuse box are clean. High beams work great no matter what (these are controlled from the steering column). I think the problem is at the control knob.
Now, how can I keep my headlights on when I turn them on every time without having to fight the gremlins? I think my next move is to remove the bezels and so on as best I can and get in there with some proper contact cleaner to see it's just built up gunk causing havoc. If that fails, or if that's a bad idea, what's next?
The tail lights do not turn off- the head lights do not turn on. every fuse was pulled and still the tail lights stayed on. Headlight switch was swapped out with a new one to eliminate it with no different result. No modifications known to have been made to the electrical system. This thing did spend a lot of time in NY state, so corrosion is likely. But this does not explain how/why the tail lights would stay on even if the headlight switch was off... IMO this would have to be an ignition switch issue.
View 9 RepliesI have an 02 Ranger 4.0 4WD and I have been doing a lot of research to try and figure out why the battery light comes on and off. I was driving the other day down the highway and the battery light came on and voltage gauge dropped. Drive a little further and it goes off, go down hill light comes on, up hill it turns off. (The up and down hill part was probably just a coincidence!) ...
Next day I pulled the alternator and had it tested at O'Reillys and it passed no issues. Yesterday I was driving again the light comes on my way home from the store and stays on for about 3 miles til I got home. Turned my truck off, restarted it later, no light. Today I drove around for a while and about 45 minutes into my driving around the light comes back on and voltage gauge drops and after about a mile it turned off. I stopped by O'Reillys again to have them test the complete charging system and everything passed. On the way home, light comes on again!
So, question is, the battery light was not on when they tested, will that make a difference in the outcome of the tests? I'm guessing not??? Belt looks good, no bad connections that I have found, battery was good...what am I missing? Battery light is still on and voltage low when I start truck after 1.5 hours of being home. Also, I get no magnetism from the alternator when the battery light is on.
I have a 02 f350 can not get power to a/c compressor have power at high pressure And low pressure can run a hot wire and ground to compressor and it works.
View 1 Replies