Ford Wiring/Electrical :: 2000 F150 - Power Cuts Out When Attempting To Start
Jan 24, 2016
2000 XLT F150 4.6 - New starter & solenoid(s), battery cable & fuse links good.
When i turn the key, I hear one single click and the power cuts out entirely. I can't attempt a second start or turn on the lights or have any power going through the truck until I disconnect the battery for about 10 seconds then reconnect. Electrical becomes live again, then when the ignition is turned the electrical cuts out again. I do hear a single cluck at the starter (probably attempting to engage when it cuts out) and a clunk right at the inside fuse box (drivers side).
View 6 Replies
Advertisement
I am trying to hook up my power door locks to my command start. I am having trouble getting it to work. Ive tried a number of relay diagrams from the12volt.com. I've tried actuators/reverse polarity and it blows both my factory door lock fuse and the fuse I have supplied to the relays. Ive also tried 5 wire alternating 12 volt positive door locks, and 3 wire positive door lock combinations. Both of these combinations the relays click back and forth fine with the actuators unhooked, when I connect the actuators the doors unlock with the factory switch but when I unlock with my remote it blows the fuse. How to properly connect the actuators?
View 3 Replies
Have and intermittent condition with my 1996 F-150 4.9. AC runs and then cuts out (compressor not turning). I lose 12v to both side of high side switch. I tried to troubleshoot using a schematic in Haynes Foprd Pickups and Bronco for 92 and later F-Series/Bronco, but the color code for the wiring doesn't match up.
On my truck, there is 2 wires from the low side pressure switch which mates to a socket with only 1 wire. I have 12 volts at switch terminal on dash control, and it seems that I have an broken wire behind the dash, as I can get it to operate again when I move the harness around. Where can I get a schematic of this part of the circuit?
View 5 Replies
Having problems with their door locks attempting to activate when turning the ignition key? If so, how can I correct it or make repairs.
View 4 Replies
My 85 f150 5L is parked to far in into my alley.. the last time i saw my keys i moved it up to water the plants that it was tucked almost on top of.
ive been looking for the keys for 2 months.. the truck isnt being driven at all but i think my neighbors are getting mad at it being out so far.
I can get in the engine bay, and i have jumped the starter on our big trucks at work before.. but what wires do i have to join to put the ignition into the run position?
View 9 Replies
I have an 08 F150 5.4L with about 68k miles. When the temperature is 40 degrees or colder it will not crank. I had the same issue with my 2005. I can turn the key and nothing, lights, radio and everything work. The dash display has dashes all the across for the miles, temp and compass. I have found out that it doesn't matter if I leave the key forward in the run position or try to crank, it won't do anything.
Battery is good and no problems with the truck. After the key is in and I give it anywhere from 15 to 60 seconds you can hear an electrical click real faintly and see the red security light come on and then the computer display comes on and then I can start with no problem? What could this be? My dealership has no clues and I can get it to act up because after I get it there it starts with no issue. The remotes work fine and this issue was why I got rid of my '05.
View 2 Replies
Once I had driven for about 15 minutes and the truck set for about 5 minutes. Then it would not start. Another time, I drove for about 20 minutes and it cut off while driving in a parking lot. I have had 2 different shops take a look at it and they cannot duplicate the problem. They have run a bunch of diagnostics and tried their selves but it always starts for them.
View 2 Replies
I have a need for a 12-volt signal to indicate the engine is in start or run mode. I would like to pull this from the engine compartment but I'm not sure what would be the best or easiest way to do this. The 12-volt signal is not used to power anything so it will draw very little current. I have a 94 F150.
View 8 Replies
I have a 1998 Ford F-150. It has an issue with starting sometimes. The truck won't start with a fully charged battery but when I hook it up to a charger, the truck starts normally. It was going to get the wheels aligned today and when the mechanic went to drive it off the ramp, it wouldn't start. I told him to put a charger on the battery and it started right up. Without the charger it just cranked over and wouldn't start. It doesn't do this every time I go to start it only occasionally. The mechanic had no idea what the problem was and has never heard of this kind of situation. I'm assuming it is an electrical problem but I'm not an expert with engines. The battery was fully charged at the shop and the battery is a year old.
View 4 Replies
I have a 2011 Ford F150 FX4, And for a while now i have been having a issue with the gauge cluster.
while driving once in a while all of the gauge cluster turns off then back on within a couple of second. all the lights for the traction control, air bag, engine.... turn on and then turn off just like when you start the truck.
The issue only last for a couple of seconds. And it can go for a day before doing it. Brought it to the Ford dealership and they said unless the gauges are completely off there is nothing to go on by. Also once in awhile the check advancetrac comes on and will be off next time i start the truck. Same thing dealer said there was no codes and nothing then can do.
I checked all the connection at the fuse box, gauge cluster. and no issues. had the truck running and try wiggling all of the connectors, in the truck one by one with no success in duplicating the issue.
Also notice that once in awhile my signal light will flas extremely slow when having the blinker on.
View 3 Replies
I have a 1993 F150 that I have been working on. I have a set of complete doors off of a 1989 with Power Windows and locks hung on the truck and need to figure out how to power them up. Looking for access to a wiring diagram that will identify the colors of the wires in the doors. I don't care about the auto down and all of that ... not going to try and convert the whole truck with comp and all ... just want to make these function.
View 14 Replies
My neighbor's kids truck battery drains from full charge to "no start" in 1-2 days. 1999 Ford F-150 w/ 4.6L engine. He has already.....
1) Replaced the Battery.
2) Replaced the GEM module.
3) Replaced the Turn Signal Relay.
He did all this before I looked at it....
I checked the following....
1) Truck off, doors closed, hood open... Amp meter shows 3.6 amp draw. When 1st hooked up, shows 4.2 amps... after a while drops to 3.6.
2) To isolate the draw, we pulled fuses while checking current draw at battery.
a) Under Dash fuse Panel. (Yes, with door closed) We remove fuse #15 "stop lamp switch, speed control, brake shift interlock, ABS, PCM,GEM, RABS test connector". (Really... couldn't be more stuff?)
b)Under the hood is another fuse box (drivers side). We remove Fuse #103. "Junction Block Battery Feed".
3) Found that if we remove the #15 fuse under the dash with the door opens, all interior lights flash on/off at about 1 second intervals... weird.
4) Again, another weird one... with the fuse #15 removed and door closed, the "ABS" indicator and some other indicators and dash lights are staying partially lit... not fully lit.
5) The only "aftermarket" stuff i can see is a dealer installed trailer brake system. Wiring looks professional and disconnecting it does not remove the amperage drain.
I'm hoping that one of you wizards will give me the "slam dunk"... if this happens, it must be that. Can I be so lucky? And, yes. I have my own '06 F-150 that i absolutely love. 6-cyl., manual trans, stripped down without even power door locks... my kinda technology.
View 8 Replies
Looking for a wiring diagram for a F-150 XLT LARIAT 5.8L 4BBL, all the books I have looked at show the wiring for this year with fuel injection and this truck came with a 351W with a Holley 600 4BBL, I have a few wire's in the engine compartment that melted away all the insulation, they are located close to where the harness passes the firewall before the ignition module. Is this a common problem on old models ?. Need a clear copy of the correct diagram for a f-150 1987 with carburetor, how I can get a copy so I can fix this problem before it gets worse.
View 3 Replies
I noticed tonight, that my driver's side outside rear view mirror is no longer defrosting. I can't really say when it last worked, we haven't had much bad weather here, and just in the wildest case that it may be relevant, I just recently had my master cylinder replaced under the Ford Recall. Why a mirror would stop defrosting?
View 2 Replies
OK, this one has me stumped...I have a 93 F150, 302 with the E4OD. I know the transmission needs to be rebuilt (probably a bad pump). When I put it in reverse, the engine will start to bog down and will die unless I put it back into park or neutral.
If the engine does die, the fuel pump does not prime with the key "on" and the engine obviously will not start. If I let the truck sit for about an hour, the fuel pump primes like it should and the engine starts right up. The fuel pump shut-off does not trip and all fuses are good.
View 5 Replies
My 1999 Ford Ranger XLT, 6 cylinder, auto trans, with 134K miles has an electric problem. When I turn the key to the 'on' position, all dash lights show normal, headlights work, radio plays, etc. But when I turn the key to the 'start' position, all electric power is lost. The power remains lost until I disconnect and reconnect the battery ground wire. After reconnecting, I again have power until the key is turned to the 'start' position. I was able to jump start the truck, so I assumed I needed a new battery. I bought one a week ago, and was back to normal until today. The truck started, I drove 4 miles to the grocery store, and then I found myself back to square 1 (i.e., the no-start situation).
View 3 Replies
I have a 2000 f250 super duty. Right now the only problems with it are:
1: When i press the door lock switch the passenger door lock will click and come down about half way but the door still is unlocked. in order to lock it, you have to press the latch down by hand.
2: My key won't unlock or lock the driver's side door from the outside, however it works to start the truck and open the passenger door.
3: When i bought the truck the previous owner game me a handheld wireless unlock and lock button. The little black thing with an alarm button, and it doesn't work either, i replaced the batteries and still nothing. So what would be the solution to fixing all of this?
View 2 Replies
Here's the breakdown. I have a '95 Ford F150 that I bought the previous year and it has been nothing but a problem. The most recent problem is the attempt to turn on the headlights. I will pull the plunger to turn on the headlights but I will only get the parking lights and when attempting to turn on the high beams I still get nothing. The only way that I get any sort of lighting is if I pull on the turning stick (almost like doing a manual override on a tripped wall plugin). Now here's the kicker. I still have parking lights, brake, tail, cab, and dash lights. Winter in quickly approaching and the nights are already getting dark, pretty soon the days will be just as dark.
View 3 Replies
I got my first truck today and it's a 1988 Ford F-150 and it runs great! The only issue is that the speedometer doesn't work and I won't be able to register it until it does. I was wondering what I can try out to maybe fix the issue and if not, how I would replace it. Every other gauge works, it's just the speedometer that isn't. The needle doesn't move at all it just sits at a 0 all the time.
View 8 Replies
I have been trying everything to get my speedo working on my Ford. It didn't work for 3 months after I got it then I decided to put some gear oil on the cable. This made it work for about 200 miles then it would only work with the clutch in and then not at all. I've replaced the speed sensor(not one on rear end the thing the cable goes into), and the gear that goes on the end of it. If I hook a drill up to the cable the tach moves. Could the cable be stretched or just needs some speedo cable lube?
View 5 Replies
I have a 1999 Ford F150 6 cyl. 4.2, 2 WD with 160,000 miles. Replaced the battery May 2010.
Today battery light came on. Battery gauge did not look like it was discharging. Had battery checked they said it was a little low but OK. Then they continued test and tried to check alternator, test stopped and they said something wrong with alternator most likely.
I took alternator out and had it bench tested. They said it was OK, putting out 98 amp on 95 amp alternator. They said check wires, grounds, harness, connections. Checked connections and wires as much as possible, reinstalled alternator, light still on.
Have not checked fuses yet. Was told to start vehicle, disconnect positive battery cable and if engine continued to run alternator was good, if cut off alternator was bad and to replace. Should I try this and is it true?
What is the part on the fire wall that is between the alternator and the battery that the wire connection runs through? Can it be bench tested/checked?
View 5 Replies
