Ford Wiring/Electrical :: 1993 F150 - Power Up Window And Locks Conversion
Aug 6, 2013
I have a 1993 F150 that I have been working on. I have a set of complete doors off of a 1989 with Power Windows and locks hung on the truck and need to figure out how to power them up. Looking for access to a wiring diagram that will identify the colors of the wires in the doors. I don't care about the auto down and all of that ... not going to try and convert the whole truck with comp and all ... just want to make these function.
View 14 Replies
Advertisement
OK, this one has me stumped...I have a 93 F150, 302 with the E4OD. I know the transmission needs to be rebuilt (probably a bad pump). When I put it in reverse, the engine will start to bog down and will die unless I put it back into park or neutral.
If the engine does die, the fuel pump does not prime with the key "on" and the engine obviously will not start. If I let the truck sit for about an hour, the fuel pump primes like it should and the engine starts right up. The fuel pump shut-off does not trip and all fuses are good.
View 5 Replies
Headlights work, done and door lights also work. Radio, door locks, and window controls do not. Car will no longer start and it doesn't seem to be the battery or starter, but I may be mistaken.
View 2 Replies
I am planning a swap in an Excursion from the automatic to the manual transmission.
How will I need to modify the wiring harness to make sure everything still works?
Things I can think of that will need addressed:
Harness for the brakes (Neutral Safety Switch?)
Harness for the clutch pedal
Cruise control harness differences?
Back up switch wiring?
View 6 Replies
I have a 95 powerstroke and every powerstroke I've seen stock on youtube has a bell instead of a buzzer when key is in ignition or lights are on. The buzz is VERY annoying but I'm bad for leaving lights on so I need something. any way to change buzz to a bell?
View 1 Replies
a buddy of mine has a 12 F250 that he bought new and is ready to add power locks and windows. I know we can get some aftermarket kits for both but he wants to use the factory door panels and switches from a power setup. I am sure we could use the factory window regulators and panels and just use and aftermarket wiring and flush mount switches. I had figured the wiring might be in the jambs but not in the doors, but when I pulled the trim back, we didn't find any extra wiring going to the rear doors, its a crew.
View 1 Replies
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
View 7 Replies
I have a 2011 Ford F150 FX4, And for a while now i have been having a issue with the gauge cluster.
while driving once in a while all of the gauge cluster turns off then back on within a couple of second. all the lights for the traction control, air bag, engine.... turn on and then turn off just like when you start the truck.
The issue only last for a couple of seconds. And it can go for a day before doing it. Brought it to the Ford dealership and they said unless the gauges are completely off there is nothing to go on by. Also once in awhile the check advancetrac comes on and will be off next time i start the truck. Same thing dealer said there was no codes and nothing then can do.
I checked all the connection at the fuse box, gauge cluster. and no issues. had the truck running and try wiggling all of the connectors, in the truck one by one with no success in duplicating the issue.
Also notice that once in awhile my signal light will flas extremely slow when having the blinker on.
View 3 Replies
2000 XLT F150 4.6 - New starter & solenoid(s), battery cable & fuse links good.
When i turn the key, I hear one single click and the power cuts out entirely. I can't attempt a second start or turn on the lights or have any power going through the truck until I disconnect the battery for about 10 seconds then reconnect. Electrical becomes live again, then when the ignition is turned the electrical cuts out again. I do hear a single cluck at the starter (probably attempting to engage when it cuts out) and a clunk right at the inside fuse box (drivers side).
View 6 Replies
Looking for a wiring diagram for a F-150 XLT LARIAT 5.8L 4BBL, all the books I have looked at show the wiring for this year with fuel injection and this truck came with a 351W with a Holley 600 4BBL, I have a few wire's in the engine compartment that melted away all the insulation, they are located close to where the harness passes the firewall before the ignition module. Is this a common problem on old models ?. Need a clear copy of the correct diagram for a f-150 1987 with carburetor, how I can get a copy so I can fix this problem before it gets worse.
View 3 Replies
I am trying to hook up my power door locks to my command start. I am having trouble getting it to work. Ive tried a number of relay diagrams from the12volt.com. I've tried actuators/reverse polarity and it blows both my factory door lock fuse and the fuse I have supplied to the relays. Ive also tried 5 wire alternating 12 volt positive door locks, and 3 wire positive door lock combinations. Both of these combinations the relays click back and forth fine with the actuators unhooked, when I connect the actuators the doors unlock with the factory switch but when I unlock with my remote it blows the fuse. How to properly connect the actuators?
View 3 Replies
I noticed tonight, that my driver's side outside rear view mirror is no longer defrosting. I can't really say when it last worked, we haven't had much bad weather here, and just in the wildest case that it may be relevant, I just recently had my master cylinder replaced under the Ford Recall. Why a mirror would stop defrosting?
View 2 Replies
I have a 04 explorer I have been trouble shooting and the master switch works all but the passenger window wont work it at all but all the others work fine, its not the switches replaced both, the passenger window switch will roll the window down but not back up. I checked for power there is power to the switch in the passenger side, the ground is good. I can pull the plug off the motor and hook a jumper ground up and the switch will make it go back up. I have been working in body shops for 40 years and now this is the first one to stump me
View 7 Replies
I have a 2002 F250 7.3 PSD and the drivers side power window will not go up. How do I troubleshhot it. Is it the switch, motor, fuse? The other three windows work fine.
View 2 Replies
Blower, seats, locks, blinkers stopped simultaneously, abs and airbag light came on. The internet suggested it was the ignition switch, I changed it to no avail. The horn, wipers, 4-way flashers, headlights, taillights, and brake lights all work. Is my wife correct in suggesting we replace this 140,000 mile pile of rust?
View 5 Replies
I just bought a used 1999 F-150 Supercab (V6) less than a month ago. As used, of course, I received no warranty of any kind. Yesterday, I found I could no longer roll down the driver's side power window. Whenever I push the button, it makes a clicking sound in the fuse box. The problem is, the fuse for the power windows covers both driver and passenger sides, but the passenger side works fine.
I did notice that there is a black plug called a Relay that affects the Auto Down power window feature. Since the driver's side is the only window with Auto Down, I'm hoping maybe that relay just needs replaced, and everything will magically work again??? I'm NOT a car/truck nut - I don't even know how to change my own oil.
I recently had a power window motor on my 1995 Thunderbird replaced. I'm hoping I don't have to do that already, just a month in to my F-150. But on my T-Bird, there was no clicking in the fuse box when I tried to window.
View 9 Replies
My landlord's daughter is having some electrical problems with her car, and we're trying to troubleshoot it ourselves. It's a 2006 chevy cobalt with 66,000 miles on it. Here are the issues: 1) The radio's display does not work (you can't see the time or the station). The radio's volume, on/off switch, AM/FM control, and tuner don't work. So, basically, it's stuck on one AM station and she can't do anything about it. 2) Her power locks occasionally lock / unlock themselves when the vehicle is running. 3) This is the most important safety issue right now - there's no power to the pump for her windshield washing fluid. What could it be? Fuses? Wiring? Something else?
View 4 Replies
Having problems with their door locks attempting to activate when turning the ignition key? If so, how can I correct it or make repairs.
View 4 Replies
Here's the breakdown. I have a '95 Ford F150 that I bought the previous year and it has been nothing but a problem. The most recent problem is the attempt to turn on the headlights. I will pull the plunger to turn on the headlights but I will only get the parking lights and when attempting to turn on the high beams I still get nothing. The only way that I get any sort of lighting is if I pull on the turning stick (almost like doing a manual override on a tripped wall plugin). Now here's the kicker. I still have parking lights, brake, tail, cab, and dash lights. Winter in quickly approaching and the nights are already getting dark, pretty soon the days will be just as dark.
View 3 Replies
I got my first truck today and it's a 1988 Ford F-150 and it runs great! The only issue is that the speedometer doesn't work and I won't be able to register it until it does. I was wondering what I can try out to maybe fix the issue and if not, how I would replace it. Every other gauge works, it's just the speedometer that isn't. The needle doesn't move at all it just sits at a 0 all the time.
View 8 Replies
I have been trying everything to get my speedo working on my Ford. It didn't work for 3 months after I got it then I decided to put some gear oil on the cable. This made it work for about 200 miles then it would only work with the clutch in and then not at all. I've replaced the speed sensor(not one on rear end the thing the cable goes into), and the gear that goes on the end of it. If I hook a drill up to the cable the tach moves. Could the cable be stretched or just needs some speedo cable lube?
View 5 Replies
