I have no left rear signal or brake lights. The right side works fine and both left/right tail lights work fine, just no left brake or signal. I checked for broken wires and can not find anything. 1992 Ford E50 7.5L.
View 1 RepliesI just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
I have a unique problem with my newly acquired 71 F250. The left brake does illuminate when the brake is pressed but when the right turn signal if activated the left brake light does come on. The left flasher light also does not work. All other rear ligh function are normal. I am assuming I have a short or a wiring issue just wanted to know if there was any common item that might be know about this topic. The bulbs are all new. The reverse lights do not work either but pretty for sure its unrelated.
View 2 RepliesI just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 RepliesI am working on friends 2011 Ford F450 Diesel He has lost Brake Lights and Turn Signal/Hazards.
Turn signals work in front of truck. Running lights are working fine.
Same goes when trailer is connected on truck. What could be the problem.
Turn signals quit working on my 2006 E-150. Swapped out the relay under the dash and it did nothing. Also noticed the brake lights aren't working. The headlights and taillight a are working. I pulled the fuses under dash for the lights and they tested ok. I did notice the flasher relay was making clicking sounds intermittently even when not touching anything.
View 3 Replies1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 Replies2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 Replies85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 Replies2010 F-250 14,000 miles, gas engine with Knapheide utility bed. Tilt wheel has been kept in the up position from day 1.
The problem:
No rear brake lights.
No high mount brake light.
No rear turn signals.
No rear hazard flashing lights.
All trailer lights work.
All other truck lights work.
Things checked: Fuses all OK. Visual inspection of multi-function switch. Looks clean. Brake switch at brake pedal has power on one wire. Jumpered the other wire-no brake lights.
I need to haul my trailer and am nervous when I see a Savannah, GA metro police car.
My brake lights don't work. Turn signals, tail lights, hazard flashers work, but if I hit the brake, nothing happens. What could possibly be the problem? Could there be a wiring issue?
View 7 RepliesI did lower the steering column, onto the seat. Also lowed the dash and the wiring. Does it sound like the Multifunction switch could be bad? I can put it in drive, so I don't think it's the brake light pedal switch, that's bad.
View 14 Repliesi have an 85 f150. the brake lights are not working. i checked the bulbs, both filiments are working. i have running lights, turn signals, and hazards, just no brake lights. i am confused as to why i have everything else except brake lights. need to figure out what to do next to figure this out.
View 14 RepliesMy new body style f150 , all the rear lights have quit working.whats really odd is at first it was the left signal then the right then everything. All bulbs are good. If I pull the bulb out and test for voltage i get voltage, I replace the bulb and test again.....NOTHING. I took the rear ground off and cleaned it up, test fusses . Don't know what to do from here.
View 7 RepliesI discovered today that I have no brake lights on my '02 Excursion. The center brake light works fine, but the two in the taillights don't come on. Stopped and bought new bulbs on the way home and replaced both, but the ones I pulled out were not blown. Checked the fuse - OK. Taillights and turn signals both work fine.
View 3 RepliesFirst off my driver side brake light with stop working. I took it apart to try and find the short. In the process I shorted out all my running lights tail lights and brake lights and turn signals I think also. While I was looking for the short, turn signal wire from my tail light touched the frame and grounded out and that's when all the lights died . My tail lights are some cheap trailer lights without reverse lights. I pulled headlight switch from another Ford truck I have. On the harness connector that connects to the switch which wires should read what when I test with a voltmeter?I checked the fuses in the power distribution box under the hood and they were good. Truck has a flat bed so I don't know if that matters with the wiring, I suspect it's different then a normal bed truck. Wiring on the bed is old, maybe from 94. I am unexperienced with electrical.
View 3 Replies85 ford ranger 2.3 efi .. My brake lights still aren't coming on. According to the Haynes manual, the wire that runs from the stop light fuse goes from there to the hazard flasher and then to the brake light switch. Since I have checked everything else, is it possible that the hazards are causing a break in the connection?
View 4 RepliesI just bought my first Ford its an 1996 f250 powerstroke, and I am having issues with it. Every time I push in the brake both blinkers come on and tail lights and upper parking lights on cab, and when I turn on a blinker everything flashes.
View 8 Replies