Ford Transmission :: Transmission Leak Around Vacuum Which Wobbles Like It Is Loose
Nov 1, 2016
I have a transmission ('86 Bronco C6 transmission without OD) leak around the vacuum which wobbles like it is loose and around the square bolt behind the kick down assembly. What do I need to fix these leaks? I am planning on changing the pan gasket as well because it also has a leak. I will change the filter while in there if it looks bad. It probably has not been changed since '86.
Also, can I use a solvent caustic degreaser for cleaning the outside of the transmission. I have been trying to clean the bottom of the truck for painting and even point blank pressure washer will not remove the grease caked mud and I need something stronger to remove it.
View 6 Replies
Advertisement
I have a 97 ford f150 v6 2wheel drive. I was driving to work when l heard rattling in the engine like something came loose when I stopped to check my transmission fluid was pouring out drained out in 2mins tops. What do you think it could be?
View 6 Replies
I read posts here about the shimmy/wobble some owners are experiencing with their GTIs and TSIs. I never had it for 10,000 miles on my Golf Sport TSI with standard triptronic. The dealer said they were upgrading my transmission software when I had my free oil change. Now it does wobble and it is very irritating. Does this affect both DSG and Triptronic vehicles? If so, I am prone to believe that the problem lies elsewhere. What do you think?
View 8 Replies
I have a F250 SD with a 6.0 diesel. My steering wheel is loose. I tested and know for sure is not a problem inside the cabin. Fallow the line thru the linkage to the steering box by the left front wheel. I found an adjustable switch there. Just on top of the steering box. It has a lock nut that must be loosen to adjust what it looks like a hex. Very hard to reach. I have watch some Youtube videos but on different vehicles.
View 1 Replies
So on my 2007 F250 My transmission dipstick is incredibly loose. I looked in the engine bay and it is not bolted to the block as it should be and I feel like it may not be entirely seated where it should be, if it is at all. There is a whole lot of wiggle room for, but I can't see anything to put it back in place.
I've done some searching and have yet to find a whole lot of anything on how to insert it back into its space from the engine bay, is it even reasonably doable?
Haven't asked a dealer what their price is to fix it, but I'm sure it will be astronomical so I'd rather try to remedy this on my own if possible, though I am currently at school so my access to tools and work space is relatively limited.
View 6 Replies
I have a 4r100 on in a 99 7.3 4x4. The shifting problem I have appears to be intermittant. it seems loose after warm up especially at the 4th shift overdrive and passing gear. possibly due to low presures ? sometimes (lately more often than not) hunts back and forth between 4th and o.d when passing or hill climbing. Under normal driving it shifts somewhat firm with 4th being an exeption.I have changed my crank position sensor filters and fluids which had turned dark and improved slightly. When I pulled the pan and replaced the filter the pan was spotless. No residue or signs of plates or debris. There is about 100,000 miles on the tranny and 350,000 on the truck. Questions: Is there a tcm for this transmission and if so could it cause these problems? I'm considering a purchase of an unlocked 1705 superchip to change the shifting but unsure if this will work for my issues...
View 14 Replies
My car is just about at 60k, and I'm really starting to notice that its not the same. Power is not all there, steering is really loose, suspension has definitely begun to sag, it has rattles, the transmission slips and stutters...maybe it is all a sign.
View 19 Replies
Last week when I had my car at Lexus dealership for the air bag recall, they took it upon themselves to do an inspection and came up with a few "recommendations".
The one that intrigues me is "found transmission mount worn/loose" recommend "replace transmission mount".
I will take car to my friendly local repair shop this week (never go to Lexus dealership unless it's free).
I'm no mechanic but I've been around cars for a long time and I've never heard of this before: besides the car only has 50000 miles on it.
Am I possibly being scammed or is this legit?
View 2 Replies
my 2002 Hyundai accent with 1.6 engine and the manual transmission has a problem in that where the axle shaft goes into the transmission is very loose. the problem is in the transmission, not the axel. Is there a bearing in the transmission for this. Or is there something else that could do it.
View 3 Replies
I have problem with my Ford F-250 7,3 diesel SD from 99' XLT transmission 4r100 . I have changed torque converter and now something leaks between transmission and this converter. What can it be? Is there gasket which must be changed ? I didn't notice anything wrong with it.
View 13 Replies
Volvo Automatic 1992 240 - So, just started to back out of the garage and, all of a sudden, my gear shift got stuck in neutral and then started shifting without engaging the transmission at all. Pushed it back into the space and, taking a look underneath, I realize the control rod's completely detached from the lever in the transmission.
I can re-attach it, but it just comes loose again when I shift. It seems like something should be in there to hold the control rod in place with the transmission lever, but I don't know what because I can't seem to find any documentation on what everything should look like down there.
Attaching a couple shots, one with a circle around the area that's coming un-attached since the angle's a bit off.
Attached File(s)
IMG_8972.jpg ( 1.09MB )
IMG_8978.jpg ( 938.64K )
View 1 Replies
How I could take my ford explorer 2002 in to the shop to replace the radiator and come out with transmission fluid leaking. The mechanic said it is some kind of hose but it wasn't leaking before and after I drive I can see it dripping out. I'm just not sure if they messed up something. Unfortunately my husband is overseas and cannot check it.
View 3 Replies
2008 Ford Explorer 4x4. 70,000 miles. Still under warranty. Took a lengthy trip and when we got home I notice a small transmission leak in the front around where the front seal is. No dipstick to check the fluid level so I dont know how much or how long of a leak. Called the Ford dealer and the mechanic told us that sometimes the transmission gets hot and leaks because of expansion! Is this for real?? I've never heard this before. I'm figuring bad seal.
View 10 Replies
My new/used 2000 4x4 excursion with 214000 miles on it has a transmission fluid leak.
It could be a rear portion of pan gasket but it seems to be coming out of the area where the transmission bolts to the extension housing.
I just put a transfer case in it. Thought all the fluid all over was due to exploded T case.
It seems the output shaft seal may be bad. I cannot seem to find an OEM part number for this seal.
What is part number for this seal, if one exists? Maybe the seal is in the extension housing and it's just the gasket between Trans and housing.
View 8 Replies
I have an 07 with a 4r75e transmission that has developed a leak. The truck has 60,000 miles on it. I looked under the truck and it is not leaking from the pan. I plan to put on stands and get under it tomorrow to see if I can find the leak. Where I might check for the leak?
View 6 Replies
Noticed an ATF leak on my van on crossmember/tailpiece mount awhile ago. Not the driveshaft seal but near mount. Checked tightness of bolts on case and mount and found the one mount bolt that goes into transmission case loose- about one whole turn.
(other bolt is on an "ear" of tranny case) Checked again after a couple of weeks and leak is worse, same bolt is loose again.
Is there a gasket or O-ring on this particular bolt? 1998 Ford E-350 with 6.8L - trans code E on door sticker. I believe it is an E4OD as the tranny pan says "Metric" (?) 324,000 miles on this and runs/shifts fine. Occasional vibe issue at highway speeds... I've added 1 quart of ATF over this time period.
View 3 Replies
I've seen this talked about before and it's happened to me before as well but now the tranny is leaking onto my Ypipe a couple times per week and it's giving me a hard time when I try to reverse. revs drop and it stalls if I don't give it enough gas.
So I know I have to change the seal but Ford is telling me the torque converter will need to be replaced but another transmission shop told me once the seal is changed and fluid level set appropriately I shouldn't have the reversing problem anymore?
Is this something I could attempt myself... looks almost like I'd have to move the exhaust to drop the tranny...
View 12 Replies
about a week ago I popped both of the passenger side tires By hitting a rather tall curb while trying to avoid being t-boned. And I have had the passenger side jacked up for about a week now while waiting for the shop to order and get in my new rims. It has been raining here for the past week so I only just noticed today that there was a puddle underneath of my truck.
It looks and feels like engine oil but it is leaking from the back of my transmission. I can't figure what it might be because transmission fluid is red and my transmission has never overheated So it should not be burned. It has 128k miles on it so it also only has 8k miles on the last fluid change. So it's fairly new fluid. What this could be?
I know some seal is obviously broken and the way everything is wet around just the back bottom of the transmission it looks like it is coming from the transmission. I originally thought it was just the transfer case got hit and it could be a bushing at either the transfer case or transmission but there is no scraping on anything under the truck so none of it was hit or damaged from that. What could be causing this?
View 12 Replies
01 F-150 7700 ed. I have a 4R100 Tranny with a 139K miles. It has been rebuilt. Ever since the rebuild (over 10 yrs ago), if I park the truck for a week or so or more, I will end up with a decent size puddle of trans fluid underneath the truck. I took it back to the shop that did the rebuild a couple times, but they could never find anything. It leaks enough to where my fluid level drops enough to cause the transmission to slip in a U-turn because the pickup tube becomes uncovered. I have a couple theories, but am wanting to hear from the collective.
Theory #1 When I park it on my slightly sloped driveway I don't regularly use the parking brake, so it rests on the gears, which eventually forces fluid out an overflow or breather tube.
Theory #2 (a very thin one) due to pressure changes associated with the weather, fluid is somehow siphoned out a breather tube due to some blockage internally in the tranny to where it's not equalizing with the outside air and has a high pressure within...
View 7 Replies
I got a fmx mated to 351w, trans was on back of a 302 and no problems other than small leak around tail shaft seal but shifted great. Now I decided to install mildly built 351w so figured it'd be a good time to build tranny. Installed after build and immediately it was slipping. Pulled trans out took it back to shop and he said the forward seal was blown. Installed again, after about 15 miles same result! What could be causing this. It is fine in reverse, but slips bad in forward gears.
View 2 Replies
Ok so my transmission feels loose, too much play between the coast and drive side of the gears. Makes enough noise now that my wife complained about it so I'm looking into taking it to the dealer. I pretty much expect them to pass this off and do nothing, but its getting worse especially in the last couple of months.
Noticed a lot of play in there gearbox? Can you hear the gears make noise as they shift from coast to drive side?
View 13 Replies
