I have a 1991 300 6 with an e40d trannsmission, our 4610 Ford tractor broke down in the field so i pulled it maybe 50 yds with my truck, it didnt like it but it did it. Now my tranny is dripping at a decent pace it looks like from the hole in the bottom of the trans, drove it ten miles home and it shifts fine. What could i have done??
View 4 RepliesLoss of coolant! I have a 2003 6.0 diesel with 200,000 miles. I put in a new oil cooler and ipr egr delete two years ago also flush the system and added a coolant filter. I filed it back up with the red antifreeze. Now the problem I have never lost any coolant since then and my deltas are about 5 degrees. But the other day I pulled a heavy load the first one since I did the repairs (coolant got up to 220 degrees and would drop back down) when I got home the coolant tank was about a inch low. I let the truck sit about 3 hours and checked it again and it was back at the full mark. Drove it the next day and it's back low about a inch, Any clue what's going on.
View 3 RepliesQuestion about my dads 2000 explorer with the 4.0, he just noticed it was leaking oil heavily. Added 2quarts and drove it home. I looked under it and the oil is dripping very steadily from what appears to be the inspection plate area where engine meets trans. Have y'all ever seen a rear main seal fall out or cause a leak this heavy? I know we will have to clean it and re check but this is all I have seen at this point. Is there any other seal or issue that could cause this from inside the bell housing area or nearby?
View 2 RepliesI have a 2000 SD F250, gasser, auto. Last week I pulled a heavy load and developed a tranny fluid leak. The fluid appears to be coming from what looks like a freeze plug on the bottom of the casing forward of the (torque converter?) pan . Is that plug easily replaced by a DYIer. Small leak. 150K on the motor. First time it has leaked. Heaviest load I've pulled.
View 2 RepliesI'm in a situation where I may be having to tow my 3500# boat/trailer with my '04 Explorer 4WD (this is well within the max tow limit, per the manual). I have the 4.0L with the 5 spd auto tranny and 3.73ls gears. I've towed the boat a handful of times with this vehicle and had a good experience every time. Now I'm looking at this being my primary towing vehicle, towing once or twice a month in the summer. The car only has 48000 miles on the ticker and is in pristine condition, so mechanically it's sound.
I asked my mechanic what he thought of this arrangement and he hates the Explorers, so he's giving a biased response. Have any of you towed something on a somewhat regular basis with this, or a similar, vehicle? Any issues? My mechanic keeps going on about the transmission seal blowing when under a heavy load.
If I press the gas a little hard in drive, my tires squeal but if I'm in reverse I can feel a slipping in the trans. If I try to back a trailer up an inclined driveway, it won't go, the trans slips. I have no crud in the pan. I've replaced the reverse boost valve. I installed a Trans-Go kit which is suppose to eliminate the reverse slip but it hasn't worked. Everything else works just fine and my fluid is red. I have engine braking in 2nd and 1st. The van backs up fine, it just does this in reverse under load.
View 2 RepliesLast night I noticed oil on my driveway. I got up under my truck and it was dripping at the trans. I'm not sure that's where it's actually leaking from because the other side of the oil pan had clean oil on the outside of it. What this could be?
View 13 RepliesI posted earlier about a whistle that appeared when I was towing my old travel trailer (6000 pounds). It only happened a couple of times, and I had a hard time replicating it, so I elected not to waste any money with the deductable, and possible additional costs for a non-covered issue at the stealership.
Now, I am towing a larger 5th wheel trailer (11000 pounds), and am experiencing this whistle on every steep grade, while towing. Below are a couple of things I noticed, that had to be, before I would get the whistle:
* It only seems to happen while the cooling fan is engaged, and also only when the rpms reached 2800 and above.
*If the fan was on, but the rpms were turning below 2800 rpms, then it would not whistle. It would, however, after the transmission downshifts, bringing the rpms back up, while climbing.
*If the engine was spinning at 2800 rpms, and the engine fan was not engaged, then it would not whistle, until the fan would kick in.
* It only seems to occur when I am climbing a steep grade, on a warm day. Although, I haven't experimented on steep grades on a cold day...
It sounds to me like there is an issue with the engine fan system, but I thought I would put it out there, just in case any of the diesel guru's out there might know of something else that would cause a whistle like this, i.e., turbo?
Oh by the way, I also think that I have a performance reduction lately. However, I can't know for sure, as I have never towed this much weight with my truck before. I just kind of expected that I would be able to pull to the top of these grades, with a little extra peddle to spare. I have to floor it, just to "try" and keep up with traffic. And I haven't calculated my fuel mileage while towing this beast yet, but WOW, that fuel gauge needle sure does drop like a rock!
I have a 2003 f 350 6.0, when under a heavy laod such as towing a 3000-pound trailer up a long hill at approx 60mph and 2000 rpm it intermittently mis fires.The boost gauge bounces up and down and i here a poping sound from the engine compartment.I have had it to several dealer and independent shops but with out the trailer or a heavy load it runs perfectly.They have told me fuel pressure is good and changed all fuel filters with OEM parts.
View 3 RepliesSo basically I thought it would be a great idea to degrease my motor from the top down.... After washing I start it up and drive down the road to head abunch of misfiring under heavy load or high rpm's.
My problem is that the misfiring won't throw a code. I then proceeded to buy a new ignition coil (thinking this was the problem) but with no code to go off which cylinder was bad I just switched the good ignition coil into each cylinder and starting it.
Up each time. None of them seemed to make it better. Also the injectors all seemed to be good. So what to do ?
2002 Ford F-250 5.4l
I have a 2008 Passat Komfort Wagon with the 2.0T. At 40,000 miles, yes it only has 40,000 miles, the thing started hesitating and misfiring on me only during heavy load. I ran the codes and it said #4 cylinder misfire. The check engine light was only on during the time it was misfiring and hesitating. Took it to the VW dealer to have them run it again and get guidance and they verified the #4. When I picked up the car the CEL was illuminated. They said it does it when it misfires. I explained that it was not on when I dropped it off and they basically said tough cookies. So I replaced the #4 coil pack and all 4 plugs. CEL light still on, but wasn't misfiring. Next day it began misfiring again under heavy load. Took to Autozone to run the codes and now says misfiring on all cylinders.
View 6 Replies2003 F150 XLT 7700 4x4 5.4 Triton. While accelerating normally from a stop the transmission? shifts into 2nd with a heavy jerk. All other gears normal. It doesn't do this under hard acceleration or under very gentle and slow throttle application. Is this a COP issue, a transmission issue or just a driving style thing?
View 7 RepliesQuestion about my 2012 Hyundai Santa Fe SE. The car has 25,000 miles on it, and just recently like in the last 1,000 miles I have notice when I use the AC, or even the air without the AC the engine reacts very poorly like it is under extremely heavy load. The car shakes and vibrates.
I completely understand that in AC mode, the compressor kicks in, but this to me seems excessive. The car vibrates and the idle drops substantially. AC on is worse that no AC.
In addition, idle or under 35 is worse that HWY driving. The vibration is so pronounced that I sometimes wont turn the AC or air on as the vehicle feels like it is going to rip itself apart.
This is something new and never vibrated this much before the 25,000 miles. Anything I should look into or have the Hyundai Dealer look into? What I may be over looking? Would more stout battery work?
Best truck I ever had but around 200k would occasionally blow a bunch of smoke when pulling a heavy load.
My 2000 f 350 xlt triton v8 has done the same thing a couple times (about 200k miles).
The (cough) "truck expert" at my local dealer has never seen that before but its happened in 2 different trucks for me. It never caused a problem other than scaring me.
I sold the 02 last year when i got a 2011 f 250--it was 12 years and 300k miles old and never was hospitalized except for a fuel pump due to my negligence of filter.
Ok, my clutch has been giving me trouble for a little bit and I'm almost positive that I have a bent release fork. It also slips under heavy acceleration in 6th gear. I am planning on doing a clutch, compete with flywheel and release fork and a new rear main seal. My problem is, here within the last couple of days the trans would pop out of 4th gear if I was just coasting. It has been getting noisy over the last few weeks also. I'm no manual tyranny expert, but this is making me think I'm gonna need to have it rebuilt.
View 14 RepliesI am the original owner of a 2006 Prius with 265k miles. I use Mobil 5-30 synthetic oil and I drive a steep hill every day and the engine knocks in the summer afternoons when I use cheap 87 Octane gasoline from Safeway or Costco. If I use better 87 octane gasoline (Chevron, Shell) generally there is less knocking. Also during the winter months no knocking even with cheap gasoline.
During summer I can sometimes make the knocking go away by accelerating or decelerating. The knocking is intermittent and generally occurs only during the steepest parts of the commute. The engine might knock for 30 seconds to 60 seconds before its goes away as I try to change the engine RPM.
Unfortunately I am burning some oil at a rate of approximately half a quart every 5k miles. Generally I watch the oil level, but there have been cases where the oil level has fallen below the lowest mark on the dip stick so I suspect I have some carbon build up.
I've read posts where others have used additives like gumout regane and I've read posts that say not to use additives.
Been having a problem where the alt belt squeals on cold start, under heavy load and sometimes at complete random when cruising at a steady speed.
It doesn't change when my air ride compressors kick on so I'm assuming it's not the alternator. The belt and tensioner are now brand new from VW. The car has no AC, so I am using belt #066 145 933 K (21.36x1264mm). Replacing the tensioner and belt made it a little better but it's still doing it.
I'm thinking PS pump because it squeals loudly when I nail the throttle around corners. Sometimes if I'm cruising and it starts doing it a little shake of the steering wheel makes it stop.
I have a 2001 chevy silverado 3500 6L gasoline engine.
I have been getting a P0307 random multiple misfire #7 on and off for a few months now, occasionally the P0300. Check engine light comes on when I am going up hills, often under heavy load and sometimes when the truck is cold in the morning and the truck starts to run rough until the code clears, which it does pretty quickly usually. I have replaced coil, crank sensor, cam sensor, fuel injectors. If I unplug the battery overnight the code will be cleared and the truck will be running just fine the next day.
I have been getting some knocking the under most any loads . I do not have any codes. I tried premium gas and that did not make any difference. If this is not fixed what issues can this cause? What should I look for do get this fixed?
View 14 RepliesI am a newbie as far as fuel injection. The original issue the truck had was no fuel. I tracked down the issues to a blown fuel pump relay and a melted inertia switch. I jumped the inertia wires with a new fuel pump relay installed and the truck ran at an idle and up to 3500 RPM when stationary. If the truck is going up a grade or needs more throttle it will start to lose fuel pressure and end up stalling. I had the fuel pressure gauge connected to the schrader valve on the fuel rail and had 30-35 PSI when idling. It runs good under light load on the throttle.
Under heavy load it starts to drop quickly and if you back off the throttle it will stay running some times. I changed the fuel filter and also replaced the high pressure pump on the main frame and it still has the same problems.The original pump was pumping about 13 ounces of fuel in the 20 second test that the repair manual suggested. I have even placed a jumper wire direct to the new fuel pump to bypass original wiring and possible problems. When it stalls under load (No Fuel pressure) at the schrader valve you can hear the fuel pump running but there is no fuel pressure.
If I turn off the ignition for a few minutes and then turn the key back to the on position it will start to pressurize and then start and run at an idle. I even replace the ignition switch as it was a little temperamental. I have not changed or checked the fuel pressure regulator as it is a pain to get to at the back of the engine. I do not want to spend a fortune tracking down this problem since the truck may not even pass its smog inspection and may be a parts truck only.
67 F-250 4x4
73 Crew 4x2 (4x4 Soon)
89 F-250 Super Cab 4x4
The video below IS NOT my truck, though my truck makes the same sound. Mine isn't nearly as loud as the truck in the video at idle, but gets much louder when under load at about 1700-1900 rpm. If you take it easy accelerating it doesn't get any louder than at idle. At cruising speed in third it isn't audible. The trans in my truck is a 1979 C6. Again, not my video. Same noise though.
Transmission whine - YouTube....