Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?
View 6 RepliesThe tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 RepliesI have a 2006 GS RWD the transmission started acting weird 4 month ago went to many workshops and no codes were found in the computer and my problem is that when i am moving in the car for more than half an hour and stop the car seems hard and jerking while shifting to 2nd gear and if i put it in tiptronic it go to 5th gear immediately it seems ok when the transmission is cold so what do you think it has got 125000 miles on it and what is the normal temperature for the transmission so i can test it with mini vci...
View 7 RepliesJust curious if there are any other 2010 owners with any difficulty shifting gears in their manual transmission camrys? I noticed during my test drive that I grinded my way into 2nd once... I thought it might have just been my nervousness with a new clutch at the time. However, I've since put 300 miles on the car and I still have trouble putting it into second gear on a daily basis. Sometimes it grinds a bit, and sometimes it catches or a half second before it pops in. All the gears OTHER than 2nd gear go in like butter as you would expect with a new transmission. I'm not new to a clutch... this is at least my 4th car with a stick, so I don't think I'm doing anything out of the ordinary when shifting.
It reminds me of some older (100,000+ mile Nissan) cars I've had in the past... the syncromesh was wearing out and it would grind going into second or third, so I put in some RedLine MTL and got a little more life out of the transmission... but there shouldn't be a need for that kind of thing on a car with less than 1000 miles on it?!
I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.
View 6 Repliesbought the truck about 3 weeks ago and still having problems with the transmission. Replaced the VSS and it didn't work. My problems are it shifting hard from 1st to 2nd, it feels like it falls out of gear ( i can floor it and the speedometer creeps up then shifts hard.) Now i read having the 3rd brake light out is a problem with the trans too, my 3rd brake light is out along with the interior dome light ( doesn't go on when doors open) i plan to replace the TRS on the tranny tmw is there anything else i can do? how do i solve the brake light problem?
View 14 RepliesCould my brake issue be related to my transmission problem? Neither are constant. Brake problem= sometimes the brake pedal feels hard, like there's no power brakes (I drove a car once. ..looong time ago. .. that had no power brakes or steering) but it will kick in after a short distance. Transmission prob= seemingly unrelated, is a problem shifting from 1st to 2nd gear. This has happened maybe a 1/2 dozen times, the first time and mostly when in heavy commute traffic and when going between 1st and 2nd gear because of the slow commute speed, but also at other times when not in lengthy slow commutes. When it doesn't shift, the odometer doesn't work (shows only dashes) and an engine light comes on (the sprocket/gear looking one). Usually the transmission will eventually shift and the light goes off.
I read that the brake problem might be a vacuum hose problem? Something about a booster? Is this dangerous? or is it like having a car w/ no power brakes? Going to have my transmission looked at this week. Read on another site about dropping valve seats on this year car. If there's a major transmission problem, I'm wondering if it's worth fixing? I changed, timing belt, water pump, front and rears brakes, tires. 143,000 miles.
This has been a problem since I got the truck. It's a 1996 F150 5.8 4x4. It's got about 140,800 miles on it; had about 139,000 when I picked it up. Not sure if the trans has been rebuilt or not. I'm the 3rd Owner. It doesn't matter what temperature it is outside or how far my foot is down on the pedal... Just about every 1-2 shift is accompanied by a little kick/jolt. Going slow..(coasting, about 15mph) and it shifts into 2nd, usually the jolt is harder than hell!
Same goes for when I'm going about 25mph and I put the pedal to the floor It downshifts then comes back up to 2nd gear and wow. It jolts, shakes and shudders. Sometimes (rarely) I don't feel anything when it shifts. But it ONLY and always happens 1-2. not 2-1 either. Furthermore, when I go to put my truck into Reverse it kind of slams into it, with a clunk noise. All fluids have been changed recently and I also put "Lucas Oil Transmission Fix" in it and that didn't seem to change anything. What is going on internally?
Have an 89 F150 WITH 5.0 AOD TRANNY has a hard shutter from 1st to 2nd and shutters hard under low rpm I am Second also shifts rough all the way through and in to od and reverse was wondering what's the possible pro lens and how to fix them....
View 2 RepliesOur 93 Ford F150 with <100,000 miles had no transmission problems until a squirrel built a nest in it and chewed through some of the wires. It wouldn't start and what a surprise when we lifted the hood. It chewed through the EEC Test wires which have been reattached, through the cruise control wires (all but two have been reattached.
The remaining two are chewed to the box and can't be attached), two other wires next to these that were reconnected and chewed completely off is a part #E53B-14A624-0 with the stubs of two red wires.
The E53B was lying under the truck. After reattaching the wires listed it started but now lugs along and shifts hard into first gear. After that it's OK most of the time but it has surged unexpectedly when making a turn. I've been told the cruise doesn't need to be rewired completely so don't know if it's the problem (can the cruise be left with two wires cut off) or if it's the E53B part or something else we can't see.
I have a 2000 F150 with the 4.6L engine and I have a question about the transmission. When shifting from 1st to 2nd gear there is sometimes a little hard jump when shifting. All the other shifting through out the range is buttery smooth. The issue has been around for a long time and has never gotten worse. Is there anything simple I can do to fix this. Do those tranny additives work at all? Otherwise, I will just continue to live with it.
View 2 RepliesI have a 2000 Ford Ranger 4X4 XLT with a 5R55E automatic transmission.
Coming out of a stop the truck jolts at about 20 mph as it shifts from 2nd to 3rd gear. It feels like it revs too high in 2nd gear, up to about 2400 rpm, and then shifts hard into third. It feels like the truck gets a gentle hit from behind.
Earlier in the week, the O/D light flashed. I took it immediately to an independent tranny shop who pulled the code for me: P7033, incorrect ratio in 3rd gear.
They cleared the code for me. In limited city and highway driving (less than 15 miles each trip) the O/D light has not flashed again. But the problem remains. I plan to take it back to the shop later next week.
What might cause this so that I might have a more informed conversation with the tranny mechanic?
I have a 2000 V10 2WD Excursion with 104,000 miles. Last week it started shifting hard between first and second, but only when I am between 1500-2k RPMs. If I rev the engine higher, it shifts smooth. I checked the fluid and it is fine. I rarely tow anything except my little trailer to the dump every few months. I have a few questions:
1. Should I drop the pan and change the tranny filter?
2. Should/Can I check the rear diff fluid? (haven't noticed any leaks)
3. Could an inline flush and fill work?
4. I saw a post about a speed sensor in the rear diff. Could this be the issue?
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 Replies1994 Lightning E40d... I was on my way home from work and noticed my speedometer jumping from zero to around the speed I was going on the highway. Then as i got off the exit I noticed hard shifting. It was in neutral between shifts for a few seconds and then it would go into gear jolting the truck forward. The abs light was the only thing on at the time. I tried turning off over drive only to get higher revs which scared me away from the gas pedal. Since I can't afford to replace my transmission. It happened all the sudden over halfway home from a 35 mile drive. I'm assuming it's some kind of electrical issue. What's going on with my baby?
View 2 RepliesI bought a '93 F150 4x4 this past Sunday. It has the 5.8 and E4OD. Yesterday when I started it up and drove to the tire shop for some wheel balancing, it shifted VERY hard with each shift, so hard that it concerned me. I know very little about transmissions in general, and this one specifically, aside from it being electronically controlled.
This afternoon, I drove it again and it seemed to be shifting more "normally" without shifting anywhere nearly as hard as it did yesterday. What I should check first? I bought a filter kit and will change the filter/fluid (including torque converter) as soon as I'm able.
I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 RepliesMy 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
So today I had a scenario where I had to pull out from a blind corner onto busy street. By the time I pulled out I realized an SUV was coming down the street fairly quickly. My immediate instinct knowing I have 360hp on tap was to put the hammer down.
I basically planted my right foot to the floor and held it there. The truck was already rolling out of the lot and turning into the street at approximately 5-7 mph. This resulted in the truck shifting hard from rolling in 2nd gear, down to 1st. I never drive this way so what I'm asking next is if this is normal or not. As I held my foot to the floor through 2nd & 3rd gears the truck seemed to blip the throttle at 4k then up-shifted from 1st to 2nd gear.
I have a stock Ford Raptor exhaust on my truck with the resonator deleted and when the truck blipped the throttle just prior to the up shift, the exhaust "popped" like a race car with an open exhaust downshifting from speed into an apex. Yes it sounded cool, but it was obviously cutting fuel or throttle for some reason.
So here is the weird part, out of curiosity I tried a few different scenarios just to see if something was wrong with my truck. *Note if I just mash the gas from a dead stop there is no fuel cut going from 1st - 2nd gears at WOT. The fuel cut only happens when I'm leaving out and getting on the gas from a turn.
If I turn off the traction control or advance trac and stability program then there is no fuel cut or 4k rpm, the truck just runs out to the 5600 or so redline seamlessly. Im just wondering if the traction control or torque management is really that sensitive or aggressive? I mean it was 70 degrees out and the road dry, plus I was already at a speed 45-50?? mph where a loss of traction would not be an issue so what gives?
2001 Super Crew
2x2 4r70w transmission
417k miles
4.6l
Transmission shifting hard when under strain. My truck has 417k miles and the transmission is shifting a little hard when it is under strain. For example going up hills when in cruise and such forth, no problems otherwise.
My question is kinda weird: Since the fluid has never been changed or added to for that matter (fluid level is correct) , should I change it now or just ride it out? It is still my primary vehicle and runs perfectly!
I have been blessed with this truck since I bought it new
No engine work
Changed DPFE a couple of times
Cleaned throttle body a couple of times
Couple of pairs of shocks
one O2 sensor
alternator
I know its a weird question but could putting new fluid in at this time make more problems?
2007 escape 4wd 3.0. I've notice some random hard shifts for the past month and today the trans has trouble shifting out of 1st. If I get the rpms between 3,000-4,000 and ease off the accelerator pedal it shifts into 2nd without drama. It will not shift at lower rpms with the same easing off the pedal. The trans light is steadily blinking.
View 7 Replies