Ford Transmission :: Hard Shifting / Speedometer Flickering And ABS Light On
Aug 16, 2016
1994 Lightning E40d... I was on my way home from work and noticed my speedometer jumping from zero to around the speed I was going on the highway. Then as i got off the exit I noticed hard shifting. It was in neutral between shifts for a few seconds and then it would go into gear jolting the truck forward. The abs light was the only thing on at the time. I tried turning off over drive only to get higher revs which scared me away from the gas pedal. Since I can't afford to replace my transmission. It happened all the sudden over halfway home from a 35 mile drive. I'm assuming it's some kind of electrical issue. What's going on with my baby?
View 2 Replies
Advertisement
I recently purchased a 1995 F150 4x4 with the 351 Windsor. Upon driving it I realized the speedo didn't work, transmission shifted hard,and OD light blinking. After googling my issue I found out it was the VSS. I climbed under the truck to find out the VSS isn't even plugged in. I searched for the wire but could not find it, only a spliced cable.....
View 4 Replies
I have a 94 E350 with a 7.3 diesel. I took it to the Ford dealership to have a new fuel filter and oil change when I got it back the OD light was flashing and transmission shifting hard. They tell me they cannot find a problem could they have possibly knock a wire off of something to make this happen...
View 3 Replies
I just got my truck back from the tranny shop 3 days ago,was driving down the hiway looked down and my speedo went from 65 to 0 instantly. it was driving fine till i exited then started reving and not shifting till about 3000 rpms. So i changed the sensor on the rear end and the vss on the transfer case but no results.
View 7 Replies
Vehicle: '99 E350, V10
Symptoms: speedometer bouncing, O/D flashing, harsh shifts. Symptoms do not present until the van has been driven at highway speeds for about 20 miles. Then, the speedometer starts to bounce a little. Then, after another 5 - 10 miles, the O/D light starts to flash. Then, with a few more miles, the harsh shifting begins.
Parts replaced: neutral safety switch, rear ABS/speed sensor (twice), instrument cluster.
Each time after I replaced a part, when I drove the van, all was fine until it had been driven at highway speeds for about 20 - 25 miles, regardless of whether the engine was warm or cold. Where to go next with it?
View 4 Replies
I have a 95 f350 with a 460 motor and a e4od trans with 90,000 miles. My speedometer,odometer quit working and then transmission shifts hard in all gears. I've checked the fuses and all are good. I've even replaced the speed sensor but still have the same problems and don't know were to look next. Where or what to check?
View 1 Replies
bought the truck about 3 weeks ago and still having problems with the transmission. Replaced the VSS and it didn't work. My problems are it shifting hard from 1st to 2nd, it feels like it falls out of gear ( i can floor it and the speedometer creeps up then shifts hard.) Now i read having the 3rd brake light out is a problem with the trans too, my 3rd brake light is out along with the interior dome light ( doesn't go on when doors open) i plan to replace the TRS on the tranny tmw is there anything else i can do? how do i solve the brake light problem?
View 14 Replies
Recently the ABS light came on (truck does not have ABS), also speedometer quit working and trans was not shifting right. After a few minutes the problem went away.
View 4 Replies
Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?
View 6 Replies
This has been a problem since I got the truck. It's a 1996 F150 5.8 4x4. It's got about 140,800 miles on it; had about 139,000 when I picked it up. Not sure if the trans has been rebuilt or not. I'm the 3rd Owner. It doesn't matter what temperature it is outside or how far my foot is down on the pedal... Just about every 1-2 shift is accompanied by a little kick/jolt. Going slow..(coasting, about 15mph) and it shifts into 2nd, usually the jolt is harder than hell!
Same goes for when I'm going about 25mph and I put the pedal to the floor It downshifts then comes back up to 2nd gear and wow. It jolts, shakes and shudders. Sometimes (rarely) I don't feel anything when it shifts. But it ONLY and always happens 1-2. not 2-1 either. Furthermore, when I go to put my truck into Reverse it kind of slams into it, with a clunk noise. All fluids have been changed recently and I also put "Lucas Oil Transmission Fix" in it and that didn't seem to change anything. What is going on internally?
View 1 Replies
Have an 89 F150 WITH 5.0 AOD TRANNY has a hard shutter from 1st to 2nd and shutters hard under low rpm I am Second also shifts rough all the way through and in to od and reverse was wondering what's the possible pro lens and how to fix them....
View 2 Replies
I have a 2000 Ford Ranger 4X4 XLT with a 5R55E automatic transmission.
Coming out of a stop the truck jolts at about 20 mph as it shifts from 2nd to 3rd gear. It feels like it revs too high in 2nd gear, up to about 2400 rpm, and then shifts hard into third. It feels like the truck gets a gentle hit from behind.
Earlier in the week, the O/D light flashed. I took it immediately to an independent tranny shop who pulled the code for me: P7033, incorrect ratio in 3rd gear.
They cleared the code for me. In limited city and highway driving (less than 15 miles each trip) the O/D light has not flashed again. But the problem remains. I plan to take it back to the shop later next week.
What might cause this so that I might have a more informed conversation with the tranny mechanic?
View 3 Replies
I have a 2000 V10 2WD Excursion with 104,000 miles. Last week it started shifting hard between first and second, but only when I am between 1500-2k RPMs. If I rev the engine higher, it shifts smooth. I checked the fluid and it is fine. I rarely tow anything except my little trailer to the dump every few months. I have a few questions:
1. Should I drop the pan and change the tranny filter?
2. Should/Can I check the rear diff fluid? (haven't noticed any leaks)
3. Could an inline flush and fill work?
4. I saw a post about a speed sensor in the rear diff. Could this be the issue?
View 4 Replies
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 Replies
I bought a '93 F150 4x4 this past Sunday. It has the 5.8 and E4OD. Yesterday when I started it up and drove to the tire shop for some wheel balancing, it shifted VERY hard with each shift, so hard that it concerned me. I know very little about transmissions in general, and this one specifically, aside from it being electronically controlled.
This afternoon, I drove it again and it seemed to be shifting more "normally" without shifting anywhere nearly as hard as it did yesterday. What I should check first? I bought a filter kit and will change the filter/fluid (including torque converter) as soon as I'm able.
View 3 Replies
I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 Replies
2001 Super Crew
2x2 4r70w transmission
417k miles
4.6l
Transmission shifting hard when under strain. My truck has 417k miles and the transmission is shifting a little hard when it is under strain. For example going up hills when in cruise and such forth, no problems otherwise.
My question is kinda weird: Since the fluid has never been changed or added to for that matter (fluid level is correct) , should I change it now or just ride it out? It is still my primary vehicle and runs perfectly!
I have been blessed with this truck since I bought it new
No engine work
Changed DPFE a couple of times
Cleaned throttle body a couple of times
Couple of pairs of shocks
one O2 sensor
alternator
I know its a weird question but could putting new fluid in at this time make more problems?
View 12 Replies
2007 escape 4wd 3.0. I've notice some random hard shifts for the past month and today the trans has trouble shifting out of 1st. If I get the rpms between 3,000-4,000 and ease off the accelerator pedal it shifts into 2nd without drama. It will not shift at lower rpms with the same easing off the pedal. The trans light is steadily blinking.
View 7 Replies
I just got this f350 6.0l and I experienced an electrical problem with the trans gauge, started flicking a lil then go all the way up to over hit and check gauge light go on and my tow light starts blinking..
View 4 Replies
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 Replies
Recently I have had an issue with my auto which was just rebuilt. About 500 kays after i picked it up it shifts dangerously hard and immediately into all gears at around 20-40 mph, converter also locks immediately. The speed sensor in the box was replaced with the rebuild but I'm having it replaced again this thursday just in case.
Just for the record I cooked it on the beach a while back, the speed sensor was replaced with the rebuild as it was doing the above, the od light also flashes when this occurs, before and after the rebuild.
Prior to cooking it never had an issue.
What could be causing it? I'm starting to worry it cant be fixed, have done a google and tried a couple of things mentioned. Code says wiring issue associated with speed sensor in box.
View 8 Replies
