Ford Transmission :: E40D - Shifts Very Hard From 1st To 2nd / Light Flashes On Overdrive Button
Aug 18, 2015
My tranny started acting up so I took it to a reputable transmission shop for repair.
Symptoms : Shifts very hard 1st to 2nd. Light flashes on overdrive button.
The following is what has been done at the transmission shop.
Computer failed to read codes. Sent out to rebuild. After rebuild, codes read FIPL needs replace. Done and gives good readout. Trans control replaced, speed sensor replaced, checked all associated wiring and plugs as well as ground. Dropped pan, changed fluid and filter. No parts in pan. Tech says pan and fluid looked good. Replaced coil pack.
After all that, this is what is happening..Clear all codes. FIPL reading good. No flashing light on shifter. It feels like it is shifting from 1st to 3rd, then back to 2nd. Still shifting hard and indicator light starts blinking again. He is going to read computer again. At this point, he suspects a mechanical problem in transmission but is reluctant to remove and tear down.
View 7 Replies
Advertisement
So while driving to work I start experiencing some weird behavior with the transmission. It would shift hard and seem like it wasn't pulling hard at all. I looked down and saw the overdrive off light flashing. Got to work, turned the car off then started back up and the light was off. Any thoughts?
View 14 Replies
I have a 2001 3/4 pickup. Sometimes the over drive light flashes. When it flashes it shifts really hard and sometimes it won't shift into 4th until I mash the overdrive button. Sometimes the light doesn't flash at all and it doesn't have any trouble shifting at all. Is it a solenoid? Or wiring issues?
View 6 Replies
Here is my issue. I have a 2000 e350 7.3 the overdrive light is flashing, the speedometer and the odometer isnt working it also shifts hard, i changed the vss, the vss plug, range sensor, and alternator. still acting up. also all the fuses are good.
View 8 Replies
I asked a question about the E40D a while back about a hard 1-2 shift. However, I needed to replace the shift lever to get my OD light operational again. I fixed it and the issue seemed to stop for a while, so I just forgot about it. It's back again, last time it did it, it was hard enough to make the whole truck almost buck. It was a real good bang. So, could this be the 1-2 accumulator piston or the bore it resides in?
The next question I had is how long should an E40D take to shift from second to third? I've noticed on a steep onramp with some throttle, mine can have around 2.5-3 seconds of rev before it finally shifts (unloaded). I could of sworn I watched the tach climb a hundred revs or so during this once (real steep onramp), however maybe I was just dreaming, as I've never replicated it. Just wanted some opinion on this, wondering if I need to start putting some funds aside.
The truck has about 139K and the transmission looks to be original. It was used to haul a camper and a boat most of it's life, or at least that's what I was told.
View 3 Replies
I have a 95 f150 5.0 with a 4r70w Trans. What to check now no overdrive Trans shifts and drives great but no od the od off light on shifter is lit up and just never goes into overdrive solenoids have been replaced and new shift lever and button where do I go from here is not throwing any codes...
View 7 Replies
I have an 2003 F-150 4.6L with a 4R70W transmission, the speedometer goes crazy while I drive, the truck feels like it kicks in & out of overdrive, it shifts hard, the o/d light flashes while driving and I cannot use speed control. I have already checked the transmission fluid, changed the speed sensor, & the range sensor. After changing the range sensor the truck ran perfect for 3 days then the same problems.
View 5 Replies
I have a 96 Ford f super duty with a 7.5l and E40d after about 30minutes of driving O/D light will flash but still operate in all gears. Pulled codes and got 628 excessive converter clutch slippage and 657 fluid over heated. Now I have not felt a shudder which would indicate slippage like my 91 ford E40d does on lockup. And the temp never got above 210 until the light started flashing or I came to a stop. and front seal leaks also which in a tsb a read of another forum claimed that leaks can cause that code. I have already replaced solenoid pack after it got fried when the problem started last Monday...
View 14 Replies
I have the p0734 and p0732 codes. Thing is it shifts hard into second and wont go into overdrive when first started. After about ten minutes of drive time you shut it off and turn it back on and the thing shifts perfectly. No hard shifts and overdrive works then check engine light turns off. The pulse generators have been replaced when i purchased car. It is an 02 accent with 90,000 miles.
View 3 Replies
My Pris 2010 would not start this morning. My wife tried to start the car this morning and it would not start. All the symbols on the display light up and would not go. She then tries to turn off the car, but the Triangle symbol with the exclamation mark within it lights up. The Start button light is red and the Park button flashes green. Added to that is the constant beep that you hear when you try to close the door with the keys in the car. I cannot even turn the steering wheel. I had to get it towed to the Toyota dealer and am was told that i would hear back tomorrow.
View 19 Replies
Today i go out and crank my truck and it fires right up. I notice the overdrive light on the shifter is flashing. It did that a few days ago but stopped within a minute or so. This time i noticed the check engine soon light was lit as well. I checked my scan gauge and it said three codes stored. The first one i looked at was P0705. The truck was running fine the whole time. I turned it off and tried to crank it again.
This time it just turned over and over but would not crank. I cleared the codes before checking the other two codes. I wish i would not have done that but I wasn't thinking straight. I tried several more times to crank but it never fired. One time it tried to but never fully did. I gave up and switched cars. I am going to try again when i get back home. What causing this?
View 14 Replies
2003 F150, 5.4 FX4, overdrive light flashes. Took to a shop they said overheating issue, but I don't understand if it is a overheating issue why does I flash at 4 in the morning when I leave for work fter sitting all night and why does it stop when I do over 70 on the highway.
View 4 Replies
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 Replies
My tranny guy just did a full scan and the ONLY thing which indicated a problem was 'output speed sensor' which we were able to trace back to most likely being caused by a completely hosed driveshaft (I've noticed a driveline vibration). We're going to install a new driveshaft, replace the output speed sensor(s), check for any frayed/chaffed wiring going to the output speed sensor(s) and then see where that leads us (he said something about some computer module in the dash which he's had to replace on several Sooper Dooties).
View 7 Replies
Auto trans. The Overdrive light flashes on the Selector lever. Never stops.I put tape over it because it is annoying. Especially at night. It goes into overdrive no problem.
A Couple of times it did not flash and was stuck in first till I manually shifted. Then the light started flashing again and works normal. What now......RPM Sensor?
View 14 Replies
I have a 2000 f150, the overdrive light flashes on the swifter, the motor has no power and sputters unless I put it in second gear. It won't shift gears in drive.
View 1 Replies
Auto trans. The Overdrive light flashes on the Selector lever. Never stops. I put tape over it because it is annoying. Especially at night. It goes into overdrive no problem.
A Couple of times it did not flash and was stuck in first till I manually shifted. Then the light started flashing again and works normal. What now......RPM Sensor?
View 11 Replies
I just rebuilt my E4OD transmission in my 1996 F250 7.3L it has all new clutch packs torque converter and a shift kit. When I first put itback together it would not shift out of second cleaned mlps and shifts threw all the gears now. I took it out on the road to test it and this thing ran great shifted smooth and quick could not askfor any better but when Trans temp gets around 140-150deg it shifts hard and od light flashes. I have ordered a scanner to read the codes but won’t be in till later this week. What I could check in the meantime.
View 13 Replies
Have an 01 f150 super crew 4x4 with 5.4 li shifts hard from 1st to 2nd - What could be the problem?
View 1 Replies
I just bought an older 1995 Ranger XLT 4.0 I was told that the truck is stuck in overdrive. The overdrive light is not working and the button does not respond. It shifts smooth but run away with it's self. It is not shifting a lot going up hill and curves.
I got a diagnostic and it did not show codes. I was told the trani has had an oil change and filter with no metal parts in the oil. Since the overdrive switch is know for a short in the steering column maybe when they looked at it they did not know what they were doing.
I am driving it only once or so a week. But don't want to hurt it. A friend did the first work and had it diagnostic done yesterday.
View 14 Replies
2000 Ranger autimatic, 2.5 lt 2wd, 155,000 miles. To my knowledge it has never had a tranny flush or the fluid changed. I have noticed last week that when you are taking off from a stop sign it jerks going into gear. This only happens when you are taking off all the other shifts are smooth. The transmission fluid color is redish-brown and doesn't have a burnt odor. I don't know where to start. Do I get a tranny flush, change the fluid or is it something else?
View 5 Replies
