Ford Transmission :: E40D - Rough Shifting From 1 To 2 Gear / Whole Truck Shudder
Jul 15, 2013
My 1992 F-250 7.3 4X4 has a very intermittent issue with the E40D. Rarely, usually after a lot of around town driving (I don't know if that has any direct correlation), I will get a rough shift from 1-2. It will kind of bang into gear and make the whole truck shudder.
On one of it's episodes, it also did it in 2-3, however that only happened once and I haven't been able to make it do that again. I'm worried that it's something that I should address, if I can do so without just rebuilding the whole transmission. It doesn't slip and shifts fine most of the time, other than the occasional 1-2 issue.
To cut this short, does this sound like a 1-2 accumulator issue? Maybe just old truck syndrome? I feel like this is a dumb as hell question, but isn't it a bad idea to install a shift kit in an E40D with 126K miles on it?
View 3 Replies
Advertisement
I just picked up my 2016 4 cylinder Camry 2 weeks ago and have 1000 miles on it. I noticed that sometimes when it shifts it shifts a little bit rough, not sure if I would call it a jerk or shudder but its more pronounced to the point I can feel the shifts. Is this normal for this transmission or is this something I should have checked out?
View 9 Replies
I have 142k miles on my 2005 RX330 AWD. This week I can feel the transmission slip/shudder when shifting from 2nd to 3rd gear.
My local transmission guy is pretty reasonable but like most salesmen he's going to say rebuild it the entire transmission in lou of something less invasive.
View 6 Replies
I had recently purchased a 2003 golf gti AUTOMATIC (with optional shifter) with a 1.8 turbo 4 cylinder engine. The vehicle has 139,000 miles on it. Before purchasing, I had a mechanic come out and look at the vehicle for a pre-purchase inspection, and ran the code P0303 (cylinder 3 misfire) which without test driving, told me that is what caused the shift shudder I noticed when I had test driven it a previous day. He told me the coil packs were in good condition by looking at the top of them, and told me if I replace the spark plugs, the issue should go away.
I feel it is important to mention that he had also run codes on the transmission and nothing came up. Taking it home, this morning I had replaced the spark plugs and driven it for about an hour both regularly and aggressively to test it. The problem is still there, and I was really hoping that there is a solution to this problem, because everything else on the car is beautiful, while being my dream car, I just want it to work as well as I know it can. To be more descriptive, when shifting to 3rd the whole car feels basically like it is tripping over itself before successfully shifting.
View 10 Replies
I have a 2007 Passat wagon 4 motion V6 and what the problem is I am getting a rough shift between 3-4 gear sometimes, usually on a slow acceleration. I have had the valve body replaced which worked for a couple of months until the problem returned. I then had the transmission replaced which worked a little but the rough shifting is still present at times. The car still has warranty and not even the dealership knows what to do?
View 12 Replies
I around 1200 miles. The car would get going when i give it gas but it feels as if their was shifting lag or slipage. Only in first gear. Doesn't happen all the tho..usually happens on rolling stops... is this normal?
View 6 Replies
A few years ago my auto transmission in my 3.5 L engine hyundai santa fe started shifting rough from 2nd to 3rd gear, i did a trans flush and changed the input output sensors, anyway last week it started again, so i just changed the input output sensors again, it did not fix the prob this time, do you think a flush would work.
View 4 Replies
My son has a 2013 Fx4 crew cab 4X4 ecoboost with 8500 miles. He says in the morning for the first couple of miles while accelerating gradually the trucks shudders when shifting gears. After a few miles it goes away. Dealer says they can't do anything endless he can duplicate the condition. He went out of town for a few days and left me the truck so I'll drive it in the morning and see what it does.
View 3 Replies
They are about my F250. It is a 92 with 186000 miles. I love this truck.
After a long trip, maybe 1.5 hours, the truck will shudder while I let out the clutch in first gear. This only occurs in first, and it doesn't happen after the truck sits for a bit, just after driving.
I have an opportunity for a good deal on a F150. It is a 2001 with 181,000 miles for $4000. Is it worth updating for the new technology even if there is the same old high mileage issue?
View 9 Replies
Replaced the 2002 ford explorer 4x4 traction control module because of a shudder in first gear. With the new module the shudder disappeared but now the truck shifts into 4wd by itself and stays there. I am now on my 2nd new module because I returned the first one thinking it was defective.
If I cycle the 4x4 high switch and the 4x4 auto switch, the truck switches back int 2wd but on for a moment then goes back into 4wd. I don't get a 4x4high indicator light but I can hear and feel it is in 4wd. Almost like it thinks the truck needs work with the traction. I have now disconnected the module completely and the trucks runs/shifts beautifully in 2wd. I know my transmission is good. BTW, I have no trouble codes.
Do I have a bad speed sensor somewhere? and How do I trouble shoot for it?
View 8 Replies
My 2011 ISF has around 50K miles. Recently I noticed that when I shift into 1st from 2nd, usually on approach to a slower curve or slowing down to a light, there appears to be a distinct shudder. It doesn't happen all the time, and it happens regardless of Sport or normal mode.
Right after it shifts to 1st and the RPMs climb (or so it seems), I get 3-4 distinct back and forth movements .. i.e shudder. I think this is a recent phenomenon, as I know shifting into 1st is usually not very smooth, but I don't think I felt this shudder before.
No codes etc ...everything else normal. Don't think the trans is slipping, as car pulls hard and traction control is always busy. Motor mounts? Car is never tracked and driven spiritedly, but never ever abused or tracked. I do enjoy shifting it.
View 11 Replies
I asked a question about the E40D a while back about a hard 1-2 shift. However, I needed to replace the shift lever to get my OD light operational again. I fixed it and the issue seemed to stop for a while, so I just forgot about it. It's back again, last time it did it, it was hard enough to make the whole truck almost buck. It was a real good bang. So, could this be the 1-2 accumulator piston or the bore it resides in?
The next question I had is how long should an E40D take to shift from second to third? I've noticed on a steep onramp with some throttle, mine can have around 2.5-3 seconds of rev before it finally shifts (unloaded). I could of sworn I watched the tach climb a hundred revs or so during this once (real steep onramp), however maybe I was just dreaming, as I've never replicated it. Just wanted some opinion on this, wondering if I need to start putting some funds aside.
The truck has about 139K and the transmission looks to be original. It was used to haul a camper and a boat most of it's life, or at least that's what I was told.
View 3 Replies
I just put a rebuilt 4r70w in my '97 expedition and it shifts good but in 4th gear when I let off of the accelerator it starts to shudder until it shifts to 3rd. It acts like it is freewheeling then catches on and off. My thoughts so far is that I don't have the digital transmission range sensor positioned right or the overdrive servo isn't working properly.
View 1 Replies
Had tranny fluid and filter replaced a couple months ago. It's in a 35 foot motorhome (F53 chassis). The motorhome is within it's GCWR. Climbing a 6% grade at 3,500 rpm, little more than half throttle, like all the other climbs. 80 degrees out. Engine temp was on the letter "R" on the word "NORMAL". All of a sudden my engine redlines as if it popped into neutral. I let off, put it into neutral, and try "D" again. Nothing.
At this point it's uphill so it's naturally slowing down and I try "2". Nothing. Even slower and I try "1". Nothing. Pulling over blocking the right lane on a blind curve on a grade is scary. Had pylon cones out, waving traffic to warn them down a ways, etc.
No fluid on the ground, no slipping prior to this. I have reverse. I see no obvious linkage or electrical/wire issues underneath (from road debris, etc). It's at a shop but I want to know all I can so if they come back with something outrageous I can make a decision. I never pulled the stick, as I was coordinating traffic, highway patrol, a tow truck, etc.
View 6 Replies
I have a 96 Ford f super duty with a 7.5l and E40d after about 30minutes of driving O/D light will flash but still operate in all gears. Pulled codes and got 628 excessive converter clutch slippage and 657 fluid over heated. Now I have not felt a shudder which would indicate slippage like my 91 ford E40d does on lockup. And the temp never got above 210 until the light started flashing or I came to a stop. and front seal leaks also which in a tsb a read of another forum claimed that leaks can cause that code. I have already replaced solenoid pack after it got fried when the problem started last Monday...
View 14 Replies
I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.
View 6 Replies
Ok long story short I was given a conversion van that is built on a e150 van and has a 5.8 liter with an e40d tranny.. This van sat for at least 3 years till recently..
I have cleaned all electric connections on the tranny and the one on the rear differential . New filter and fluid but did not drain the converter after driving it for about an hour we finally got it to start shifting gears automatically the problem is it wants to shift only under heavy acceleration and then only to second at about 35 mph and drive at about 60 mph and over drive around 80 mph and all this only under heavy acceleration you let of the gas a little and it starts down shifting..
What I may look for next that may be pretty easy to try. My thoughts at this point are maybe the torque converter is going south but I am hoping for a more simple solution..
View 8 Replies
I have already logged 6K miles on her, crazy, but it's my job. I have pulled 5 maybe 6 trailers (form trailers, about 15K pounds loaded, this time of year). Loaded or unloaded, when I push the throttle in 2nd, 3rd gear, I feel a shudder, like transmission shudder.I know this thing throws down 800 ft. lbs. of torque, should I not be pushing it so hard? Or, what am I feeling?
View 14 Replies
My tranny started acting up so I took it to a reputable transmission shop for repair.
Symptoms : Shifts very hard 1st to 2nd. Light flashes on overdrive button.
The following is what has been done at the transmission shop.
Computer failed to read codes. Sent out to rebuild. After rebuild, codes read FIPL needs replace. Done and gives good readout. Trans control replaced, speed sensor replaced, checked all associated wiring and plugs as well as ground. Dropped pan, changed fluid and filter. No parts in pan. Tech says pan and fluid looked good. Replaced coil pack.
After all that, this is what is happening..Clear all codes. FIPL reading good. No flashing light on shifter. It feels like it is shifting from 1st to 3rd, then back to 2nd. Still shifting hard and indicator light starts blinking again. He is going to read computer again. At this point, he suspects a mechanical problem in transmission but is reluctant to remove and tear down.
View 7 Replies
I bought a 1997 f150 with 160l miles on it. It is a 4x4 with the 5.4 v automatic. While I'm drive and in 4th and 5th gear, the tranny shakes the whole truck and then shifts hard! I check the fluid and it's still good and red but looks like there is to much. I'm planning on removing some and adding some lucus additive in it. What could cause this???
View 8 Replies
For the last few months my truck shifts rough between 2e and 3e gear. However it only does this first thing in the morning, when I leave the house I speed up until the end of the street, then when I let go of the gas it'll rev up a bit and shift from 2e to 3e while making a big clunking noise which I can definitely feel ...
It does it sometimes very rough and sometimes just a little bit. I used to not worry about it but i'm starting to wonder if something is wrong with my trans. Could it have something to do with the slip yoke?
Truck: f150 2009 xlt 4x4 supercab 6,5' box.....
View 14 Replies
