Ford Transmission :: 2004 Explorer Reverse In All Gears
Feb 8, 2015
I have a 04 Explorer 4.0 4x4 with 130,000 mi. It all started about 3 months ago. The truck would neutral out while driving. After changing tranny fluid and filter, along with rear speed sensor the problem returned after driving 3-4 miles. After digging deeper I found the transfer case was bone dry and fried inside. Replaced the TC and check fluid level again. Back out of garage and drove the vehicle approx. 2 miles. Stopped to grab a coffee and left truck running. Returned to find I had no reverse or drive. This is after driving it to where I was. Towed truck back home.
I noticed the vehicle would start in gear. Replaced neutral safety switch ( grooves properly aligned ). Started truck, reverse lights come on when in reverse.. The problem now is when I put vehicle into R,N,D,3,2,1, the truck does one thing... REVERSE. All gears put truck into reverse, no forward movement at all. I attempted to replace safety switch a couple of weeks ago but was unable to remove the nut holding the lever on. 2 days I spent on that nut. Now I'm wondering if I did something inside the tranny when I was wrenching on that nut for 2 days?
View 5 Replies
Advertisement
I have a 98 expedition with a 4.2 liter 4x4 and what I believe to be a 4r70w transmission (u code on the door sticker)
The original transmission went at 105k miles and was replaced with a new factory ford transmission by a ford dealer 3.5 years ago. The new transmission only has 10k miles on it.
Now the new transmission only has reverse. reverse works like normal but no forward gears. the idle will change when i put if in gear, but will not move, acts like it is in N . There is no strange noises.
It's hard to believe a new trany is shot already, no towing, or off road use.
My question is : is there ANYTHING that can go bad that would cause this? The trany fluid is clean and clear bright red, and no burnt smell.
I want to check everything I can before calling a tow truck to have it looked at. I will have it repaired if needed, but I don't think I want to replace another tranny.
View 14 Replies
The truck is a 2002 f150 4x4 5.4l... I was driving down the free way last night in 2wd doing about 90kpm when there was a loud bang like a ran over something. Speedo went to zero and abs light came on. Pulled over and shut it down. Crawled underneath to check so damage and couldn't see anything. Stared it back up put it in drive and it just revs. No forward gears or reverse. Fluid level is good, bright pink. Dropped the transmission pan, pan is clean and magnet has next to nothing on it.
View 14 Replies
2003 Explorer with a slipping transmission...codes are P0731, P0732, P0733... Just had a new solenoid pack installed last week when O/D light came on and truck was clunking into reverse. Now, after new pack was installed the forward gears are slipping all over the place!
View 5 Replies
I had been waiting to fix my explorer for a long time. The "previous owner" I will call him knowingly sold me a vehicle with a bad tranny without disclosing it... long story. To get to the important part, it had the common 2/3 shift flare. I dropped the pan, filter, and valve body, making sure to use a template and put the bolts where they go. Then i took the valve body to the work bench and replaced the gasket, which was surprisingly not blown. After more looking around, I realized the previous owner had already had the fix done. I tightened the EPC 1/4 turn and reassembled the tranny. When i started it, it was stuck in first gear. PRN21 all went forward (park just revved a bit due to the park lockout.)
I tore it back apart and found that the plunger on the side of the valve body was stuck in the 1st gear position. I pushed it back out and cleaned it up so it moved freely. Then I reassembled the tranny using new fluid again.
After that the tranny was stuck in neutral. I dropped the pan again today, and tightened the valve body bolts and made sure my solenoids are tight. Filled it back up slowly with the engine running. It shifted into gear for a second (tried to go forward while it was in reverse though). Then it was again stuck in neutral in all the gears again.
View 2 Replies
I recently bought a decent looking 1999 f250 4x4 5.4 auto. It has no forward gears and will only move in reverse. I topped off the fluids and have found no leaks so far the cooler lines are crusty but dry. I am gonna need to swap this thing out or do some more trouble shooting if there may be a non rebuild issue to solve.
View 4 Replies
I have a 95 F250 with 7.5 and E4OD. I was towing my Jeep and trailer out for the weekend a few months back (its been parked since) and heard some noise coming from the trailer. So at a stop light I put it in park with the engine running for a second, went to put it back into drive and it hasn't gone back into drive since. Reverse works perfectly. Fortunately I was able to back up onto the center divide, unload my Jeep and back the truck onto the trailer and tow home with my buddies Chevy. Anyways, its been dead since. Where I can start to look? None of the forward gears work at all.
View 13 Replies
The other day I was leaving my house. I started the car and heard a quick, loud chirp. That was the only noise it made so I continued to leave. I rolled out of my driveway and proceeded to put it in drive and found myself rolling backwards. I tried every forward shift, kicked on the 4x4 and continued to roll backwards. I thought reverse worked but found that it wasn't engaging either. My question: is there anything I can look at before resorting to taking it to the tranny shop? I'm in school for automotive and am confident in my abilities to test solenoids and maybe even dropping the valve body to check that. Other than that, I lack the skill to pull the tranny myself and work on it.
View 3 Replies
My 1999 7.3l Disel 4x4 transmission quit on me the other day. No forward or reverse. Got towed to my regular repair shop, and they are treating the transmission as a black box and recommending total replacement. The diagnostics they performed were to make sure it was shifting, and that indeed it wasn't going forward or reverse. They drained the fluid and said "it's pitch black" and said it had to be completely replaced.
Fluid level was OK, and it wasn't hot. I was driving along, and merging onto the highway. It downshifted, shuddred, and nadda. Free rev. I coasted to the next exit and into a parking lot. Verified that it was shifting, checked Rev and all forwards. It wouldn't shift into 4W, and 1-2 also wouldn't move.
I'm trying to figure out what might have happened... and if it's worth trying to have the truck towed to a transmission shop and have them diagnose and rebuild, vs just getting a remanufactured transmission. None of the local wreckers have any used transmissions, and the cost between a reman and a used is pretty negligible...
Not sure what the symptoms points to for exact failure mode, be it the torque converter, pump, input shaft, etc... I've never had an automatic transmission apart before, but built plenty of motors and am a machinist by trade. My preference is to try and root cause the failure...
View 1 Replies
My '87 Chevy S-10 transmission slips like mad in forward gears and I can't go everywhere in reverse. The truck is gaaged in southern Virginia about 60 miles from my home and is used on some country property. The local transmission shop wants $1600 to rebuild the trans. He says he used sturdier parts than the replacement GM parts. I'd like to fix the truck because it comes in handy and was my dad's old mode of transportation around the Va. countryside, so it has sentimental value.
View 3 Replies
I have a 1995 Subaru legacy wagon, 176K miles. The reverse went out about 10 months ago; all the other gears shift fine and it runs great. Do I have a bad transmission or could it possibly be some kind of switch or solenoid? I have searched the net for hours and keep coming up empty.
View 1 Replies
I'm having trouble with the automatic transmission in my 04' Elantra, it acted like the speed sensor was failing, but later the same day it lost all gears, forward and reverse. after turning the car off and sitting a while I started it back up and had gears again, but the trany is making noise. Fluid level is ok.
View 3 Replies
I recently bought a 2001 Sante Fe 4X4, (my first Hyundai), that has transmission issues. It has about 135,000 miles on it. It will start easily, and go into Reverse just fine, but would not move in any forward gears. It would occasionally shudder a bit when put in 'drive', but only move forward a few inches. Recently, my mechanic backed it around, then decided to try it in forward again. This time it went forward a couple hundred feet, then quit moving forward. Do I need a new transmission, and if so, what vehicles use this same transmission? Or is there a sensor or valve that could be defective?
View 5 Replies
I drive a 1998 honda civic 5 speed manual transmission. The transmission is loud in all gears(including reverse) nearly all the time. It is not exactly a grinding sound, but that is as close as I can describe it. When taking off from a stop, sometimes it won't initially make the sound, but around 15-20 mph it will start to make the sound in 1st or 2nd gear. Once the sound starts, it won't go away. I can't link the time when it starts making the noise to any particular RPM.
I've hard the car for 5 years and 50,000 miles and it's made this noise the whole time I've had it. It is annoying more than anything (shifts smoothly, clutch not slipping). Someone who looked at my car shrugged his shoulders and said "when the clutch goes, put in a whole new transmission, that will probably fix it".
View 8 Replies
I'm in a situation where I may be having to tow my 3500# boat/trailer with my '04 Explorer 4WD (this is well within the max tow limit, per the manual). I have the 4.0L with the 5 spd auto tranny and 3.73ls gears. I've towed the boat a handful of times with this vehicle and had a good experience every time. Now I'm looking at this being my primary towing vehicle, towing once or twice a month in the summer. The car only has 48000 miles on the ticker and is in pristine condition, so mechanically it's sound.
I asked my mechanic what he thought of this arrangement and he hates the Explorers, so he's giving a biased response. Have any of you towed something on a somewhat regular basis with this, or a similar, vehicle? Any issues? My mechanic keeps going on about the transmission seal blowing when under a heavy load.
View 3 Replies
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 Replies
While driving on highway lost gears no reverse or any gears. check fluid ok no burnt smell
View 2 Replies
My car has an intermittent crackling noise when changing gears from park to reverse, park to drive, and vice versa. It also starts squeaking (coming from the engine) when backing up. The crackling noise almost sounds like sparks.
Having that issue in their generation 2 Prius? I was told by the service adviser that it was the brakes. I think it sounds like a bad issue, although I was told it was completely normal, and maybe they can clean something. Is this pretty commonplace?
View 19 Replies
Transmission on 04 V8 phaeton is slipping between first & second gears. transmission repair $4-10K. thought of just taking out the first gear via reprogramming (had a jag where you could do that for snow/ice conditions). do yo think taking out the first gear will cause extra wear & tear on the drive train? The first gear seems to be very short.
View 16 Replies
I got a 2004 F150 that won't go into reverse. All other gears work, including 4 wheel drive. I checked the linkage and it is working.
View 1 Replies
2004 Dodge Neon SXT ... Let me say first, I know very, very little about cars. But it all started when I was driving down the road and my car was bucking around 40-45 mph, it stayed that way up until I put some gas in the car the next day and the car started shaking violently when I turned it on. Ever since then my car has been not able to change gears. Reverse works normally however. Now the speedo doesn't work at all and somehow the has gauge will fall or rise depending on whether I'm stopping or going.
So I ran to AutoZone and got a diagnostic ran on my car. It gave me codes P0700, P0731, and P0720. I kept calling around and got horrific quotes around a thousand bucks and mechanics saying my transmission was out. However, I turned it over to a close friend who could work on it for free and has some mechanic experience. The first thing we did was replaced both the output and input speed sensors, which didn't fix it. Then I got a new transmission control module, which for my car I assume it is the TCM and solenoid. Still. That didn't fix the problem. Those were some common fixes I found online for neons. But what else it could be.
View 5 Replies
