2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 RepliesMy sonata 3.3 dies when switching from forward to reverse and vice versa. Suspecting the fuel pressure regulator. Have seen conflicting sites saying its on the firewall and some saying in-tank. What else may be causing this.
View 2 RepliesI continuously read that people with 6.2 F250s averaging 13 mpg or so in a combination city/highway driving. This 2014 4x4 barely has enough power to move itself (honestly, I'd rather have my Ram 1500 back) and barely gets 10mpg. Basically have to give it about half-pedal to even get up to freeway speed and floor it if i want to pass anything. Is it just that much of a POS or does this not sound right? Other than a massive "clunk" sound when shifting from reverse to drive or vice versa, no indication of any problems.
View 14 Repliesmy 99 f250 sd ABS light comes on and the A/C stops, when the ABS light goes off, A/C comes back on. Any clue as to what is happening?
View 5 RepliesI have a 2008 f350, crew cab,6.4L. with 27,173 miles. may have a problem with the steering, seems to be tight when turning from left to right or right to left, doesn't seem to center, if I turn a little to left or right it stays there. I can go in complete a circle. Raised front off ground turns ok no binding, nothing loose on the front end.
View 1 RepliesSuddenly I notice noice/clunk when moving from P to R/D or to P from R/D with voice like shifting something , also I am feeling Like something hold the gear sticky, I think the voice came from the transmission itself.
My car santa fe 2009 / 70,000 KM , 2700 cc automatic gear. I changed the transmission fluid since around 2 month @ 64k from the Hyundai dealer , with reset the transmission software ,
is it normal to have or there is something major , is that to indicate of problem at the transmission ??
2016 push button start, need to confirm something? It's cold up here in these parts this time of year and I have been letting my car run for a few minutes when it's frosted over in the morning. The issue I'm having is that I start the car and go back into the house. When I come back out to get in, The driver's door is unlocked but the rest of the doors are not. When I press the unlock button on the key fob, nothing happens. Is this how it's supposed to work or do I have an issue?
View 4 RepliesI have an 05 F 250 super duty with the Triton in it. When I shift either into overdrive or reverse the transmission hesitates (does not go into either gear for about 5 to 10 seconds). After that it engages and it's fine. It does not appear to be slipping or acting up regardless of temperature or speed. Sometimes it will sort of engage and than bang into gear solid. I do not have any check engine lights. Not sure if the PCM has any codes. So I'm trying to figure out if I need to have a complete rebuild or if I have a valve / solenoid body problem Where do I start?
View 4 RepliesI have a 2002 7.3 e350 quigley 4x4 Sportsmobile with 312k miles. 2nd owner. Bought it with 295k miles 2 years ago. From what I gathered the tranny is original.
After reversing at a downhill angle, stopping, and shifting the lever to Drive, the tranny doesn't seem to put Drive in gear and depending on the angle of the slope, the van will roll back or barely creeps forward even with throttle. Put it in 1st gear, and the tranny engages that in gear and drives forward no issues, then I can shift to 2nd, then Drive and the tranny shifts fine after that.
No weird tranny noises or clunking. Noticed this issue about a month ago or about a couple thousand miles ago. Did tranny service (drain, filter, fill) at the ford dealership at 305k months ago.
I can only replicate this issue when Reversing on a down slope. On a flat surface van Reverses and engages Drive like normal.
My 1999 7.3l Disel 4x4 transmission quit on me the other day. No forward or reverse. Got towed to my regular repair shop, and they are treating the transmission as a black box and recommending total replacement. The diagnostics they performed were to make sure it was shifting, and that indeed it wasn't going forward or reverse. They drained the fluid and said "it's pitch black" and said it had to be completely replaced.
Fluid level was OK, and it wasn't hot. I was driving along, and merging onto the highway. It downshifted, shuddred, and nadda. Free rev. I coasted to the next exit and into a parking lot. Verified that it was shifting, checked Rev and all forwards. It wouldn't shift into 4W, and 1-2 also wouldn't move.
I'm trying to figure out what might have happened... and if it's worth trying to have the truck towed to a transmission shop and have them diagnose and rebuild, vs just getting a remanufactured transmission. None of the local wreckers have any used transmissions, and the cost between a reman and a used is pretty negligible...
Not sure what the symptoms points to for exact failure mode, be it the torque converter, pump, input shaft, etc... I've never had an automatic transmission apart before, but built plenty of motors and am a machinist by trade. My preference is to try and root cause the failure...
I have a 89 f-150 xlt with what i believe is the m5od (4 speed with O.D) transmission and the 5.0 motor, the trans has been whining since I've owned the truck and it started popping out of reverse on me a couple months ago, now i have to slam it into gear to make it go anywhere even when I am going down the road! The clutch is fine but the trans is hanging up, anyways i have a granny gear transmission a buddy of mine gave me out of an 85 f150 that had the inline 6 if i take the bell housing off of my transmission can i put the internal slave cylinder on that transmission? Will it work or will i have to find a way to put an external slave cylinder on it?
View 9 RepliesI have an 01 Elantra Gls with perplexing issues. The car starts at 3000 rpms, and continues to bounce between 2k and 3.5k in both park and neutral. when I put it in reverse i get a very hard shift. It actually jerks the whole car. in drive and reverse, it idles around 1.5k it hesitates quite a bit to accelerate. All fluid levels are right and don't smell burnt. it takes me 10 mins to put 4 gallons of gas in. if i pump too fast it shoots back at me. i randomly smell gas while driving. Im hoping these problems are a couple of issue I can handle at home. i just wanted some input before i buy the manual. thinking vacuum lines maf sensor.
View 7 Replies Daughter driving truck truck quits moving, I get there no drive and no reverse, has low and 2nd manually.
drive truck home, flush trans and cooler, road test all ok. this was 3 weeks ago.
This morning did it to here again, no drive and no reverse, she drove it home using manual low and 2nd.
I get in and when put into drive it feels like it tries but doesn't go all in, same with reverse. pulled it into low and vola I now have drive and reverse again
I'm thinking a we may have a bad or going bad shift solenoid. What I need to know is, is any of the solenoid valves on when in reverse are they the same as when in drive?
Just recently, my '93 transport 3800 has started making weird sounds when engaging transmission , forward...and specially reverse. This is not a transmission problem. It sounds like there is increased torsional movement of the engine/transmission unit and it made me take a look at the engine while would shift in drive and reverse....it does lean much..impressive ..but in fact I do not remember having tried looking for that before...so I cannot compare.
View 9 RepliesThis transmission shifted smooth and strong through all gears until today when it stopped all of a sudden to engage either Drive or Reverse. No previous signs of slippage, hesitation, stalling or lack of power whatsoever.
We checked the linkage to the transmission and it works as intended, nothing loose or broken, everything is in place. If there was something slightly different with it from other similar vans we have then it had a slightly delayed engagement in Drive (it took a second to engage it after you moved the lever) - on all other vans we have the transmission go into Drive almost instantly.
Van is a '92 Pontiac Trans Sport/Chevrolet Lumina APV with the 3.1L V6 Chevy TBI engine with the 3T40 automatic transaxle. Where we should start tackling this issue?
02 ranger 4.0 v6 auto has 110000 miles on it. at highway speeds 65-70mph feels like it strugles to shift, truck will shake and bounce some. when this happens rpm's jump from about 2200 to 3000-3200 after a little bouncing rpms drop to normal. issue seems to be the worst going up hill but will happen every time i hit 65-70. Also the truck will not bounce or shake with the OD turned off and seems to run fine this way.
tranny fluid/ filter just replaced with no change. new plugs and wires
If I press the gas a little hard in drive, my tires squeal but if I'm in reverse I can feel a slipping in the trans. If I try to back a trailer up an inclined driveway, it won't go, the trans slips. I have no crud in the pan. I've replaced the reverse boost valve. I installed a Trans-Go kit which is suppose to eliminate the reverse slip but it hasn't worked. Everything else works just fine and my fluid is red. I have engine braking in 2nd and 1st. The van backs up fine, it just does this in reverse under load.
View 2 RepliesHad this thing rebuilt less than 8k by a reputable local trans builder and the reverse started to fail on me told the guy the problem and said everything is "normal". Drove it and the thing started to act up slamed out of OD and the light started to blink. Took it to the guy to get it checked and said most likely the tranny is toast the fluid does smell burnt.
Then he told me that I had two codes and that they were the cause of the tranny to fail, the codes were P1105, P1106 and that the voltage going to the solenoids was low roughly at 8.6 volts... Can the alternators have anything to do with tranny messing up? I took the to be tested and both alt are good I have a constant supply of 14.4 volts from the alternators. Can this be the pcm taking a dump?
Forgot to mention that this is a 2001 f250 platinum Edition 7.3 power stroke.
My transmission has started acting weird. When it's cold it seems to be not as bad. First thing is when I put it in reverse it hesitates for a few seconds then goes into gear. Second it will drive great then just out of no where start shifting very hard then go back to shifting smooth again. Third when pulling a load it won't always start in 1st gear when you come to a complete stop sometimes it tries to start off in 4th.
View 8 Repliesmy parents have a f350 which now has no reverse. it has a reman sticker on it, 230k on the truck but no idea on mileage on the tranny. shifts 1st through 4th fine, no slip. Tc lockup works just fine. No codes found with my solus scanner. When shifted in reverse it will move back about 2 ft if revved above 2k and then nothing. Am I looking a trans rebuild or is there something I can check and repair with in it the truck?
View 4 RepliesI have a 2011 super duty with the 6.2 flex. When shifting into reverse, it hesitates, then slams into reverse. Same on the lower gears when driving. This doesn't occur all the time, but the majority. Been talking to a couple other super duty owners (diesel owners) who have been having the same prob, but not as severe. We all have noticed the prob after having charcoal filter replaced. Is this a tranny issue or computer issue?
View 3 Replies