Ford Transmission :: 2001 F150 Truck Shudders When Letting Out The Clutch
Jun 23, 2013
I have a 2001 F-150 4.2L 2WD LS with 102k miles. At 95k miles, the clutch slave cylinder started leaking fluid. So, I had my local garage replace it. And while they were at it, put in a new clutch. That is when the trouble started.
I cannot let the clutch out like I used too. When letting out the clutch from a dead stop,the rear end now shakes, shutters, and if it is really bad, the rear end starts bouncing. To minimize the shakes, I have to keep the engine below 1000rpm until the clutch/1<sup>st</sup> gear is fully engage. It is worst when there is a load on the truck like going uphill, or a sharp turn for a dead stop. After the truck gets rolling, I don’t notice the problem when shifting gears.
I have been babying it for 7k miles and it has not improved. What is wrong? Did I get a bad clutch job?
View 8 Replies
Advertisement
Started up my truck today, accel pedal didn't want to move, after giving it some more force it eventually became "unstuck". Now, the real issue I'm having is from a dead stop, in 1st gear, as I'm letting out the clutch the truck boggs down as if I'm not trying to accelerate. I'm giving it as much as I normally would as I'm letting out the clutch but the motor will either die or take a couple seconds before it starts to go. Once I'm moving I don't notice any problems clutching through gears. The check engine light IS on now, however I don't have any diagnostic gear or really any tools for that matter. 1998 2.4L 5-speed...
View 2 Replies
Normally I'm pretty good about searching and finding info, but there doesn't seem to be a lot out there for these trannys. In any case, when I hopped in my 20th to move it today, I got this grinding noise when letting out the clutch. The car won't go move in reverse or any of the forward gears. Idles fine, sounds fine when in neutral or when the clutch is depressed. It just grinds when you let the clutch out. Seems like I can select each gear OK. Linkage feels normal.
View 2 Replies
I have a 1991 Ford F150 I bought. Told the transmission was shot, long story short, found out it was just a bad clutch. Pulled the transmission, replaced the clutch, pressure plate, and throw out bearing. Put everything back together, now i cant get the clutch to fully disengage. Had good pressure prior to replacement of the clutch, still has some pressure. just doesn't have enough to disengage the clutch. pulled the inspection cover, and verified the slave is moving. What is causing this issue?
View 14 Replies
1996, f150, 300, 4x4, 5 speed, 296,000 miles... My pedal goes almost to the floor before the clutch engages and about a half inch, maby less, of travel back out the clutch disengages. I think it is about time for a new clutch. My question is what is the best clutch to put in my truck?
while i have the transmission slid back to replace the clutch i am planning on replacing the slave cylinder while im in there as well. Any particular brand better than the next on that item? Are there any other items that I should think about replacing while i have the transmission slid back to do the clutch?
View 4 Replies
I have a 1995 F150 with the 4.9L and it has 73000 miles on it. One morning recently (it was about 35 degrees outside) I went to start my truck to let it warm up. When I let off of the clutch it stayed on the floor. I shut it off and drove my car to work instead. I asked around at work and one guy mentioned that it was probably my clutch master cylinder...so that day we replaced it, and bled it until it felt like knew. Since then, we have had to bleed it three more times, because the pedal keeps losing its pressure making it harder to shift. I have inspected around the clutch line and the bellhousing for signs of needing to replace my slave cylinder, but everything looks fine.
View 8 Replies
I know my clutch is not going to last forever and I do think Ive gotten my share of use out of it but i want to know if there is a way i can determine just how much more life there may or may not be. Although I have not looked into it yet, Ive just learned to read these awesome forums before jumping to conclusions.
I have a 2000 f150 4.2 v6 with about 180.000 miles and i am starting to lose my pedal, not much left anymore. I think. Am I able to see the clutch plate via the inspection cover?( i know stupid question). if so , what do I look for.
View 3 Replies
1996 F150 4x4 with 300/6 and M5OD mazda tranny. 145k miles on it and looking really clean, and just the truck we wanted. It used to be well cared for, but has been a bit neglected since the owner passed away.
I spent a few hours searching the forums here and didn't find anything matching my symptoms exactly so I thought I would just jump in a post, but if I missed a thread feel free to redirect me.
I've got a bit of a rattling noise as the clutch engages when taking off in first. Once the clutch is fully engaged it's quiet and it shifts well and smooth. Noise also occurs (but less so) if I don't match RPM's and ride the clutch into second or third. I don't think its engine noise from lugging or anything because it goes away as soon as the clutch is fully engaged or disengaged.
Changed the trans fluid last night and no different, Clutch fluid reservoir is full, clutch travel feels good, master cylinder looks good, (slave is hidden, but looks dry though dust cover) a little play in the white bushing that holds the clutch pedal bar in place, and the plastic pushrod that goes into the firewall, thinking about replacing this linkage.
I work on big diesels for a living so i'm not scared of getting greasy. I'm almost inclined to think someone did a clutch job without resurfacing the flywheel. Is there an improved replacement for the pedal bracket and linkage? I don't mind just doing the clutch, but I don't want to be throwing my money away.
View 4 Replies
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
View 3 Replies
Recently my 2001 F150 4x4 5.4 truck has been misbehaving by being difficult to start at random times. The engine will turn over with however will not fire. After some time, I am able to get it to fire. When this happens the truck start normally for the rest of the day and maybe several days. Around the same time, error codes for a variety of sensors would occur. This problem was traced to a broken PCM connection. When this problem does materialize, no error codes are generated. After some time in repair shop, a probable cause could not be found.
View 9 Replies
I have a 2001 m5r2 ford f-150 standard transmission. i have replaced the slave cyl., the entire clutch assy., the master cyl. pilot bearing. the trans. will engage all five gears plus reverse while truck is off but will not engage a gear while running. i have bled and bled and bled and still will not engage.
View 1 Replies
I'm a new owner of an '89 F150. It's a four speed manual trans, 4.9L 6cyl. This is my first truck and I bought a beater in hopes of learning while I fix it up. I have minimal experience (biggest repairs have been replacing disk brakes on a previous car and replacing the EGR valve on this truck), but I want to learn more.
The truck has a bypass switch and the forward fuel tank was removed. Both of these modifications occurred before I owed it. Also, the clutch is a bit grumpy. Sometimes I'm unable to get it into first (I usually "granny start" from second), and every once in a while it doesn't want to go into reverse.
When I bought the truck, it would just choke and cut off after driving for 30 minutes or so. It would restart after cooling down. My mechanic said it was a problem with the fuel pump and replaced it, and that fixed that problem.
After that, the truck began to have trouble starting. I would flip the bypass switch and the engine would rev up, then drop RPM's quickly until choking off within a couple seconds. When I flipped the switch again, it would start up fine. It would run fine after that.
A mechanic recommended having the fuel injectors cleaned. The fixed the problem for about a week, then it started again. A friend of a friend who has a home garage suggested a vacuum leak, and we found a leak in the EGR value, which we replaced.
Replacing the EGR valve fixed the problem again, for a couple days, but it came back. Meanwhile, immediately after the EGR valve was replaced, a new problem started. Periodically while I'm driving (I haven't been able to detect any pattern), the engine will just shudder or choke a bit. It feels like it's threatening to choke, but it never actually does. Once it starts, it typically does this every couple seconds until I shift gears.
I'd really like diagnosing what might be causing the choking when it starts and the new shudder when driving. I realize it could be a number of things.
View 6 Replies
I have a 2001 Ford F150 Lariat. It has the 5.4L Triton motor. I was having starting problems as such the truck would crank and not start or crank, start and barely idle and stall within 5 seconds. It was NOT tripping any lights. I was told it was a possible fuel issue. I have since changed the fuel pump, fuel filter, as well as the hoses in the rear connected to the tank. Truck started, ran great, even seemed to have more power. Ran great for about a week. I was on my way out yesterday about 2 miles from home when the truck just stalled out on me. It is now having the same issues it was having before I changed the pump, filter, etc. What the issue may be? Clogged line? Fuel injector? If it is an injector how can I tell which one?
View 8 Replies
I'm under the understanding that my 03 explorer AWD tranny level can't be checked. Is this true. Well anyway , went on a 1000 mile round trip. Left for work following morning and truck wouldn't shift to 2nd without letting off the gas. OD lite was flashing. Got to work. Left work and goes into 2nd fine but now it wont hit 3rd till I let off the gas. No OD lite flashing but now check engine lite is on. Watzz up. I would like to check the fluid....but see above.
View 2 Replies
Pretty nice condition 2003 1.8t Passat 5 speed yesterday with 45k miles. nice price, mint interior, only a few minor blemishes on the bumpers.
Anyways, I was noticing that the gas pedal needs to be pushed in about half half before the car wants to move. I do not believe it was the clutch going bad as the engine wasn't revving when i was letting the clutch out, it just didn't seem to move until the gas pedal was half way down. again, no clutch slippage, engine was not revving.
View 7 Replies
2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 Replies
I've got a 01 f150 yesterday stopped running (like it ran out of gas). Has half a tank. Fuel pressure at rails good but truck will not turn over. Fuel pump and filter less than year old.
View 1 Replies
The car runs fine clutch has pressure and everything. I can idle with the clutch pressed down and put into reverse and every gear BUT if I put it in a gear and start to let the clutch out I can hear a clanking or something flying around in there and it doesn't really want to go anywhere and I don't want to really let the clutch all the way out in gear or let it out for too long and screw anything else up worse..
View 2 Replies
I own a 2000 f150, 7700 with 199,000 miles, 5.4 eng. In drive with foot on brake, it idles at 600 rps, fairly smooth. When I accelerate from a stop the engine shudders. Ten months ago I had the plugs replaced, last week I bought 8 new coils and I installed them, no change. I removed the down stream o2 sensor from the exhaust, it was as clean as blued gun metal. Can these 2 sensors be cleaned or tested? The service engine lite is not on. List of things to check?
View 12 Replies
I have a 1996 VW Passat TDI which has a 5 speed stick (they all did). Yes, it's really old but it runs great and gets 45 mpg. However, the model is probably not relevant to this problem. My question has to do with clutch performance. When the car is cold (and it's cold outside), the car sometimes shudders starting out in first gear for a couple minutes. I have tried to be extra careful letting out the clutch in these circumstances. Sometimes that works, but it doesn't eliminate the problem. After about 5 minutes or so the clutch starts working well as it usually does.
View 10 Replies
I have a 2004 F250 with a 6.0l Diesel and a 5 speed automatic. The truck is 4 wheel drive. As far as I know it is completely stock and has 236,500 miles on it. I thought that I was having stiction issues because when the truck is cold and when driving ~55 mph (1500 rpm) in 6th, the truck shudders until ECT gets to about 150F. This is at a constant speed, when accelerating or decelerating it doesn't shudder. Today I held 40 mph (1500 rpm) in 5th and there was no shudder. I don't know the TFT the shudder goes away at because the epiphany about the transmission was today. Once warmed up there is no to very slight shudder and only around 55 mph (1500 rpm). Above or below that the shudder goes away.
View 11 Replies
