Ford Transmission :: 1999 F250 Will Not Shift Out Of First
Oct 6, 2012
1999 F250 super duty 5.4L 4x4 103000 miles. Just started yesterday going to work will not shift out of first.
I can pedal shift it. and then it is ok till come to stop . Start all over again.
Trans 4R100 automatic
Trans has never been touch from day one .
No engine light and nothing on shifter as for flashing light.
I would like to no what the problem is and about what it would cost to fix I am not going to try to fix this myself i can not do that.
View 6 Replies
Advertisement
I have a 93 f250 4x4 with a 5.8 liter with 69 thousand miles.. the problem I'm having Is if I put It in drive it won't shift out of first but if I manually shift it from 1st to 2nd to drive it works but shifts very hard. Sometimes it will shift in drive but It shifts really hard. I don't know what It could be. We just put the transmisson back into the truck due to having to change a broken flywheel. It just don't Seem like it has any power...
View 5 Replies
Well I Took my truck (1985 F250 6.9L IDI C6) and went through a little mud bog got some water in the tranny, no biggy i flushed the fluids out a couple times and went to drive it. But now it wont shift from 1st to 2nd but i can manually shift it from 1-2 I replaced the Modulator and that havent made a difference. Is there anything I should look into?
View 14 Replies
On my 96' F-250 4x4, The tranny will shift to 3rd gear and that's it. If I put it in Neutral and then back into drive it will stay in 4th gear for about 15 seconds then go back to 3rd. What could be causing that?
View 14 Replies
I have a 93 F250 diesel 4X4 with the automatic, the transmission was rebuilt by a reputable shop les than 10000. miles ago, every few months it will act up, it will act like I put it in neutral then it slams back in gear, then it shifts very hard, sometimes it will not shift until i lift the throttle. Sometimes I can shut it off and when i start it again it will be back to normal, other times it will do this for a few days, then work fine for another month or two.
View 5 Replies
I have a 1970 f250 with a factory 390 (vin verified) and a C6, I believe the transmission was rebuilt but have no way to verify. It works fine while cold and mildly warm. Once heat soaked it is very slow to shift (going from neutral to reverse can take almost 30 sec) and leaks profusely from the front. I can not tell exactly where the leak is. Could this be a case of just having too much fluid or is there a more serious concern? The dipstick does read high but level ground in my area is hard to come by so the accuracy can be questioned. If it does have to much fluid, do I just drain the pan, re-install and let it run till hot and replace fluid as needed or should I drain and replace with 3 qrts prior to starting?
View 7 Replies
2005 Ford F250 4x4 XL 5.4L 5R110W WITH 177,600 MILES... Tow Haul light flashed after 78 miles (along with other codes) after purchased. I purchased it used. While driving transmission would stop pulling as if it went into neutral and slam back into gear, at same time Tow Haul light be flashing...
Code is P0760 shift solenoid #3, I read from the forums on the site one caused could be the ground wire. We installed a ground strap from battery to tranny
Still does the same.
I have a shift solenoid ordered if needed, knowing the location of #3 solenoid in the tranny is the key to not having to keep dropping the pan. I love this site and have been reading it for long time.
View 9 Replies
99 F-250 with the manual shift 4x4, feels like I'm arm wrestling with King Kong to get it to work, this is my first 4x4 but I'm inclined to think this is not normal. This used to be a PA truck so it is rusty, the cursory look I gave it showed me massive amount of rust on the 4x4 shift mechanism. Should I just replace it or can it be rebuilt? Also should I replace the manual shift cover on the transfer case also?
View 3 Replies
I have a 1999 ford f150 v6 no 4x4 has wont shift from 2nd to 3rd, shifts fine from 1st to 2nd, after that tho there's nothing. What to do or what it could b?
View 1 Replies
My two oldest sons and I have a 1999 SD F250 4x4 with the V10 automatic. My boys burnt the trans. We had a spare that was pulled from the same year truck with the same motor. The boys installed it without me. Everything seems to work as it should, EXCEPT! 1-2 will not shift until 2800 rpm. 2-3 is the same. When I checked the install I found that the new trans has a speed input sensor on top of the housing behind the bell housing. It is Not plugged in, my harness does not have that plug. Old trans does not have that sensor. Is this the cause of the high rpm shifting?
View 14 Replies
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 Replies
2001 F250 7.3 - warn manual hubs.. However, the wife has been driving the truck and I don't know how often she has cycled 4WD.
Basically if you choose 4WD hi it doesn't light up to indicate that it has engaged, if you drive for a couple of minutes slowly then eventually it drops in - not much use if you're already stuck. It will then select 4Lo. Coming out of 4Lo to 4Hi or 2WD is painfully slow - like 5-6 minutes before the dash light goes out for 2WD.
I was thinking maybe the electric motor for the transfer case - unless it is the transfer case dying.
View 10 Replies
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 Replies
I tried searching and googling but came to no results, unless its like similar trucks. How do the 4x4 shift remove? I have an 04 F250 and someone decided to put the shift on sideways so the 4HI and etc read upside down before I purchased the truck. Do I just rip the thing off?
View 1 Replies
99.5 F-250 4 wheel drive. I have a rattle near the firewall in the shift mechanism. If I hold lever the noise stops. What is required to fix?
View 2 Replies
i bought a f250, i rebuilt the 7.3 after installing it the transmission isn't shifting correctly. Reverse perfect, 1st and shifts to 2nd great. wont go into 3rd. i replaced the 2 sensors on the transmission, i replaces the sensor on the 3rd member. the speedometer works but not correctly, i can unplug the sensor on the front of transmission and it shifts into 3rd. but when i plug it back it doesn't. no codes. could it be the ecm?
View 10 Replies
2015 F 250, less then 5k miles. When towing travel trailer, weight 7500lbs, on occasion transmission will not shift out of gear. Happens in first, second, or third. Very intermittent. Take off from a stop engine goes to 6k rpm. Let foot of the throttle goes all the way back to idle, still no shift. Accelerate back up to speed still will not shift. After doing this a couple of times finally shifts. Have had this happen in second and third. Not a lot of fun with cars behind you or trying to merge on highway. No codes
First trip to Ford dealer they re calibrated computer. Still happened towing. Second trip to dealer they put a flight recorder on it and I towed again. Did not hang up in first or second ,but would not shift out of third on highway doing 70mph, even when I lifted from the throttle and coasted. I finally shifted to manual and shifted to fourth and was able to upshift After reading flight recorder mechanic said it appeared normal. I explained that having to shift the transmission manually is not really normal and they agreed.
View 14 Replies
2014 F250 automatic- 35k miles... just started having an issue. Noticed when the transmission is cold, the shift from 2nd to 3rd is almost delayed. It's enough of a pause you can feel it then it shifts. Weird thing is it only does for the first 3 stop signs leaving my house. Once the trans starts getting some temperature to it, it shifts perfect. I checked the fluid while hot and it showed a little low. I drove it after adding fluid but will have to wait till it's cold to see if it's any better... Think it was the fluid? But why just 2nd to 3rd gear only?
View 3 Replies
I have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
I was driving down the freeway the other day and when I hit a rough patch of road, nothing major, the truck sputtered and the 4x4 Low light blinked a few times on the console. I was driving in 2wd at the time. I kept driving and every bump I hit the truck sputtered as though trying to shift and the light blinked. On smooth road it didn't happen.
Today I drove to work at 6:30AM (40 miles), no issue. At noon I drove home and the issue started again. Every bump I hit the light came on and the truck seemed to want to try and shift into 4x4 low.
I got home, parked the truck for a few hours, then went out again, no issue. But about 20 minutes later it started again. I pulled over shifted to 4x4 high, drove it, was fine, went into 4x4 low seemed fine, went back to 2wd drove it some more issue came back. I've read tons of online threads regarding 4x4 lights etc, none like this and none on F250 Super Duty (2008).
View 14 Replies
