Ford Transmission :: 1998 F250 Truck Starts Shaking Really Bad When It Shifts Into 3rd
Jan 7, 2014
I have a 1998 F250 XLT single cab 5.4L V8 Triton. Truck idles fine 1st and 2nd are fine, when it shifts into 3rd it starts shaking really bad until it gets higher into the gear then it smooths out. same with 4th gear. If i punch the gas it flies right through the gears with little shaking. Ive heard its the u joints, I've heard its the tranny. I don't know what to do or try to figure it out.
View 1 Replies
Advertisement
I'll try not to post an entire book.. But I bought a 2000 F250 not even 8 months ago, it did have issues before but I changed out the spark plugs and coils and it fixed it's original missing issues.. I also just recently changed the fuel filter but it didn't fix it's new problem.. It drives ok around town but if I get over 35 mph it doesn't run well... If I try to keep a steady foot on the gas but don't get the RPMs over 2000, the RPMs will stay where they're at for just a second then they will drop down and the whole truck starts shaking.. I push more on the gas and it shakes even more and the RPMs don't move at all until I really step on it.. It lacks in power going up hills as well... The dealership i bought it from said the Catalytic Converter was bad but my uncle who is a mechanic says it isn't.. It's the first vehicle I've bought so kinda wanna make it last..
View 11 Replies
I have a 1998 e-250, 5.4 4EOD/4R100. The speedometer quit working and with that came hard shifts. This happened previously (only with a blinking O/D light that time) and I replaced the VSS and then the shift solenoid and filter in the transmission pan. That fixed the issue for about 3 days. There were no codes in the computer.
For a couple days the speedometer would not work until about 15-20 mph, then it would work and shift normally. Now there is no speedo action and the shifts are hard at high RPMs.
In the days leading up to this problem I heard a clicking in the dash, seemingly behind the cluster. Kind of like a turn signal but a bit fainter. Before I go and order a cluster...is there anything else I should be checking for? I have no warning lights, and as I said earlier the O/D light is not blinking. We're converting the van to a camper for our upcoming honeymoon and tracing this down is cutting into the buildout.
View 4 Replies
We just purchased a 2003 Ford Lightning with 114,000 miles on it. Had oil changed. Had to get floor master mufflers attached back on. Ever since then now when it gets up to 65-70 mph it starts a terrible rattling noise , almost sounds like a spark knock. Truck starts riding very rough. We have have only run premium fuel and even put in some gas treatment to see if this works, it hasn't, only getting worse. We are currently out of town and trying to make it home but don't want to cause any major damage to it. All the gauges are fine. Just the rattling and shaking...
View 7 Replies
I was driving my 1998 Ford F150 the other day and pulled into a driveway. At that time, the transmission quit pulling like I put it in neutral. It shifts from park and goes into reverse but not drive. It has the 4.6L and is 2 wheel drive.
View 4 Replies
Driving up a slight hill unloaded yesterday at about 40mph constant pedal pressure the truck shifts into neutral...at least that's what it feels like. Revs go up and no power. When I take my foot off the pedal the transmission catches and drives fine. There is no bucking or hard shifting, just that slipping. What it could be? This problem arose suddenly....never had any problems prior. It is not an issue that has gotten worse over time...
View 14 Replies
My 98 honda v6 accord shifts hard sometimes when going into and out of low gears. The transmission guy told me it had to do with the material that was on the clutches wearing off, dislodging, and clogging things. I have been driving the car for several years as is. Should I have the tranny rebuild or keep driving? Am I making matters worse by driving it as is?
View 6 Replies
What is making my auto transmission shift harshly on my 1998 Mercury Sable? I changed its fluid but it didn't work.
View 1 Replies
I have a 1998 chevy blazer v6 about 127024 miles. My transmission shifts hard out of first gear when i get to 4 gear and it shifts hard. When car warms up really good car shifts find out of first gear but 4th gear still shifts hard. I did change transmission fluid and new filter in it and I check fluid level and it's full.
View 6 Replies
My 1997 F250 Heavy duty shifts very hard and sometimes feel like it slips out of gear (i press the gas pedal to the floor and speedometer rises very slow and truck doesn't move like it should.
View 14 Replies
I have a 2011 F250 with the 6.2 34000 miles and my Transmission shifts hard between 2-3 and 4-5 took it to the Ford dealer and they said it is the shift solenoids are bad but it is cause from the Powertrain Control Module and its not covered by the warranty because it is part of the emission system.
View 4 Replies
I currently have a 2006 F-250 6.0 with 187,XXX.
My problem that i am having is that the transmission recently within a couple weeks started acting weird about the same time 3 of my fuel injectors started failing. When i start up the truck and put it into drive it takes about 3-5 seconds to shift. Once it's in drive it runs pretty well but it will start shifting out of normal when i go to accelerate. Also when i go to slow down sometime the transmission shifts hard to a lower gear. I also have a video of the sound that it had started to make since its hard to describe.
Here are attached videos and photos. I want to hopefully fix the problems myself so i can learn more about my truck. I am going to handle the fuel injectors here soon since 2 are failing and ones about to these have been causing the truck to shudder at around 47-53 mph but after that its fine.
The transmission is stocked and never been altered, i do admit for 3-4 years I have changed the fluids or filters.
The truck is bullet proofed, sct tuner, upgraded turbo from stock, 4" exhaust, head studs and new everything when the engine was rebuilt and bulletproofed.
I plan on going to ford tmw to have them figure out the problem and hopefully its just solenoids so i can fix it myself. I have a link posted also where you can hear the noise it has been making when in R P and when shifting going down the road and it is a automatic.
YouTube.....
View 14 Replies
2008 f250 standard cab long bed 2wd base model 5.4. This thing has been great for the last few years i i owned it but it developed a shake since i got new tires. My mechanic mounted 4 new Hercules Terra trac at 2's on my 18 inch wheels (275 70 18) and when i got the truck back it was shaking violently at anything over 45. Mechanic says the new tires are heavy and its affecting other things...sounds plausible. So here i am a month later with a New steering stabilizer, all new ball joints, new shocks, new u joints, and 1 new tire (he said 1 of the brand new Hercules had a broken chord). The shake is 80% gone but this truck is still not the same. Anything after 65mph and it has a feint wobbly bouncy shake. I don't think its the dreaded hop that everyone gets on these. I have 2 theories:
1. These cheap tires just suck and will never be right
2. The cheap junk Monroe shocks he put on are way too soft to do anything
so what do i do? Should i get some crazy shocks or will that make this truck even bouncier? Im worried about making it even stiffer than it already is.
View 12 Replies
I have a 98 F250LD, its a Lariat, so everything electric/auto. Shift on the Fly 4x4, 5.4, 188K, Factory rear air suspension. Typical Minnesota rust. Anyway, I just noticed in the last 75 miles or so, a drive-line vibration. There is nothing until 39 MPH. Then from 39-41 MPH there is a decent vibration. Stops until 50, then from 50 MPH up it is a steady vibration. I have already changed the u-joints in the rear shaft. I have pulled/wiggled on everything else I can think of with no luck of finding of anything loose.
One thing I did notice, is that the front axle is locked in all the time. How long it has been like this: years for all I know... I can flip the switch from 2wd to 4H and 4L. It all seems to work fine, I hear clicking, the 4x4 engages, the proper lights come on/off. The front axle will pull when supposed to. The transfer case seems to be working fine, but the front axle won't disengage. I am hoping this can be fixed cheaply/easily (DIYer), and also hoping this explains my low fuel mileage.
Front axle? Where to look or what to try and fix for the vibration?
View 2 Replies
I have a 1994 F-250 XLT heavy duty model. No warning lights are on. A few times a month my transmission will start shifting hard, kicking into the next gear. The odd thing is, if I reset the computer it stops. Shifts smooth as butter. The fluid is a vibrant red and the fluid looks great like it's new. What is going on? I'm getting tired of having this happen. The truck has 108,500 miles on it.
View 10 Replies
I have a 2008 F250 crew cab lariat 4x4 with 20 inch factory wheels that the steering wheel shakes during normal driving left to right. I bought this truck with 1500 miles on it. This shaking started at 50k miles and I was thinking it was a balance issue so I got new tires a month later since mine were about worn out anyways. They were factory replacement nitto terragrapplers. Shake was still there, swapped out for another set of nittos and shake still there, swapped to BFG AT KO's and shake better, but still there. I have gone through 10 or so balances, 5 roadforce balances, 2 alignments at 4 different shops including the ford dealer through the 3 sets. My wheels are scratched to hell and back from the careless people at the tire stores from so many balances.
My truck sat at the Ford dealer for a week just the other day and they changed the steering stabilizer. I thought it was gone, but a a few days later shaking started again. It almost feels as if every little bump, rut, crack in the road the steering wheel feels and shimmies (doesn't matter the speed, gets worse and more noticeable at higher speeds). The Ford Dealer says can't duplicate, but then when I go down there and test drive with them it's "oh yeah I see that, it shouldn't be doing that". The Ford Dealer says they can't find anything loose in the front end when I tell them to check tie rods, bearings, etc.
My truck has 62k miles on it now and it's driving me to the point of thinking about trading it on a Chevy. I love my truck, but it kills me everytime I make a payment and it rides like crap. I am still under extended warranty so I need to get this fixed before it goes out. I've also noticed that if I turn my steering wheel back and forth real quick while driving like warming up for a Nascar race I can feel a bumble in the steering wheel. This is NOT the death wobble as I use to get that around the 20k mile range and it disappeared and has never been back.
View 14 Replies
Well I just bought a 2011F250 6.7 on Friday. The truck has 42000 miles when I picked it up and now has almost 42800 4 days later. I love the truck so far. But anyways its an early build so is there anything I need to look out for? I noticed today I pulled into a parking spot and went to back up and as soon as I put it in reverse the truck shook pretty bad. It did it a few times as I sat there and went from drive to reverse. Is this something that is normal?
View 9 Replies
I'm posting this for my neighbor who has a F250 that's 8 years old. He has replaced many parts, engine from what I know but now when he starts the truck it starts fine but as soon as he starts the truck, the brakes lock up. He can't move it. He hasn't had the chance to move it because the brakes lock as soon as the truck starts. It starts fine and idles fine but can't move because the brakes are locked. Tomorrow the tow truck will haul it to the ford dealership so they can look at it and run the diagnosis computer on it.
View 4 Replies
When the truck shifts into 5th gear i instantly feel a constant vibration and noise until it shifts to 6th gear. This happens nearly every time while driving at 40mph. Rpm range 1200 - 2000. I bought the truck new on June 30th and noticed the problem on my way to work on Monday July 2nd. Took it to the dealer on July 5th and the tech said it was the torque converter slipping. I drove it home because they didn't have time to work on it. Took it back on July 12th and the dealer has had it since (currently 30 days) They originally told me it was not the engine or transmission and it was an exhaust problem. Last week they said it was the motor mounts and said they would be done.
View 14 Replies
I have a little more detail on when the truck starts and does not . I have gone out the past two days and put the key in the ignition and turn it to the on position and all the lights come on except Service Engine Soon light and truck will not start. I bought a ceramic electric heater and placed it on the floor directing the heat under the dash. after ten to fifteen minutes I go out and put the key in the ignition turn the key to the on position and the service engine soon light is on and the truck starts right up. I let it warm up for about a half hour and then shut it off. I then try to start it right back up and the service engine soon light comes on momentarily then goes off and the truck does not start?
View 5 Replies
I'm a new Ford owner, when I engage 4wd I get a fairly annoying whinning / wheering sound that sound like the front end. Only makes sound under acceleration not coasting. No vibration at all.
View 11 Replies
