Ford Transmission :: 1994 - Downshifts When Step Harder On Accelerator At Cruising Speed
Nov 6, 2015
I have a 1994 4x2 shortbed standard cab Ranger XLT. It has the 4.0 OHV engine, A4LD Automatic transmission, and 195,000 miles.
Under average driving conditions, it operates fine. It shifts up through the gears much like it always has, although the shifts may not be quite as firm as they used to be.
If I'm at cruising speed and step harder on the accelerator, it downshifts, RPMs increase, and it upshifts rather poorly, & then I feel a thump, (maybe the torque converter locking up when it shouldn't be?), and I'm in the higher gear. This seems to happen when it upshifts from 3rd to 4th gears for sure, maybe from 2nd to 3rd, but I'm not sure. Again, it only seems to happen when I attempt to speed up from cruising speed, not from a stand-still.
The transmission fluid and filter have been changed at regular intervals, and the truck has never been abused. The fluid is red in color, doesn't smell burnt, and the level is correct. I don't want to get rid of this truck if I can avoid it. It has been super-reliable and mostly trouble-free for the 16 years I've owned it.
View 1 Replies
Advertisement
I have a 1994 4x2 shortbed standard cab Ranger XLT. It has the 4.0 OHV engine, A4LD Automatic transmission, and 195,000 miles. Under average driving conditions, it operates fine. It shifts up through the gears much like it always has, although the shifts may not be quite as firm as they used to be.
If I'm at cruising speed and step harder on the accelerator, it downshifts, RPMs increase, and it upshifts rather poorly, & then I feel a thump, (maybe the torque converter locking up when it shouldn't be?), and I'm in the higher gear. This seems to happen when it upshifts from 3rd to 4th gears for sure, maybe from 2nd to 3rd, but I'm not sure.
Again, it only seems to happen when I attempt to speed up from cruising speed, not from a stand-still. The transmission fluid and filter have been changed at regular intervals, and the truck has never been abused. The fluid is red in color, doesn't smell burnt, and the level is correct. I don't want to get rid of this truck if I can avoid it. It has been super-reliable and mostly trouble-free for the 16 years I've owned it. What might be wrong with it?
View 5 Replies
I have a 2002 Mercury Mountaineer with 150K+ miles on it. Lately the transmission seems "rough" as in it seems to 'thud' randomly when I step on the gas while cruising. I think it's trying to change gears, but I'm not sure. It runs okay, but I feel like I should start thinking about rebuilding the transmission. I have access to a full set of tools and mechanics on hand and about a weeks worth of time. Think I can do it?
View 8 Replies
Ford F-150, 1994 : intermittent problem. going down highway, foot on the gas. At times, will press accelerator to go faster but nothing happens, like clog somewhere. Sometimes, with foot still on gas, i will hear a popping sound coming from under the truck, (under the engine?, or drivers seat). Usually 4-5 pops, sometimes none. But after each pop, car accelerates slightly, as if it is a slight clearing, until finally, as if some clog was opened up, the car plunges forward, so i then take my foot off the gas. Sounds like either problem with fuel getting to the engine or a problem with the exhaust.
View 4 Replies
I've noticed that when I'm coasting to a stop and my speed gets to about 27 MPH, the transmission downshifts (RPMs increase) until I reach about 22 MPH. I'm not applying the brakes at the time.
It's a bit annoying as it sometimes bleeds off just enough speed that I need to accelerate to reach the point I was planning to stop at. Is this normal?
View 6 Replies
I've got a 03 x with the 6.8 2wd 4r100. It was flaring pretty bad for a while going into lock up, about 2 months ago the flare went away now NO lockup. Its taking more pedal to get moving and alot more slip, once you reach cruising speed tranny goes into high pressure. Told to replace the selonoid pack, got one use from a tranny shop from a tranny that lost reverse, got it home took mine out and found out the new one is not PWM and mine is, I tested my selonoid by putting 12v to pin 1 and 4 and nothing (on the pwm pack) did it to the new pack and it works. My question is what will happen if I put the non pwm in my tranny that originally had pwm pack in it?
View 2 Replies
2000 Hyundai Sonata 2.4 L engine, transmission drops from 4th gear to 3rd gear at cruising speed (65mph) and locks into 3rd gear, I have to stop and turn the key off and start the engine again to reset the A/T what do you think is happening?
View 1 Replies
i have a 04 ford excursion 6.0 with the egr delete, was stopped at a light to make a left turn, when i stepped on the accelerator pedal nothing happened as the engine was just idling. i pumped the pedal around 10 times and finally got the engine to rev up. i just got this excursion and don't know to much about the maintenance on it. i am going to drain the water and change the two fuel filters. my neighbor is familiar with diesel engines and he said to look at the throttle sensor. i have run this engine up to 900 miles and it has started and run perfectly. i believe the usual maintenance like oil changes etc were done on it. would any error codes show up even though no warning lights on the dash.
View 8 Replies
This morning I went to go to work, started to back out of the drive, and the transmission locked up. So I go to put it in first gear, let off the clutch, and the engine bogs down like its in 5th gear. I then decided I will just push it back in the drive, so I put it in neutral, let off the clutch, and its still in a gear while in neutral. Last night it drove fine before parking it, and then when waking up its broke. What could be wrong?
View 3 Replies
Just purchased my 2007 Passat 3.6 FWD and we just love it but having hesitation problem? This only happens from a stop, when you step on the accelerator it seems to have a delay of a second or two before the engine response.
View 12 Replies
I have a 2001 Honda Odessey with 114K miles. When I step on the accelerator I hear a whistling sound. The sound sounds louder as the RPMs go up. However I don't hear the sound when I take my foot off the gas or when the RPMs are 1,000 or less. What the sound is and what I should do? I had my transmission replaced last year and my wife thinks its related to the transmission.
View 2 Replies
I have a 1999 Toyota Camry (4-cylinder). When I step on the accelerator, it hesitates for a moment before accelerating. Once it finally does kick in, it isn't jerky but fairly smooth, just takes a while before it will go. Other times, when I accelerate, and the car is actually moving, I feel as though the RPMs are higher than they should be considering the (slow) speed that I'm going. These problems have increased quite a bit over the past few weeks.
Prior to this, my check engine light came on. An autozone employee checked the code related to the light and said I have a faulty EGR. He didn't seem to know whether or not this would be at all related to my acceleration problem. Someone else suggested that an EGR's importance is more environmental than functional. While I'm all for "being green"...can only afford one problem at a time, and the acceleration problem comes first.
If the two are connected, and if not, what my acceleration problem might be? How critical is a properly working EGR anyhow? The actual code according to autozone was EGR P0401...
View 5 Replies
I have a 1994 celica GT, 2.2 with a 5 speed. I thought I either had bad tire noise, or maybe a wheel bearing noise, I put the car up on jack stands, started the car and put it in gear, and the noise I have is a loud growling sound, which gets worse the faster the wheel spins. I took a 2x4 and stopped the passenger side tire (drive wheel) so the driver's side would spin, the noise went away. From what I can tell, or am guessing, the noise is coming from the trans. Could this be a bearing in the trans case? Of course I can't find an exploded view of the trans!
View 3 Replies
I got a funny shifting issues that happens infrequently that I can no figure out. It happens after driving the car for a while on the highway, but not every time, and not just on the highway.
Here is my problem... when cruising down the highway the check engine light will come on stay on for a around a minute, the the check engine light will turn off, then of which my truck will lose power, not accelerate no matter how much I stomp on the gas, until my speed drops to under 55mph.
Once I get down to 55mph the truck will drop 2 gears into 3rd gear and then I can accelerate back up to speed. This will repeat every few miles. The computer will not store the check engine code, so no codes are pulled.
View 7 Replies
Almost every morning, when I put my car in reverse and then step on the accelerator, I hear a sharp "clink" sound from the front of the car. After I've backed from the driveway to the street, I put the transmission in drive and step on the accelerator again and often hear the clink again. It doesn't happen EVERY time, but has become very common in the mornings. It only started doing this within the last month or two. I haven't observed any other problems.
The car has about 80k miles on it and has not had any transmission work done.
View 2 Replies
My car (1994 TBird, LX) has an intermittent problem where the rpm's surge while I'm cruising down the freeway. I've noticed that it happens more often on an incline, and it also happens more during rush hour when I have to frequently slow down and the accelerate again.
If I had to guess, I think it's the TCC Solenoid that's the issue. Would replacing this likely solve the problem? Or would I be better served having my mechanic unplug it? My car is giving error codes to replace the camshaft position sensor (related?), and while important, I need to address the rpm issue first as it's getting progressively worse. Tranny fluid is clean, although I've only owned the car for 2 months so I don't know when it was last replaced.
I can't afford a huge repair, but I have a certified mechanic who's always done right by me, but he's not the best at diagnosis. I'd feel better if I could whittle down the issues and then just tell him what to fix.
View 2 Replies
"step on gas, truck feel like it is pulling a house, slight buck, but with more gas it moves, it has good presure out the exhast, all wheels are turning freely, engine idles great has lots of power,"
tested, cyl pressure, fine
check engine timing, fine
made sure all wheels spin freely, fine
check all fluids, fine
slight pinging sound can be heard, from time to time from center of truck. I'm thinking torque convertor. Feels like engine is binding only when you put it in gear.
View 4 Replies
If I understand correctly my 2004 Expedition has the 4R75E transmission. We are experiencing a clunk upon acceleration when the truck downshifts from 4th to 2nd. I had the fluid & filter changed, flushed the transmission with cleaner. It still does it but not all the time. I turned OD off and I didn't notice the problem when shifting from 3 to 2.
View 1 Replies
2001 expedition, 198,000 miles. Got p0781 code ,1-2 shift error. replaced the accumulator valve with a factory tech valve body. Pan was clean, some gray material on the magnet but not bad. 1-2 worked fine after vacuum swap, but when trying to shift from 2nd to 3rd gear, the transmission downshifts hard all the way to a stop, like the brakes are on.
I can manually drive in 1st and and 2nd but when I put it in drive it will downshift/brake instead of shifting from 2nd to 3rd. pulled the main valve body and 2-3 and 3-4 shift valves seem good, no sticking. 3 other valves were sticking. i think they are the Solenoid regulator valve , and coast clutch shift valve, and low/rev modulator. Could they be causing the hard downshift/braking?
View 8 Replies
I bought a 95 Explorer with a known bad transmission, rebuilt it (broken band and chipped intermediate apply piston), put it back in, and now it's acting odd.
It wants to start in third. I can manually start it in second (first rarely works), shift it to drive at about 30, and it's fine. It shifts into OD, locks the TC, and when given a bit of gas kicks down to second. It downshifts during deceleration, but once I come to a complete stop, it'll try to start in third again. The only transmission code it's giving is for incorrect first gear ratio, there is an off and on engine code for the EGR pressure sensor as well.
View 5 Replies
Been having a very light vibration when cruising at speed as well as on some lower speed shifts and finally crawled under the truck today to check for drivetrain play. Other than the amazingly soft and sloppy transmission mount I noticed a TON of play in the driveshaft transmission yolk. Didn't feel like the u-joint but actually the tailshaft yolk. Dealer said on the phone they have seen this on a few of the newer trucks and it *should* be covered under the power train warranty. I have the subercab with the 1 piece aluminum driveshaft.
View 4 Replies
