I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 RepliesMy buddy's 2001 7.3L F350 has had 3 transmissions. Rebuilt and used. Once the new trans is in he goes like 15 miles and then is starts shifting hard and grinding gears. What this could be?
View 8 RepliesI have a 2006 Chevy 2500HD with about 180000 miles. All of a sudden the transmission is shifting extremely hard at times. It doesn't shift this way all the time. What could be causing this problem? It doesn't have to be under hard acceleration either when it does shift hard. It sometimes is during hard accelerating and sometimes it is under very little acceleration, but as I said it doesn't do it every time. When it does shift hard, it seems to do it in all gears.
View 1 RepliesI've had 2 Elantra 2012 models 1 a gls the second a limited. As far as transmission issues both Elantra's from a cold start after allowing RPM's to idle down before taking off they both have started shifting hard going from 1st to second gear 1st car was around 8-9 k miles now 2nd started at 3 k miles. Since owning 2 cars same make same year same transmission and many times to dealer 1st car ended with Transmission replaced 2nd has now started doing the same thing they reset adaptive and next day did it again its now back at dealer waiting for them to diagnose again.
View 13 RepliesI bought my '07 Passat 2.0T Wagon as a CPOVW 6 weeks ago. It had 4700 miles on it. I complained about the transmission having a delayed engagement when shifting into reverse and drive. (it drives normally however with positive shifts and is very enjoyable) I was told it was normal and not to worry. (could it be designed-in to soften the engagement?).
This week I noticed a light "thunk" in the right front when re-applying power while coasting below 40 MPH. I never noticed it before but I usually strive for smooth driving so that may be why. I've had other Aisin Warners but they were in Volvos. I got out of a '99 Volvo Cross Country because I didn't trust the driveline. Am I going down the same road?
My transmission has been shifting rough and seems "delayed" in shift response.
I can only go from gears 1-3 without revving up to 3500-4500 RPM's before it will go ino 4th.
It does not hold RPM in 4, 5, or 6 and instead goes down to the normal idle spot.
I had it diagnosed and the codes are
P0761 Shift solenoid C Performance or stuck off
P0781
1-2 shift error
I am looking at buying a 91 f250 4x4 with a 5.0 and an e4od. When I start the truck I can feel It roll forward A little bit. I can put the trans In od or nuetral and It will drive and shift normally thru all 4 gears, no slipping and no noise no vibration, It shifts and acts perfectly normal. 1st and 2nd work fine as well. When I put it in reverse It rolls forward slightly then drops Into reverse, it will not actually back up, you can rev the engine to stall speed but no higher. Sometimes in park If you rev the engine It will actually over come the parking pawl and roll forward.
Also when In park I can rev the engine to stall speed only. It only starts in p or n, and the reverse lights come on in R so Im assuming the mlps is adjusted properly and the manual protion is adjusted properly. I pulled codes and had 3 in total, ect shorted, egr flow insufficient, and 1 code for torque convertor clutch solenoid I believe It was 632. Im assuming the reving up to stall speed Is related to the tc code. The fluid level Is fine but is a little dark In color, I tried doing a search with no luck ..
The 91 bonneville stopped having forward gears but was drove back in reverse about 4 miles, reverse appears to work fine does this thing need new transmission or is there an easier fix...
View 7 RepliesThe trans in my motor home has made a growling or slight grinding metallic noise after it shifts into 3rd gear. It only does it for maybe 3 seconds and it doesn't seem to affect the operation. Only way I can describe it is that it grinds, and shudders then goes away. I have towed my race car all this year and it has not caused any issues at all. I am planning on driving out west next year and would like to figure out what the deal is before I hit the road. Also if a rebuild was in order what improvements can be made during a rebuild?
View 1 RepliesMy trusty 1994 Ford F150 is starting to show her age, I think. I'm noticing a few issues:
1 - most concerning to me is she jerks pretty hard when shifting through the first few gears during relatively warm weather. The cold snap has abated the issue for now. Had the transmission fluid checked - mechanic said it's fine.
2 - This is a fun electrical issue. I'm driving down the highway when suddenly the cruise control shuts off, as does the speedometer and the digital odometer. The Tach still works, as do the rest of the gauges. Maybe 10 - 15 minutes later, they all come back on. It's done this a couple times.
3# - Really annoying but very minor; when I push down on the foot feed, there's a bit of a squeak in the engine. I'm guessing it's a tensioner pulley on the serpentine belt, but why it would only happen when I give it some gas?
So I have a 1995 f-250 4x4 with the 460 and a E4od. So when I bought the truck I drive it two hours home and when I got into town it started shifting really hard and searching for gears. So I flushed it and installed a new oil filter because the oil in it was brown. Very brown. And smelled awful. So it shifts good, but what's happening now is that it shifts good in drive when it wants to.
In the morning it works great but when I get in it to leave after school it shifts really late (around 2900 rpm) and hard. So I put it in first and then into second but when it's time for third and I put it in drive it shifts back to first. But if I stop shut it off for a few minutes and turn it back on it works fine. It only does this after it's been sitting in the school parking lot all day. I replaced the mlps but not the connector due to I didn't have time at the moment. Could it be the tps? Something mechanical?
My son has a 2013 Fx4 crew cab 4X4 ecoboost with 8500 miles. He says in the morning for the first couple of miles while accelerating gradually the trucks shudders when shifting gears. After a few miles it goes away. Dealer says they can't do anything endless he can duplicate the condition. He went out of town for a few days and left me the truck so I'll drive it in the morning and see what it does.
View 3 RepliesI have been trying to self diagnose an issue with my pick up for a while now. I have an 01 Silverado 2500HD 6.0 that shifts really hard into all gears. I was told it was the transmission going out, so we replaced the transmission with a rebuilt one and it did nothing for the shifting issues. We then had the transfer case rebuilt which also did nothing for our problems. My father who has some general mechanic knowledge is certain that the free floating rear end is not turning with the correct timing for the transmission shifting. No check engine lights come on at all during these issues. When I took it to a mechanic he told me I needed a new transmission and blew me off when I told him it was just replaced.
View 3 RepliesHard shifting from the car. sort of a slam between gears and while in gear.
Possibly a mount?
My 2004 Forester (73000 miles) with 5-speed manual, is sometimes hard shifting into gears. The Subaru agency says that there's 'not much left' on the clutch and I need a new clutch @ $1300. Does hard shifting , no clutch slipping, indicate new clutch is necessary?
View 5 RepliesThat said my wife bought a 2001 Accent 1.6L Auto while I was overseas and it's been a great car, about 8 days ago it just crapped out. The reverse went out on her so we took it to get the codes read and on the way it went in limp mode, started hard shifting between gears and wouldn't go over 45 she says. Took it in to the stealership today and they said that the trans is shot as well as showing codes for P1527, P0732, and P0734. I know what the two slippage codes are and I can prolly just replace the speed sensors and that will be fixed but I'm not sure about the reverse and P1527.
View 4 RepliesI own a 2005 f-250 superduty with the 6L diesel. Just recently when I leave to work in the morning I notice the trans shifts slow through the gears and when it does start to shift it will start slipping then kinda vibrate for a few seconds then finally shifts into the next gear. It will do this through all the gears until I get up to speed on the highway. After it warms up it shifts and drives great until I let it sit for around 8hrs or more. I really hope I don't need a new Transmission considering I bought this truck as is from the dealership just a little over a month ago. I have checked the trans fluid it is full, I even drained all the fluid and replace with new and it still does the same thing.
View 4 RepliesMy sonata 2012 with 71K km on it just started hard shifting in the morning, after first start. It slamming in D from R very harsh and then shifts all other gears for ~3 minutes harshly (upshift / downshift) and then it gets fine and shifts gears with absolutely no problem throughout the day. Dealer of course was not able to reproduce the problem.
View 37 RepliesIssues with the transmission in the 2000 Century. My car shifts perfectly fine cold, but once it warms up it shits hard between all gears. Downshifts are never an issue, just up shifts. To me this sounds like both shift solenoids may be sticking or shot... I have already drained the fluid and changed the filter, added lucas tranny stop-slip, drained that out and replaced fluids again... no codes to go by and no high revs before shifts when accelerating...
View 5 RepliesMy 1991 Volvo 240 with automatic transmission suddenly stopped shifting out of first. No warning. Fluid level is good.
View 4 RepliesMy friend has a 2007 accent with a manual transmission they said that they were driving and the transmission stopped shifting gears. The clutch pedal still has pressure so I don't think it is a master or slave cylinder issue. They freaked out and turned off the car and now the car will not start up again. Have any of you experienced anything like this before or know on this car where to start looking? I think the issue with not being able to switch gears could be a pressure plate issue but this would not cause the car not to start.
View 6 Replies