Ford Transmission :: 1970 F250 - Slow To Shift Going From Neutral To Reverse Can Take Almost 30 Sec When Hot
Jun 10, 2017
I have a 1970 f250 with a factory 390 (vin verified) and a C6, I believe the transmission was rebuilt but have no way to verify. It works fine while cold and mildly warm. Once heat soaked it is very slow to shift (going from neutral to reverse can take almost 30 sec) and leaks profusely from the front. I can not tell exactly where the leak is. Could this be a case of just having too much fluid or is there a more serious concern? The dipstick does read high but level ground in my area is hard to come by so the accuracy can be questioned. If it does have to much fluid, do I just drain the pan, re-install and let it run till hot and replace fluid as needed or should I drain and replace with 3 qrts prior to starting?
View 7 Replies
Advertisement
I got Ford C6 Transmission bolted up to a 460 in a 1978 Ford F250 4x4. I recently had put all new gaskets in it and I change the fluid. The day I put it all back in my reverse was trying to lunge forward, my natural was a 1st gear, and drive was working fine. Now recently my park throws itself into gear. I got no burnt fluid, the clutches were fine when I put it back in???? What could it be, I'm running out of options before I do a manual transmission swap.
View 7 Replies
I've got a 2006 F250 6.0 5R110W 4wd 220,000 miles It started getting a slight delay going into reverse and tow light flashing last week. all else functioning perfect Got a pending code P0700 and P0741 I stopped at NAPA when I was leaving no reverse checked every thing all was normal no leaks and fluid good color drove perfect in drive I got back to the shop [10 miles] put truck in park it was like its still in drive same with neutral, in reverse it wants to creep forward.
View 1 Replies
1991 4x4 f250 idi w e4od w 3:55 ratio... The truck is slow to engage in reverse, about 5-10 sec. It also has a very hard shift 1-2. All other shift points are good. Drop down is good, and TC lock up happens at all the right points (feels like anyway).
I've had the truck for about 2 years now, replaced several sensors an harnesses and a full fluid change to solve other problems but this still remains.
Sometimes when I start it in the morning if I let it sit and idle for a few min it will engage reverse much quicker AND shifts way smoother and constant. Shifts smoothly thro all gears, holding a constant 1800-2000 rpms with no drop or lug. Or do I need a rebuild?
View 4 Replies
This is on my 7.3PSD. I've observed that the 1-2 gear shift drops about 1,000 RPMs and takes a good half second or longer to do so when given a lot of accelerator pedal input. And then the 2-3 shift is a very quick and harsh shift.
If I am accelerating gently the 2-3 shift is as unnoticeable as the 1-2 shift is quick. Is the slow 1-2 shift causing the trans to protect itself and affecting the 2-3 shift? And if so, what do I do to resolve all of this? I changed the trans fluid a week ago and there is no change.
View 2 Replies
My car is taking a long time shifting from reverse to drive in the morning. Do you know what may be causing it and how to fix it. It's a 1995 automatic ford explorer.
View 3 Replies
Vehicle was repaired after front end collision and I get no codes found on scanner, had some bad connectors which I replaced and codes went away. I don't get ready light and the dash lights do not cycle off (ABS, SRS, Check engine, Etc. Etc.) The car will shift into neutral but not drive or reverse. Has new Aux battery and Hybrid battery is showing two bars. What to check ?
View 6 Replies
I have recently been having problems with my 2013 Prius v (lowercase v for the Prius v wagon). When I press power, all the dashboard lights turn on. And when I try to shift the car into reverse or drive the car stays on neutral. What is going on?
View 7 Replies
Well, like the title says, The trans is stuck in third gear, with no other gears, or neutral or reverse. The car is slightly modified 02 GTI 337. APR Chip, Forge TIP, Full 3" exhaust, Greddy FMIC. I definitely drive the car, and had been beating up on it on the highway for a little on my way in to work, then on the way home, down shifted to pass someone, dropped it third, passed them, went to shift to fourth, Shifter moved, felt like it engaged "a gear" and then then i let off the clutch and it was still in third.
I also noticed that unless, I press the clutch in the, the car stays in this gear, even when the shifter is in neutral. I looked at the linkage, and it appears to be functioning. I did some reading around the Vortex and it seems like this might be a shift fork problem. Also, if the trans will be apart, what items should be upgraded?
View 10 Replies
I am having difficulty with my Prius, (just started) that it won't shift out of neutral to drive or reverse. I have read several posts, one says replace the shifter knob, but I did read one i thought that said the 12v battery might be the problem with low voltage. The battery is 5 years old.
View 2 Replies
I have an '07 Prius Touring with about 95K miles that I have owned for about a month (after my previous '07 was totaled). My wife tried to drive it for the first time today, and the problem is that when my wife tries to start the engine, the dash lights come on and the color display comes on, but the car won't "shift" into Drive or Reverse (it will go into Neutral). A dash warning light also comes on that the owner's manual says means Take to the Toyota Dealer for Service. Then if she gets out of the car and then I get into the drivers seat, everything works fine.
View 16 Replies
2009 Touring Dead at 55000... All lights on dash light up and won't shift to reverse or drive only neutral. Towed to dealer and they said it threw several codes and are replacing the tranny.
View 18 Replies
I have been driving a 2003 Chevrolet cavalier and the automatic shift is stuck and can only shift to neutral and drive since Thursday morning. It wont go up to reverse and parking and down to the other 3 shifts.
This first happened last April but somehow with the right grip or pressure was able to get back to all the other shifts. Since then it happened 2-3 times as I can remember and now could be getting worse.
View 1 Replies
My 82 f150 4x4 302 c6 trans is acting up. My c6 is slow to shift into any gear when I shift the column shifter, after a moment it jerks into gear, also it doesn't seem D is doing anything but all the other gears seems to function manually or auto.
Fluid level looks ok, maybe a little high on the dipstick. I'm going to check the modulator and do a fluid/filter change but looking for a link to the band adjustment screw ?
View 3 Replies
2001 F250 7.3 - warn manual hubs.. However, the wife has been driving the truck and I don't know how often she has cycled 4WD.
Basically if you choose 4WD hi it doesn't light up to indicate that it has engaged, if you drive for a couple of minutes slowly then eventually it drops in - not much use if you're already stuck. It will then select 4Lo. Coming out of 4Lo to 4Hi or 2WD is painfully slow - like 5-6 minutes before the dash light goes out for 2WD.
I was thinking maybe the electric motor for the transfer case - unless it is the transfer case dying.
View 10 Replies
1986 S10 blazer automatic transmission won't go into reverse OR neutral! It goes fwd in both reverse and neutral. It goes into park just fine. The fluid is full and not burnt. It will drive forward when in reverse and in neutral. I turned the engine off and checked neutral, it was not in gear but tried to go forward as soon as I started the engine.
View 16 Replies
1986 S10 blazer automatic transmission won't go into reverse OR neutral! It goes fwd in both reverse and neutral. It goes into park just fine. The fluid is full and not burnt. It will drive forward when in reverse and in neutral. I turned the engine off and checked neutral, it was not in gear but tried to go forward as soon as I started the engine. I have never seen this!
View 11 Replies
My 1970 chevy c10 pickup is a 350 with automatic transmission 2wd. It doesn't get driven frequently and when I do the first time I put it into gear, fwd or reverse, it is slow to engage. Shortly after it has warmed up however, this problem goes away. What this sounds like?
View 6 Replies
I just recently picked up a 87 F250 with a 6.9 and a ZF5 trans. The PO replaced the clutch, and mentioned that he replaced the clutch fork too
Since I bought the truck, I've had some nasty rattling noises. It rattles when in neutral, and stops when I put the clutch in. The noise also comes back on occasion when decelerating at highway speeds, in 2nd as soon as I stop accelerating, and at low speeds in 3rd.
What is causing this?
View 4 Replies
I've got a 1994 F-150 with the 4.9 straight six. The transmission is the E40D.
In drive, it shifts silky smooth. In reverse, it acts like it's bogging down the engine.
I only recently got the truck. It's had a fluid and filter change, and is full on the stick when hot.
I didn't notice this problem until I replaced the engine thermostat. It was stuck open, so I replaced it with a 195 degree Stant unit.
Should I let the engine control computer re-learn this engine? I've fixed bad vacuum lines, too.
I've heard tales about the electronic transmissions. This one has 145K on it.
View 14 Replies
On a manual car, I know it's not the best thing to go from neutral, completely bypass 1st gear, and shift to 2nd gear. As well as 3rd to 5th bypassing 4th. However, is it the same for downshifting into neutral or another gear? Will it hurt the transmission to go from 3rd to neutral (bypassing 1st and 2nd) when coming to a stop? I do know that shifting from 4th to 2nd gear and bypassing 3rd will harm your tranny. I just want to double check if I'm right...
View 24 Replies