Ford - Taurus :: Check Engine Light Flashes When Start The Car And It Idles
May 21, 2013
I have a 2001 ford taurus. just changed the engine with a used engine has 130k, did tuneup changing all spark plugs, wires and distributor cap. Also changed the 02 sensor upstream. And the check engine light remains on. if i start the car and it idles the check engine light flashes. but once i drive it, it just remains on. brought to the mechanic and he put on the machine and it reads that the problem is the 02 sensor upstream and the spark plugs misfiring. my mechanic is lost not sure what the problem is. someone told me it could be the manifold gaskets and pedlum gasket.
View 1 Replies
Advertisement
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies
Having some issues with my 2003 Alero 4 cylinder. Upon start the entire engine shudders and the check engine light flashes. I have to turn it off and turn it on and it will stop most of the time. I've taken it in and the mechanics can't get it to reproduce the same issue for them. Just replaced all four plugs, boots, ignition coil.
View 1 Replies
I go in this week to recheck my nagging check engine light. Flashes after a warm start, then stays on. Been there once already for it, it has come on too after a cold start... Last time they said it was a very vague miss fire code.... It did shake a bit... On the plus I get to drive a nice new Elantra again.... On the down, I never want my car back after driving it ...
View 2 Replies
I have 104k miles on car, had tune up back in 09, new die hard battery from sears spring '10, just today my car started to shake when in idling, check engine light flashing. It seems to shake itself even while driving, when in idle it will then kill or die. Had radiator flushed January 2nd, 2011 due to heat not pumping through, still doesn't work (I know heater core) like it should. Finally the other problem is when I start & turn the car on it won't turn over-it wants to but takes a few tries like turning key each click like as if it were alternator, does sound like it would if it did turnover but like I said it takes a while & maybe will fire/catch. What the heck is going on? 2001 flex fuel as well but I only once put it in.
View 10 Replies
I got a 1986 Camaro 5 speed 350 4 barrel carb and the check engine light flashes on and off, when it comes on the engine idles really low and when it goes off it runs normal. I've changed the ignition control module twice already because it wouldn't start. i change the ignition coil because thought that was messing the module up. I hooked a obd ll and 1scanner too the car but wouldn't respond.
View 14 Replies
While I am driving the car it will start to die and skip. Happens randomly. Today I was driving up a small hill and it went quits on me started lurching with check engine light coming on and off. The car will turn over and start, but only for a few seconds before dying again.
Seems to happen when the car is running for a while. Also the ABS light flashes on then off randomly while driving sometimes although It hasn't been an issue. Will be checking tomorrow to see if it starts.
View 1 Replies
I am a grad student hoping my car will hang in there till graduation next year. I have about 227,000 miles on my Honda Accord Wagon and recently the odometer stopped working, S light started flashing, and the check engine light came on. This only happens sometimes, and the check engine light does not always come on when the S light flashes and odometer stops working. I've continued driving the car to see what happens and so far, no problems have come up. I have driven another 1000 miles and am hoping I can just ignore the problem and continue driving the vehicle since I am not in a position to fix it or get a new car.
Recently I passed my California emissions test and she seems to be running smooth. Any thoughts or warnings as to why sometimes these signals happen?
I have to drive with GPS on all the time to know my speed, but other than that I feel OK.
View 14 Replies
The check engine light came on again after coming on about a week ago and then shutting of by itself. Everything seems to run normal with the car so I don't know if I should ignore the light and just keep driving or what. What would you do? My car is a 2011 Ford Taurus.
View 1 Replies
I have an old 2000 Ford Taurus that has been having some misfire issues. I replaced the wires and plugs about a year ago and hooray! it worked... until about a month ago when the check engine light came one. Misfire in cylinders 1 and 3... again. I ran some SeaFoam through and it did okay until this week, when the warning/flashing check engine light came back.
It is idling very hard (expected) and feels like it is trying to stall, even before the misfire came back (also to be expected??). So here is the question: is this a coil pack issue, or something more sinister (and expensive)?
View 9 Replies
I have a BMW 740I that has over 200,000 miles on the clock, I have noticed in the past couple of day that the check engine light when I turn on the ignition that it flashes then becomes still, what the problem could be, and if it is safe to drive?
View 9 Replies
This car has been giving me quite a bit of trouble lately. 04 Ford Taurus SES, about 97,000 miles on it. Just last weekend, it broke down on the highway. Found out the torque converter failed and needed to be replaced. I was suspecting that something was wrong with the transmission for a while now, because it would stutter sometimes when accelerating, and sometimes start shaking in the front when I turned it on. (It still stutters after having the torque converter replaced.)
Well now, a day after shelling out quite a bit of money to the dealer for this torque converter, the check engine light is on. I went to Autozone to check the codes, and they found P0300, P0305 (cylinder misfire) and P0316 ("crank sensor condition"). Is it possible the transmission is failing?? I found a bunch of complaints online about the transmission failing on the 04 Taurus. I'm trying to avoid more expensive repairs, but I don't want the car to break down on me again....
Also, a couple months ago, the check engine light went on a few times, but always went off within a day or two. Never did get it checked out because it didn't stay on long enough.
View 18 Replies
98 Taurus, 6cyl, 3.0L OHV, 184K miles. Check engine light is on and code reads "P0411 - secondary air injection system - incorrect flow". This is my son's hand me down car and has a rather large exhaust leak that I plan on fixing. Could this code be related ?? I found out that the CEL has been on for quite sometime now and the car is due for emissions testing (state inspection) in October.
View 3 Replies
I was in cruise control at 50 and pressed and held the increase speed button to pass a car and once i got to 55 and still holding it the check engine light flashed twice a second until i released the increase speed button. Are you not suppose hold that button? Could this be APR related? I also noticed that the speed doesn't matter, it could be at any speed just hold it for like 5 seconds...
View 4 Replies
I have a 2003 Jaguar X-type that gives me trouble when the temperature drops below 32 degrees. I have to warm it for at least 10 minutes. During that time it coughs and sputters and my check engine light flashes. Once the light stops flashing I am able to drive. What is going on?
View 5 Replies
My wife was about to go into work today and when she started the Accent she said it started rough and revved up two or three times and the check engine light flashed 5 or 6 times. The light stayed on solid after that but there was no loss of power, smoke, low gas mileage or vibrating or any other symptoms after initial start up. I plan to take it to an auto parts store tomorrow (the car is at her work about 20 miles away) and get the code read. What I may be in for? I'm hoping its something simple. I told her to check the gas cap just in case.
View 24 Replies
while driving her 01 taurus to work last night my daughters car just died while in motion. the "check transaxle" light came on. car would not turn over and start. went back this morning, and it still won't turn over...what gives?
View 1 Replies
I have a 1996 ford taurus lx v6 3.0 dohm..my check engine light flashing. then it stop flashing..i did replace spark plug,wires,coil pack..when it start to flash i put it gear the car start to shake and sputter.i really don't know why its doing that the car has about 150000 miles on it..i do get a code p0302 Cylinder #2 Misfire..the new plugs and wires and coil pack is about 2 weeks old..
View 11 Replies
My 2004 Cadillac CTS 3.6L started running rough, check engine light flashed on and off. Codes P0300 and P0303. The car has about 119000 miles. Could this just be the plugs? The car has been running fine up to today.
View 2 Replies
I just bought this car from the original owner. She didn't take that great of care of the car. First oil change was done at 8,000 miles for example. Basically if it was broken she would fix it, but didn't do much preventative maintenance.
I just replaced all 4 spark plugs and coils since one was misfiring and didn't want to have to go back in and replace one in another few months. Replaced the AC belt a few days ago since it was cracked and worn. All other belts are fine. I drove the car around for a few hours the next day and it ran great.
Today, the check engine light flashes and then stays on. The car is idling rough at stop lights and acceleration is poor. Previously, the light came on and it was the EVAP system. Not sure which component and I was told it isn't supposed to affect the way the car drives.
View 14 Replies
My 2002 Jetta GLS 2.0 is misfiring only when it rains out. I go to start the car and the car idles extremely rough and seems like it wants to die. I checked out the codes for the check engine light and I got misfire codes p0304 and p0300. Which is a general misfire detected, and misfire on cylinder 4. I noticed that when I misted the alternator during the day around 70 degrees with the car running the car would misfire and almost die out. I know you are not supposed to get the alternator wet, but keep in mind i did not soak it I misted water on it. I misted the coil pack and nothing happened. I replaced the spark plugs and wires a few days ago. But as soon as it rains my car does not idle right and the check engine light flashes.
View 4 Replies
