I have a 2004 Ford Taurus SEL with the Duratec 24 valve DOHC, had an accident and the engine compartment power distribution box broke and have been having different issues since. I found a wrecked 2006 ford taurus with an intact box, can I use the 2006 on the 2004? Is there anything I need to make sure of first? The part numbers seem to be the same although at ford they sell different ones.
View 7 RepliesI have a 97 F150 with the 4.6L and a 4x4 auto transmission that I got it on a trade. I was told the packs were shorted (he had a diagnostic write up as proof) so I replaced them and still no spark. It has the 4 plug packs. I checked every fuse and relay twice and the PCM and packs are getting power I also checked them with a multimeter and they're getting a 12v feed in the distribution box and the packs have 12v on the hot wire. There's something keeping it from firing the distribution wires and I'm kinda stumped. Also the MIL comes on and sometimes go off and I tried to scan tool it but it says it can't connect.
View 8 RepliesWhere this box is located?
View 1 RepliesThis car has been giving me quite a bit of trouble lately. 04 Ford Taurus SES, about 97,000 miles on it. Just last weekend, it broke down on the highway. Found out the torque converter failed and needed to be replaced. I was suspecting that something was wrong with the transmission for a while now, because it would stutter sometimes when accelerating, and sometimes start shaking in the front when I turned it on. (It still stutters after having the torque converter replaced.)
Well now, a day after shelling out quite a bit of money to the dealer for this torque converter, the check engine light is on. I went to Autozone to check the codes, and they found P0300, P0305 (cylinder misfire) and P0316 ("crank sensor condition"). Is it possible the transmission is failing?? I found a bunch of complaints online about the transmission failing on the 04 Taurus. I'm trying to avoid more expensive repairs, but I don't want the car to break down on me again....
Also, a couple months ago, the check engine light went on a few times, but always went off within a day or two. Never did get it checked out because it didn't stay on long enough.
Can I replace a non-heated passenger side view mirror with a heated one?
View 5 Replies I was driving my Taurus a few days ago when it lost all acceleration and power steering. The engine seemed to be running okay, and it restarted at the side of the road, but still no acceleration. I called AAA and had it towed to my mechanic. The following day they called and could find no problem.....
they had driven it several times, checked out likely causes but found nothing. This garage has been very reliable in the past. They said it could just be an electrical issue that may or may not happen again. The car seemed fine when I was driving it today, but I am worried about it happening again. What could have caused this/what I should do?
I have a 1999 ford taurus (3L,automatic) which I use here on the farm. A fluid leak in the return line from the cooler needed to be repaired last summer now after a couple of months a new problem occurred. When you stop and turn off the engine power steering fluid explodes out the filler cap. The fluid is foamy with air. I replaced the pump with a good used pump, then replaced the rack with a remanufactured unit and checked all the lines. I can't detect any evidence of a leak, (The old rack did appear to leak). I suspect that this is caused by an air leak in the return circuit causing air in the fluid which is compressed until the pump stops then expanding back through the pump into the reservoir.
View 3 RepliesMy wife's 89 Aerostar is leaking brake fluid from the back side of what is either the distribution block or combination valve. I am not sure which it is but it is the first block you run into following the lines from the master cylinder and it is right below it near the fender well.
The part has been discontinued and is too expensive anyway so I am looking for input as to what this peice is and if / how to rebuild it.
I need a new engine for my 2004 SOHC 5.4 3v F150. Without sounding like a dumb question, what engines can I use? All I've heard about this engine is that it was a horrible one. I can vouch for that personally. I will be looking for a crate engine soon.
View 2 RepliesSo I'll give a little history. Had blown head gaskets so I tackled that got it back together and now I can't get it to start. I have a monitor but it won't tell me if I have ficm sync. I have 1500 psi cop reading. I have spinning it over far 15 to 20 minutes. I'm using a bluetooth scanner and a app on my phone. I have no codes thrown or anything else. Do I keep cranking on it or am i missing something.
View 14 RepliesI just replaced my batteries today on my 2011 F250 because of a no start situation. I guess it was about due since they were original and that gives me 5 + years of service and it happened in my driveway so I definitely am not complaining. However after I replaced them and started the truck the check eng lite came on....
View 8 RepliesI have a 2004 E350 6.0 with a bad vacuum pump. I tried looking on Youtube for a video on replacing the pump but no luck. Looking for a video or instructions on replacing the pump? It looks fairly easy but you need to be a snake to gain access to the pump bolts.
View 9 Repliesafter a loud screeching sound that sounded like a spun shaft rubbing on metal iwent under and found the starter wabbling around. Its going to be a first for me. Anything out of the ordinary i should know before moving on with the replacement..
04 f250 diesel 6.0
00 Silverado 1500 Z71.. What is the location of the HVAC distribution servo?? I found the air blend servo under dash. Only getting air blowing out of Defrost. I switched the head unit and got same result. Also tried the reset as suggested by Jcat, neither one worked.
View 1 RepliesAttempting to take this on myself. My passenger side manifold was replaced a year ago.....BTW This damn truck - all stock - no modifications of any kind - just turned 100k miles. One owner - me.
So I have removed everything I think I need to to gain reasonable access including the fenderwell and all the intake tubes and battery and coolant reservoir. I want to use some heat and try not to break the bolts but there is a thin wiring harness just above the exhaust manifold. I can't find it in any diagrams on the ford parts site. It looks like the glow plug and injector harnesses are up above near the intake manifold but this one is down below all that. It connects to small rubber thing - 1 for each cylinder. There is nothing else electrical near it - everything else is up top.
Now my rant - look away if you are a die hard ford truck fan or 6.0L powerstroke fan.
So far I've had to replace both exhaust manifolds because they burned and rusted right through. New transmission cooler lines -yes - rusted through and cooler (because we couldn't get the lines off without destroying the cooler). Cat got clogged (that was fun to find and fix). All 4 front ball joints replaced. Transmission dip stick tube rusted through. Several brake lines had to be replaced due to rust. The air conditioner quit with about 80k miles. I haven't fixed that yet. My oil pan is rusting through and needs replacement. Friggin oil pan! I have never in my long life experienced that. I know of other diesel pickups that are older with far more miles that live in the northeast, used for plowing and never garaged that don't have their oil pans rusting through. Just had to change both power steering lines that go to the gearbox due to leak caused by rusting through. EGR needs to be cleaned or replaced almost as often as the oil need changing. This POS needs to be out of my life!
Too bad because if it was dependable and wasn't made out of the cheapest crappy metal Ford could find it would be a great truck. Rides and hauls great. Plows great. Good looking truck, too. Standard cab 8 foot bed. Dark green. Just can't keep doing this.
Have a problem with the rear air distribution. I can not get it to work. What am I doing wrong?
View 6 RepliesOn my Ford Taurus the car seems to just suddenly accelerate on its own. The RPMs jump and and the car gains seed. I take my foot of the gas pedal and try to lift up it just keeps going faster. It seems the only way to stop it is to mash on the gas pedal and lift up and than it will start to slow down. What is going on? I have a 2004 Taurus SES with 119323 miles.
View 2 RepliesI recently had my rear engine mount replaced on my 2004 Acura TSX. It was originally identified by the original dealer as requiring replacement and when I took it to anther Mechanic he also verified this and during the replacement he showed me the original engine mount which had a definitive crack.
After installation the Mechanic indicated that the car would feel a little stiff for a while and would smooth out over time. What I found after the first couple of days is that the engine seems to have a significant vibration when I am in idle or after I brake. When the car is in motion there is still a vibration but it is not very noticeable. I just remember from prior feel of the vehicle. This vibration did not exist prior to replacing the rear engine mount.
Is this expected to be normal until I put miles on it. The Acura is a 2004 but only has 75,000 miles. I don't drive it very much but I am concerned that the vibration I feel when I brake may be creating additional damage.
I've decide to replace the engine in a 2005 Prius. For whatever reason it went bad around 110,000 miles. It was making some noise and then went all at once. I don't know the complete maintenance history of the car, but I know it was pretty regular. I also know the car was driven mainly highway miles and on A LOT of dirt roads. So, the oil may have needed more frequent oil changes.
View 19 RepliesLooking for a guide to replace the under engine splash guard and spoiler (Part# 17 and 19 on Parts.com front bumper illustration)?
I just purchased a '05 Prius and the last owner curbed the front bumper thus breaking most of the attachment points on the bottom of the bumper and splash guard.
I see the exploded illustration but it is not very detailed.
I have a 2006 Ford Taurus SE. Tried to start the car, it would turn over, but would not catch. I shut it off and tried again and it started right up. Is this a sign of trouble and needs something?
View 10 Replies