I have a 1996 ford taurus lx about 150000 miles.. When I start the car the rpm goes up then drops to like 300 rpm then goes back up then back down.. Now if I hold on to gas pedal the car runs fine then and I don't have any codes.....
View 8 Replies96 Taurus 3.0 liter OHV will not shift out of Park. I tried the workaround in the owners manual where you take the key out, re-insert it, turn it to the OFF position then start car in neutral, but shifter still will not come out of Park. Fuse #5 is fine, and all my brake lights work. Steering wheel is not locked.
View 6 RepliesI have a 1996 Ford Taurus. With the headlight in the OFF position and the ignition off, key OUT, the headlights stay on. All other lights are off. The highbeam indicator in the cluster stays on also. I've disconnected the headlight switch (completely removed from vehicle), and the headlights still stay ON! I know absolutely nothing about this car.
View 7 RepliesI have a 1996 ford taurus dohc v6 147239 miles..when i get over 60 mph my overdrive light starts flashing and the car still drives find..i did have new transmission fluid and new fillter put in and the light was coming on before i did that and still comes on when i get over 60 mph.
View 1 RepliesMy 1996 Taurus has 202,000 miles on it. One day a while back I was headed home from work. I had the AC on and fan on HIGH. I all of a sudden started smelling something hot. I threw my sunglasses into the passenger seat and saw a gray haze in my interior and slammed on the brakes and pulled over thinking my car was on fire. I got out quickly and looked under the car and then under the hood. I then followed the HOT ELECTRICAL smell to passenger side floorboard under dash. Blower motor part so I changed it. The weather got cool again so i didn't need AC for a couple of weeks. Now, ANYTIME I try to put the fan on HIGH I get that hot electrical smell. The fan has 4 settings, on the first three it's fine, but as soon as you put it on high it smells very hot. My AC isn't as cold as it used to be but it was like that before the fan motor gave trouble. I think I just need to charge the system. Why my fan motor gets/smells hot on high setting. No fuses has blown. I definitely don't want to burn this motor up. I got new fan motor that has the same electrical connection so I didn't have to splice anything. Is something overloading??
View 6 Replies1996 Ford Taurus 3.0L EFI DOHC 6cyl...... Every time I try to start the car it want start less I push on the gas pedal... Then its start to sputter really bad then dies.. I put new spark plugs in and new spark plug wires.. I do hear the fuel pump turn on... Car has about 147000 miles...
View 13 RepliesI have a 1996 ford taurus lx 3.0 v6 engine dohc about 150000 miles..when i start the car about 5 mins the car dies..so i start it back up then it dies again.. So I start it back up then i keep my foot on gas the car stays running as soon i take my foot off gas it dies. I did have a new fuel pump in..
View 12 RepliesCan I replace a non-heated passenger side view mirror with a heated one?
View 5 RepliesCar started losing electrical power on the way home from work last week. Dim lights, blower stopped, wipers stop, almost stalled out when getting off the interstate. Barely made it home. 30 minutes later went out to troubleshoot and it started right up. Ran for about 2 minutes and stalled out from lack of electricity. Put voltmeter to alternator and it seemed to only be putting out 8.5v. Took to store to have tested. Replaced alternator and it didn't work. Reman alternator still seemed to only be putting out 8.5v or so.
Checked fuses and cleaned battery terminal and verified good block ground and good body ground. Still having problem. 1996 Taurus. What next? Battery is exactly 2 yrs old and was putting out 11.6 when the problem first started last week. Due to cold and this existing issue, battery is only at 6.5v right now. Can jump the car, but then after removing jumper cables car dies in 30 seconds. Should I have the battery tested? What else could/should I be looking at?
Well, let me rephrase that, the AC works but blower motor doesn't. When you put your hand up to the vents, they're cold.
Long story short, I ran my AC on MAX on way home from work, driving time of approx. 35 minutes. I got home, showered, and got back into car to go downtown to store. It was then I discovered that the AC wasn't coming on, and it was still on max. I shut it off and turned it back on, but to no avail. I checked all related fuses, or at least what I think is related and checked my "Taurus Bible" the chilton manual. I swapped out a blower motor relay and it didn't work, but i'm not sure that relay was or was not good, it was out of a '96 E-250 at work.
So now I get out my test light. I pulled the connection from blower motor, connect it and turn on AC and light comes on. Vents are getting cooler. So I get my tool and pull the radio and climate control assembly. I pull the plug to the actual fan connection, the part that connects to the fan switch that controld fan speed. I'm getting nothing there.
Is there a relay I don't know of? I know the AC still works because vents are still getting cold, but I can't get air to move. A LONG time ago it did this but "corrected" itself. What is my next step? I'm not sure what to check next and my repair manual is leaving me in a boat with no oars.
More details of car:
1996 Ford Taurus 3.0 V6 Vulcan motor, 8th VIN is UAUTO188,000 miles
White 4 door gray interior 3 car seats
GoodYear Tires inflated to : 33lbs LF34lbs RF36lbs RR35lbs LR
Have a code PO305. Replaced coil. Plugs and wires. Checked front injectors. They make that correct clicking noise when listened to with a long screwdriver touching their bases. Attempted to listen to rear injectors. Only could touch outer two and they make more of a swishing noise. CEL will blink after driving higher speeds but will return to steady on when engine is turned off and rested for a few minutes. Does have new fuel filter. Newer pump. Newer Cat. CEL came on when driving at highway speed with cruise control on. Engine is a 3.0 not flex.
View 14 RepliesI changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 RepliesI have a 2002 Ford Taurus with 219000+ on it. The las couple times that I have driven when the air temp was over 85 the temp gage moves to hot when the air is on. When I turn the air off the temp comes down. I have checked the fans and they are running. I also looked at the condenser and it seems to be clear. I have talked with some one and he suggested flushing the radiator.
View 10 RepliesMy wife car is a Ford Taurus 2006. I wonder is this a popular problem, or what can I check.
The Point is that the AC is on always, no matter what that ac is working and throwing cool air all the time.
Only when the Air flow selections switch is off, then ac will go off.
I have replaced the battery, spark plugs and wires and also replaced the starter in the last 8 months. also I have replaced some fuses and the fuel filter and changed the oil. My car won't start sometimes. it cranks but will not turn over. The fuel pressure is good and it sounds like it is firing but it will not start. Sometimes it will start right up after a try or two.
Also wanted to mention that when we replaced the battery less than a month ago, we bought some ethanol for fuel system and bought some starter fluid to put into it. once we did all this, it ran GREAT for about 2 and a half weeks. it started up every time on the first try. Then a few days ago it started doing what it use to do, start when it wanted to and not a minute sooner.
I have a 1991 Ford Taurus 3.0 V6 and when we go to start it, the thing tries to keep starting(turning over). Even after the key is turned off and removed. The starter just keeps going. Have to remove positive battery cable to stop it. While it was doing that the neg wire started to smoke. If I just touch the battery cable back on it tries to start. If it sits for a bit we can hook it back up and it works ok. I just had the starter and the starter solenoid replaced.
View 5 RepliesMy 2003 Taurus wagon stalled and ran out of gas even though the gauge read 1/4 full. Called AAA they came and put a can of gas (less than 2 gals.) in and the car started. I went to the nearest gas station a block away and filled the tank. It took only 10 gals. That means that there was 3 or 4 gal. in the tank when it stalled. What gives?
View 6 RepliesMy 1999 Ford Taurus (140,000 miles) is giving me trouble. This usually happens when I have just driven off the freeway and now am driving in stop and go street traffic. The O/D light indicates it is off. The odometer stops working. The needle on the tachometer slowly accelerates. The speedometer remains stuck at zero. The engine sounds like it it straining to work.I fear that this is going to be an expensive repair; I hesitate taking it to my Ford dealership. My family's trusted auto repair shop technicians seem perplexed by this problem. They hint that this might have something to do with my turbo engine.
View 4 Replies192,852 miles. I pushed down on the wiring harness when reattaching the (now) somewhat shorter "H" hose. Thought this could be a problem, so I then ran the "H" hose UNDER the harness (which seemed better). Any chance I could've broken a wire in the harness? I didn't move it very much at all, but those wires have been drying out for 13 years now. The car started right up afterward repairing the hose, but suddenly stopped after idling for about 5-7 minutes ... then it wouldn't start again for at least 15 minutes when it "caught" and idled for about 1 minute. Hasn't started again since. Besides the usual P0430 and P1131 codes, I noticed two other codes: P1744 and P0340.
Don't know if they just showed up today or if they've been there a while. My guess is it's the latter because I once saw P1744 about 7+ years ago and it was due to the cooling system not cooling the tranny fluid sufficiently (which is what has been happening again lately with the coolant leaking out of the "H" hose ... and the Degas tank before that). Temp gauge has been running past mid-scale at idle ... an indication of low fluid, and I've been filling as needed to prevent overheating until this weekend when I finally installed a new "T" on the "H" hose (it was leaking at the molded "T"). P0340 I saw pop up about a year ago during very cold weather. I wouldn't doubt that the damn magnet on the sensor has once again fallen into the synchro like it did 8+ years ago, but would this cause a no-start condition? I wouldn't think so... The car cranks plenty strong. Just won't "catch" and start. Up until today and the hose job, it had been running fine. Even drove it this morning about 10 miles. Could I have a coincidental fuel pump failure? Seems TOO coincidental, doesn't it?
My parents' car is a '99 Ford Taurus. The first time they go to start it in the morning, it either won't start or has some trouble starting. If it doesn't start, they can go back out a little later and it starts fine. Either way, once it does start, it runs fine for the rest of the day, and can be started with no trouble at all. Then the next morning the cycle begins again. It's been to the mechanic twice for this problem, but he can find nothing wrong with it. Btw, this problem has been happening in May and June, so cold weather is not responsible, it has been warm.
View 1 RepliesMy A/C does not work on my Taurus. It never has since I bought the car about 7 months ago. A few days ago I attempted to add freon. I started adding it with the A/C on at max. As I started adding A/C my compressor kicked on and started making an ominous noise; the sound was of air hissing for about 2.5 - 3 seconds punctuated by a click. So it would go something like this: airrrrrrrrrrr CLICK airrrrrrrrrr CLICK airrrrrrrr CLICK etc... My A/C starting to cool EVERSO slightly; almost imperceptible. It was advertised as having COLD A/C but I could not very well test it as I bought it in the dead of winter.
View 4 Replies