Ford Super Duty (1999-2016) :: Wire From Cab To Engine Compartment
Feb 12, 2016
Where is the best/easiest location to run some wires from the cab to the engine compartment?
I need to run some wires for a remote start with alarm and a backup camera.
View 13 Replies
Advertisement
I have a 2008 f-350 diesel, with 33k miles, I am getting a light thump or thud from the passenger side in the engine compartment, It does it when the truck is NOT moving as well as when it is moving. It use to do it only periodically but now it is doing it about every 1-2 minutes and it happened 3 times while we were sitting at a stop light.
View 3 Replies
I bought a 99 f250 super duty with v-10. Ran great then I decided to hose off engine compartment. No pressure washer just running water trying to get all the dirt off now the engine sounds like its missing. Could I have a coil pack that got wet or is something else wrong.
View 3 Replies
Looking for some input on a recent "hissing" noise coming from eng compartment. It's only noticeable during initial acceleration, and sometimes at the beginning of gear changes. I am assuming its tubo and/or exhaust related, as I've noticed a strong exhaust odor in the cab as well. I wasn't under load when the problem started but i was under rapid acceleration. Not noticing any fluids or oils leaking. No warning lights have tripped, as of yet.
View 1 Replies
Recently purchased a CPO 2009 F250SD 6.4L. Happy with the truck overall but this AM I noticed a slight burning plastic smell so I opened the hood and looked around closely. Didn't really find the culprit(I don't think) but noticed that the engine compartment heat shield/barrier appears to be falling down above and behind the turbos (pictures linked below). How big a deal is this? Would it be covered under the CPO warranty? It almost seems like a safety issue. I also wonder if the insulation material, now exposed without the metal reflector material, is what is causing the smell....
View 14 Replies
where do the wires from the cabin aux switches end up? Are any pre wired to outside of the cab (past the firewall?).
i was wanting to install a better back up light on an aux switch but don't want to deal with running thru firewall, etc.
View 2 Replies
I figured out how to go from the passenger door to in the cab, but how do you do it on the driver's side? The area is pretty "busy" around the emergency brake area.
View 6 Replies
Looking for a diagram which wire to tap so I can trigger/run my aux back up light? I tried tapping the existing wire behind the tail light and it didn't work, made the truck do funny stuff like killing the ignition. I had read on here on white knights web site that on the newer trucks you cannot use the back up circuit from the seven pin so I didn't try that. I don't have up-fitters and really didn't want to run a wire to the front but will if that is the best solution.
View 8 Replies
Trying to find ground wire location on my 99 f250 super duty with the 5.4 triton I didn't unbolt it myself. Going to be doing the big 3 upgrade soon and would like to use the factory ground spots.
View 13 Replies
I have a 1999 Ford F-250 superduty single cab. I am trying to put in rear speakers into the stock speaker housing but there are no wires run to the area. Where are the wires located in the dash to run the wire from?
View 2 Replies
I have a 2007 F-350 SRW. I bought some mirrors of craigslist from two different sellers. They are from 2008 or later, they didn't know the exact year. I have looked in the tech folder and searched and searched. could not find wires that are the same color as mine. Yes, mirrors are OEM. I need to know what color goes to what color.
Do they match color to color? question mark represents color that doesn't line up
drivers side door colors=============== new drivers side mirror colors
green------------------------------------------------- green
black--------------------------------------------------black
green/white-------------------------------------------black/white?
blue----------------------------------------------------blue
yellow--------------------------------------------------yellow
red------------------------------------------------------red
brown---------------------------------------------------brown
passenger door colors=================new passenger mirror colors
green/purple------------------------------------------white?
black---------------------------------------------------black
white/blue---------------------------------------------black/white?
yellow--------------------------------------------------yellow
green---------------------------------------------------green
brown---------------------------------------------------brown
brown/purple-------------------------------------------purple?
Side note these are in no particular order as far as pin location.
View 5 Replies
I was getting ready to run a fused wire from the battery to the rear of the truck to power my bed lights. Then I read where some owners have jumped the trailer charge relay socket to provide constant 12v at the 7-pin trailer plug.
I never keep my trailer cord connected to the truck when camping so the chances of the trailer draining the battery are nil.I don't want powering the bed lights from other sources as I have decided I want 12v to bed light switch always available.
View 1 Replies
Any limited number of lights the factory trailer harness on the truck can tolerate? I'm looking to add some extra running lights on my trailer, also want to put a couple of lights on each running board on the truck, they will be tied in with the trailer harness since it is not monitored by the BCM. I did a search on this a few different ways and couldn't find anything.
View 8 Replies
I installed a reverse camera to my new Pioneer in-dash nav head unit this morning. I wired (at the rear of the truck) the power signal lead to the reverse wire at the trailer connector. I also need to wire a reverse signal input into the back of the head unit. I really do not want to run a power lead from the rear of the truck to the cab. Is there a wire under the dash I can tap into, or could I use the wire going to the backup alarm that’s somewhere under the dash (if I can find it). 2010 F350 deisel, crew cab, 4WD, long bed.
View 9 Replies
What color wire controls the high beams?
View 1 Replies
I am putting work lights and LED warning lights on the back rack of the 2014 F350 diesel in work. Where are the wires for the upfitter switches, and are they prewired into the fuse box, or do i have to hook them up?
View 7 Replies
I have a 2013 F250 that I am installing a amber warning beacon on. I need to be able to get the end of the electrical cable into the cab of the truck but it has a 12 volt lighter plug on the end that cannot come off. Is there a rubber plug somewhere in the cab that I can route the cable through?
View 3 Replies
Went to change the plugs on an 02 f350, the bolt holding the plug wire boot on doesn't seem to fit any standard size socket. 7 is too big, 6 is too small. 1/4 is too small, 9/32 is too big.
View 14 Replies
I'm putting a new double din stereo w/ backup camera in my truck, I have everything wired except the violet/white wire (from the stereo) that needs to be hooked to a wire (on the truck) that will activate the camera when you put it in reverse. I cannot figure where this wire is on the 2012 for the life of me.
View 3 Replies
Installing a back up camera and need to locate reverse lights on driver's side at rear bumper. What color wire is for the reverse lights on a 2003 F-350 (truck in my sig)?
View 4 Replies
I 2000 f250 throughout a few years.
Anyways, I recently aquired a tekonsha voyager (for free) and went to install it, but have run into a problem with the installation.
I searched to find a wire color guide to figure out what wires are which on the under dash connector, but cannot find the answer I'm searching for.
Currently I have a red, green, blue, brown, and yellow wire on the underdash connector, while the tekonsha only has red, white, blue, and black. (I know what colors do what on the controller, but am completly lost on the under dash plug, and can't trace it back without tearing out the entire dash assembly.
View 3 Replies