Still using the ones that came on my truck new in April 2014. We've had some miserable mix of weather lately. Snow/sleet/rain/freezing rain. The blades are definitely on the way out. What are the best year round wiper blades for northern climate?
View 14 RepliesSwitch out a 5.4 in a F-250 4X4 4 my neighbor now I have a noise like fan blades hitting coming from the torque converter it goes and comes and hits good in reverse...
View 9 RepliesHaving problems with 1999 or later 7.3 missing or dying when you turn on the wiper switch?
View 8 RepliesI have no windshield wipers. Since i bought the truck ive fixed other issues but cannot figure out the issue with the wipers. Tested for power not sure if it's accurate but seems like there is power to the harness to the motor but not 100% positive.... Can it be the switch? Blinkers and rest on same switch still work but no ww. I also dont hear clicking from a solenoid like ive read on some research.. Fuses are all good pulled everyone out since they arent labeled with numbers next to them...im at such a stand still and cant drive the truck was screwed the other day when we got sun showers for nor reason and i was on a major highway.
View 6 RepliesI have a 1999 f250 super duty and an old problem has reoccurred , I start the truck and as I put on the windscreen wipers the truck cuts out?
View 6 RepliesWindshield wipers not quiet? This morning mine sounded like they were hitting the rubber windshield gasket above the windshield at the end of their sweep. I wanted to stop and get out and watch then it quit raining. I looked at the windshield gasket just now in good daylight and I don't see any scratches or hickeys anywhere....
View 2 RepliesOn my 02 f350 xlt my turn signals work but not my wiper speed switch, when i put the small fuze in, the wiper go full speed and wont stop unless i pull the fuze out... What could be wrong?
View 3 Replies2015 F250 and I'd like to have the wipers stop a little higher on the windshield causing the ice build up. Previous trucks I could pop the wipers off and rotate them and put back on. These are keyed so I can't. Any trick?
View 5 RepliesThe driver side wiper shaft on our '01 F350 is slipping/ stripped and we cant find anything online about this. Does the whole shebang need replacing? Is there an easy fix?
View 5 RepliesIve got a 99 F250 (5.4 if that matters), after a good long rain like the one we had this weekend, when I drive the truck I get water splashed on the passenger floorboard. It hold enough water that if I rock the truck side to side I can hear it sloshing. I am wondering if there is a common drain for these things that gets clogged. When my a/c runs I get a nice puddle under the truck so it looks like that is not clogged up, and I didn't know if they were the same drain or not.
View 11 RepliesWindshield wipers, and washer were suddenly not working the other day, so I discovered a blown fuse. Put a new one in, and it immediately blew again. So there is definitely something grounding out, and I am suspecting the wiper motor itself because so far I have not been able to find any wires shorting out, but before I go to the trouble of pulling the motor out and testing it, or replacing it.
Truck is a 2002 F350CC 7.3 TD. Wipers were working fine the other day before I pressure washed it, which is why I really suspect the wiper motor itself.
Mine do. Its really weird especially if I haven't been using the wipers at all and I arrive somewhere, shut the car off, and the wiper blades twitch. Just curious to see if this is normal.
View 9 RepliesHaving issue with these wiper blades? My wife's touareg has less than 15k, but the wiper blades are streaking and otherwise less than useless. I have had the same wiper blades on my jetta for over 2 years with no issue. I have tried cleaning the wipers several times, but to no avail. Before I shell out $60+ on some wiper blades. I know I am gonna probably gonna have to get the new wipers.
View 1 RepliesI am on my 3rd set of wiper blades trying to get rid of the skipping motion. I did not notice this problem with original. I bought one set at Autozone that skipped, went back and bought an expensive pair of blades, they skipped.
I bought the best wipers t, they skipped.
I just went to the dealer and got a pair of blades, they skip just as bad as all the others I've tried.
I have tried cleaning the windshield, This last time I used clay bar on the windshield but that made it worst. It would skip after each swipe after I used clay bar.
The last thing I done was use some waterless wash on windshield that has it temporally stopped skipping. The wipers run smooth so there is not a problem with any jerking or motion or anything like that.
I have 115K on 2011 Prius, not had a minute trouble out of it except for this skipping. I also have about 65K mile on this set of Michelin Energy saver A/S tires, they will go another 10K. I'm averaging 51 mpg Summer and Winter.
I was wondering if the wiper blades are controlled by two separate motors because the other day, I cut off my engine while the blades were half-way through their cycle leaving the blades exposed across the windshield. When turning the ignition back on, one of the blades starting moving slightly sooner than the other one. This may just be slack in the mechanism but it did raise a question for me. If this is the case, it might be a pretty neat safety feature.
View 12 RepliesSince when I bought the car (used) if the windshield isn't really wet, the wiper blades skip across the surface of the windshield and make a lot of noise. This occurred before and after I replaced just the wiper rubber.
View 17 Replies1971 cadillac wiper control lever will not turn on the wiper blades at any speed selected on the control lever but if you push forward on the chrome button on the lever the washer and intermittent wiper blades will work.
View 1 RepliesAfter I changed to blade on the left wiper of my 2005 GC the blades hang up at the bottom of the return stroke. This pulls the end of the rubber from the holder on the end of the blade. Wrecks the blade and requires a new one. Happens with new blades so it must be the arm. I may have bent the arm a bit the first time I replaced the blade. Could this be the cause. Need a new arm?
View 1 RepliesI just took in my 2007 RX350 to the Lexus dealer for a "once over" as I recently purchased it, as well as a squeak that was coming from the passenger side wiper blades.
After several replacements (including the high end Rainx and Michelin from Home Depot) the squeak would not go away.
Lexus indicated that the "aftermarket" blades were causing the problem and I needed Lexus blades.
I pushed back as they were about $120 for both, but, much to my surprise no squeak.
Not sure what the OEM blades are and I guess I could have researched it more, but, was at my witts end with the squeak.
Anyway, that fixed the problem.
When I turn off the wiper blades on my 1997 Toyota Camry they do not return to the home or lowest position. They stop at whatever spot they happen to be. The wipers work OK on both slow speed and fast speed. Also the intermittent function is no longer working. In this position the wiper blades operate cintinually in the slow speed. What could be the causing this problem? Could it be the wiper switch on the steering column, the wiper motor, or some other component such as a fuse or relay?
View 5 RepliesOne of the super coils busted while driving my 2002 F250 Super Duty. I drove it for less than 100 ft. before parking it. It made a rapid "check,check,check,check" sound, which I'm assuming was mainly the coil smacking against other parts while loose. It busted near the point where it screws into the motor. I felt like I lost some compression as it drove sluggishly once broken, although I only drove for a very short time. I also thought I may have smelt a slight burning scent, or maybe oil, but didn't smell anything once I got out of my truck. Any problems I should look forward to other than simply replacing this coil?
View 14 Replies